Aerodynamics and Fluid Mechanics Commons^™

Sizing Wind Tunnel Heater For High Enthalpy Conditions, Justin M. Slavick

Master's Theses

This paper determines the feasibility of adding a heater to an existing blowdown supersonic wind tunnel to unlock new high-enthalpy test applications, considering cost and power requirements at a variety of different states. This process includes both modeling the current range of test section properties in Cal Poly's blowdown wind tunnel and determining the new range of properties that a heat exchanger could induce. These results are verified with a computational fluid dynamics study. Additionally, sublimation and ablation properties of materials are explored to create appropriate models to study atmospheric re-entry once the heat exchanger is implemented.

It is found …

The Pressure Distribution Of Rotating Cylinders Using An Onboard Wireless Data Acquisition System, Nathan Eller

Master's Theses

This thesis presents a novel, cost-effective method for mapping the pressure distribution on a rotating cylinder in cross flow, a phenomenon central to the Magnus effect. Utilizing commercial-off-the-shelf (COTS) micro-electromechanical system (MEMS) pressure sensors, a high-resolution data acquisition system was developed and integrated into a rotating cylinder model. Compared to traditional approaches, such as slip rings or one-off designs, this method proved significantly cheaper and faster while achieving comparable or superior resolution. The experimental setup, including a modified continuous rotation technique and adaptable model design, facilitated rapid testing across a broad range of Reynolds numbers and reduced frequencies, exceeding the …

Interaction Of Particles With Plasma And Shock Produced By Pulsed Spark Discharge, Shomik Mukhopadhyay

Dissertations

Interactions of powders with high-temperature plasma and shockwaves occur in diverse scenarios, such as nuclear blasts, accidental industrial dust explosions, solid propellant combustion in explosive charges and when removing contaminants from surfaces. Electrostatic Discharge (ESD), known for generating shock and plasma, is a promising lab-scale technique for simulating these interactions. Studies with ESD involved placing powders near a spark-producing gap between electrodes and observing mechanical and chemical processes like particle motion and ignition. A limited range of spark conditions and material properties have been tested, which facilitated the development and validation of preliminary computational models describing this system. Significant gaps …

Reproducible Fluid Structure Interaction For Complex Flows In Engineered Systems, Allen Prasad Varghese

Dissertations

This dissertation focuses on the application of numerical models to study Fluid Structure Interaction (FSI) in the industrial context. The emphasis is on a series of case studies belonging to practical applications in design and manufacturing and that are solved by a synergistic use of theoretical and computational models. The first study looks into the hydrodynamic actions experienced by vibrating slender structures immersed in viscous fluids near the free surface. This study case is relevant to applications such as, for example, marine propulsion, micro-electro-mechanical systems, and atomic force microscopy. The hydrodynamic problem is governed by three parameters, namely the frequency, …

Consequences Of Spatial Heterogeneity For Turbulent Wake Development, Ryan Scott

Dissertations and Theses

Spatial heterogeneity is an fundamental property of natural systems. In fluid dynamics subtle variations in fluid motion give rise to chaotic turbulent flows. When a fluid passes an object it retains an imprint of the object as a momentum deficit known as a wake. The resulting spatial structure of the wake is intrinsically linked to the object responsible for its creation. The coupling between geometric complexity in wake producing entities and turbulent wake evolution is considered in terms of spatial heterogeneity from individual wakes through turbulent canopy flows. First a novel Lacunarity-based method is developed for quantifying spatial heterogeneity in …

Analysis Of Wingtip Vortex Structure Generated By Bio-Inspired Winglets, D'Zahn A. Smith

Doctoral Dissertations and Master's Theses

Bio-inspired winglets were studied with the goal of better understanding the structure of the wingtip vortices they generate. Measurements of the tip vortex were previously carried out using stereoscopic particle image velocimetry (sPIV). The bio-inspired winglet was tested on a rectangular NACA 0012 wing section at a 5-degree angle of attack and at a chord Reynolds number of 900,000. Velocity field measurements were recorded at 0.7 and 2 chord lengths aft of the wing’s trailing edge. Compared to the wing with no attachment and a traditional blended winglet, the bio-inspired winglet’s vortex exhibited significantly less intense flow field properties. These …

Numerical Investigation Of Supersonic Flow Over A Wedge By Solving 2d Euler Equations Utilizing The Steger–Warming Flux Vector Splitting (Fvs) Scheme, Mitch Wolff, Hashim H. Abada, Hussein Awad Kurdi Awad Kurdi Saad

Mechanical and Materials Engineering Faculty Publications

Supersonic flow over a half-angle wedge (θ = 15°) with an upstream Mach number of 2.0 was investigated using 2D Euler equations where sea level conditions were considered. The investigation employed the Steger–Warming flux vector splitting (FVS) method executed in MATLAB 9.13.0 (R2022b) software. The study involved a meticulous comparison between theoretical calculations and numerical results. Particularly, the research emphasized the angle of oblique shock and downstream flow properties. A substantial iteration count of 2000 iteratively refined the outcomes, underscoring the role of advanced computational resources. Validation and comparative assessment were conducted to elucidate the superiority of the Steger–Warming flux …

Towing Tank Trials Of Hydrokinetic Turbine Scale Model To Support Marine Energy System Verification, Shahab Rouhi

LSU New Orleans Theses and Dissertations

In response to the escalating demand for sustainable energy solutions and the critical reevaluation of conventional fossil fuels due to environmental concerns, this dissertation embarks on a comprehensive exploration of hydrokinetic energy as a promising alternative. The study delves into the underexplored domain of hydrokinetic energy, leveraging innovative methodologies for effective utilization and harnessing, particularly through the development and investigation of hydrokinetic turbines.

In the realm of hydrokinetic energy conversion, our research has exclusively concentrated on horizontal-axis turbines, distinct from other turbine configurations. Noteworthy is the adaptation of a conventional horizontal-axis wind turbine for water currents, revealing enhanced performance through …

Investigation On The Effects Of Biofouling On The Boundary Layer, Adam N. Bacon

LSU New Orleans Theses and Dissertations

This study is an investigation of the effect of biofouling on the boundary layer of a flat plate and a NACA 4-digit series foil. Three identical hydrofoils made of resin were placed in the Gulf of Mexico at Grand Isle, Louisiana, and observed and analyzed by marine biologists at the University of New Orleans for their species composition. The resulting biofouling that grew was primarily made up of barnacles and bryozoans. The foils were submerged in an open channel flume at zero incidence and subjected to a series of experiments whose arc-length Reynolds numbers ranged from approximately 13000 to 32000. …

An Investigation Into In-Flight Loss Of Control Accidents Due To Horizontal Stabilizer Changes On The Piper Cherokee, Connor John Geran

Theses and Dissertations

Loss of Control (LOC) while in-flight in General Aviation (GA) has been the subject of intense research by academic institutions and regulatory agencies in recent years [4] [9] [11] [19] [20] [21]. This interest is primarily due to a disproportionate number of all aircraft accidents occurring within the GA category of flight, with 94% of accidents in 2022 occurring within GA, caused primarily by pilot LOC, with 42% of accidents having LOC as the listed cause. Research into this subject at FIT yielded the results that many common GA aircraft tend to experience a strong pitch up response after undergoing …

Blade Design And Validation Of Hydrokinetic Turbine To Harvest Water Current Energy, Setare Sadeqi

LSU New Orleans Theses and Dissertations

The innovative aspect of this research lies in the careful integration of cutting-edge technologies throughout the entire process of designing, fabricating, and testing the carbon fiber propeller for the 3-bladed horizontal axis ocean current turbine (OCT). SolidWorks software played a pivotal role in the initial design phase, enabling a meticulous and precise modeling of the propeller's geometry. The utilization of SolidWorks allowed for a detailed exploration of various design parameters, ensuring that the propeller's structure and form were optimized for performance in ocean current conditions. Moving beyond the realm of virtual design, the choice of carbon fiber as the fabrication …

Performance Effects Of Dissociated Hydrogen In Nuclear Thermal Propulsion Engines, Richard Adam Gorrell

UNLV Theses, Dissertations, Professional Papers, and Capstones

Nuclear thermal propulsion (NTP) research considers hydrogen dissociation as negligible to design and analysis of propulsion engines. This study reintroduces chemically reacting flow to NTP engine analysis for investigation of the dissociation effect on engine performance. A first-principles approach observes the basic chemical mechanism and reaction within the high-speed, high-temperature NTP flow to baseline expected atomic hydrogen levels and validate equilibrium. A surface reaction study looks into hydrogen absorption through dissociation and its effect on the boundary layer, and bulk flow. For total performance, the resulting dissociated flow is analyzed through nozzle expansion and performance metrics calculated.

All historic reactor …

Characterization And Analysis Of Supersonic Flow Through De Laval Nozzles At Varied Design Conditions, Sarah Baird

Doctoral Dissertations and Master's Theses

A combined numerical and experimental investigation of supersonic planar nozzles under different design conditions has been conducted. Supersonic planar nozzles are common geometries observed in supersonic wind tunnels and aircraft or rocket engines. For the important role they play in wind tunnel testing and aircraft propulsion, it is important to conduct a thorough numerical and experimental study to characterize their performance at different operating conditions. In this study, a de Laval nozzle was scanned to extract its contours and subsequently modeled to compare analytical and numerical performance expectations under design and off-design conditions. The nozzle was then installed in a …

Modeling Of Rotor Wake Vortex Dynamics And Interactions In Non-Homogenous Vertiport Environments, Garrison P. Shaw

Doctoral Dissertations and Master's Theses

The current research serves to analyze and study the effects ground forces can have on the thrust performance of a propeller in multiple different configurations. The current research utilizes an open source Computational Fluid Dynamics (CFD) software known as OpenFOAM to generate calculate and visualize these runs. The model used for this experiment is a hybrid model that employs both a Unsteady Reynolds-Averaged Navier-Stokes (URANS) and a detached eddy simulation using a hybrid Large Eddy Simulation (LES) via a KomegaSSTDDES model. This model serves to save computational time as well as allow for accurate results. The three cases run are …

Experimental And Numerical Analysis Of Laminar And Transitional Flow Through Annular Corrugated Pipes, Joseph Russell Sargent

Theses and Dissertations

This dissertation presents studies on pressure loss through annular corrugated pipes to determine a friction factor coefficient using nitrogen. Ten different corrugated pipes’ geometries were evaluated via testing and experimentation. The ratio of corrugation height to inner diameter varied from 0.233 to 0.333 and the ratio of corrugation pitch to inner diameter varied from 0.181 to 0.446. Nitrogen flow rates between 0.25 to 94.4 standard liters per minute were used, resulting in Reynolds numbers, based on the corrugated pipe inner diameter, from 100 to 23,000. The experimental set-up was validated using smooth-pipe pressure loss measurements and the derived friction factor …

Aerodynamic Design And Analysis Of A Modified 2006 Mazda Miata, William N. Recher

Honors College Theses

Aerodynamic forces developed by automobiles have destabilizing effects at high speed. These forces tend to skew toward a vehicle’s rear which can present safety concerns, especially for rear-wheel-drive automobiles like the Mazda Miata. To address oversteer and high-speed instability, a vehicle’s design can be tailored to bring about aerodynamic balance and improve traction. LiDAR was used to bring the physical automobile into the digital space. Then, a splitter and diffuser were added to reduce the magnitude of the destabilizing forces. Next, the size and shape of the rear-wing required to balance the vehicle was calculated using a combination of parameters …

Martian Atmospheric Rover Simulation (M.A.R.S.), Matt Berard, Shelby Beddard, Alexander Brunette, Emma Conti, Collin Duke, Delaney Novak, Keelin Weaver

Aerospace, Physics, and Space Science Student Publications

While rovers have been used by various agencies to explore Mars, their travel is limited by terrain obstacles, which may prevent mission completion. Creating a vehicle equipped with both driving and flight capabilities would allow greater range of motion on extraterrestrial planets. Integrating the technology for both transportation modes into one rover allows for efficiency and advancements in technological and planetary research.

Development Of Eagle3d Solver For Wall Modeled Les Of Transonic Flows, Spencer Moore

Doctoral Dissertations and Master's Theses

Wall modeled Large Eddy Simulation (LES) is an area of interest due to its ability to lower computational costs of LES simulation. Even with the application of wall models, LES still proves to have practicality issues when it comes to use in industry, due to the expertise, time, and computational resources required to get results. A case described by an axisymmetric transonic bump is explored utilizing the Embry-Riddle Aeronautical Universities in house unstructured finite volume multi-element CFD code, Eagle3D. Eagle3D, has been brought to the state of the art and validated against current research using this transonic bump case as …

Conceptual Design Methodology For The Fan-In-Wing Vtol Aircraft, Brock Steinfeldt

Doctoral Dissertations and Master's Theses

The Fan-In-Wing (FIW) aircraft concept is one of the most compelling solutions for missions demanding jet-like cruise speeds and Vertical TakeOff and Landing (VTOL) capability. However, despite years of interest and documented improvements in lift-fan technology, there exists little in the way of an adequate theory for conceptual design of a fan-in-wing aircraft. To address this issue, a general conceptual design methodology has been developed as a source of guidance for the FIW designer. Through this work, the top-level requirements ranking the fan-in-wing concept above other VTOL aircraft have been defined, while a cross-comparison between the FIW concept and conventional …

Adaptive Control Of An Aeroelastic System For Active Flutter Suppression And Disturbance Rejection, Patrick Sterling Downs

Doctoral Dissertations and Master's Theses

The future of aircraft design strives for lighter weight, more aerodynamically efficient structures. These improvements may come with the drawback of increased structural flexibility and elevated aeroelastic effects, often resulting in a lower flutter speed. This motivates the implementation of advanced control methods to control aeroelastic systems over a range of flight conditions, suppress and delay the onset of flutter, and compensate for disturbances, actuator dynamics, and unmodeled nonlinear dynamics.

This dissertation first develops a novel method for constructing time-domain simulation models of two and three-dimensional aeroelastic systems, resulting in models that are suitable for the implementation of state-space control …