Engineering Commons^™

A Thermodynamic Analysis Of A Primary Waste Stabilization Pond, David W. Hendricks

Reports

Traditional design practice for waste stabilization ponds is based upon the premise that sufficient photosynthetic oxygen must be produced within the pond to satisfy oxygen requirements of the incoming waste flow. Thus, because algae production is proportional to pond surface area, surface organic loading rate is a principal design criterion (hydraulic detention time is the other) . That a possible adverse energy trade exists in the sequence of coupled reactions (aerobic waste degradation-photosynthesis) has been largely ignored. This work is focused on quantitatively articulating this energy trade, in terms of algae produced vis a vis waste degraded. This is done …

Indiana's Motorboat Fuel Tax : Progress Report, David C. Robinson, William Louise Grecco

JTRP Technical Reports

No abstract provided.

Test 1055: Oliver 1955 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 1056: Oliver 1755, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Electric Field Strength Dependence Of Surface Damage In Oxide Passivated Silicon Planar Transistors, C. A. Goben

Electrical and Computer Engineering Faculty Research & Creative Works

A dependence of surface degradation induced by ionizing radiation in matched oxide-passivated silicon planar epitaxial transistors on junction fringing electric field strength present during exposure is reported. The electric field strength and gamma dose dependence are investigated of the decrease in the forward current gain, hFE (as reflected by the increase in the surface recombination current component), the increase in the surface recombination velocity (as reflected by the increase in the reciprocal of the minority carrier lifetime), and the increase in junction capacitance. Empirical prediction equations have been derived, for matched devices, correlating the normalized base current increase and the …

Baseband Agc In An Am-Fm Telemetry System, Richard S. Simpson, William H. Tranter

Electrical and Computer Engineering Faculty Research & Creative Works

The use of AGc loops at the input and output of the FM link in an AM-FM telemetry system allows the mean-square transmitter deviation to be maintained near maximum value, even though data may be nonstationary. However, errors result because of the inability of the receiver AGc loop to track perfectly gain variations in the transmitter loop. In this paper the general characteristics of AGc are discussed, and a theoretical analysis is performed to determine the time constant, steady-state error, and tracking error for a first-order loop. Also, tracking error for first order and second-order loops is investigated by simulation. …

Patent Drawing, John L. Byers

Graduate Research Papers

This study is concerned with an investigation of procedures and methods for patent drawings. Specifically, the study involves research in standards of acceptable patent drawings, their proper execution, necessary materials, type of training needed to become a patent draftsman, and the location of available source of training.

Test 1050: John Deere 4320 Syncro Range, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 1046: International Farmall 826 Hydrostatic Diesel (Also International 826 Hydrostatic Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1047: International Farmall 1026 Hydrostatic Diesel (Also International 1026 Hydrostatic Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1054: Ford 2000 Gasoline 6-Speed (All Purpose), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1061: Case 770 Manual Gasoline, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1057: Oliver 1755 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Computer Simulation Of The Hydrologic-Salinity Flow System Within The Upper Colorado River Basin, M. Leon Hyatt, J. Paul Riley, M. Lynn Mckee, Eugene K. Israelsen

Reports

Changes in the hydrologic equilibrium of a river basin resulting from resource development also produce changes in the quality pattern. Since the burden of quality maintenance must be shared by users (just as are quantities) predictions are needed for quality changes which might result from contemplated development at any specified location within the river system. This study reports the development of a computer simulation model of the water and salt flow systems within the Upper Colorado River basin. Because of the close relationship between the hydrologic and salinity flow systems, an understanding of the hydrologic system is essential to successful …

Time And Load Independent Properties Of Bituminous Mixtures: Technical Paper, S. A. Swami, William Harner Goetz, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

Flow In Aggregate-Binder Mixes : Technical Paper, Egons Tons, William Harner Goetz, Virgil L. Anderson

JTRP Technical Reports

No abstract provided.

A Predictive Model For Travel Times On Two-Lane State Highways : Progress Report, Salim Said Hejal, Harold L. Michael

JTRP Technical Reports

No abstract provided.

A Study Of Relative Costs Of Flexible Highway Pavements, Farideh Ramjerdi

JTRP Technical Reports

No abstract provided.

Analysis Of Concrete Slabs On Ground And Subjected To Warping And Moving Loads: Technical Paper, Karl Harcourt Lewis, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

A Generalized Investigation Of Selected Highway Design And Construction Factors By Regional Geomorphic Units Within The Continental United States, Matthew W. Witczak

JTRP Technical Reports

No abstract provided.

Precast, Prestressed Concrete For Bridge Decks : Technical Paper, Martin J. Gutzwiller, Robert H. Lee, Charles F. Scholer

JTRP Technical Reports

No abstract provided.

Carburization Of Type 316l Stainless Steel In Static Sodium, F. B. Litton, Arthur E. Morris

Materials Science and Engineering Faculty Research & Creative Works

The transport of carbon from an iron-87 wt.% carbon alloy through static sodium to Type 316L stainless steel was investigated at temperatures of interest to the liquid-metal fast-breeder reactor (LMFBR) program. The rate-controlling step for the experimental geometry employed was the diffusion of carbon in the source. © 1970.

Thermal Expansion Of Orthorhombic Pbo, Charles A. Sorrell

Materials Science and Engineering Faculty Research & Creative Works

Thermal expansion of orthorhombic PbO was investigated by high‐temperature X‐ray diffraction. The coefficients in the a0, and c0 directions are equal and Pb–O chains extended in the a0 direction and bonded into layers in the b0 direction; appreciable Pb–Pb bonding is indicated. Coordination and bond distances observed in PbSiO3 and lead silicate glasses, which are similar to those of massicot, and PbnOn polymeric units reported in PbO vapor are interpreted as additional evidence of the importance of PbO chains as structural entities. Copyright © 1970, Wiley Blackwell. All rights reserved

Thermal Expansion Of Tetragonal Pbo, Charles A. Sorrell

Materials Science and Engineering Faculty Research & Creative Works

Thermal expansion of tetragonal PbO, investigated by high‐temperature X‐ray diffraction in vacuum, is nearly isotropic, with the coefficient in the c0 direction only slightly greater than that in the a0 direction. Volume thermal expansion is only slightly greater than in massicot. Retardation of the litharge‐massicot transformation is tentatively interpreted as the result of very low oxygen partial pressures caused by catastrophic oxidation of the stainless‐steel sample holder and resulting oxygen scavenging by lead vapor. Copyright © 1970, Wiley Blackwell. All rights reserved

Exact Solution For A Model Of Dislocation Pipe Diffusion, J. Mimkes, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

The dislocations are treated as an ideal array of parallel pipes of radius and diffusivity Dp embedded in the bulk material of the diffusivity Db. The exact solution of this problem of diffusion along semi-infinite edge dislocations is presented for cubic, tetragonal, and hexagonal crystals. The solution makes it possible to evaluate the dislocation pipe radius a and the ratio of diffusivities from one experiment. It is applied to experimental data for self-diffusion in tellurium available in the literature. The results of the calculations are a dislocation pipe radius a=(1.5 0.5)x10-4 cm and an activation energy for the pipe diffusion …

Electrochemical Reduction Of Chromate In The Presence Of Nickel Chloride In Molten Lithium Chloride-Potassium Chloride Eutectic, Branko N. Popov, H. A. Laitinen

Faculty Publications

Chronopotentiometry of chromate in the presence of NiCl₂ in molten LiCl-KCl eutectic reveals a diffusion controlled, three electron reduction step. In the presence of excess NiCl₂, chromate is reduced at −0.35V vs. Pt(II)/Pt reference electrode and the electroactive species responsible for the chrono-potentiometric wave is estimated to have a diffusion coefficient of 1.06 · 10⁻⁵ cm² sec⁻¹ at 450°C. The stoichiometry of the reduction product depends mainly on the temperature at which the deposit is formed. At 500°C the deposit approaches the composition LiNi₂CrO₄. X-ray powder diffraction shows the deposit …

Radiative Heat Transfer Analysis From A Heated Airport Runway To Fog, Gordon L. Scofield, Tom J. Love

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Radiative heat transfer between a plane source and an aerosol is investigated through the Monte Carlo method. Thermal energy is transferred from a long rectangular source to monodisperse natural fog models. The analysis is only for radiative transport and does not include convection which would be coupled in a complete analysis. Direct energy transfer to the droplets of the aerosol is investigated for values of extinction coefficient of 10 km-1 and 80 km-1, absorption coefficient to extinction coefficient ratios of 0·4 and 0·5, and scattering functions of the strong forward and isotropic types. Monochromatic radiation at a wave length of …

Stability Of Asymmetric Hydrodynamically Developing Channel Flows, T. S. Chen, E. M. Sparrow

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Linear stability is studied for developing channel flows induced by asymmetric velocity profiles at the inlet. Neutral stability curves and axial variations of the critical Reynolds number are presented, showing greater stability for more skewed inlet profiles.

Time-Domain Analysis And Measurement Techniques For Distributed Rc Structures. Ii. Impulse Measurement Techniques, Robert C. Peirson, Edward C. Bertnolli

Electrical and Computer Engineering Faculty Research & Creative Works

Transient analysis for uniform RC structures is considered in this paper. A method is presented for determining the parameters of such structures. The measurements are obtained using impulse excitations in open-circuit and short-circuit configurations. The theoretical results obtained predict fairly the experimental results. © 1969 The American Institute of Physics.

Cation Grain-Boundary Diffusion In Sodium Chloride, K. R. Riggs, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.