Engineering Commons^™

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I. SCOPE OF THIS REPORT At the present time failure tests are being carried out on the 24 beams series D and E. To date the following beams have been tested: D-18-16-816a and E-18-16-816a and b; E-18-14-816a and b; D-18-14-816a and b; E-18-12-816b; D-18-816a and b; E-18-18-88a and b; total - 13 beams. The failure tests on those beams are carried out in a way different from data used heretofore (see section II of the report). As a result very extensive data are obtained for each of these beams. Since the evaluation of these data will require considerable time it …

American Iron And Steel Institute Tests On Cold Formed Steel Studs, American Iron And Steel Institute

CCFSS Library (1939 - present)

I. SCOPE This report presents results of buckling tests on: Type A studs with free-ends condition, Type B studs with "minimum restraint" or "actual" end condition.

Adjusting Planters And Listers For Sorghums, L. W. Hurlbut

Nebraska Agricultural Experiment Station: Historical Circulars

It is the purpose of this circular to present data and suggestions that will aid the farmer in attaining greater success in the planting of sorghum. It has been prepared primarily for the machine operator; and, although it is not a complete discussion of planters and listers, it contains highly practical suggestions regarding the adjustment of the corn planter and lister for sorghum seed.

Tests On Cold Formed Steel Studs American Iron And Steel Institute, American Iron And Steel Institute

CCFSS Library (1939 - present)

I. PURPOSE OF THE INVESTIGATION The purpose of the investigation is to provide technical information for the development of standard specifications for steel stud wall construction, suitable for inclusion in building codes.

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I. SCOPE OF THIS REPORT 1. A stress investigation has been made at the load points of beam E-18-14-88a for spans of 6 and 12 ft. with center load and for spans of 12 ft. with quarter point loading. 2. A similar investigation has been made on beam E-18-12-816a.

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I. SCOPE OF THIS REPORT 1. A.stress investigation has been made on beam E-18-12-816 b at the load points with 6 and 12 ft. span and center load and with 12 ft. span and quarter point load. 2. The results of these tests seem to show that, after the completion of similar tests on two more beams of the present shipment enough data will have been gathered to answer the question of stress distribution. It was therefore thought advisable to carry out a more complete investigation on this beam. For this purpose the stress distribution at five additional cross sections …

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I. OBJECT OF THIS REPORT 1. Investigation of the stress distribution in the bottom flange of beam A-14-612a after its reconstruction. 2. Investigation of the strain distribution in the bottom flange of beam D-18-12-816a. 3. Observations on beams E-18-12-816a and b.

John Deere Model D, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I. IDENTIFICATION OF SPECIMENS. The method of designation used hitherto is not sufficiently differentiated to identify the present and future specimens since specimens with identical bottom flanges but different top flanges are used. For this reason from now on each specimen is designated by symbols and figures, for example D-18-16-88a in which: D designates a series of beams, 18 designates the gage of mterial used for web and bottom flange, 16 designates the gage of material used for the top flange, 8 designates the depth of the section in inches, 8 designates the width of the bottom flange in inches, …

Test 349: Case Model D, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 362: Allis-Chalmers Model Hd-14, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

1940 Report Of Trip To Mines And Tunnels In The Southwest, T.H. Oaas, E.I. Renouard

Mining Engineering

No abstract provided.

Report Of Cooperative Investigation Of Joint Spacing In Concrete Pavements, Louis Campbell

Kentucky Transportation Center Research Report

In order to aid in a final determination of a rational, economical, and practical jointing method for concrete pavement, and to obtain factual data for future construction, the Kentucky Department of Highway built 6.27 miles of experimental pavement during the summer of 1940. This project was one of those planned by the Public Roads Administration and the Portland Cement Association in cooperation with the various states.

Test 350: John Deere D, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere D TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear. This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated. BELT HORSEPOWER TESTS TEST …

Test 344: International Tractractor Model Td-9 (Wide Tread), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 341: M-M Twin City Model Rtu, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 345: International Tractractor Model Td-6 (Widetread), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 346: International Tractractor Model T-6 (Wide Tread) (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 260: Allis-Chalmers Model Hd-7w (Wide Tread), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 359: Massey-Harris Model 101r Junior, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 360: Allis-Chalmers Model Hd-7w (Wide Tread), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 356: Mccormick-Deering Model Wd-6 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 363: Allis-Chalmers Model C (Distillate), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 355: Mccormick-Deering Model W-6 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 343: International Tractractor Model Td-14 (Wide Tread), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 364: Allis-Chalmers Model C (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Advertising Brochure: International Harvester Td-6 Crawler, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 351:Oliver Row-Crop 70 Hc, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 365: Oliver 80 Standard Hc, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Advertising Brochure: Case V, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.