Systems and Communications Commons^™

Performance Measures In Acousto-Optic Chaotic Signal Encryption System Subject To Parametric Variations And Additive Noise, Monish Ranjan Chatterjee, Anjan K. Ghosh, Mohammed A. Al-Saedi

Electrical and Computer Engineering Faculty Publications

Signal encryption and recovery using chaotic optical waves has been a subject of active research in the past 10 years. Since an acousto-optic Bragg cell with zeroth- and first-order feedback exhibits chaotic behavior past the threshold for bistability, such a system was recently examined for possible chaotic encryption using a low-amplitude sinusoidal signal applied via the bias input of the sound cell driver.

Subsequent recovery of the message signal was carried out via a heterodyne strategy employing a locally generated chaotic carrier, with threshold parameters matched to the transmitting Bragg cell. The simulation results, though encouraging, were limited to relatively …

Consideration Of Dispersion And Group Velocity Dispersion In The Determination Of Velocities Of Electromagnetic Propagation, Monish Ranjan Chatterjee, Partha P. Banerjee

Electrical and Computer Engineering Faculty Publications

Electromagnetic (EM) propagation velocities play an important role in the determination of power and energy flow in materials and interfaces. It is well known that group and phase velocities need to be in opposition in order to achieve negative refractive index.

Recently, we have shown that considerable differences may exist in phase, group and signal/energy velocities for normal and anomalous dispersion, especially near dielectric resonances. This paper examines the phase and group velocities in the presence of normal and anomalous dispersion, and group velocity dispersion (GVD), which requires introduction of the second order coefficient in the permittivity and permeability models.

Differentially Encoded Quadrature Phase Shift Key Communication And Real-Time Implementation, Robert Walton Conant

Boise State University Theses and Dissertations

Robust communication methods are integral to advances in modern technology. Software defined radios (SDRs) have been the chief instruments of communication for the last three decades. Upcoming generations of wireless networks and phone systems depend on successful implementations of increasingly sophisticated software defined modulation methods. The challenges presented by encoding, modulation, signal conditioning, timing, and decision algorithms are non-trivial. Adapting to the impacts of wired and wireless channels adds further complexity.

While not comprehensive on the subject of communications, this text serves to introduce the practical concepts of binary communications, modulation methods, the digital signal processor (DSP), and software defined …

Attaining Realistic Simulations Of Mobile Ad-Hoc Networks, Derek J. Huber

Theses and Dissertations

Mobile Ad-hoc Networks (MANET) are comprised of wireless systems that communicate without the assistance of centrally managed routers or base stations. MANET research and development has increased due to computing technologies offering smaller, faster, smarter, and more power efficient platforms to operate on. Largely the testing and evaluation of new and existing MANET protocols has resided in simulation environments. This is due in part to the complexities and expenses incurred when conducting real world tests. Many researchers have come to recognize that these current simulations tend to assume away critical components of the MANET domain. These assumptions are made either …

Fm Radio Receiver With Digital Demodulation, Nicholas Burnett

Electrical Engineering

This paper reports on the design, construction, and testing of an FM receiver. The design is split into two portions, the analog FM front end and the digital demodulator. The job of the front end is to down convert the RF signal to a frequency that is low enough to sample with an analog to digital converter. The construction of the front end is done using what is known as “Ugly Construction.” That is, all the components are soldered together floating over a ground plane.

The second portion of the design is the demodulator. The phase lock loop method of …

Touch Screen Sound Controller, James Fenley, Jonathan Law

Electrical Engineering

The Touch Screen Sound Controller sets out to explore the use of a touch screen as a sound control interface for the disk jockey profession. In addition, the project aims to provide an alternate means of transferring audio data by way of TCP/IP communications as opposed to MIDI. By applying our method, a user may stream pulse-code modulated data from a server onto a client’s RAM via an Ethernet connection. A 32bit, 200MHz ARM9 microprocessor addresses data from the RAM and proceeds with executing DSP instructions from the user. The connection between the touch screen and the central microprocessor is …

La Traducción Del Software De Mindbody Al Español, Molly Kathryn Mcfarland

World Languages and Cultures

This project entails the translation of the business management software of MINDBODY to Spanish to facilitate international communication and commerce for the company. This translation is meant to better equip MINDBODY with the tools necessary to engage in bilingual international commerce. Translation of this software demo is intended to aid the company’s Spanish speaking clientele and prospective clients by breaking down many of the language barriers they currently face with the software in English, and also to promote the recognition of the growing need for bilingualism in the rapidly changing world, both within and outside the realm of business.

The …

Characterization Of The Rfx400 For Use In Software Defined Radio, Edward Adams

Computer Engineering

While software defined radio is an extremely flexible technology that is fairly rarely used, as a single purpose radio is much cheaper, it provides an excellent means of learning RF and communications skills through the lens of digital electronics, and it would behoove a Cal Poly student interested in these areas to take on a project in software defined radio. This project aims to lower the barrier to entry for future students to undertake such a project. The use of an up-converter/down-converter is documented for future students to interface with.

Modular Laser Combat System For Remotely Operated Vehicles: Bridging The Gap Between Computer Simulation And Live Fire, Thomas Edward Fulenwider

Master's Theses

In the emerging industry of small unmanned vehicles, pioneered by small businesses and research institutions, a suitable combat system test platform is needed. Computer simulations are useful, but do not provide the definitive proof of effective operation necessary for deployment of a combat system. What is needed is an affordable simulated weapons system that enables live flight testing without the used of live weaponry.

A framework is developed here for the construction of a simulated weapon using Free Space Optical (FSO) infrared communication. It is developed in such a way to ensure compatibility with a variety of platforms including ground …

Ofdm Simulation In Matlab, Paul Guanming Lin

Electrical Engineering

The objective of this project is to demonstrate the concept and feasibility of an OFDM system, and investigate how its performance is changed by varying some of its major parameters. This objective is met by developing a MATLAB program to simulate a basic OFDM system. From the process of this development, the mechanism of an OFDM system can be studied; and with a completed MATLAB program, the characteristics of an OFDM system can be explored.

Micro Forest Fire Detection, John Cape

Electrical Engineering

No abstract provided.

Circular Polarized Splatch Antenna, Cynthia Truong

Electrical Engineering

The Splatch Antenna combines excellent performance and cost-effectiveness into an antenna package that can be integrated. The goal of this project is to figure out how to connect two Splatch antennas to realize a Circular Polarized (CP) antenna. The advantage of CP versus linear polarization is that CP eliminates polarization mismatch losses caused by Faraday’s rotation.

Sign Language Glove, Nicholas Born

Electrical Engineering

Between 500,000 and 2 million Americans use American Sign Language (ASL) as their primary language. As such, a device capable of translating those movements into text would be useful in many areas, such as teaching and the entertainment industry.

The goal of this project was to show that the creation of a glove device that takes in sign language letters, interprets them into the desired characters, and can input those characters into a computer is feasible. I chose to work on this project for many different reasons. One reason is many members of my family know sign language and use …

Aperture Coupled Microstrip Antenna Design And Analysis, Michael Paul Civerolo

Master's Theses

A linearly-polarized aperture coupled patch antenna design is characterized and optimized using HFSS antenna simulation software. This thesis focuses on the aperture coupled patch antenna due to the lack of fabrication and tuning documentation for the design of this antenna and its usefulness in arrays and orthogonally polarized communications. The goal of this thesis is to explore dimension effects on aperture coupled antenna performance, to develop a design and tuning procedure, and to describe performance effects through electromagnetic principles.

Antenna parameters examined in this study include the dimensions and locations of the substrates, feed line, ground plane coupling slot, and …

5 Ghz Band Vehicle-To-Vehicle Channels: Models For Multiple Values Of Channel Bandwidth, Qiong Wu, David W. Matolak, Indranil Sen

Faculty Publications

In Sen and Matolak's earlier paper, 5-GHz-band vehicle-to-vehicle (V2V) channel models were presented for channel bandwidths of 5 and 10 MHz. In this paper, we provide additional tapped delay line models for bandwidths of 1, 20, 33.33, and 50 MHz based upon the data used in Sen and Matolak's paper. We provide tables of channel parameters for five types of V2V channel classes and also include example tap correlation coefficients. Root-mean-square delay spread values are summarized, as are values of bandwidth for which the channel frequency correlation takes values of 0.7 and 0.5. As with the results from Sen and …

Negative Conductance Load Modulation Rf Power Amplifier, Cody R. Neslen

Master's Theses

The number of mobile wireless devices on the market has increased substantially over the last decade. The frequency spectrum has become crowded due to the number of devices demanding radio traffic and new modulation schemes have been developed to accommodate the number of users. These new modulation schemes have caused very poor efficiencies in power amplifiers for wireless transmission systems due to high peak-to-average power ratios (PAPR). This thesis first presents the issue with classical power amplifiers in modern modulation systems. A brief overview of current attempts to mitigate this issue is provided. A new RF power amplifier topology is …

A Constant Conduction Angle Biased Rf Power Amplifier For Improved Linearization In Class C Operation, Greg Lacaille

Master's Theses

Class C power amplifiers offer higher efficiency than class B power amplifiers, but suffer from poor linearity. A feedback based biasing system to improve the linearity of a class C power amplifier is designed. A class B amplifier with a gain of 20 dB and 20 MHz bandwidth at 900 MHz acts as the launching point for the design. The biasing and output network of the class B power amplifier is modified to produce a class C amplifier at conduction angles of 180°, 162°, 126°, 90°, and 54°. A feedback based biasing system, which uses two matched and scaled down …

Compact Spiral Loaded Printed Monopole Antenna, Xiulong Bao, Max Ammann

Conference Papers

A novel miniaturized printed monopole structure is proposed. The antenna comprises a printed monopole strip which is loaded by a spiral located on the rearside connected by a via. The inductive loading provided by the spiral enables considerable miniaturization of antenna. A parametric study of key dimensional parameters and groundplane are discussed.

A Pattern Reconfigurable Slot Antenna With Hybrid Feed, Matthias John, Max Ammann

Conference Papers

In this paper we investigate the design and operating principle of a pattern reconfigurable multi-mode slot antenna with a hybrid feed. The slot antenna is excited by an orthogonal arrangement of a co-planar waveguide (CPW) fed circular disc and a microstrip fed square patch. The design objective is to be able to change the direction of the main lobe by feeding the two orthogonal elements with different phases.

Embedding Gps Data Into Speech Signal, Kagan Can

Electrical & Computer Engineering Theses & Dissertations

Communication between deployed troops is very important on a battlefield. The real time knowledge of the location of the communicating patter is also very important in many situations because if you do not know the exact position of your units you cannot give correct orders. A minor error in an order can cause fatal results or lead to defeat. In many cases the position of the units is given through the speech channel by simply speaking the coordinates of the location. This can cause misunderstandings due to misinterpretation of the speech and makes it unsafe to rely on such communications. …