Energy Systems Commons^™

Nebraska Summary: S919 Challenger Mt475d, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Test 2073: Case Ih Steiger 500 Quadtrac, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Test 2061: Challenger Mt755d, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Project Haiti 2012: Providing An Experiential Learning Experience Through The Design And Delivery Of A Water Purifier In Haiti, Yung Wong, Johnathon Camp, Shavin Pinto, Kyle Fennesy, Marc Compere, Yan Tang

Publications

In this paper, we share our experiences and lessons learned from Project Haiti 2012, a project to design and install a water purification system serving 20,000 people per day in the largest tent city in Haiti. Project Haiti 2012 was the third and largest system we have built for Haitians and represents a huge success for all participants and stakeholders. This paper discusses the unique experiential learning opportunity involved in the design and delivery of the water purifier in a foreign developing country. Multiple positive educational, social, and economic outcomes were achieved including students applying knowledge gained from coursework towards …

A Study On Implementation Of Co2 Abatement Solutions For Existing Ships, Young C. Kwon

World Maritime University Dissertations

Recent high fuel prices and global economic recessions have driven shipowners to turn their attention to saving operational costs of their ships. For this reason, a variety of energy saving solutions has been developed and proposed in order to improve energy efficiency of ships. In addition, IMO have also proposed the best practices for energy saving solutions for existing ships through the SEEMP Guidelines. However, these proposed energy saving solutions (i.e. CO2 abatement solutions) do not give sufficient reliability due to the uncertainties of various parameters surrounding ships. These uncertainties may have a significant impact on effectiveness of individual energy …

A Building Energy Efficiency Optimization Method By Evaluating The Effective Thermal Zones Occupancy, Anna Laura Pisello, Michael Bobker, Franco Cotana

Publications and Research

Building energy efficiency is strongly linked to the operations and control systems, together with the integrated performance of passive and active systems. In new high quality buildings in particular, where these two latter aspects have been already implemented at the design stage, users’ perspective, obtained through post-occupancy assessment, has to be considered to reduce whole energy requirement during service life. This research presents an innovative and low-cost methodology to reduce buildings’ energy requirements through post-occupancy assessment and optimization of energy operations using effective users’ attitudes and requirements as feedback. As a meaningful example, the proposed method is applied to a …

Micro-Grid Wind Energy System, Aaron Steinkraus, Brian Huntziker, Cesar Hurtado

Mechanical Engineering

With the completion of a 3.5kW wind turbine located on Esculea Ranch, the power generated from the turbine was dissipated through electric resistance heaters. ABC Wind was given the task to design, build, and implement a system what will efficiently use the turbine’s harnessed power. After interviewing with the Beef Operations Manager of Escuela Ranch, it was decided to use the turbine’s power to supply supplementary water to anywhere on the ranch where and when needed by grazing cattle. The purpose of this project was to research, design, build and implement a system that would harness the generated power and …

Potential Energy Cost Savings By Use Of Building Roofs As Thermal Storage Of A Multi-Storied Building, Ahmad Adam Shelbaya

Masters Theses and Doctoral Dissertations

The thermal mass of a building has been used for more than two decades to shift the peak cooling load occurring during the day time to evening or night time. This is typically accomplished by use of concrete slabs embedded with pipes carrying hot or chilled water to meet the heating or cooling load, respectively. The water temperature drops across the coils and the frequency and intensity of room air circulation can be varied, along with controlling the gains through the windows, to shift the peak load hours to the nighttime when energy costs are cheaper and electric demands are …

Cost Effectiveness Of Home Energy Retrofits In Pre-Code Vintage Homes In The United States, Florida Solar Energy Center, Philip W. Fairey

FSEC Energy Research Center®

This study investigates the cost effectiveness of a large number of potential home energy retrofit measures using pre-code home archetypes that can be considered typical in a range of climates throughout the United States.

Managing The Drivers Of Airflow And Water Vapor Transport In Existing Single-Family Homes (Revised), Florida Solar Energy Center, James Cummings

FSEC Energy Research Center®

Air and water vapor are transported into and within single-family homes as a result of pathways and driving forces. Without pathways, no air or water vapor transport could occur. Likewise, without driving forces, little or no air or water vapor transport will occur. Homes always have pathways and driving forces. This report focuses on managing the driving forces that move air and water vapor across the building envelope.

A Comparison Of Homes Built To The 2009 And 1984 Florida Energy Codes, Florida Solar Energy Center, Charles Withers, Jr.

FSEC Energy Research Center®

The Florida Solar Energy Center conducted research into the effectiveness of the Florida energy code to reduce energy use in residential buildings. FSEC examined two groups of homes: those built to the 1984 energy code (June 1,1984-1985) and those built to the 2007 with 2009 supplement energy code (March 1, 2009-2010). This report discusses data collection methods, analysis and results that focus on comparisons of measured energy use and house characteristics between both code periods.

Measured Performance Of Occupied, Side-By-Side, South Texas Homes, Florida Solar Energy Center, Dave Chasar

FSEC Energy Research Center®

The performance of three occupied homes built in 2009 in San Antonio, Texas with identical floor plans and orientation were evaluated through a partnership between the Florida Solar Energy Center, CPS Energy, and Woodside Homes of South Texas. Measurements included whole-house gas and electricity use as well as heating, cooling, hot water, major appliances, and indoor and outdoor conditions. One home built to the builder's standard practice served as the control; the other homes demonstrated high performance features.

The goals of this research were to: (1) learn how energy systems affect peak load profiles during the hottest weather conditions; (2) …

The Role Of Transport Phenomena In The Direct Oxidation Of Solid Fuels, Charles J. Banas

Master's Theses

Direct carbon fuel cells have shown promise for stationary power generation by utilizing the direct oxidation of a solid carbon fuel source at the anode. In laboratory settings, researchers have reported up to 300mA/cm2 of current density from these cells types which suffer from mass transport losses. This paper studies the surface properties of the solid fuel source, and describes the process of CO2 evolution through an analogy to pool boiling. In nucleate boiling (a subset of pool boiling) vapor bubbles grow from nucleation sites where gas are trapped in micro-cavities on the surface. Carbon surfaces possess these same features, …

Accuracy Of The Home Energy Saver Energy Calculation Methodology, Florida Solar Energy Center, Danny Parker

FSEC Energy Research Center®

The Home Energy Saver (HES) suite offers popular online simulation tools that enable U.S. homeowners and energy professionals to rigorously evaluate home energy use and develop recommendations on how energy can be saved across all end uses. The underlying analytical system is also available as a web service to power third-party energy analysis tools. Given the system's diverse uses, it is important that the simulation is robust and intrinsically accurate. While the engineering methods and assumptions are extensively documented and subjected to peer review, it is useful to evaluate how well HES predicts energy use in occupied homes. In this …

Static Balancing Of The Cal Poly Wind Turbine Rotor, Derek Simon

Master's Theses

The balancing of a wind turbine rotor is a crucial step affecting the machine’s performance, reliability, and safety, as it directly impacts the dynamic loads on the entire structure.

A rotor can be balanced either statically or dynamically. A method of rotor balancing was developed that achieves both the simplicity of static balancing and the accuracy of dynamic balancing. This method is best suited, but not limited, to hollow composite blades of any size. The method starts by quantifying the mass and center of gravity of each blade. A dynamic calculation is performed to determine the theoretical shaking force on …

Clean Energy Infrastructure Educational Initiative, Kevin P. Hallinan, James A. Menart, Robert Gilbert

Mechanical and Aerospace Engineering Faculty Publications

The Clean Energy Infrastructure Educational Initiative represents a collaborative effort by the University of Dayton, Wright State University and Sinclair Community College. This effort above all aimed to establish energy related programs at each of the universities while also providing outreach to the local, state-wide, and national communities. At the University of Dayton, the grant has aimed at: solidfying a newly created Master's program in Renewable and Clean Energy; helping to establish and staff a regional sustainability organization for SW Ohio. As well, as the prime grantee, the University of Dayton was responsible for ensuring curricular sharing between WSU and …

Automated Resonant Wireless Power Transfer To Remote Sensors From An Unmanned Aerial Vehicle, Brent Griffin

Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research

Wireless magnetic resonant power transfer is an emerging technology that has many advantages over other wireless power transfer methods due to its safety, lack of interference, and efficiency at medium ranges. In this thesis, we develop a wire- less magnetic resonant power transfer system that enables unmanned aerial vehicles (UAVs) to provide power to, and recharge batteries of, wireless sensors and other electronics far removed from the electric grid. We address the difficulties of implementing and outfitting this system on a UAV with limited payload capabilities and develop a controller that maximizes the received power as the UAV moves into …

Absorber Geometry Optimization For A New Wave Energy Converter, Rachel A. Durren

Masters Theses

Alternative energy technologies are on the forefront of research due to the rising costs of oil and natural gas. One relatively under development source of energy is ocean waves. In order to make the use of ocean waves economically viable, the amount of energy absorbed by wave energy converters (WEC) must be optimized. The research within presents a new conceptual design, "Aqua Fly", for a WEC with emphasis on maximizing the amount of energy absorbed. The energy absorption component of the "Aqua Fly" was isolated and a small scale 2-D study of energy absorption. First, the amount of energy in …

Side-By-Side Testing Of Water Heating Systems: Results From The 2010-2011 Evaluation, Florida Solar Energy Center, Carlos Colon

FSEC Energy Research Center®

REVISED MARCH 2013 The Building America (BAPIRC) team at FSEC has released a report containing results from a second testing rotation (Phase II) on seven hot water systems evaluated side-by side. Results show the seasonal performance variation and compares solar systems against electric resistance and the Heat Pump Water Heater (HPWH). Standard and tankless natural gas were also evaluated, where the latter demonstrated a 24% natural gas reduction. The lowest averaged electric power consumptions were demonstrated by the HPWH (2.75 kWh/day) and the PV-pumped solar water heater (3.03 kWh/day). Other testing performed on the HPWH under conditioned and restricted air …

Final Technical Report (2nd Revision) Arra: Florida Energy Code Compliance Train-The-Trainer Program, Florida Solar Energy Center, Jeffrey Sonne

FSEC Energy Research Center®

A multi-faceted Florida Energy Code compliance methods, tools and field verification training program was established that included development of two instructor-led and two web-based courses, instructor training and course development support, and training of building officials and contractors throughout the state.

Separate instructor-led commercial and residential 2010 Florida Energy Code compliance courses were developed for train-the-trainer class use, and existing instructor-led blueprints data collection and energy code software courses were redeveloped as web-based courses.

Through partnerships with Florida colleges, building departments and industry organizations, a total of 42 instructors were trained to provide commercial energy code compliance training and 42 …