Aeronautical Vehicles Commons^™

Clean-Fuel E-Vtol Air Mobility Vehicles For Unmanned And Manned Operations, Larry D. Mccarroll, Brian Morrison, Bruce J. Holmes D.E., Faiaa, Fraes, Henry Vu

National Training Aircraft Symposium (NTAS)

Imagine for a moment, having your very own safe, affordable, clean-fuel, point-to-any point vehicle for travel in the 21st-century 3-dimensional airspace system. Your ultra-reliable e-VTOL allows commuters to leave behind the constraints of hub-and-spoke airports, and the congestion of interstates, turnpikes and freeways. Facilitating Inter- and Intra-urban travel, such as downtown-to-airport, or metropolis-to-metropolis, or home-to-work. Perfect for dense urban environments worldwide. And all while offering the clean power of hydrogen for zero-emission travel.

This vision for efficient, clean, delay-free mobility has been talked about for decades, but always waived aside as some kind of futurist vision. This future requires tackling …

Experiments Of Propeller-Induced Flow Effects On A Low-Reynolds-Number Wing, Gavin K. Ananda, Robert Deters, Michael S. Selig

Publications

Novel findings are discussed in this paper that will be especially beneficial to designers and modelers of small-scale unmanned air vehicles and high-altitude long-endurance vehicles that both operate at low Reynolds numbers (Re = 50,000-300,000). Propeller-induced Oow effects in both tractor and pusher configurations on a recta ngular wing using the Wortmann FX 63-137 airfoil (a common low-Reynolds-number high-lift airfoil) are presented in this paper . Significant performance benefits can be found for a wing in the tractor configuration. Experiments, including trip tests and upper-surface oil Dow visualization, show and verify that the propeller slipstream induces early transition to turbulent …

A Comparison Of The Strengths And Weaknesses Of Small-Format Aerial Photography Platforms, Jeremy W. Aber, Tyler A. Babb, Douglas E. Campbell, Kevin M. Corns

International Journal of Aviation, Aeronautics, and Aerospace

The demand for small-format aerial photography continues to grow in large part due to the rapid adoption of unmanned aerial vehicles (UAVs). Prior to the explosion of UAV use, this kind of photography was collected using older technologies such as tethered kites and blimps. Due to the increased demand for aerial imagery, this article looks at four platforms commonly used to collect small-format aerial imagery: multi-rotor UAVs, fixed-wing UAVs, kites, and blimps. Practical use considerations are explored, including characteristics of flight and operation, atmospheric and site factors, imaging sensors and costs, and regulatory limitations.

Each of the four categories of …

Surgical And Medical Applications Of Drones: A Comprehensive Review, James C. Rosser, Vudatha Vignesh, Brent A. Terwilliger, Brett C. Parker

Publications

Background: Drones have the ability to gather real time data cost effectively, to deliver payloads and have initiated the rapid evolution of many industrial, commercial, and recreational applications. Unfortunately, there has been a slower expansion in the field of medicine. This article provides a comprehensive review of current and future drone applications in medicine, in hopes of empowering and inspiring more aggressive investigation. Database: A literature search was performed by EBSCO (Elton B. Stephens Company) Discovery Service, searching the phrases "drones," "UAV," "unmanned aerial vehicles," "UAS," and "unmanned aerial systems." A second search was used to identify sources that contained …

Surgical And Medical Applications Of Drones: A Comprehensive Review, Brent Terwilliger, James C. Rosser Jr., Vudatha Vignesh, Brett C. Parker

Publications

Drones have the ability to gather real time data cost effectively, to deliver payloads and have initiated the rapid evolution of many industrial, commercial, and recreational applications. Unfortunately, there has been a slower expansion in the field of medicine. This article provides a comprehensive review of current and future drone applications in medicine, in hopes of empowering and inspiring more aggressive investigation.

Book Review: Fundamentals Of International Aviation, Alan Bender

International Journal of Aviation, Aeronautics, and Aerospace

Not applicable.

The Pocketqube Standard: Issue 1, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A report titled "The PocketQube Standard Issue 1" published on June 7, 2018.

Investigating Forward Flight Multirotor Wind Tunnel Testing In A 3-By 4-Foot Wind Tunnel, Reed Danis

Master's Theses

Investigation of complex multirotor aerodynamic phenomena via wind tunnel experimentation is becoming extremely important with the rapid progress in advanced distributed propulsion VTOL concepts. Much of this experimentation is being performed in large, highly advanced tunnels. However, the proliferation of this class of vehicles extends to small aircraft used by small businesses, universities, and hobbyists without ready access to this level of test facility. Therefore, there is a need to investigate whether multirotor vehicles can be adequately tested in smaller wind tunnel facilities. A test rig for a 2.82-pound quadcopter was developed to perform powered testing in the Cal Poly …

The Design And Implementation Of A Supersonic Indraft Tube Wind Tunnel For The Demonstration Of Supersonic Flows, Daniel Kenneth Johnson

Master's Theses

Historically, the endeavor of scale testing flight vehicles at supersonic Mach numbers, especially for long durations, has required the development of closed-loop wind tunnels, which are extremely expensive both to build and operate due to the high complexity and incredible power required to drive such a system. The intermittent blowdown wind tunnel, indraft tunnel, and shock tunnel have alleviated many of these cost requirements to some degree, whilst facilitating testing at very high Mach numbers and enthalpies; however, these systems require the handling of gases at pressures and temperatures that can be prohibitive for many university settings. The Ludwieg tube …

Development Of A Small Unmanned Aerial Vehicle Longitudinal Model For Future Flutter Testing, Said S. Hamada

Doctoral Dissertations and Master's Theses

This thesis presents the system identification of the longitudinal motion of a small unmanned aerial vehicle with flexible characteristics. The unmanned aerial vehicle of study is an off-the-shelf aircraft with limited knowledge about the dynamic model. The first task in obtaining a model for flutter testing is determining the rigid body model. Specifically, this thesis will focus in the development of the aircraft and obtaining the longitudinal rigid body model. This involves the assembly and configuration of the avionics and sensors, performing experiments to determine mass and inertia properties and using software tools for aerodynamic analysis to get preliminary values …

Homography-Based State Estimation For Autonomous Exploration In Unknown Environments, Andres S. Chavez Armijos

Doctoral Dissertations and Master's Theses

This thesis presents the development of vision-based state estimation algorithms to enable a quadcopter UAV to navigate and explore a previously unknown GPS denied environment. These state estimation algorithms are based on tracked Speeded-Up Robust Features (SURF) points and the homography relationship that relates the camera motion to the locations of tracked planar feature points in the image plane. An extended Kalman filter implementation is developed to perform sensor fusion using measurements from an onboard inertial measurement unit (accelerometers and rate gyros) with vision-based measurements derived from the homography relationship. Therefore, the measurement update in the filter requires the processing …

Active Permanent Magnet Attitude Control For Cubesats Using Mu-Metal Shielding, Maxwell Martin

Mechanical Engineering Undergraduate Honors Theses

Cube-Satellites (CubeSats) are nanosatellites composed of cube shaped units, each nominally 10cm to a side and around 1kg in mass. Due to their inherent size and weight limitations, it is often impractical to use conventional attitude, or rotational, control methods such as thrusters on these small satellites. Several methods, including magnetorquer rods and small reaction wheels, are often used instead of traditional methods to work around the size and weight limitations. As a new alternative to these methods, a permanent magnet mounted on a rotatable shaft could be used to achieve attitude control. In much the same way that a …

Algal Biofuel: The Future Of Green Jet Fuel In Air Transportation, Rajee Olaganathan

Publications

The aviation industry is one of the major contributors for the greenhouse gases. As air travel has become inevitable in this modern era, and fossil fuel usage is not sustainable, it is essential to produce renewable fuel and commercialize it to reduce the greenhouse gas emissions. In order to produce an alternate aviation biofuel a lot of industrial and academic collaborations have been developed worldwide. The main concern of this collaborative research is to produce aviation biofuel from renewable resources with low environmental impacts, and which is sustainable at an economically viable price. This mini-review briefly discusses the biotechnological approaches …

Measurement Of Forces On A Flapping Wing Micro Aerial Vehicle, Darnisha Crane

Research Horizons Day Posters

No abstract provided.

Safety Analysis Of Automatic Dependent Surveillance – Broadcast (Ads-B) System, Rajee Olaganathan

Publications

ADS-B is one of the significant implementation systems of NextGen, to help pilots and air traffic controllers to create a safer, and more efficient National Airspace System (NAS). First, this research paper will briefly describe the ADS-B system, its design structure, ADS-B In and ADS-B Out systems, its efficiency both in pilot applications and in air traffic control applications, and then discuss about the system safety analysis. The preliminary hazard analysis and fault tree analysis will be done for the identified and selected hazards, and will be briefly discussed. The paper will conclude by providing recommendations to prevent/mitigate the hazards …

Single Axis Stability Autonomous Glider Control, Brian Study

Student Works

To investigate and increase knowledge on autonomous control systems, an autonomous glider was fitted with a control system with the purpose of creating a craft that would be capable of maintaining a wings level condition despite perturbations to the trim condition. The glider measures bank angle and roll rate information from an accelerometer and gyro, before it relays the data to an equipped microcontroller. Programmed on the microcontroller is a control law to take the input from the sensors and issue a command to a single servo that controls both ailerons, allowing for the vehicle to autonomously correct its bank …

Experimental Investigation Of A New Spiral Wingtip, Naseeb Ahmed Siddiqui, Mohammed Aldheeb, Waqar Asrar, Erwin Sulaeman

International Journal of Aviation, Aeronautics, and Aerospace

Experiments on the relative merits and demerits of slotted wingtips mimicking a bird’s primary feathers have been performed. The real emargination length of feather tips, their flexibility and curved shapes during cruise are considered in the present study. The experiments were performed at a Reynolds number of 3.7 x 10⁵ on a symmetric flat plate half wing of aspect ratio 3. Lift, drag and pitching moments were measured using a six component aerodynamic balance. Four different shapes inspired by bird primary feathers have been analysed. The rigid curved tip performed the best increasing the L/D ratio by 20%. This …

Nanosatellite Space Experiment, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A report written by Professor Bob Twiggs titled "Nanosatellite Space Experiment" from March 30, 2018.

The Challenges Of Processing Kite Aerial Photography Imagery With Modern Photogrammetry Techniques, Jeremy W. Aber, Tyler A. Babb

International Journal of Aviation, Aeronautics, and Aerospace

Kite Aerial Photography (KAP) is a traditional method of collecting small-format aerial photography used for work in a variety of fields. This research explored techniques for processing KAP imagery with a focus on some of the challenges specific to photo processing. The performance of multiple automated image compositing programs was compared using a common set of 29 images. Those packages that were based on a photogrammetry approach outperformed the non-photogrammetric software, and generated similar levels of quality to one another. While all three photogrammetric packages produced satisfactory output, each had unique challenges.

Effects Of Manufacturing Process Variables On Ultrasonic Testing In Electron Beam Melted Ti-6al-4v, Andrew D. Durkee

Theses and Dissertations

Further research on validating additive manufacturing production quality is required before the realization of direct print-to-fly application of critical components. This research examines the response of ultrasonic testing as a function of various manufacturing variables in electron beam melted samples of Ti-6Al-4V. Four dimensionally identical blocks with 6 spherical voids at varying depths were manufactured using different combinations of stock powder, edge treatments, and void melting. Scans were completed on two sides of each specimen with the transducer focused on the mid-plane. Additionally, one specimen was scanned 6 times, with the focal plane adjusted for each scan to match the …