Systems Engineering and Multidisciplinary Design Optimization Commons^™

The Creation, Analysis, And Verification Of A Comprehensive Model Of A Micro Ion Thruster, Maxwell J. Bodnar

Master's Theses

A computational model of the micro-ion thruster MiXI has been developed, analyzed, and partially verified. This model includes submodels that govern the physical, magnetic, electrostatic, plasma physics, and power deposition of the thruster. Over the past few years, theses have been conducted with the goal of running tests and analyzing the results; this model is used to understand how the thruster components interact so as to make predictions about, and allow for optimization of, the thruster operation. Testing is then performed on the thruster and the results are compared to the output of the code. The magnetic structure of the …

A Customer Value Assessment Process (Cvap) For Ballistic Missile Defense, Alex Hernandez

Master's Theses

A systematic customer value assessment process (CVAP) was developed to give system engineering teams the capability to qualitatively and quantitatively assess customer values. It also provides processes and techniques used to create and identify alternatives, evaluate alternatives in terms of effectiveness, cost, and risk. The ultimate goal is to provide customers (or decision makers) with objective and traceable procurement recommendations. The creation of CVAP was driven by an industry need to provide ballistic missile defense (BMD) customers with a value proposition of contractors’ BMD systems. The information that outputs from CVAP can be used to guide BMD contractors in formulating …

Simulation Of A Dissimilar Fresnel Relfectarray Antenna, Paul L. Rogers

Electrical Engineering Undergraduate Honors Theses

Planar reflectarray antennas behave similarly to parabolic dish antennas, but are flat in their construction. They work by having areas on the planar surface of different reflection phase, causing the signal to be reflected to a focal point. This is done today by making planar patch antennas with the required reflection phase. These antennas are typically used in aerospace. This paper specifically discusses a planar reflectarray antenna that was originally constructed in Millimeter Wave Circularly Polarized Fresnel Reflector for On-Board Radar on Rescue Helicopters by K. Mazouni. In this paper, the authors eight different shaped antennas to form the planar …

Synthetic Aperture Radar: Rapid Detection Of Target Motion In Matlab, Daniel S. Kassen

Master's Theses

Synthetic Aperture Radar (SAR) has come into widespread use in several civilian and military applications. The focus of this paper is the military application of imaging point targets captured by an airborne SAR platform. Using the traditional SAR method of determining target motion by analyzing the difference between subsequent images takes a relatively large amount of processing resources. Using methods in this thesis, target motion can be estimated before even a single image is obtained, reducing the amount of time and power used by a significantly large amount. This thesis builds on work done by Brain Zaharri and David So. …

Design And Analysis Of A Labview And Arduino-Based Automatic Solar Tracking System, Caiwen Ding

Morehead State Theses and Dissertations

A Thesis Presented to the Faculty of the College of Science and Technology Morehead State University in Partial Fulfillment of the requirements for the Degree Master of Science by Caiwen Ding April 24, 2015

Improving The Performance Of The Space Surveillance Telescope As A Function Of Seeing Parameter, Jae H. Jeon

Theses and Dissertations

This research paper investigates ways to improve the detection capability and predict the performance of the Space Surveillance Telescope (SST) system when it's relocated to Exmouth, Australia. The dataset collected by the SST observing the Geosynchronous Earth Orbit (GEO) satellite, ANIK-F1, entering the earth's eclipse is used to test the performance of the three existing and one new detection algorithm. The three existing algorithms are the point detection (Binary Hypothesis Test (BHT)), correlation detection (CD-BHT), and Multi-hypothesis Test using ten hypotheses (MHT10), and the new detection algorithm is the Multi-hypothesis Test using six hypotheses (MHT6). To improve the accuracy and …

Low Fidelity Flight Simulation In Collegiate Aviation, Vladimir N. Risukhin

Aviation / Aeronautics / Aerospace International Research Conference

Aviation college pilot training programs, lessons and exercises contain portions that do not require training in sophisticated and highly expensive full flight simulators and flight training devices (FTD) with high fidelity of simulation, or in real aircraft flights. Relatively inexpensive personal-computer-based flight simulation facilities named low fidelity simulators (LFS) can boost development of aircraft pilots’ cognitive and behavioral skills. The paper attempts to reveal how the LFS can support aviation college flight training and research activities. In the Western Michigan University College of Aviation, peer mentoring technique proven to be helpful in higher education institutions has been applied to flight …

Inkjet Printing: Facing Challenges And Its New Applications In Coating Industry, Sadegh Poozesh

Theses and Dissertations--Mechanical and Aerospace Engineering

This study is devoted to some of the most important issues for advancing inkjet printing for possible application in the coating industry with a focus on piezoelectric droplet on demand (DOD) inkjet technology. Current problems, as embodied in liquid filament breakup along with satellite droplet formation and reduction in droplet sizes, are discussed and then potential solutions identified. For satellite droplets, it is shown that liquid filament break-up behavior can be predicted by using a combination of two pi-numbers, including the Weber number, We and the Ohnesorge number, Oh, or the Reynolds number, Re, and the Weber number, …

Design Of The Structural And Propulsion Systems For The 2015 University Of Akron Rocket Team, Kyle W. Dehoff, Nicholas J. Hrusch

Williams Honors College, Honors Research Projects

No abstract provided.

Multi-Objective Trajectory Optimization Of A Hypersonic Reconnaissance Vehicle With Temperature Constraints, Tadeusz J. Masternak

Theses and Dissertations

Temperature-constrained optimal trajectories for a scramjet-based hypersonic reconnaissance vehicle were generated by developing an optimal control formulation and solving it using a variable order Gauss-Radau quadrature collocation method. The vehicle was assumed to be an air-breathing reconnaissance aircraft that has specified takeoff/landing locations, airborne refueling constraints, specified no-fly zones, and specified targets for sensor data collections. The aircraft model included fight dynamics, aerodynamics, and thermal constraints. This model was incorporated into an optimal control formulation that includes constraints on both the vehicle as well as mission parameters, such as avoidance of no-fly zones and coverage of high-value targets. Optimal trajectories …

Identification Of Hydrodynamic Forces Developed By Flapping Fins In A Watercraft Propulsion Flow Field, Erdem Aktosun

LSU New Orleans Theses and Dissertations

In this work, the data analysis of oscillating flapping fins is conducted for mathematical model. Data points of heave and surge force obtained by the CFD (Computational Fluid Dynamics) for different geometrical kinds of flapping fins. The fin undergoes a combination of vertical and angular oscillatory motion, while travelling at constant forward speed. The surge thrust and heave lift are generated by the combined motion of the flapping fins, especially due to the carrier vehicle’s heave and pitch motion will be investigated to acquire system identification with CFD data available while the fin pitching motion is selected as a function …

Development Of Long Endurance Small Unmanned Aerial System, Andreas Quainoo

Honors Theses

The purpose of this Senior Design Project is to design, build, and test an Unmanned Aerial System (UAS). This will be used as a test platform for airborne electronics. The intended capabilities of this project include a 12-hour flight time, the ability to carry 5 lbs of payload, and the ability to recharge the batteries of electronics while in the air. With these parameters in mind, the focus of the design was on endurance, and, by extension, efficiency and durability. Upon completion, the aircraft and its onboard systems was constructed and evaluated. Secondary products of this project include an instrumented …

A Pareto-Frontier Analysis Of Performance Trends For Small Regional Coverage Leo Constellation Systems, Christopher Alan Hinds

Master's Theses

As satellites become smaller, cheaper, and quicker to manufacture, constellation systems will be an increasingly attractive means of meeting mission objectives. Optimizing satellite constellation geometries is therefore a topic of considerable interest. As constellation systems become more achievable, providing coverage to specific regions of the Earth will become more common place. Small countries or companies that are currently unable to afford large and expensive constellation systems will now, or in the near future, be able to afford their own constellation systems to meet their individual requirements for small coverage regions.

The focus of this thesis was to optimize constellation geometries …

Achieving Global Range In Future Subsonic And Supersonic Airplanes, Nihad E. Daidzic Ph.D., Sc.D.

International Journal of Aviation, Aeronautics, and Aerospace

No commercial airplane in service today is able to fly half great-circle distances over the globe and achieve the non-stop or the global range to any antipodal location on Earth. A subsonic jetliner has the optimum cruising speed at Mach numbers approaching the drag divergence Mach number while still preserving relatively high aerodynamic efficiency. Various fuel-flow laws were used to investigate the cruise performance of subsonic and supersonic aircraft. The effect of wind and aircraft weight and how it affects the optimal cruising airspeed was investigated. Of all different operational cruising techniques, the cruise-climb at high Mach numbers is the …

Cognitively Tailored Interfaces (Ctis) For Unmanned Aerial Vehicles (Uavs), Anna Parker Strickland

Von Braun Symposium Student Posters

No abstract provided.

Foss Big Data Storage Solution, Gary L. Jaffe

STAR Program Research Presentations

Utilizing the AERO Institute as an IT test bed or “sandbox”, a small-agile development team will design, build, and test a data management storage system to support post processing of archived and in-flight data collected with the Piccolo flight control system and Compact Fiber Optic Sensing System (C-FOSS). Both systems are integrated on the APV3 aircraft, a small remote-operated vehicle. Due to the amount of data collected from C-FOSS, a system will be designed to sort and organize large data sets. An open-source database will be explored as a viable solution to manage large data loads and provide multi-cluster system …

Hil Simulation For Smartphone-Guided Autonomous Systems, Matthew Gerdt

Computer Engineering

My bachelor thesis focuses on implementing a Hardware in the Loop (HIL) simulation for a quadcopter controlled by an Android smartphone. The HIL simulation will be able to test the software running on an Android smartphone by simulating a virtual quadcopter on the computer without the need to use an actual quadcopter. To accomplish this I will have to modify my team’s existing simulation to allow for the communication between the smartphone and simulation. At the completion of my work the HIL simulation will allow the testing of different aspects of the Android application, such as the tracking of an …

Applied Mass Properties Identification Method To The Cal Poly's Spacecraft Simulator, Long H. Dam

Master's Theses

The Cal Poly Spacecraft Simulator is currently being developed for future testing and verifying theoretical control applications. This paper details the effort to balance the platform and remove undesired external torque from the system using System Identification technique developed by Patrick Healy. Since the relationship between the input and output of the system is linear, the least square method is proposed to identify the mass properties and location of center of mass of the system. The tests use four sine wave generators that are out of phase with different amplitudes as the inputs to excite various structural modes of the …

Feasibilty Of Very Large Sparse Aperture Depolyable Antennas, Jason C. Heller

Theses and Dissertations

The objective of this research is to explore the technical soundness of a very large, cross-shaped, parabolic, sparse aperture antenna extending 75 m from the bus. Specifically, describing the environment of the satellite, the effect of fabrication error on the structure and the remaining error budget for the system. The methodology involves creation of an ideal truss structure, to which all others are compared. A uniform distribution of proportional errors up to 1e-5 is introduced into the truss members' lengths and the models are subjected to a static Finite Element Analysis. A solution for the surface normal error is addressed …

Development Of Safety Standards For Cubesat Propulsion Systems, Liam Jon Cheney

Master's Theses

The CubeSat community has begun to develop and implement propulsion systems. This movement represents a new capability which may satisfy mission needs such as orbital and constellation maintenance, formation flight, de-orbit, and even interplanetary travel. With the freedom and capability granted by propulsion systems, CubeSat providers must accept new responsibilities in proportion to the potential hazards that propulsion systems may present.

The Cal Poly CubeSat program publishes and maintains the CubeSat Design Specification (CDS). They wish to help the CubeSat community to safety and responsibly expand its capabilities to include propulsive designs. For this reason, the author embarked on the …