Aerospace Engineering Commons^™

Disposal And Earth-Moon Escape From Cislunar Orbits Using Non-Linear Programming Techniques, Sam T. Loeffler

Theses and Dissertations

This thesis involves theoretical and numerical analysis of trajectories off of cislunar orbits to determine the reachability and escape of various impulsive Δ^→v. The research will propagate trajectories using three body dynamics from various orbit families around the Earth-Moon Lagrange points and find low energy transfers that escape the Earth-Moon system. In order to achieve this, various different nonlinear programming solvers in MATLAB will be used to explore low energy impulsive escape transfers from common cislunar orbit families given long periods of computation time. After many points on cislunar orbits are analyzed, the data will be analyzed to …

Heat Sink With Fins And Phase Change Material For Cooling Of High-Power Electronic Devices, Farooq Fakher Mahmoud

Theses

Electronics are integral to modern life, present in everything from household appliances to advanced computers. The performance and reliability of these devices are closely tied to their operating temperatures. High-power operations can lead to significant heating, necessitating effective thermal management to enhance functionality and prevent failure. This requirement drives the demand for efficient heat sinks, which dissipate the heat generated by these devices. Phase change material (PCM)-based heat sinks have become a popular passive cooling solution, increasingly replacing traditional heat sinks.

This research investigates finned PCM-based heat sinks using numerical simulations validated by existing literature and experimental data. Gallium is …

Interaction Of Particles With Plasma And Shock Produced By Pulsed Spark Discharge, Shomik Mukhopadhyay

Dissertations

Interactions of powders with high-temperature plasma and shockwaves occur in diverse scenarios, such as nuclear blasts, accidental industrial dust explosions, solid propellant combustion in explosive charges and when removing contaminants from surfaces. Electrostatic Discharge (ESD), known for generating shock and plasma, is a promising lab-scale technique for simulating these interactions. Studies with ESD involved placing powders near a spark-producing gap between electrodes and observing mechanical and chemical processes like particle motion and ignition. A limited range of spark conditions and material properties have been tested, which facilitated the development and validation of preliminary computational models describing this system. Significant gaps …

Reproducible Fluid Structure Interaction For Complex Flows In Engineered Systems, Allen Prasad Varghese

Dissertations

This dissertation focuses on the application of numerical models to study Fluid Structure Interaction (FSI) in the industrial context. The emphasis is on a series of case studies belonging to practical applications in design and manufacturing and that are solved by a synergistic use of theoretical and computational models. The first study looks into the hydrodynamic actions experienced by vibrating slender structures immersed in viscous fluids near the free surface. This study case is relevant to applications such as, for example, marine propulsion, micro-electro-mechanical systems, and atomic force microscopy. The hydrodynamic problem is governed by three parameters, namely the frequency, …

Consequences Of Spatial Heterogeneity For Turbulent Wake Development, Ryan Scott

Dissertations and Theses

Spatial heterogeneity is an fundamental property of natural systems. In fluid dynamics subtle variations in fluid motion give rise to chaotic turbulent flows. When a fluid passes an object it retains an imprint of the object as a momentum deficit known as a wake. The resulting spatial structure of the wake is intrinsically linked to the object responsible for its creation. The coupling between geometric complexity in wake producing entities and turbulent wake evolution is considered in terms of spatial heterogeneity from individual wakes through turbulent canopy flows. First a novel Lacunarity-based method is developed for quantifying spatial heterogeneity in …

Raditation Test Report: Characterization Of Fairchild Imaging Cis2521 Cmos Focal Plane Array, Space Dynamics Laboratory

Space Dynamics Laboratory Publications

This report documents the results of radiation testing of Fairchild CIS2521 CMOS imaging sensor. Proton radiation measurements (both transient and total ionizing dose) were performed at the Crocker Nuclear Laboratory (CNL) of the University of California, Davis (UC Davis). Latchup characterization using Heavy Ion radiation was performed at the Texas A&M University Cyclotron Institute, Radiation Effects Facility.

New Frontier In Race For Deep Space Exploration: Lunar Water Resources, Yong Wei, Honglei Lin, Fei He, Hui Zhang

Bulletin of Chinese Academy of Sciences (Chinese Version)

Deep space exploration has become the commanding heights of science and technology competition. Since the beginning of the 21st century, China has successfully completed the lunar exploration missions of “orbiting, landing, and returning” in just twenty years, and upgraded to a new roadmap of “survey, construction, and utilization”. Meanwhile, lunar exploration worldwide has shown a trend towards normalization and commercialization. The research on lunar water resources has sparked widespread interest and intense competition among countries and space agencies, marking a new focus in human’s deep space exploration. The exploration of lunar water can help reveal crucial processes in the formation …

Experimental Investigation On Downstream Characteristics Of S809 Airfoil With And Without Passive Flow Control Device, Mano S

Theses and Dissertations

The wake behaviour of extended flat plate (EFP) and serration in the trailing edge of S809 airfoil is presented in this experimental study using wind tunnel testing for several freestream turbulence intensities (TI). The clustering wind turbines in wind parks has recently been an important problem, as it involves determining the number of wind turbines to be installed to increase the power output.

The downstream wake characteristics are one of the most significantparameter that influence the performance of subsequent wind turbines.These wind turbine blades are made up of airfoil cross sections and need to be studied in detail. A series …

Infrared Phase-Change Chiral Metasurfaces With Tunable Circular Dichroism, Haotian Tang, Liliana Stan, David A. Czaplewski, Xiaodong Yang, Jie Gao

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Integrating Phase-Change Materials in Meta surfaces Has Emerged as a Powerful Strategy to Realize Optical Devices with Tunable Electromagnetic Responses. Here, Phase-Change Chiral Meta surfaces based on GST-225 Material with the Designed Trapezoid-Shaped Resonators Are Demonstrated to Achieve Tunable Circular Dichroism (CD) Responses in the Infrared Regime. the Asymmetric Trapezoid-Shaped Resonators Are Designed to Support Two Chiral Plasmonic Resonances with OppositeCDresponses for Realizing SwitchableCDbetween Negative and Positive Values using the GST Phase Change from Amorphous to Crystalline. the Electromagnetic Field Distributions of the Chiral Plasmonic Resonant Modes Are Analyzed to Understand the Chiroptical Responses of the Meta surface. Furthermore, the …

Winning Battle For Key And Core Technologies In Emerging Fields—Inspiration Based On 863 Program Related Projects, Guangzu Bai, Li Li, Hongfei Meng, Qiang Wang, Xiaoyang Cao, Anrong Liu, Bo Cheng, Mimi Zhan, Jing Li, Leiei Cui, Xiangwan Du

Bulletin of Chinese Academy of Sciences (Chinese Version)

Emerging technology fields have become the main battleground for strategic competition among major powers today, with key and core technologies serving as crucial approach in shaping a nation’s international competitive advantage. This study, from the perspective of national strategy, profoundly understands the significant importance of winning the key and core technology battle in emerging fields. Based on this understanding, it starts with a comparison between the implementation background of the 863 Program and the current reality. It systematically summarizes valuable experiences from projects aimed at advancing key and core technologies in emerging fields, and puts forward reflections and suggestions for …

Redeveloping System Noise Temperature Test Capabilities For Dss-17 Using The Moon As A Noise Source, Emily R. Walter

Morehead State Theses and Dissertations

A thesis presented to the faculty of the College of Science and Engineering at Morehead State University in partial fulfillment of the requirements for the Degree Master of Science by Emily R. Walter on May 16, 2024.

Development, Numerical Simulation And Turbulence Modeling Of A Sustainable Transonic Truss-Braced Wing Aircraft Using Liquid Hydrogen Fuel And Active Flow Control, Bryce Zachary Thomas

McKelvey School of Engineering Graduate Student Theses & Dissertations

There is pressing need for emissions reduction and an increase in efficiency for the next generation of commercial aircraft in order to reduce the environmental impact of the aviation sector and combat global climate change. The implementation of alternative fuels as well as new engine and wing designs are actively being explored as methods to reduce emissions. This thesis analyzes the implementation of hydrogen fuel, a transonic truss braced wing and active flow controls as means to improve the performance of a medium range commercial airliner. The widespread adoption of cryogenic liquid hydrogen (LH2) fuel as a green alternative to …

Regular Algorythms For Synthesis Of Optimal Control Systems For Dynamic Objects, Igamberdiyev Husan, Uktam Farkhodovich Mamirov, Xankeldiyeva Zebiniso

Technical science and innovation

The article presents algorithms for the synthesis of an optimal control system for dynamic objects. As a model, we consider a differential equation of a continuous one-dimensional system in the form of a state space, which has the properties of controllability and observability. The paper shows the need to use an observation device in order to assess how the properties of the controlled system change with the slightest change in the parameters of the control object, to assess the sensitivity of the system to these changes. When finding a solution to the equation formulated to find the parameters of the …

Heat Sink Integrating Phase Change Materials For Cooling High Power Electronic Devices, Mohammad Sameer Qasem

Thesis/ Dissertation Defenses

This research explores the numerical analysis of phase change materials (PCMs) heat sinks, focusing on high heat flux dissipation applications, e.g. electronics cooling. Both 2D and 3D numerical models using gallium and paraffin RT31 as PCMs are considered within a heat sink design framework featuring a rectangular cavity and dual opposing vertical copper walls serving as fins to dissipate heat from the hot sink base that receives heat from the heat source. The inclusion of a Triply Periodic Minimal Surface (TPMS) ‘Primitive’ structure as an in-fill thermal conductivity enhancer (TCE) in the case of the gallium heat sink, and a …

The Conceptual Design, Analysis And Optimization Of A Hydrogen Combustion And A Hydrogen Fuel-Cell Powered Aircraft, Michael Kiely

McKelvey School of Engineering Graduate Student Theses & Dissertations

In the effort to combat climate change worldwide, the aviation industry faces particularly complex design challenges in designing new, emission free vehicles. One potential solution to this problem is the use of hydrogen fuel as a means of propulsion. Hydrogen fuel has many benefits over traditional jet fuel such as a higher gravimetric energy density; however, it requires the aircraft to carry large, pressurized, cryogenic fuel tanks. This thesis examines the design challenges, potential solutions, and the analysis methods for the design of a short to medium range hydrogen powered commercial airliner. To accomplish this goal, a comprehensive conceptual design …

Emulsion Stability, Rheological Properties, And Combustion Characteristics Of Waterjojoba Biofuel Emulsion, Ihab Mohamed Ayad

Thesis/ Dissertation Defenses

This thesis comprehensively investigates the stability, rheological properties, and engine performance implications of water in jojoba biodiesel (WJBD) emulsion. The research delves into multiple aspects, including the influence of diverse surfactants and water concentrations on emulsion stability. It also yields valuable insights into the development of stable water in jojoba biodiesel emulsions, specifically tailored for diesel engines. These insights contribute significantly to the body of knowledge of positioning emulsion fuels as viable alternative to traditional diesel fuels. The anticipated benefits include notable reductions in emissions. Importantly, this study underscores the critical importance of considering emulsion stability, both during storage and …

Studying The Production Of Nanocelluloses, Shohzodbek Abduvahobovich Rashidov, Elmurod Abduqodirovich Egamberdiev, Sadritdin Maxamatdinovich Turabdjanov

Technical science and innovation

Nanoscience is a broad field that includes nanophysics and nanochemistry. Nanotechnologies are aimed at obtaining nanoparticles with new properties and creating materials and devices based on them. This is one of the modern trends in the development of science in the 21st century.

Based on the study of information about nano-sized materials, the mechanisms of their production and changes in their properties, we will consider the technology for producing nanocellulose from organic substances, i.e. from cellulose. The article describes a technology that examines devices for producing nanocellulose and the principles of their operation, as well as a combined method of …

Analysis Of Wingtip Vortex Structure Generated By Bio-Inspired Winglets, D'Zahn A. Smith

Doctoral Dissertations and Master's Theses

Bio-inspired winglets were studied with the goal of better understanding the structure of the wingtip vortices they generate. Measurements of the tip vortex were previously carried out using stereoscopic particle image velocimetry (sPIV). The bio-inspired winglet was tested on a rectangular NACA 0012 wing section at a 5-degree angle of attack and at a chord Reynolds number of 900,000. Velocity field measurements were recorded at 0.7 and 2 chord lengths aft of the wing’s trailing edge. Compared to the wing with no attachment and a traditional blended winglet, the bio-inspired winglet’s vortex exhibited significantly less intense flow field properties. These …

Comparative Analysis Of Cutting Forces In Axial-Compliant And Rigid Chamfering Tools, Sultonmurod Bekpulatovich Normatov, Oybek Tuyboyov, Azimjon Axror O'G'Li Pardayev, Alisher G‘Ayratjon Ogli Boratov, Shohjahon Tuxtasin Ogli Abdullayev

Technical science and innovation

This study delves into the analysis of cutting forces in axial-compliant systems, focusing specifically on the comparison between axially spring-compensated 90° conical tools and rigid chamfering tools. The research incorporates a predictive model for chamfer size calculation in the axially spring-compensated tools, verified through experimental tests on representative parts. The study aims to control chamfer size within tolerances by adjusting process conditions and optimizing processing efficiency. By exploring the fundamentals of the chamfering process, this research offers insights into breaking sharp edges on components with positional errors and shape deformations, with a particular emphasis on aero-engine casings. The integration of …

Enhancing Cybersecurity In Wireless Sensor Networks: Machine Learning, Blockchain And Future Perspectives, Ilemona Solomon Atawodi

Dissertations

Security in the Industrial Internet of Things encounters various security issues but the main issues can be broken down into three core issues: Availability, Integrity, and Confidentiality. Security challenges generally tend to be caused by a failure of the system in one of these areas or cause a failure in one of these areas. Therefore researching scalable solutions to these security issues is prudent to explore methods that could be applied to large-scale industrial IIoT with tens to hundreds of devices as well as small-scale systems on a tiny factory floor comprising of just a few devices. In our research, …