Structural Engineering Commons^™

Modified Design Procedures For Bridge Pile Foundations Subjected To Liquefaction-Induced Lateral Spreading, Arash Khosravifar, Jonathan Nasr

Civil and Environmental Engineering Faculty Publications and Presentations

Effective-stress nonlinear dynamic analyses (NDA) were performed for piles in the liquefiable sloped ground to assess how inertia and liquefaction-induced lateral spreading combine in long- and short-duration motions. A parametric study was performed using input motions from subduction and crustal earthquakes covering a wide range of durations and amplitudes. The NDA results showed that the pile demands increased due to (a) longer duration shakings, and (b) liquefaction-induced lateral spreading compared to nonliquefied conditions. The NDA results were used to evaluate the accuracy of the equivalent static analysis (ESA) recommended by Caltrans/ODOT for estimating pile demands. Finally, the NDA results were …

Inertial And Liquefaction-Induced Kinematic Demands On A Pile-Supported Wharf: Physical Modeling, Milad Souri, Arash Khosravifar, Stephen E. Dickenson, Scott Schlechter, Nason Mccullough

Civil and Environmental Engineering Faculty Publications and Presentations

Results of a centrifuge test on a pile-supported wharf were used to investigate the time-, depth-, and row-dependent nature of kinematic and inertial loading on wharf piles in sloping rockfill. P-y models were calibrated against recorded bending moments in different piles and different depths. It was found that full kinematic demands and full superstructure inertia should be combined to estimate bending moments at pile head and shallow depths (less than 10 diameters below the ground surface). On the contrary, it was found that applying full kinematic demands alone was adequate to estimate pile bending moments at large depths (greater than …

The Effects Of Long-Duration Subduction Earthquakes On Inelastic Behavior Of Bridge Pile Foundations Subjected To Liquefaction-Induced Lateral Spreading, Jonathan Nasr, Arash Khosravifar

Civil and Environmental Engineering Faculty Publications and Presentations

Effective-stress nonlinear dynamic analyses (NDA) were performed for a large-diameter reinforced concrete (RC) pile in multi-layered liquefiable sloped ground. The objective was to assess the effects of earthquake duration on the combination of inertia and liquefaction-induced lateral spreading. A parametric study was performed using input motions from subduction and crustal earthquakes covering a wide range of motion durations. The NDA results showed that the pile head displacements increased under liquefied conditions, compared to nonliquefied conditions, due to liquefaction-induced lateral spreading. The NDA results were used to develop a displacement-based equivalent static analysis (ESA) method that combines inertial and lateral spreading …

Designing And Testing 3-D Printed Wafer-Box With Embedded Pzt Sensors To Identify The Shape Effect On Energy Harvesting, Ahmad Jami Safayet

College of Graduate Studies: Theses & Dissertations

Piezoelectric energy has been recently paid attention in the field of alternative energy. Day by day the traditional energy sources including Coal tar and oils are becoming scarce. People are heading to an alternative energy source to meet the future energy demand. Piezoelectric energy is one of the competitive energy sources compared to the conventional renewable energy sources including solar, wind, and geothermal power and so on. This energy production method bears enormous research potential because it can be used as the roadway for a new method of power generation. This research project aimed to identify which shaped wafer-box produced …

Cyclic Axial Compression Behavior Of Concrete-Filled Hybrid Large Rupture Strain Frp Tubes, Monika Nain

Masters Theses

"This study introduces an experimental investigation of the behavior of concrete filled fiber reinforced polymer (FRP) tubes (CFFTs) under cyclic axial compression. The FRP used in this study were either small rupture strain FRP (SRS-FRP) or large rupture strain FRP (LRS-FRP). This paper also presents the first-ever experimental study on the behavior of concrete confined using hybrid LRS-FRP and SRS-FRP. LRS-FRP included PEN (polyethylene napthalate) and PET (polyethylene terephthalate) where both of them having ultimate axial strain larger than 5%, and low stiffness. SRP-FRP included carbon and glass FRP having small rupture strains, smaller than 2%, and high stiffness. The …

The Determination Of The Concrete Tensile Creep At Early Age Using The Ring Test, Tadamon Mohammed

Graduate Theses, Dissertations, and Problem Reports (ETD)

In this study, the modified double power law (MDPL) model is used to determine the tensile creep of concrete at an early age based on the ASTM C1581 restrained shrinkage ring test. Three concrete mixes using Ordinary Portland Cement (OPC) were tested. The three concrete mixes were cast, and each underwent the ring tests up to cracking. Mechanical properties of concrete at the age of 1, 3, 7, 14, and 28 days were tested to find the compressive strength, tensile strength and Young’s Modulus of concrete. The strength tests results were obtained from both 4x8 inch and 6x12 inch cylinders. …

Inspire Newsletter Spring 2018, Missouri University Of Science And Technology. Inspire - University Transportation Center

INSPIRE Newsletters

No abstract provided.

Inspire Newsletter Fall 2018, Missouri University Of Science And Technology. Inspire - University Transportation Center

INSPIRE Newsletters

No abstract provided.

Investigation Of Rapid Remote Sensing Techniques For Forensic Wind Analyses, Yijun Liao, Richard L. Wood, Mohammad Ebrahim Mohammadi, Peter J. Hughes, J. Arn Womble

Department of Civil and Environmental Engineering: Faculty Publications

Perishable damage data resulting from severe windstorms require efficient and rapid field collection techniques. Such datasets permit forensic damage investigations and characterization of civil infrastructure. Ultimately, observed structural damage serves as a proxy approach to estimate wind speeds for storms that include hurricanes, tornadoes, straight-line winds, etc. One of the more common methods to collect, preserve, and reconstruct three-dimensional damage scenes is the use of an unmanned aerial system (UAS), commonly known as a drone. Onboard photographic payloads permit scene reconstruction via structure-from-motion; however, such approaches often require direct site access and survey points for accurate results, which limit its …

Behavior Of Cold-Formed Steel Metal Industrial Buildings, Adrianna M. Early, Mohammad Ebrahim Mohammadi, Richard L. Wood, Kara D. Peterma

Department of Civil and Environmental Engineering: Faculty Publications

This paper presents research focused on understanding the observed behavior of cold-formed steel (CFS) metal buildings during Hurricane Harvey, which made landfall Friday, August 25, 2017 between Port Aransas and Port O’Connor, Texas. Through the Geotechnical Extreme Event Reconnaissance (GEER) association (funded by the National Science Foundation) a team of structural engineers and researchers performed rapid and detailed assessments of structural damage caused by the hurricane. The National Science Foundation gathered photographs, damage assessments sheets, and three-dimensional laser point cloud data of severely damaged cold-formed steel industrial buildings. The Port Aransas County Airport experienced severe damage to several cold-formed steel …

Post-Earthquake Structural Damage Assessment Through Point Cloud Data, Mohammad Ebrahim Mohammadi, Richard L. Wood

Department of Civil and Environmental Engineering: Faculty Publications

Structural damage assessment following an extreme event can provide valuable information and insight into unanticipated damage and failure modes to improve design philosophies and design codes as well as reduce vulnerability. Oftentimes, structural engineers create finite element models (FEM) of the structure in which numerous model parameters require calibration to simulate the current state. This information may include structural plan details (geometry), material characteristics (strength and stiffness parameters), as well as observed damage patterns (cracks, spalling, etc.). Ground-based lidar (GBL) scans and Structure-from-Motion (SfM) can rapidly capture dimensionally accurate point clouds of the structure or facility of interest. Furthermore, point …

Damage Assessment Of Built-Up Areas Via Uas-Sfm Derived Point Cloud Data, Mohammad Ebrahim Mohammadi, Richard L. Wood

Department of Civil and Environmental Engineering: Faculty Publications

In the aftermath of extreme events (e.g., earthquakes, tsunami, tornados, etc.), rapid and reliable identification of the damage in a built-up area are crucial in to rescue, recovery, and reconstruction operations. While it is critical to conduct efficient emergency response management, lack of classified or tagged damaged regions due to communications and accessibility limitations can further delay recovery operations, rescue efforts, and resource management. Furthermore, critical and perishable damage scenes can also be lost during recovery and cleanup operations immediately following the event. In recent decades, advances in remote sensing technologies demonstrate a great potential to perform rapid reconnaissance and …

Coupling Radio Frequency Energy Via The Embedded Rebar Cage In A Reinforced Concrete Structure For The Purpose Of Concrete Degradation Sensing, Ryan Campiz

UNF Graduate Theses and Dissertations

This study focuses on utilizing an energy harvesting system in which a dedicated Radio Frequency (RF) power source transmits RF power via rebar in a reinforced concrete column. The RF power is received and decoupled by a receiver, and is then rectified, boosted, and stored as electrical energy in a supercapacitor, later to be used to make measurements, process data, and communicate to the source via rebar. Two design attempts are presented in this study: (a) one uses single line conduction at 2.4 GHz for RF power transfer; (b) the other uses a more conventional two-line conduction at 8.0 kHz …

Critical Buckling And Post-Buckling Behavior Of Thin-Walled Liners Encased By Underground Pipelines In Saturated Soils, Zhaochao Li

Doctoral Dissertations

"This study aims to investigate the structural stability of thin-walled liners encased in functionally-obsolete underground pipelines in saturated soil under external hydrostatic pressure, a concentrated load, temperature change or their combination, and develop a simplified circular arch model of thin-walled liners when not constrained by the pipelines. The friction and adhesion on the interface between a liner and its constraining surface (pipeline or grouting), and the pressure gradient on deeply-buried pipelines are neglected. The critical buckling load of elastic liners is analytically derived under a plane strain condition using the principle of minimum potential energy. The analytical solution is either …

Investigation Of Ribbed Dome Including Tuned Mass Damper, Ali Parva

Civil & Environmental Engineering Master's Projects

This research report presents the outcome of an investigation of lightweight ribbed steel dome structure. The proposed ribbed dome structure is studied both numerically and experimentally under static, natural vibration, and base excitation conditions. The base excitation is considered in the form of a sinusoidal as well as seismic loading in the form of a scaled-down 1940 El Centro earthquake. A numerical study of the ribbed dome is also conducted including a tuned mass damper (TMD). The performance of the dome is also compared with that of a hexagonal vertical structure showing a superior response of the dome under seismic …

Moisture Induced Deformations In Glulam Members - Experiments And 3-D Finite Element Model, Henry Meleki Kiwelu

Tanzania Journal of Engineering and Technology (TJET)

Experiments were performed on scaled glue laminated bending specimens to observe time dependent development of deformations during drying and wetting. Measurements determined changes in the average moisture content and external shape and dimensions between when specimens were placed into constant or variable climates. Alterations in the external shape and dimensions reflected changes in the average value and distribution of moisture and mechanosorptive creep in the glulam. The results are being used to develop a sequentially-coupled three-dimensional hygrothermal Finite Element (FE) model for predicting temporally varying internal strains and external deformations of drying or wetting solid wood structural components. The model …

Highly Vented Truss Wall Honeycomb Structures, David J. Sypeck

Publications

A vented honeycomb structure with a plurality of honeycomb cells arranged in a hierarchical order and having a plurality of truss walls, each truss wall including a plurality of members. The vented honeycomb structure is fabricated by joining a plurality of sheets of trusses using any one of an expansion, a corrugation, and a slotting process. Fabrication can also occur by deposition, casting, additive, extrusion, or aligning and joining methods. The honeycomb cells, truss walls, truss wall openings, and truss wall members can be functionally graded.

Characterization And Modeling Of Asphalt Concrete For Dynamic Properties And Performances, A S M A. Rahman

Civil Engineering ETDs

The recently developed mechanistic-empirical pavement design guide (MEPDG, also known as Pavement M-E design method) uses the nationally calibrated, binder viscosity-based dynamic modulus predictive model for the design and analysis of asphalt pavements. In this study, this model is assessed for its appropriateness for asphalt-aggregate mixtures typically used in New Mexico. In essence, this study investigates the predictability issue of complex modulus of New Mexico mixes. A total of 54 Superpave mixes with different aggregate gradations, air voids, and binder grades were collected from the mixing plants and from the pavement construction sites. The loose asphalt mixtures were then compacted, …

Drone-Enabled Remote Sensing For Transportation Infrastructure Assessment, Colin Brooks

INSPIRE Archived Webinars

Unmanned aerial systems (UAS or “drones”) are a rapidly developing technology that can help meet the needs of transportation agencies for reliable, repeatable data that can save money and increase safety for the data collection process. By taking advantage of flexible platforms that can deploy a variety of sensors, transportation agencies and their information suppliers can help meet these data needs for operations, asset management, and other areas. Location-specific data on infrastructure condition and distresses can help with improved management of assets.

In this presentation, recent applied research led by a Michigan Technological University team is reviewed, with a focus …

Multi-Hazard Performance Assessment Of High-Rise Buildings, Jad El Khoury Antoun

LSU Master's Theses

In the last few decades, there has been an important increase in building high-rise constructions in many cities around the world. Since they offer several benefits in populous areas in terms of space efficiency, economy and sustainability, tower buildings attracted practitioners and researchers to understand better their exclusive behavior and response to natural hazards (e.g., hurricanes, earthquakes). Because of their flexibility and their commonly limited damping, skyscrapers are more susceptible to wind and earthquake actions than low- and mid-rise buildings. Moreover, many locations are prone to multiple hazards; hence, it is important to understand thoroughly the structural behavior of structures …