Electrical and Computer Engineering Commons^™

Smooth Ternary Signaling For Deep-Submicron(Dsm) Buses, Robert Endicott Hanson, Ryan Ian Fullerton

Electrical Engineering

This project demonstrates the error mitigating effects of using a three-level “smooth ternary” signal on a Deep-Submicron(DSM) bus with large inter-wire capacitance. An RC circuit used to simulate and exaggerate (for easier testing) the charging and discharging of the DSM bus. An encoder stage translates binary input data into a three-level signal before sending it to the bus. A decoder stage then translates the three-level signal back to binary that is ideally identical to the original signal. Our results show that the three-level signal has much cleaner transitions than a traditional binary signal. A few glitches that appeared when decoding …

Design And Simulation Of V2g Bidirectional Inverter And Dc-Dc Converter, Allan Agatep, Mason Ung

Electrical Engineering

As plug-in hybrid electric vehicles (PHEV) become more popular, the utility companies are forced to feed the grid more electricity. However, these PHEVs are capable of providing power to the grid when they are parked serving as ancillary systems for grid regulation (V2G). Using a system based on photovoltaic (PV) technology, a design for a bidirectional inverter with LCL filter, and a bidirectional dc-dc with a constant current controller, was constructed using LTspice. Various papers were researched and analyzed to determine applicable designs for components. Simulations show the designs are capable of bidirectional power transfer. ETAP simulations show that delivering …

Development Of Wind Tunnel For Laboratory Wind Turbine Testing, Danny Alexander Zepeda

Electrical Engineering

A wind tunnel with a 0.5 HP motor was purchased by Cal Poly Electrical Engineering Department from Hampden for $16,000. It can only simulate winds of up to 10 MPH. The tunnel has a manual dial that controls the wind speed. It also measures the voltage and current output with an analog measure display. This wind tunnel was expensive and unfortunately cannot achieve very high wind speeds. For this reason, a similar wind tunnel with more potential and with a smaller budget was proposed to be built for use in the Sustainable Energy Lab. The new wind tunnel that was …

Constant Conduction Angle Bias Generation For Monolithic Rf Power Amplifiers, Stephen Garber

Electrical Engineering

There is a need for linear, efficient monolithic power amplifiers used for the wireless transmission of signals with amplitude variations. This paper proposes a circuit that actively biases a bipolar transistor so that it operates as a Class C amplifier, with a conduction angle that is constant over a range of output powers. This results in a linear amplifier with a very low two tone intermodulation distortion. By forcing a scaled DC current vs. input magnitude curve from a Class B amplifier on to a Class C amplifier, a constant conduction angle can be maintained in the Class C amplifier. …

Variability Of Electroluminescent Displays, Christopher (C.) Michael Shedd, Nathan Ostrout

Graphic Communication

No abstract provided.

Development Of A Cubesat Instrument For Microgravity Particle Damper Performance Analysis, John Trevor Abel

Master's Theses

Spacecraft pointing accuracy and structural longevity requirements often necessitate auxiliary vibration dissipation mechanisms.  However, temperature sensitivity and material degradation limit the effectiveness of traditional damping techniques in space.  Robust particle damping technology offers a potential solution, driving the need for microgravity characterization.   A 1U cubesat satellite presents a low cost, low risk platform for the acquisition of data needed for this evaluation, but severely restricts available mass, volume, power and bandwidth resources.  This paper details the development of an instrument subject to these constraints that is capable of capturing high resolution frequency response measurements of highly nonlinear particle damper dynamics.

Bridgeless Active Power Factor Correction Using A Current Fed Push Pull Converter, Jeramie Seth Bianchi

Master's Theses

ABSTRACT

Bridgeless Active Power Factor Correction

Using a Current Fed Push Pull Converter

Jeramie Seth Bianchi

Switched Mode Power Supplies have become increasingly popular for efficient methods of delivering power to an assortment of electronic devices. This thesis proposes a method of using a current fed push pull converter to provide active power factor correction and rectification in a single stage. While most AC-DC converters utilize a bridge rectifier to convert AC-DC and then perform DC-DC conversion, the proposed circuit will utilize its output diodes to perform rectification, thus eliminating the need for a bridge rectifier. This circuit will also …

Printed Circularly-Polarized Antenna With Ultra-Wide Axial-Ratio Bandwidth, Xiulong Bao, Max Ammann

Articles

A circularly polarised printed dipole-like antenna employing asymmetrical arms and an orthogonal slit in the ground plane is presented. It is fed by a stepped microstrip line which connects to the shorter arm. By utilising surface currents on the asymmetrical arms and the orthogonal feedline structure, circular polarisation is realised. Experimental and numerical data are in agreement and the measured results show a fractional impedance bandwidth of 41.3% (1.77–2.69 GHz) and a wide axial-ratio bandwidth of 38.4% (1.81–2.67 GHz).

Project 308: Augmented Reality Mario Kart, Joseph Abad, David Allender, Joryl Calizo, Ryan Gaspar, Gavin Lee

Computer Engineering

Mario Kart is a popular go-kart racing game developed by Nintendo. The premise of the game is simple: drive a go-kart along a racetrack and reach the finish line before the other players. What makes this game unique, however, is the inclusion of weapons, traps, and other projectiles that a player can use to gain an advantage in the race. We have taken on the challenge of not only recreating this amazing game, but using the art of Augmented Reality to fully immerse the player in the full experience. Rather than play the game on a television screen with a …

Transverse Isotachophoresis Using Polyacrylamide Gel Electrodes, Mark P. Stambaugh

Master's Theses

Separation and isolation of a desired analyte from an impure sample solution containing numerous unwanted interfering agents is the first step of nearly every laboratory test performed in medicine and biology. Nucleic acids are often of particular interest to doctors and researchers, and although methods currently exist for their isolation, these procedures are costly in time, man-power, and real-estate. In addition to easing the execution of presently performed tests, mitigation or elimination of these drawbacks would make a large range of currently unperformed tests both practical and feasible.

This thesis presents a microfluidics-based approach to the isolation of nucleic acids …

Plug-In Hybrid Electric Vehicle Impacts On A Central California Residential Distribution Circuit, Darren Janigian

Master's Theses

The adoption of plug-in hybrid electric vehicles (PHEV) as a means of transportation over conventionally fueled vehicles introduces new challenges to the existing infrastructure of the electrical transmission and distribution system.  PHEV battery charging can represent a significant power demand that has the potential to overload electrical distribution components.  This study examines the impacts of PHEV charging on household service transformers, distribution conductors and voltage levels of a Central California residential distribution system.  The system is simulated using ETAP power system analysis software.  Transformers are the most vulnerable to overloads, especially if PHEV charging occurs in clusters.  Main feeder conductors …

Modeling And Analysis Of The Effects Of Pcb Parasitics On Integrated Dc-Dc Converters, Darwin Domingo Fernandez

Master's Theses

Load transients are prevalent in every electronic device including semiconductor memory, card readers, microprocessors, disc drives, piezoelectric devices, and digitally based systems. They are capable of producing voltage stress, introducing noise, and degrading device functionality. In order to avoid damage to the device, a feedback control loop is implemented with system compensation to regulate the output voltage deviations by the converter. Because designing compensation networks can be rather complicated, DC-DC converters with integrated feedback control topologies help minimize design time and complexity of converter compensation at the expense of design flexibility. This thesis widens the limitations of an integrated DC-DC …

Low-Power Self-Sustaining Schedule Display, Samuel (Sam) August

Electrical Engineering

The completed project is an Amazon Kindle, powered by a USB solar charger, running a student designed program to display a weekly schedule for a faculty member.  The purpose of the project was to design a sustainable electronic schedule display for use outside a faculty office.  It was designed in the hopes that faculty members could more easily update their schedules, and possibly allow for students to schedule appointments.  The program was designed using Java and the solar-charger was designed using a solar cell, Schottky diode, and a USB to micro-B USB cable.

Design And Implementation Of A Byzantine Fault Tolerance Framework For Non-Deterministic Applications, H. Zhang, Wenbing Zhao, Louise E. Moser, P. Michael Melliar-Smith

Electrical and Computer Engineering Faculty Publications

State-machine-based replication is an effective way to increase the availability and dependability of mission-critical applications. However, all practical applications contain some degree of non-determinism. Consequently, ensuring strong replica consistency in the presence of application non-determinism has been one of the biggest challenges in building dependable distributed systems. In this Study, the authors propose a classification of common types of application non-determinism with respect to the requirement of achieving Byzantine fault tolerance (BFT), and present the design and implementation of a BFT framework that controls these types of non-determinism in a systematic manner.

Fuzzy Robot Controller Tuning With Biogeography-Based Optimization, George Thomas, Paul Lozovyy, Daniel J. Simon

Electrical and Computer Engineering Faculty Publications

Biogeography-based optimization (BBO) is an evolutionary algorithm (EA) based upon the models of biogeography, which describe the relationship between habitat suitability and the migration of species across habitats. In this work, we apply BBO to the problem of tuning the fuzzy tracking controller of mobile robots. This is an extension of previous work, in which we used BBO to tune a proportional-derivative (PD) controller for these robots. We show that BBO can successfully tune the shape of membership functions for a fuzzy controller with both simulation and real world experimental results.

Distributed Learning With Biogeography-Based Optimization, Carre Scheidegger, Arpit Shah, Daniel J. Simon

Electrical and Computer Engineering Faculty Publications

We present hardware testing of an evolutionary algorithm known as biogeography-based optimization (BBO) and extend it to distributed learning. BBO is an evolutionary algorithm based on the theory of biogeography, which describes how nature geographically distributes organisms. We introduce a new BBO algorithm that does not use a centralized computer, and which we call distributed BBO. BBO and distributed BBO have been developed by mimicking nature to obtain an algorithm that optimizes solutions for different situations and problems. We use fourteen common benchmark functions to obtain results from BBO and distributed BBO, and we also use both algorithms to optimize …

Redesign Of Freshman Electrical Engineering Courses For Improved Motivation And Early Introduction Of Design, Phillip Wong, Melinda Holtzman, Branimir Pejcinovic, Malgorzata Chrzanowska-Jeske

Electrical and Computer Engineering Faculty Publications and Presentations

The student experience during the freshman year has been recognized as one of the keys to not only attracting more students into engineering and improving retention, but also to forming some significant attributes of successful engineering graduates. Portland State University is an urban university, and its Electrical and Computer Engineering (ECE) department serves a relatively large and very diverse student population including a large fraction of transfer and part-time students. Traditionally, all engineering disciplines within our Maseeh College of Engineering and Computer Science had a similar freshman year curriculum. The common entry course – Engineering and Applied Science (EAS) 101 …

Multispectral Classification With Bias-Tunable Quantum Dots-In-A-Well Focal Plane Arrays, Biliana S. Paskaleva, Woo-Yong Jang, Yagya D. Sharma, Sanjay Krishna, Majeed M. Hayat

Electrical and Computer Engineering Faculty Research and Publications

Mid-wave and long-wave infrared (IR) quantum-dots-in-a-well (DWELL) focal plane arrays (FPAs) are promising technology for multispectral (MS) imaging and sensing. The DWELL structure design provides the detector with a unique property that allows the spectral response of the detector to be continuously, albeit coarsely, tuned with the applied bias. In this paper, a MS classification capability of the DWELL FPA is demonstrated. The approach is based upon: 1) imaging an object repeatedly using a sequence of bias voltages in the tuning range of the FPA and then 2) applying a classification algorithm to the totality of readouts, over multiple biases, …

Efficient Packet Delivery In Modern Communication Networks, Nan Wang

Dissertations

Modern communication networks are often designed for diverse applications, such as voice, data and video. Packet-switching is often adapted in today’s networks to transmit multiple types of traffic. In packet-switching networks, network performance is directly affected by how the networks handle their packets. This work addresses the packet-handling issues from the following two aspects: Quality of Service (QoS) and network coding.

QoS has been a well-addressed issue in the study of IP-based networks. Generally, nodes in a network need to be informed of the state of each communication link in order to make intelligent decisions to route packets according to …

Optimizing Resource Allocation In Next-Generation Optical Access Networks, Jingjing Zhang

Dissertations

To meet rapidly increasing traffic demands caused by the popularization of Internet and the spouting of bandwidth-demanding applications, Passive Optical Networks (PONs) exploit the potential capacities of optical fibers, and are becoming promising future-proof access network technologies. On the other hand, for a broader coverage area and higher data rate, integrated optical and wireless access is becoming a future trend for wireless access. This thesis investigates three next-generation access networks: Time Division Multiplexing (TDM) PONs, Wavelength Division Multiplexing (WDM) PONs, and WDM Radio-Over-Fiber (RoF) Picocellular networks.

To address resource allocation problems in these three networks, this thesis first investigates respective …