Civil Engineering Commons^™

Reducing Infiltration And Inflow In Small Collection Systems: Environmental, Economic, And Other Impacts, Andrew Hansen

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Wastewater treatment facilities (WWTFs) and the collection systems (CSs) which feed them provide essential services to society by collecting sewage (aka wastewater), biologically treating it, and minimizing risks to human health as well as the impact of waste on the environment. However, as collection systems age, increasing infiltration and inflow (I/I) from groundwater and stormwater can negatively affect the system. I/I is often mitigated to reduce flow and eliminate other negative impacts to the system.

Ten total case studies, seven mechanical water resource recovery facilities (WRRFs) and three lagoon facilities, were examined for the environmental, economic, and other impacts/benefits from …

Sustainable Revitalization Of Asphalt Pavements: An In-Depth Analysis Of Enhancing The Performance Of Asphalt Binder Through The Application Of Rheological And Molecular Dynamics Simulation Techniques, Muhammad Ahmad

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Vegetable-based oils such as corn and soybean oil have triglycerides and fatty acids that allow them to be considered sustainable and effective recycling agents (RAs) for aged asphalt binder. However, there are concerns about their effect on the recycled asphalt binder's long-term performance, moisture damage resistance, and self-healing characteristics restoration. In this study, crude corn oil (CO) and crude soybean oil (SO) were used as RAs to restore the performance of a reclaimed asphalt binder (RAB) extracted from reclaimed asphalt pavement. The binder extracted from RAB was modified with a neat binder PG64-28 and RAs to restore the high-end performance …

Force Coefficients And Wind Loads For Wide Flange Section And Retrofitted Pipe Racks, Sovanroth Ou

All Theses

While relatively rare, the failures of steel structures occasionally occur due to extreme wind events such as hurricanes and tornadoes. The American Society of Civil Engineers (ASCE) provides well-defined guidelines for determining wind loads for regular buildings; nonetheless, the actual wind loads for complex open-frame steel structures are not as clearly understood by practicing engineers. Pipe bridges and pipe racks are open-frame structures, commonly used in many petrochemical plants. Over the years, additional pipes are often added to existing pipe racks or pipe bridges to accommodate changes in the operation needs of the petrochemical plant. The objectives of this study …

Pyrolysis—A Tool In The Wastewater Solids Handling Portfolio, Not A Silver Bullet: Benefits, Drawbacks, And Future Directions, Patrick J. Mcnamara, Zhongzhe Liu, Yiran Tong, Hari Santha, Lynne Moss, Daniel Zitomer

Civil and Environmental Engineering Faculty Research and Publications

Pyrolysis is the process whereby carbonaceous materials, such as biosolids, are heated between 400°C and 900°C in the absence of oxygen. Three main products are generated: a solid product called biochar, a py-liquid that consists of aqueous phase and non-aqueous phase liquid, and py-gas. The biochar holds value as a beneficial soil amendment and sequesters carbon. The py-liquid is potentially hazardous and needs to be dealt with (including potentially reducing it on-site via catalysis or thermal oxidation). Py-gas can be used on-site for energy recovery. Pyrolysis has gained recent interest due to concern over per- and polyfluoroalkyl substances (PFAS) in …

Ranking Highway Transportation Asset Criticality Through Stakeholder Input Using The Analytical Hierarchy Process (Ahp), Kwadwo Amankwah-Nkyi

Graduate Theses and Dissertations

The transportation system is especially vulnerable to natural and human-made disasters which can have effects on mobility, safety, and the economy. This thesis presents a method to rank transportation assets based on their criticality to the transportation system by uniquely gathering stakeholder input on criticality criteria weights. This serves as a typical first step in vulnerability and resilience assessments. Six criteria were used to estimate asset criticality: Annual Average Daily Traffic (AADT), roadway classification, freight output, tourism output, Social Vulnerability Index (SoVI), and redundancy. Then, the criteria are combined via stakeholder input using a weighted ranking scheme called the Analytical …

Enhancing Security At Baxter Arena, Jennifer Davis

Theses/Capstones/Creative Projects

The purpose of this report is to detail two options proposed for enhancing security at Baxter Arena. Both options are focused on metal detection. In this report we will look at the benefits and negatives of metal detection, both handheld and stationery, and how it can be used in enhancing building security.

Slo Botanical Garden Deck, Noah E. Demer

Architectural Engineering

This project consists of the design and construction of an outdoor-use deck. This deck is to be located in the NE corner of the Sage Meadow at the San Luis Obispo Botanical Garden at 3450 Dairy Creek Rd, San Luis Obispo, CA 93405. This deck’s intended use is as a gathering area for people to congregate. Originally, the ideal deck area was proposed as 700+ square feet, but with further site and project limitations the final design was ~480 square feet. This deck has not been constructed.

Analyzing The Effects Of Rejuvenators In Balanced Mix Design With High Percentages Of Recycled Asphalt Pavement, Amanda Jo Mullins

Boise State University Theses and Dissertations

Interest in sustainable practices have increased in several industries, including civil engineering pavement materials. The incorporation of Recycled Asphalt Pavement (RAP) into new pavement mix design is a popular method of application for sustainable practice and is accompanied by numerous economic and environmental benefits. There is significant interest in using large amounts of this RAP material in pavement design to maximize the benefits, but several problems arise when utilizing “high” amounts of this material (more than 25% RAP replacement) due to aged and oxidized binder that negatively impacts the properties. The use of rejuvenators (RAs) and Balanced Mix Design (BMD) …

Photocatalytic Nanoparticle Treatment Of Cyanotoxins In Harmful Algal Blooms, Brian Baird

Civil Engineering Undergraduate Honors Theses

Harmful Algal Blooms (HAB) have the ability to cause detriment to water bodies, ecosystems, and human health. Furthermore, current evidence suggests that these events are becoming increasingly common due to factors such as increased pollution and global warming. While there are current methods to treat water that is negatively impacted by the bacteria and toxins associated with HABs, these methods are often costly and inefficient. The purpose of this research is to explore a potential treatment option that uses titanium dioxide photocatalytic nanoparticles attached to a retractable net to treat toxins produced by HABs in situ. Specifically, the toxin …

Understanding The Bond Strength Of Bcsa Cement Repair Concrete To Portland Cement Concrete, Brenden Simmons

Civil Engineering Undergraduate Honors Theses

Concrete structures deteriorate over time, and there is an increasing demand for quick repair solutions. Belitic calcium sulfoaluminate (BCSA) cement, a type of rapid setting cement, is thought to be a more sustainable and convenient alternative to portland cement in repair concrete applications. Indicated by the name, rapid setting concrete can set up quicker than traditional portland cement concrete. Because of this, there has been a lot of research about the properties of rapid setting concrete mixes. One of the most popular topics is the strength of the concrete itself. However, there is a need for more research to understand …

Optimizing Laboratory Curing Conditions For Hot Mix Asphalt To Simulate Field Behavior, Benjamin Arras

Open Access Theses & Dissertations

The engineering properties of asphalt mixtures change with time. Shortly after placement, asphalt concrete (AC) layers are more susceptible to rutting. As the pavement ages, the AC layer becomes stiffer, brittle, and thus more susceptible to cracking. Current protocols provide guidelines for the selection of materials, the determination of the material proportions (e.g., aggregates and binder content), and the evaluation of the engineering properties (e.g., cracking and rutting potentials) of any given asphalt mix design. However, these protocols do not consider the impact of aging on the mixture. This study investigated existing and novel laboratory methods to determine protocols that …

A Multiple Model Approach To Bridge Deterioration Modeling, Jin A. Collins

Open Access Theses & Dissertations

Bridge Management Systems (BMSs) have been used to support decision-making in bridgeprojects, including maintenance, rehabilitation, and replacement under financial constraints. These decisions are predicated on the ability to estimate bridgesâ?? future condition states to optimize bridge network systems' performance. Deterioration models are commonly used tools to help transportation agencies make predictions of future condition states of infrastructure facilities, schedule capital investments, and make comparative decisions. Numerous deterioration models have been developed over the last few decades. In particular, Markov chain models utilize bridge data collected from the National Bridge Inventory (NBI) database to make predictions. The accuracy of predictions is …

An Approach For Verification Of Traffic Speed Deflectometer Measurements, Mahsa Beizaei

Open Access Theses & Dissertations

Recent research studies have shown the usefulness and applicability of Traffic Speed Deflectometers (TSD) in support of the network-level pavement management process. There are, however, no accepted procedures for verification and validation of the TSD measurements to be utilized by practitioners. To address this need, TSD measurements may be verified with the data obtained by widely accepted road-testing equipment, Falling Weight Deflectometer (FWD). In this study, TSD and FWD operations on pavement sections were simulated employing the finite layer approach which resulted in the development of a comprehensive database of pavement responses. Using the established numerical simulation database, theoretical relationships …

Machine Learning-Based Data And Model Driven Bayesian Uncertanity Quantification Of Inverse Problems For Suspended Non-Structural System, Zhiyuan Qin

All Dissertations

Inverse problems involve extracting the internal structure of a physical system from noisy measurement data. In many fields, the Bayesian inference is used to address the ill-conditioned nature of the inverse problem by incorporating prior information through an initial distribution. In the nonparametric Bayesian framework, surrogate models such as Gaussian Processes or Deep Neural Networks are used as flexible and effective probabilistic modeling tools to overcome the high-dimensional curse and reduce computational costs. In practical systems and computer models, uncertainties can be addressed through parameter calibration, sensitivity analysis, and uncertainty quantification, leading to improved reliability and robustness of decision and …

Using Metal-Organic Frameworks (Mofs) In Producing Self-Curing Concrete, Lama Fathi Allan

Theses

Curing of concrete is the presence of adequate moisture content in concrete throughout its early stages to produce the desired properties, as it is significant in improving the concrete microstructure and pore structure and hence in developing its performance and durability. However, good curing is not always practical in several cases, such as in hot weather regions and areas of water inadequacy. For that reason, the need to develop self-curing concrete attracted several researchers. The use of self-curing agents minimizes the water evaporation from concrete and consequently increases its water retention capacity compared to conventional concrete. This thesis is concerned …

Upgrading The Performance Of Steel Beams Using Fastened Advanced Composite Materials, Omnia Ragab Abouelhamd

Dissertations

Bonding Fiber-Reinforced Polymers (FRP) is commonly used to enhance the structural performance of existing steel beams; however, the brittle failure at the adhesive risks the effectiveness of the bonded system. Fastening FRP is recently proposed to avoid the brittle failure of the adhesive. Promising outcomes of few studies on fastened FRPsteel system provoked the interest to investigate the effects of various fastening parameters on the performance of fastened FRP-steel beams.

This study investigates, experimentally and numerically, the impact of various fastening parameters on the performance of fastened FRP-steel beams. The proposed method involves fastening carbon-glass hybrid FRP (HFRP) strips to …

Field Application Of A High-Power Density Electromagnetic Energy Harvester To Power Wireless Sensors In Transportation Infrastructures, Anil Agrawal, Mohsen Amjadian, Wai Yan Tun, Hani Nassif, Hongfan Wang

Civil Engineering Faculty Publications

Finding an efficient source of energy has always been a big challenge for humans on Earth. Fossil fuels, such as coal and oil, have traditionally been considered as major sources of energy. These energy sources are not only nonrenewable but are also harmful to our health and environment. A large portion of this energy is consumed by vehicles moving daily in big cities, causing significant pollution of the environment. However, the motion of vehicles through the transportation infrastructures can also be a significant source of kinetic energy, which can be harvested to power transportation system components, such as sensors, street …

Building Services Engineering May/June 2023

Building Services Engineering

No abstract provided.

The Impact Of Grout Specimen Geometry On Compressive Strength Results, Leo J. Keegan

LSU New Orleans Theses and Dissertations

Some project standards specify that grout be tested in accordance with ASTM C1019 “Standard Test Method for Sampling and Testing Grout for Masonry”. This is true even when the grout is not being used for the purpose of masonry construction, such as bridge riser bearing plates and anchoring applications, amongst others. In these instances, the grout compressive strength samples cannot be formed in accordance with ASTM C1019, as there are no masonry units.

The purpose of this project was to evaluate the accuracy of sampling grout in accordance with ASTM C109 “Standard Test Method of Hydraulic Cement Mortars (Using 2-inch …

Non-Destructive Means Of Predicting Masonry Prism Strength Using Ultrasonic Pulse Velocity (Upv), Connor J. Barlow

UNLV Theses, Dissertations, Professional Papers, and Capstones

Current ASTM standards call for grouted masonry prisms to be tested for compressive strength at 28-days to ensure compliance with the structural design. In the event of failing tests, the subject samples may require redesign or reconstruction which can pose problems due to ongoing development around and including the prisms between the time of placement and obtaining test results. The purpose of this research is to determine if the use of ultrasonic pulse velocity (UPV) testing can be utilized to determine a correlation between prism composite strength of the masonry prism with ultrasound readings as to provide preliminary means of …