Engineering Commons^™

Thermal Models For A 3 Cm Miniature Xenon Ion Thruster, Coleman Thomas Younger

Master's Theses

In order to support UCLA’s development of the 3 cm Miniature Xenon Ion (MiXI) thruster, Cal Poly has a 3 cm thruster under development. This version, called MiXI Cal Poly Version 1 (MiXI-CPv1), is complete and has been utilized in vacuum chamber thermal validation testing. Testing on this version was used to check the validity of heat transfer simulations modeled in SolidWorks. Investigations of the 3 cm ion thruster configuration were intended to discover the driving factors affecting the thermal behavior of the discharge chamber and surrounding design space.

Numerical simulations indicate that the heating of the samarium cobalt permanent …

Modeling And Simulation Of Autonomous Thermal Soaring With Horizon Simulation Framework, Zhenhua Li

Master's Theses

A thermal is a column of warm rising air triggered by differential heating on the ground. In recent studies UAVs were programmed to exploit this free atmospheric energy from thermals to improve their range and endurance. Researchers had successfully flown UAVs autonomously with thermal soaring method. Most research involved some form of flight simulation. Improvements to the aircraft and thermal models for simulation purpose would enable researchers to better design their UAVs and explore any potential flaws in their designs. An aircraft simulation with a thermal environment was created in Horizon Simulation Framework, a modeling and verification framework that was …

Hot Air Balloon Navigation, Dustin Blackwell

Aerospace Engineering

This report describes a program used for navigating a hot air balloon.  The program, Balloon_Trip, was written using MATLAB and gives a flight path to follow from a start position to an end position.  Balloon_Trip calculates the flight path by taking in wind conditions and then flying through these different winds so as to steer the hot air balloon.  The program calculates the flight path by taking into consideration at all times how the wind will propel the balloon while it is rising or falling in elevation.  It then takes the most direct and least complicated, if not fastest, …

Static And Fatigue Failure Response Of Woven Carbon Fiber Specimens With Double Edge Notches, Ahmad J. Amini

Master's Theses

Carbon fiber composites are continually seeing increased use in aerospace applications. It is necessary to understand their failure modes in order to properly design and perform analysis on structures constructed primarily from them. This thesis studies woven carbon fiber composites with and without double-edge notches in a series of static and fatigue tests performed on an Instron 8801 servo-hydraulic testing system.

Specimens were constructed of Advanced Composites Group product # LTM45EL woven carbon fiber pre-preg/epoxy and were cut to approximately 9-inch in length and 1-inch in width. Notches were cut into some of the specimens using a slitting saw blade …

The Effectiveness Of Damage Arrestment Devices In Delaying Fastener-Hole Interaction Failures In Carbon Fiber Polyurethane Foam Composite Sandwich Panels Subjected To Static And Dynamic Loading Under Increased Temperatures, Dominic E. Surano

Master's Theses

A study was conducted to investigate simple, cost-effective manufacturing techniques to delay skin-core delamination, micro-buckling and bearing stress failures resulting from fastener-hole interactions. Composite sandwich panels, with and without damage arrestment devices (DADs), were subjected to monotonic compression at a rate of 5mm per second, and compression-compression fatigue at 50% yield at an amplitude of 65%, under temperatures of 75, 100, 125, 150, 175, and 200 °F.

The sandwiches tested were composed of two-layer cross-weave carbon fiber facesheets, a polyurethane foam core, and an epoxy film adhesive to join the two materials. The most successful method to delay the aforementioned …

Development Of Cubesat Vibration Testing Capabilities For The Naval Postgraduate School And Cal Poly San Luis Obispo, Marissa Brummitt

Master's Theses

The Naval Postgraduate School is currently developing their first CubeSat, the Solar Cell Array Tester CubeSat, or NPS-SCAT. Launching a CubeSat, such as NPS-SCAT, requires environmental testing to ensure not only the success of the mission, but also the safety of other CubeSats housed in the same deployer. This thesis will address the development of CubeSat vibration testing methodology at NPS, including subsystem testing, engineering unit qualification, and flight unit testing. In addition, the new Cal Poly CubeSat Test POD Mk III will be introduced and evaluated based upon comparison with the Poly Picosatellite Orbital Deployer (P-POD). Using examples from …

A 24ft/7.3m Parabolic Reflector Antenna Performance & Feed Design Analysis, Anthony Shelley

Morehead State Theses and Dissertations

A thesis presented to the faculty of the College of Science & Technology at Morehead State University in partial fulfillment of the requirements for the Degree of Master of Science by Anthony Shelley on November 29, 2010.

The Weather Forecast Fortoday In Space! Exploring Our Space Environment & Satellite Orbits, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint presentation created by Professor Bob Twiggs titled "The Weather Forecast forToday in Space! Exploring our space environment & satellite orbits" from November 17, 2010.

Descent Systems For An Improved And Reusable Gemini Capsule, Heather Pitts

Von Braun Symposium Student Posters

No abstract provided.

Nasa X-Toolss Design Optimization, David Keeton, Cheryl Rose, Daniel Cervantes, Kelly Green, Justin Chism

Von Braun Symposium Student Posters

No abstract provided.

Aethon Research Rocket, Charger Rocket Works, Daniel Cavender, Diana Alsbrook, Leonard French, Jarred Green, Andrew Hiatt, Jarrod Mosteller, Brandon Setayesh, Nathan Toy

Von Braun Symposium Student Posters

No abstract provided.

Mars Sample Return Utilizing The Capabilities Of The Heavy Lift Launch Vehicle, Matt White

Von Braun Symposium Student Posters

No abstract provided.

Design And Fabrication Of A 1/3 Scale Gemini-Style Capsule, Toshawnka Walker, Jonathan Davis, Brockton Thompson, Ryohsuke Aoki

Von Braun Symposium Student Posters

No abstract provided.

Poias Philoctetes/Okyrhoe Integrated Asteroid Surveyor, Ian Maddox

Von Braun Symposium Student Posters

No abstract provided.

Formula Sae Preliminary Aerodynamic Design, Robert Coates, Matt Wright

Von Braun Symposium Student Posters

No abstract provided.

Noegenetic Io Monitoring Observernimo, William Daniels

Von Braun Symposium Student Posters

No abstract provided.

Space Science From Morehead State University, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint presentation created by Professor Bob Twiggs titled "Space Science from Morehead State University" from October 10, 2010.

Neural Network Burst Pressure Prediction In Composite Overwrapped Pressure Vessels Using Mathematically Modeled Acoustic Emission Data, Junya Iizuka

Master's Theses - Daytona Beach

The purpose of this research was to predict burst pressures in composite overwrapped pressure vessels (COPV) using mathematically modeled acoustic emission (AE) data. The AE data were collected during hydrostatic burst (hydroburst) testing often 15-inch (380 mm) diameter COP Vs. The data gathered during these tests were filtered in order to remove long duration hits, multiple hit data, and obvious outliers. Based on the duration, energy, and amplitude of the AE hits, the filtered data were classified into the various failure mechanisms of composites using a MATLAB based self-organizing map (SOM) neural network. Previous research has demonstrated that the parameters …

Investigation Of Scaling Effects For A Synthetic Jet Actuator Using High And Low Fidelity Analyses, Amandine Bourlier

Master's Theses - Daytona Beach

This research presents an investigation on the scaling effects for synthetic jet actuators using Ansys-CFX and a Lumped Element Model (LEM). Synthetic jets or zero net mass-flux devices use a vibrating diaphragm to generate an oscillatory flow through a small orifice. A synthetic jet actuator can be used on MAVs as thrust generator or fixed on an airfoil for flow separation control. A Computational Fluid Dynamics (CFD) model was created, using Ansys-CFX, to be validated against referred publications. The use of mesh adaption is discussed. This baseline model was then used to complete a scaling analysis using a set of …

Estimation Of Air Flow Angles Derived From An Inertial Navigation System, Brett Douglas Mather

Master's Theses - Daytona Beach

The purpose of this study is to explore the use of an Inertial Navigation System as a primary method for measuring aircraft air flow angles in flight testing. The traditional methods used to measure air flow angles consist of sensors external to the aircraft, such as an air data boom or an angle of attack probe. The advantage of using INS to measure air flow angles would be in the simplicity of the instrumentation. All components could be fixed internally, leaving minimal external modifications to the aircraft necessary for instrumentation. This would reduce costs and instrumentation time and enable air …

Defining An Abrasion Index For Lunar Surface Systems As A Function Of Dust Interaction Modes And Variable Concentration Zones, Ryan L. Kobrick, David M. Klaus, Kenneth W. Street Jr.

Publications

Unexpected issues were encountered during the Apollo era of lunar exploration due to detrimental abrasion of materials upon exposure to the fine-grained, irregular shaped dust on the surface of the Moon. For critical design features involving contact with the lunar surface and for astronaut safety concerns, operational concepts and dust tolerance must be considered in the early phases of mission planning. To systematically define material selection criteria, dust interaction can be characterized by two-body or three-body abrasion testing, and sub-categorically by physical interactions of compression, rolling, sliding and bending representing specific applications within the system. Two-body abrasion occurs when a …

Fault-Injection Experiment For The Statistical Characterization Of Faults In Avionics Communication System, Amy M. Yates

Electrical & Computer Engineering Theses & Dissertations

Since flight control systems perform safety-critical functions, it is important to understand the possible effects on the closed-loop dynamical system's performance caused by these faults. The purpose of this project is to design the software and hardware needed to add fault-injection and monitoring capabilities to ROBUS-2, a flight communication system. ROBUS-2 is the current version of the fault-tolerant computer communication system used by the Scalable Processor-Independent Design for Enhanced Reliability (SPIDER), a general-purpose fault-tolerant integrated modular architecture (IMA) developed at the NASA Langley Research Center. The major components of SPIDER include processing elements (PEs) to perform calculations, bus interface units …

Optimization And Oscillation Of A Two-Dimensional Bump To Enhance Airfoil Performance, Dinesh Atchala

Mechanical & Aerospace Engineering Theses & Dissertations

The objective of this project is to improve the aerodynamic performance of an aircraft in transonic speed using a two dimensional contour bump. A natural laminar flow airfoil, RAE5243, has been chosen for the validation case to demonstrate the adequacy of the flow solver used in this study. 2D contour bump is parameterized as the bump position via airfoil, the crest position via bump, maximum height and length of the bump for the parametric study. After these studies, one of the gradient based optimization techniques is utilized to optimize the 2D bump parameters to achieve an augmentation in lift-to-drag …

Design And Wind Tunnel Testing Of Cal Poly's Amelia 10 Foot Span Hybrid Wing-Body Low Noise Cestol Aircraft, Kristina K. Jameson, David D. Marshall, Robert Ehrmann, Eric Paciano, Rory Golden, Dave Mason

Aerospace Engineering

California Polytechnic Corporation, Georgia Tech Research Institute (GTRI), and DHC Engineering collaborated on a NASA NRA to develop and validate predictive capabilities for the design and performance of Cruise Efficient, Short TakeOff and Landing (CESTOL) subsonic aircraft. In addition, a large scale wind tunnel effort to validate predictive capabilities for aerodynamic performance and noise during takeoff and landing has been undertaken.

The model, Advanced Model for Extreme Lift and Improved Aeroacoustics (AMELIA), was designed as a 100 passenger, N+2 generation, regional, CESTOL airliner with hybrid blended wingbody with circulation control. The model design was focused on fuelsavings and noise goals …

Mission Performance As Point Performance, Robert A. Mcdonald

Aerospace Engineering

The cruise or loiter performance of an aircraft is intimately tied to its wing loading (W/S) and its thrust to weight ratio (T/W). Paradoxically, mission performance is often not considered when these fundamental aircraft parameters are determined in conceptual design. In this research, the traditional constraint diagram is extended to include contours of range parameter. This point performance metric represents the mission performance capability of the aircraft without sizing the aircraft to a particular mission. This gives the designer an immediate and intuitive understanding of the tradeoff between the point and mission performance of the aircraft. This improved constraint diagram …

Orbital Tori Construction Using Trajectory Following Spectral Methods, Ralph E. Bordner Iii

Theses and Dissertations

By assuming the motion of a satellite about the earth’s geopotential mimics the known Kolmogorov-Arnold-Moser (KAM) solution of a lightly perturbed integrable Hamiltonian system, this research focused on applying trajectory following spectral methods to estimate orbital tori from sampled orbital data. From an estimated basis frequency set, orbital data was decomposed into multi-periodic Fourier series, essentially compressing ephemerides for long-term use. Real-world Global Positioning System (GPS) orbital tracks were decomposed and reconstructed with error from as low as few kilometers per coordinate axis over a 10-week span to tens of kilometers per coordinate axis over the same time period, depending …

Exploring The Effects Of International Traffic In Arms Regulations Restrictions On Innovation In The U.S. Space Industrial Base, Kalliroi L. Landry

Theses and Dissertations

The International Traffic in Arms Regulations (ITAR) are used to protect United States (U.S.) military technologies. However, changes to ITAR export controls regarding space technologies have had a major impact to the U.S. space industry. The literature mentions a concern for the health of lower-tier firms because they are a major source of innovation, but there is no additional information considering the effects of ITAR on space innovation at those lower tiers. The purpose of this thesis was to explore the implications of continuing the current ITAR restrictions with regard to innovation in the space industry. This research used a …

Satellite Capabilities Mapping - Utilizing Small Satellites, David A. Grigsby

Theses and Dissertations

The cost and schedule advantages small satellites have over larger legacy systems have been studied, but there has been very little experimentation performed to determine whether small satellites can actually deliver the capabilities of larger spacecraft. To date, a desired operational capability has not been fully realized by a scalable satellite design. Advances in sensor technology have led to significant reductions in size, weight, and power (SWaP) presenting an opportunity to exploit the evolution of space operations by using small satellites to perform specific missions. This paper describes a methodology that maps a specific set of large space vehicle capabilities …

Earth Systems Lesson Plan: Size And Forces Of The Solar System, Getaway Special Team 2010

Education and Outreach

No abstract provided.

Physics Lesson Plan: How Far And Fast Does It Travel?, Getaway Special Team 2010

Education and Outreach

No abstract provided.