Materials Science and Engineering Commons^™

Processing Of Zrb2-Zrc-Zrxsiy Ceramic By Reactive Metal Penetration, Nischel B. Maheswaraiah

Open Access Theses & Dissertations

The processing of ZrB2-ZrC-ZrxSiy composite by reactive metal penetration was investigated as a successor to the ZrB2-SiC composites for hypersonic vehicles application, which cannot be used for extended time at temperatures greater than 1600C due to formation of SiO and CO gases. Zirconium (Zr), zirconium disilicide (ZrSi2), and boron carbide (B4C) were reacted in graphite crucibles for 60, 120, 180, and 240 minutes. Microscopy and x-ray diffraction (XRD) deduced the formation of a heterogeneous microstructure of ZrB2-ZrC-ZrxSiy precipitates surrounded by a solidified Zr-Si melt. Unreacted boron carbide was observed in samples held at 1860C for 60 minutes and 120 minutes, …

Microstructure Investigation Of Al-Rich Titanium Aluminum Alloys, David Pham

Open Access Theses & Dissertations

The microstructures of Ti-Al alloys with 70-80 wt% Al were investigated. Aluminum wire (99.999%) and TiH₂ powder (99.7%) were used to produce the sample compositions inside a vertical tube furnace at 1600^oC in an Ar atmosphere. Argon is purified through a dehumidification and deoxidation system. Magnesium perchlorate Mg(ClO₄)₂ acts as a desiccant and titanium sponge pulls oxygen from the Ar in furnaces operating at 800^oC and 750^oC. X-ray diffraction and an optical microscope are used to identify phases and compositions

Spectroscopic Study Of The Inhibition Of Calcium Oxalate Calculi By Larrea Tridentata, Luis Alonso Pinales

Open Access Theses & Dissertations

The causes of urolithiasis include such influences as diet, metabolic disorders, and genetic factors which have been documented as sources that aggravate urinary calculi depositions and aggregations, and, implicitly, as causes of urolithiasis. This study endeavors to detail the scientific mechanisms involved in calcium oxalate calculi formation, and, more importantly, their inhibition under growth conditions imposed by the traditional medicinal approach using the herbal extract, Larrea tridentata. The calculi were synthesized without and with Larrea tridentata infusion by employing the single diffusion gel technique. A visible decrease in calcium oxalate crystal growth with increasing amounts of Larrea tridentata herbal infusion …

The Reactivity Of A Zr-Si Melt With B4c At Ultrahigh Temperatures, Alvaro Vega Sandate

Open Access Theses & Dissertations

Surfaces with exceptional properties are needed for next generation materials. Hypersonic re-entry space vehicles or turbines are subjected to both oxidizing and neutral environments and nose-caps or wings on such vehicles could easily reach operating temperatures of over 2000°C. Ultrahigh temperature ceramics like ZrB2 and HfB2 have melting temperatures of 3245°C and 3380°C respectively. However, these materials need to be protected from oxidation, usually with an oxide layer. Zirconium is more affordable and will be used to study its reaction with B4C and ZrSi2.

Experimentation was conducted by melting Zr slugs into a B4C and ZrSi2 packed bed at 1860°C …

Resistive Switching Of Tin Dioxide (Sno2) For Memristor Applications, Sergio Fabian Almeida

Open Access Theses & Dissertations

In the last decades new electrical devices have been investigated in order to overcome problems caused by integrated circuit shrinking. Within these devices there is one that has attracted much attention due to its high scalability and simple structure. This device was proposed theoretically by Leon Chua in 1971 who gave it the name of "Memristor". In the recent years thin films structures composed of a metal/oxide/metal (MOM) stack have been linked to this new device, also known as "Resistive switching". There are several applications for the memristor; one of the most important is for resistive random access memory (ReRAM) …

Strain-Stiffening In Synthetic And Biopolymer Networks, Kendra Erk, Kevin J. Henderson, Kenneth R. Shull

School of Materials Engineering Faculty Publications

Strain-stiffening behavior common to biopolymer networks is difficult to reproduce in synthetic networks. Physically associating synthetic polymer networks can be an exception to this rule and can demonstrate strain-stiffening behavior at relatively low values of strain. Here, the stiffening behavior of model elastic networks of physically associating triblock copolymers is characterized by shear rheometry. Experiments demonstrate a clear correlation between network structure and strain-stiffening behavior. Stiffening is accurately captured by a constitutive model with a single fitting parameter related to the midblock length. The same model is also effective for describing the stiffening of actin, collagen, and other biopolymer networks. …

Hybrid Manufacturing: Integrating Stereolithography And Direct Print Technologies, Amit Lopes

Open Access Theses & Dissertations

The focus of this research was the development of a hybrid manufacturing system that integrates stereolithography (SL) and direct print (DP) technologies to fabricate three dimensional (3D) structural electronic devices within a single set-up. The capabilities of this new additive manufacturing (AM) technology was explored in the context of fabricating and prototyping complex electronic devices in which conformal shape, rugged and light-weight integration, and a natural resistance to reverse engineering are all of paramount importance. Consequently, electronic components can be tightly integrated together in a rugged, light-weight 3D structure of arbitrary form. This research is a continuing advancement of the …

Understanding Materials, Petros J. Katsioloudis

STEMPS Faculty Publications

The article discusses the importance of understanding the characteristics of materials that will be used for different applications. Through the years, the inventions and innovations in the technology of materials are becoming more technologically complex. Innovations in the materials are divided in different categories, including metals, ceramics, polymers and composites. Example of such innovations in the technology of materials include the ceramic composite applied to the surface of the space shuttle panels to absorb and release high amounts of heat.

Thermal Detection Of Biomarkers Using Phase Change Nanoparticles, Chaoming Wang

Electronic Theses and Dissertations

Most of existing techniques cannot be used to detect molecular biomarkers (i.e., protein and DNA) contained in complex body fluids due to issues such as enzyme inhibition or signal interference. This thesis describes a nanoparticle-based thermal detection method for the highly sensitive detections of multiple DNA biomarkers or proteins contained in different type of fluids such as buffer solution, cell lysate and milk by using solid-liquid phase change nanoparticles as thermal barcodes. Besides, this method has also been applied for thrombin detection by using RNA aptamer-functionalized phase change nanoparticles as thermal probes. Furthermore, using nanostructured Si surface that have higher …

Localized Mechanical Deformation And Dissolution Of 45s5 Bioglass, Ding Li

University of Kentucky Doctoral Dissertations

Bioactive glasses react with the human physiological solution in control of their biofunctionality. The stress state in bioactive glasses determines the chemomechanical reaction and their biofunctionality. Using the microindentation technique, the effect of the indentation deformation on the surface damage and material dissolution of 45S5 bioglass was investigated.

The indentation-induced residual stresses were calculated. Complete anelastic recoveries of the indentation depths and the impression marks were observed for the first time, which was likely driven by the stored strain energy over the anelastic deformation zone. The indentation-induced local surface damages were revealed before and after the immersion tests in phosphate …

Investigation Of The Thermoelectric Behavior Of Cu-Doped Pbteagxse, Ben Ma

All Theses

Sustainable energy research is currently on the forefront of scientific exploration thus a major effort is devoted to the development of new energy conservation and production techniques. Thermoelectric materials can play a significant part both in energy conservation and energy production via the Seebeck effect (heat to electric power) and the Peltier effect (electricity to cooling power), since they can convert wasted heat to useful electrical energy.
Presented herein are the measured electrical and thermal transport properties and phenomenal analysis of the PbTeAgxSe (x=1.9, 2.0, 2.01) system. First, it would lead to a significant reduction in the thermal conductivity and …

Giant Raman Enhancement On Nanoporous Gold Film By Conjugating With Nanoparticles For Single-Molecule Detection, Lihua Qian, Biswajit Das, Yan Li, Zhilin Yang

Electrical & Computer Engineering Faculty Research

Hot spots have the contradictively geometrical requirements for both the narrowest interstices to provide strong near-field coupling, and sufficient space to allow entrance of the analytes. Herein, a two-step method is employed to create hot spots within hybrid nanostructures, which consist of self-supported nanoporous gold films with the absorbed probes and subsequent nanoparticle conjugates without surface agents or mechanical motion. The molecules confined into 1 nm interstice exhibit 2.9 × 10⁷ times enhancement in Raman scattering compared to pure nanoporous gold. Giant enhancement primarily results from strong near-field coupling between nanopore and nanoparticle, which is theoretically confirmed by finite-difference …

Mse News 2010, Department Of Materials Science And Engineering, Michigan Technological University

Department of Materials Science and Engineering Annual Reports

Table of Contents

• MSE Welcomes New Professors
• Professor Emeritus Passes
• Alumni Achieves Milestone
• Hydrogen Storage Research
• Student Accomplishments
• Staff News
• Alumni News

Production And Characterization Of Novel Air Filtration Media, Elizabeth Skomra

All Dissertations

HEPA and ULPA filtration systems have proven to be an advantageous instrument in removing common contaminants from the air. However, an increased pressure drop due to the build-up of particulates on the filters results in its inevitable decrease in performance. Improving current filtration systems would include increasing collection efficiency all the while either maintaining or reducing the differential pressure drop in order to extend the life of the filter. One method of improving collection efficiency would be viable by increasing the amount of surface area within the filter media by glass fibers because of their inherent quality of being smaller …

Factors Controlling Ductility In Ultrafine Grain Aluminum Alloys Under Monotonic And Cyclic Loading, Partha Sarathi De

Doctoral Dissertations

"Ultrafine grained (UFG) Al processed by severe plastic deformation (SPD) methods are characterized by high strength and a limited uniform ductility. Friction stir processing (FSP), an offshoot of friction stir welding has emerged as a new technique to produce UFG alloys. FSP-UFG Al alloys show a distinctly different behavior with higher uniform elongation and improved high cycle fatigue life as compared to other SPD processed variants. The objective of this work was to study the microstructural basis for such mechanical behavior in FSP-UFG Al alloys.

To study the mechanical behavior of FSP Al alloys, a subsize bending fatigue and uniaxial …

Excitation-Induced Germanium Quantum Dot Formation On Si (100)-(2×1), Ali Oguz Er, Hani E. Elsayed-Ali

Physics Faculty Publications

The effect of nanosecond pulsed laser excitation on the self-assembly of Ge quantum dots grown by pulsed laser deposition on Si (100)-(2×1) was studied. In situ reflection high-energy electron diffraction and ex situ atomic force microscopy were used to probe the quantum dot structure and morphology. At room temperature, applying the excitation laser decreased the surface roughness of the grown Ge film. With surface electronic excitation, crystalline Ge quantum dots were formed at 250 °C, a temperature too low for their formation without excitation. At a substrate temperature of 390 °C, electronic excitation during growth was found to improve the …

Characterization Of Diamond Thin Films And Related Materials, Travis K. Mckindra

Doctoral Dissertations

"Thin carbon films including sputtered deposited graphite and CO₂ laser-assisted combustion-flame deposited graphite and diamond thin films were characterized using optical and electron microscopy, X-ray diffraction and micro-Raman spectroscopy. Amorphous carbon thin films were deposited by DC magnetron sputtering using Ar/O₂ gases. The film morphology changed with the oxygen content. The deposition rate decreased as the amount of oxygen increased due to oxygen reacting with the growing film. The use of oxygen in the working gas enhanced the crystalline nature of the films. Graphite was deposited on WC substrates by a CO₂ laser-assisted O₂/C₂H₂ combustion-flame method. Two distinct microstructural areas …

Dependency Of Machinability In Gray Cast Iron On Nitride-Induced Age Strengthening, Jared Teague

Doctoral Dissertations

"Work of previous researchers has suggested that room temperature age strengthening in gray cast irons improves machinability. Verification and quantification of the machinability improvement is important to industry. Improved machinability will reduce overall manufacturing costs and reduce raw material consumption by decreasing the rate at which tools are replaced. Experimental work was performed to determine a connection between improved machinability in gray cast iron and changes in machining mechanics. An industrial tool wear study verified that age strengthening improved machinability by reducing tool wear to less than one-quarter of the unaged value. Laboratory tests on iron castings from the same …

Ceramic Dielectrics For High Energy Density Capacity Application, Sheng Chao

Doctoral Dissertations

"The objective of this dissertation is to investigate the relationship between the processing parameters, microstructural development, defect chemistry and electrical properties of titanium oxide (TiO₂) dielectrics for high energy density capacitor applications. The effects of aliovalent dopants on the dielectric properties of TiO₂ ceramics were investigated, aiming to further improve the desired dielectric properties especially at elevated temperatures (up to 200°C). Due to the segregation of acceptor type impurities in the starting powders, space charge polarization took place in TiO₂ ceramics with relative large grain size (>̲500nm), leading to high dielectric loss and low energy storage efficiency. Increased ratio …

Borate Based Bioactive Glass Scaffolds For Hard And Soft Tissue Engineering, Steven B. Jung

Doctoral Dissertations

"The main objectives of this dissertation were to evaluate bioactive borate glass scaffolds for hard and soft tissue applications and determine the potential toxicity of the borate glasses on the adjacent and systemic tissues. Porous randomly oriented fiber scaffolds composed of bioactive borate glass were implanted in subcutaneous soft tissue sites and in calvaria defects of laboratory rats and no signs of toxicity (necrotic tissue, increase in macrophages or other immune cells) were detected in any of the adjacent tissues (hard or soft). Systemic organs (kidney and liver) of laboratory rats implanted with bioactive borate scaffolds were analyzed for possible …