Energy Systems Commons^™

Test 2188: Case Ih Steiger 540 Quadtrac, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Heat Transfer Analysis In A Paddle Reactor For Biomass Fast Pyrolyis, Ankith Ullal

Dissertations, Master's Theses and Master's Reports

Heat transfer analysis was performed on a novel auger reactor for biomass fast pyrolysis. As part of this analysis, correlations for specific heat capacity and heat transfer coefficients for biomass (sawdust) and sand (used as heat transfer medium) were developed. For sand, the heat transfer coefficient followed a power law distribution with reactor fill level and temperature. For raw biomass, the heat transfer coefficient also showed similar dependence on fill level, but was independent of temperature up to 300°C. These correlations were used in a one dimensional heat transfer model developed to calculate the heating time and heating rate of …

Solar Energy R & D Project: Teachers Incorporating Stem- Modules To Yield An Energy Literate Generation, Tricia Kirkland, Lindsay Snowden

ENgaging Educators in Renewable enerGY (ENERGY): Lesson Plans & Slideshows (2017-2019)

Background- Photovoltaic (PV) cells produce the largest amount of electricity when they are directly facing the sun. Solar panels that use tracking systems to position the panel to constantly face the sun have the greatest efficiency. But, these systems are expensive.

Aim- Design a dual axis tracking solar panel with microcontroller and sensors (light, humidity, temperature, and compass) that are both cost effective and efficient. Sensors will be used to determine performance depending on environmental factors.

Ethics Statement: Researchers will keep honest, clear, and accurate records when collecting all data in lab and communication of information learned.

Wind Energy, Bob Deckard, Jaimee Howard

ENgaging Educators in Renewable enerGY (ENERGY): Lesson Plans & Slideshows (2017-2019)

No abstract provided.

Solar Irradiance Forecasting And Implications For Domestic Electric Water Heating, Christopher Nutter

College of Graduate Studies: Theses & Dissertations

As the effects of burning fossil fuels continues to present its prevalence, the interests in alternative forms of energy is expanding. Within the home, the domestic electrical water heater accounts for approximately 17% of its energy consumption. Reducing the amount of energy required to produce hot water from this thermal system alone can have a significant effect on reducing its carbon footprint. In this presented work, a modeled domestic electrical water heater was supplied photovoltaic and on-grid electrical power to increase its energy efficiency. As photovoltaic (PV) energy is directly related to solar irradiation, it is important to receive accurate …

Natural Convection Heat Transfer Of Inclined Sierpinski Carpet Fractal Fins, Luke A. Fussell

College of Graduate Studies: Theses & Dissertations

When designing extended surfaces for the thermal management of electronic devices in aerospace applications it is critically important to minimize mass. However, this can be difficult to achieve as the rate of heat dissipated is directly proportional to the surface area. Fortunately, when certain fractal geometries, like the Sierpinski carpet, are utilized in the design of extended surfaces an increase in surface area and simultaneous decrease in mass can be achieved. The thermal performance of fins inspired by the first four fractal iterations of the Sierpinski carpet pattern was experimentally examined in a natural convection environment. The fractal fins were …

Module 2: Solar Powered Cricket Lab & Engineering Guest Speaker, Lindsay Snowden

ENgaging Educators in Renewable enerGY (ENERGY): Lesson Plans & Slideshows (2017-2019)

Students will participate in a Solar Panel Cricket lab to determine which environmental condition would allow for the solar panel to produce the most power. The three conditions are inside, inside with a flashlight, or outside in the sun. The students will complete a correlating lab worksheet. Students will also ask questions and hold discussions with the guest speaker. Students will actively participate while the guest speaker is presenting.

Power House Sustainable Energy Education, Rachael Grillo, Molly Hopper, Laura Mills

ENgaging Educators in Renewable enerGY (ENERGY): Lesson Plans & Slideshows (2017-2019)

No abstract provided.

Renewable Energy, Keith Bazemore

ENgaging Educators in Renewable enerGY (ENERGY): Lesson Plans & Slideshows (2017-2019)

Lesson Plan for Renewable Energy- Environmental Science.

Nsf Energy - Pico-Grid Smart Homes Power Management System, Aaron Specht, Shaina Neal

ENgaging Educators in Renewable enerGY (ENERGY): Lesson Plans & Slideshows (2017-2019)

No abstract provided.

Performance Analysis On Free-Piston Linear Expander, Furkan Kodakoglu

UNF Graduate Theses and Dissertations

The growing global demand for energy and environmental implications have created a need to further develop the current energy generation technologies (solar, wind, geothermal, etc.). Recovering energy from low grade energy sources such as waste heat is one of the methods for improving the performance of thermodynamic cycles. The objective of this work was to achieve long-term steady state operation of a Free-Piston Linear Expander (FPLE) and to compare the FPLE with the currently existing expander types for use in low temperature energy recovery systems. A previously designed FPLE with a single piston, two chambers, and linear alternator was studied …

Exploiting Modern Image Processing In Surface Flow Visualisation, Tarek Ihab Abdelsalam, Richard Williams, Grant Ingram

Mechanical Engineering

Surface flow visualisation is an experimental technique where the surface of interest is painted with an oil and dye mixture before a flow is applied to the object. In regions of high shear stress the oil/dye mixture is then removed and in regions of low shear stress the oil/dye mixture stays or builds up. The resulting pattern can be analysed to determine the structure near the surface under test, this is normally done in a qualitative manner with flow structures being identified based on the expertise of the experimentalist. Modern image processing tools can identify shapes and lines in pictures …

Design Of Electrical Layout Of Offshore Wind Farms, Shirshak K. Dhali, Mahidhar Nandigam

Electrical & Computer Engineering Faculty Publications

The cost and efficiency of offshore wind farms are determined by a variety of factors which include the type of electrical system (AC or DC), transmission length, transmission voltage, rated power, wind turbine type, farm topology, and wind speed. Since the design variable space is large for such problems, computational optimization is necessary to find an optimal solution. This paper discusses a design methodology to determine the optimal values of components to minimize the cost of an offshore wind farm. The cost, loss, reliability models, and the application of geometric programing for optimization of the layout and configuration of an …

Processing, Microstructure, And Mechanical Properties Of Zirconium Diboride-Molybdenum Disilicide Ceramics And Dual Composite Architectures, Ryan Joseph Grohsmeyer

Doctoral Dissertations

"This research had two objectives: characterization of processing-microstructure-mechanical property relationships of conventional ZrB₂-MoSi₂ ceramics at room temperature (RT) and 1500⁰C in air, and fabrication of ZrB₂-MoSi₂ dual composite architectures (DCAs) for use near 1500⁰C. Elastic moduli, fracture toughness, and flexure strength were measured at RT and 1500⁰C for 15 ZrB₂-MoSi₂ ceramics hot pressed using fine, medium, or coarse ZrB₂ starting powder with 5-70 vol.% MoSi₂, referred to as FX, MX, and CX respectively where X is the nominal MoSi₂ content. MoSi₂ decomposed during sintering, resulting in …

Florida Rural Small Business Energy Assistance Collaborative Cumulative Report Ending December 31, 2016, Florida Solar Energy Center, Janet Mcilvaine

FSEC Energy Research Center®

The U.S. Department of Agriculture's (USDA) Rural Development initiative reaches out to communities across America with many programs (http://www.rd.usda.gov/programs-services/all-programs). USDA's Rural Energy for America Program (REAP) offers grants and loan guarantees for energy efficiency improvements and renewable energy systems to agriculture operations and qualifying rural small businesses. USDA has awarded the University of Central Florida a grant to provide a limited number of subsidized Energy Audits to eligible businesses in Florida in support of USDA Rural Development (USDA-RD) Grant and Loan programs for rural small businesses. The ultimate goal of the energy audits is to increase participation in REAP. Audits …

Phased Retrofits In Existing Homes In Florida Phase Ii: Shallow Plus Retrofits [Revised], Florida Solar Energy Center, Karen Sutherland

FSEC Energy Research Center®

The U.S. Department of Energy Building America team Partnership for Improved Residential Construction is collaborating with Florida Power & Light Company (FPL) to conduct a phased residential energy-efficiency retrofit program. This research seeks to determine the impacts on annual energy reductions from the installation of advanced residential technologies. Earlier project work involving the application of two levels of retrofit, shallow and deep, found average savings of 9% and 38%, respectively. Whole-house demand reduction among the deep retrofit homes averaged 39% during FPL's peak summer hour. These savings levels approach the Building America program goals of reducing whole-house energy use of …

Energy-Efficient Management Of Mechanical Ventilation And Relative Humidity In Hot-Humid Climates, Florida Solar Energy Center, Charles Withers, Jr.

FSEC Energy Research Center®

The U.S. Department of Energy's Building America research team Building America Partnership for Improved Residential Construction conducted this research project to gain data and insight into these issues. The project focused on energy-efficient management of mechanical ventilation and RH during the cooling season. It consisted of eight test configurations. A particular focus evaluated how well a ductless seasonal energy-efficiency ratio (SEER) 21.5 mini-split heat pump (MSHP) could perform as the primary cooling system without a dehumidifier for supplemental dehumidification in a continuously mechanically ventilated house.

Photovoltaic Cooking In The Developing World, Tyler Watkins, Christopher O'Day, Omar Arriaga

Mechanical Engineering

The challenge of clean cooking is faced by hundreds of millions of people worldwide. We present a cooking technology consisting of a solar panel directly connected to an electric heater in a well-insulated chamber. Assuming continued decrease in solar panel prices, we anticipate that in a few decades Solar Electric Cooking technologies will be the most common cooking technology for the poor. Appropriate use of insulation reduces the power demand making low-power Insulated Solar Electric Cooking systems already cost competitive.

Thermal Transport In Lithium Ion Batteries: An Experimental Investigation Of Interfaces And Granular Materials, Aalok Jaisheela Uday Gaitonde

Open Access Theses

Increasing usage and recent accidents due to lithium-ion (Li-ion) batteries exploding or catching on fire has inspired research on the characterization and thermal management of these batteries. In cylindrical 18650 cells, heat generated during the battery's charge/discharge cycle is poorly dissipated to the surrounding through its metallic case due to the poor thermal conductivity of the jelly roll, which is spirally wound with many interfaces between electrodes and the polymeric separator. This work presents a technique to measure the thermal conduction across the metallic case-plastic separator interface, which ultimately limits heat transfer out of the jelly roll.

The polymeric separator …

Effect Of Ducted Hpwh On Space-Conditioning And Water Heating Energy Use - Central Florida Lab Home, Florida Solar Energy Center, Carlos Colon

FSEC Energy Research Center®

The purpose of this research is to investigate the impact of ducted heat pump water heaters (HPWHs) on space-conditioning and water heating energy use in residential applications. Two identical HPWHs, each with a capacity of 60 gal, were tested side by side at the Flexible Residential Test Facility (FRTF) laboratories on the Florida Solar Energy Center (FSEC) campus in Cocoa, Florida. The FRTF's residential buildings feature the same square footage (1,535 ft2 ), orientation, and envelope characteristics; currently, the only difference between them is the finished floor material. The east FRTF building is furnished with standard carpet flooring, whereas the …