Open Access. Powered by Scholars. Published by Universities.®

Energy Systems Commons™

Open Access. Powered by Scholars. Published by Universities.®

5,621 Full-Text Articles 2,962 Authors 1,621,421 Downloads 115 Institutions

All Articles in Energy Systems

Faceted Search

5,621 full-text articles. Page 116 of 123.

Simulation And Validation Of Two-Component Flow In A Void Recirculation System, Oscar Eduardo Daza 2011 California Polytechnic State University, San Luis Obispo

Simulation And Validation Of Two-Component Flow In A Void Recirculation System, Oscar Eduardo Daza

Master's Theses

Nuclear power plants rely on the Emergency Core Cooling System (ECCS) to cool down the reactor core in case of an accident. Occasionally, air is entrained into the suction piping of ECCS causing voids that decrease pumping efficiency, and consequently damage the pumps. In an attempt to minimize the amount of voids entering the suction side of the pump in ECCS, a Void Recirculation System (VRS) experiment was conducted for a proof of concept purpose. While many studies have been oriented in studying two-component flow behavior in ECCS, none of them propose a solution to minimize air entrainment. As a …


Some Experiences, Thoughts, Ideas And Open Questions Relating To Applied Thermodynamics, Jim McGovern 2011 Technological University Dublin

Some Experiences, Thoughts, Ideas And Open Questions Relating To Applied Thermodynamics, Jim Mcgovern

Articles

In this paper I present some of my thoughts and experiences relating to 'applied thermodynamics' over my career so far. I explain my interest in thermodynamics, describe some topics I have worked on, point out some questions that appear still to be open and outline some ideas for work that could be done. I describe how I was inspired to pursue the area of applied thermodynamics, with reference to a glass, opposed-piston internal combustion engine. I put my heat pump research in the late 1970s briefly into today's context. Some of my research has been in relation to compressors, which …


Arra Advanced Weatherization Training Center - Quarterly Report (January 2011-March 2011), Florida Solar Energy Center, Neil Moyer 2011 Florida Solar Energy Center

Arra Advanced Weatherization Training Center - Quarterly Report (January 2011-March 2011), Florida Solar Energy Center, Neil Moyer

FSEC Energy Research Center®

The 1st quarter of 2011 was the beginning of procurement for the training center. Two pieces of equipment, the insulation blowing machine and infrared cameras, were put out for quotes. Both have been selected and purchase orders created.


Building America Industrialized Housing Partnership (Baihp Ii) Final Report Budget Periods 1-5, April 1, 2006 - November 30, 2010, Florida Solar Energy Center, Robert Abernethy 2011 Florida Solar Energy Center

Building America Industrialized Housing Partnership (Baihp Ii) Final Report Budget Periods 1-5, April 1, 2006 - November 30, 2010, Florida Solar Energy Center, Robert Abernethy

FSEC Energy Research Center®

This report summarizes the work conducted by the Building America Industrialized Housing Partnership (BAIHP - www.baihp.org) during the final budget period (BP5) of our contract, January 1, 2010 to November 30, 2010. Highlights from the four previous budget periods are included for context.

BAIHP is led by the Florida Solar Energy Center (FSEC) of the University of Central Florida. With over 50 Industry Partners including factory and site builders, work in BP5 was performed in six tasks areas:

  • Task 1: Building America System Research Management, Documentation and Technical Support
  • Task 2A: Stage G1A: Integrated Solutions for Specific Climate Regions
  • Task …


Tower-Tracking Heliostat Array, Joel T. Masters 2011 California Polytechnic State University, San Luis Obispo

Tower-Tracking Heliostat Array, Joel T. Masters

Master's Theses

This thesis presents a method of tracking and correcting for the swaying of a central receiver tower in concentrated solar production plants.  The method uses a camera with image processing algorithms to detect movement of the center of the tower.  A prototype was constructed utilizing a CMOS camera connected to a microcontroller to control the movements of three surrounding heliostats.  The prototype uses blob-tracking algorithms to detect and correct for movements of a colored model target.  The model was able to detect movements in the tower with average error of 0.32 degrees, and was able to correctly orient the surrounding …


Short-Term Curtailment Of Hvac Loads - Executive Summary, Florida Solar Energy Center, Lixing Gu 2011 Florida Solar Energy Center

Short-Term Curtailment Of Hvac Loads - Executive Summary, Florida Solar Energy Center, Lixing Gu

FSEC Energy Research Center®

Rapidly increasing requirements placed on utilities to reduce peak loads has led to utility customer incentives to shift peak demand to non-peak times or reduce peak loads when notified by the utility that the grid is close to capacity. This study investigates methods used to reduce building demand during a fixed time window near a utilities on-peak period. The window was chosen to be 5-9 A.M. in winter and 2-5 P.M. in summer. The most common methods for reducing building peak demand were reviewed and categorized by their usefulness and wide-spread availability. These strategies were reductions in lighting power density, …


Arra Advanced Weatherization Training Center - Quarterly Report (September 2010-December 2010), Florida Solar Energy Center, Neil Moyer 2011 Florida Solar Energy Center

Arra Advanced Weatherization Training Center - Quarterly Report (September 2010-December 2010), Florida Solar Energy Center, Neil Moyer

FSEC Energy Research Center®

The 4th quarter of 2010 was the initialization of the contract with DOE. During this time period, there were two major events that occurred. First, representatives from UCF-FSEC attended the three day Atlanta Weatherization Training Center Grantee Training Workshop with DOE representatives and the various organizations that were awarded funding. Secondly, the project management plan (PMP) was finalized and submitted to the Project Manager.


A Method For Defining Wind Turbine Setback Standards, Jonathan Rogers, Nathan Slegers, Mark Costello 2011 Georgia Institute of Technology - Main Campus

A Method For Defining Wind Turbine Setback Standards, Jonathan Rogers, Nathan Slegers, Mark Costello

Faculty Publications - Biomedical, Mechanical, and Civil Engineering

Setback distances established by regulatory authorities to minimize the probability of blade fragment impact with roads, structures and infrastructure can often have a significant impact on wind farm development. However, these minimum distance requirements typically rely on arbitrary rules of thumb and are not based on a physical or probabilistic analysis of blade throw. The work reported here uses a probabilistic approach to evaluate the effectiveness of current standards and to propose a new technique for determining setback distances. This is accomplished through the use of a dynamic model of wind turbine blade failure coupled with Monte Carlo simulation techniques …


Wind Energy Potential For Reverse Osmosis Desalination Plants In La Guajira, Colombia, Carlos Martinez-Smit 2011 University of Dayton

Wind Energy Potential For Reverse Osmosis Desalination Plants In La Guajira, Colombia, Carlos Martinez-Smit

Faculty-Selected Student Works

Project report required by the Master of Science Degree in Renewable and Clean Energy.

Abstract:

The region of La Guajira, located in the north of Colombia, has a lot of potential for wind power with annual average wind speeds up to 11 m/s at 10 m height in some locations, according to the national wind map. Most of the wind potential is located in Upper Guajira, where 90% of the population is indigenous Wayuu people (among the country’s poorest population) and it is also characterized with low precipitation, 500 mm/yr, high evapotranspiration, 1500 mm/yr, and low humidity. All this creates …


Test 2012a: New Holland Workmaster 55, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 2012a: New Holland Workmaster 55, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Nebraska Summary: S806 New Holland T7.250, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Nebraska Summary: S806 New Holland T7.250, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Test 1999: John Deere 8335rt, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1999: John Deere 8335rt, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Investigation Into The Potential Use Of Windbreaks To Improve Solar Collector Performance, Michael Watts 2011 Minnesota State University - Mankato

Investigation Into The Potential Use Of Windbreaks To Improve Solar Collector Performance, Michael Watts

All Graduate Theses, Dissertations, and Other Capstone Projects

The global demand for energy is ever increasing; however, the world has a limited number of fossil fuels available. Therefore, alternative renewable energy sources must be utilized. For this reason, solar thermal collectors have become an increasingly popular method for providing hot water or space heating. However, solar thermal collectors are most commonly used in areas that experience warm climates throughout the year. In areas that experience seasonal climates, the cold temperatures and harsh climate conditions significantly reduce the performance of solar thermal collectors during the winter months. This thesis examined the potential that the implementation of a windbreak could …


Test 1985: John Deere 6230 Premium, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1985: John Deere 6230 Premium, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Test 1986: John Deere 6330 Premium, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1986: John Deere 6330 Premium, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Test 1992: Case Ih Magnum 180, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1992: Case Ih Magnum 180, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Test 1991a: John Deere 8360r My12, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1991a: John Deere 8360r My12, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Test 1991: John Deere 8360r, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1991: John Deere 8360r, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Test 1990a: John Deere 8335r My12, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1990a: John Deere 8335r My12, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Test 1990: John Deere 8335r, Nebraska Tractor Test Lab 2011 University of Nebraska-Lincoln

Test 1990: John Deere 8335r, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …


Digital Commons powered by bepress