Oil, Gas, and Energy Commons^™

The Potential For Gaseous Biofuels In Ireland, Darren Kenneally

Theses

According to the EU Renewables Directive 2009/28/EC, 20% of the energy across Europe needs to be renewable by 2020. This is inclusive of the energy utilised in the transport sector where 10% of this energy needs to be renewable. In order for Ireland to meet the targets set in the Renewables Directive various changes need to be applied. The utilisation of gaseous biofuels produced from the anaerobic digestion of various feedstocks will aid Ireland in meeting this directive.

In this study biodegradable municipal waste (BMW) and energy crops are analysed as potential feedstocks for the production of biomethane. This biomethane …

Investigating Fabrication Methods For Micro Single-Chamber Solid Oxide Fuel Cells, Man Yang

Dissertations

A Solid Oxide Fuel Cell (SOFC) is a green energy technology that offers a cleaner and efficient alternative to fossil fuels. The efficiency and utility of SOFCs can be enhanced by fabricating miniaturized component structures within the fuel cell footprint. This research focuses on the microfabrication of parallel-connected inter-digitized design of micro single chamber SOFC (µ-SC-SOFCs). In this dissertation, candidate micro/nano fabrication techniques to precisely fabricate micro patterns on planar substrates have been studied. These include EBL, soft lithography, photolithography, and direct-writing. After analyzing preliminary results, two combinational approaches were further investigated. The first method involves the combination of the …

Oxidation Of Dibenzothiophene To Dibenzothiophene Using Metal Nanoparticles Supported On Silica, Karina Castillo

Open Access Theses & Dissertations

Silica and nanoparticles of Pt, Au, and Ag supported on silica were tested for the ability to oxidize dibenzothiophene (DBT) to sulfone. High performance liquid chromatography was used to study the removal of DBT from solution. In addition, X- ray diffraction, infrared spectroscopy and Raman Spectroscopy were used to characterize the product of the oxidation reaction. Further studies involved the use X-ray absorption spectroscopy to characterize the nanoparticle catalysts before and after the oxidation reaction.

To better understand the reaction, silica was synthesized at different pHs using three different acids. The acids used to synthesize the silica were HCl, HNO3, …

Simulation And Optimization Of Ultra Thin Photovoltaics, Jose Luis Cruz-Campa

Open Access Theses & Dissertations

Sandia National Laboratories (SNL) conducts pioneering research and development in Micro-Electro-Mechanical Systems (MEMS) and solar cell research. This dissertation project combines these two areas to create ultra-thin small-form-factor crystalline silicon (c-Si) solar cells. These miniature solar cells create a new class of photovoltaics with potentially novel applications and benefits such as dramatic reductions in cost, weight and material usage.

At the beginning of the project, unusually low efficiencies were obtained in the research group. The intention of this research was thus to investigate the main causes of the low efficiencies through simulation, design, fabrication, and characterization.

Commercial simulation tools were …

Fabrication Of Zinc Oxide Thin Films For Renewable Energy And Sensor Applications, Theresa Y. Hill

Browse all Theses and Dissertations

Progress in commercializing renewable energy technologies is being advanced by developments in Zinc Oxide material science. The photovoltaic cell, for example, generates electricity by receiving solar energy into the cell, generating electrons, and simultaneously transporting electrical charge out of the cell. Metals are capable of removing electrical charge but block transmission of sunshine. Glass and plastics are capable of transmitting sunshine but block the removal of electrical charge. Therefore an exterior layer that is both optically transparent and electrically conductive is desirable. Transparent conductive oxides (TCOs) are the ideal material for such applications since they are capable of both functions. …

Sulfur-Tolerant Catalyst For The Solid Oxide Fuel Cell, Bozeman Joe Frank Iii

Browse all Theses and Dissertations

JP-8 fuel is easily accessible, transportable, and has hydrogen content essential to solid oxide fuel cell (SOFC) operation. However, this syngas has sulfur content which results in a poisonous hydrogen sulfide that degrades electrochemical activity and causes complete SOFC failure in some cases. The goal is to synthesize and verify a cost-effective, catalyst supported on cerium oxide that either stabilizes ionic conductivity in the presence of hydrogen sulfide and/or is highly sulfur-resistant. After thorough computational analysis, it was concluded that the platinum-copper skin catalyst was the most cost-effective, sulfur-resistant catalyst. Experimental synthesis of copper, platinum, and platinum-copper skin catalysts supported …

Concentrating Solar Power Commercial Application Study: Reducing Water Consumption Of Concentrating Solar Power Electricity Generation, U.S. Department Of Energy

Publications (E)

This report discusses potential methods to reduce water consumption associated with CSP. Four main concentrating solar power technologies are described in this report: parabolic troughs, linear Fresnel, power towers, and dish/engine. Parabolic troughs are the most commercially available technology. Linear Fresnel and power tower technologies are presently being planned as commercial plants, but none have yet been built in the U.S. The first three of these technologies use the heat collected from the sun to power conventional Rankine steam cycles, similar to those used for coal and nuclear plants. Steam cycle power plants require cooling to function (cooling is needed …

The Role Of Energy Storage With Renewable Electricity Generation, Paul Denholm, Erik Ela, Brendan Kirby, Michael Milligan

Publications (E)

Renewable energy sources, such as wind and solar, have vast potential to reduce dependence on fossil fuels and greenhouse gas emissions in the electric sector. Climate change concerns, state initiatives including renewable portfolio standards, and consumer efforts are resulting in increased deployments of both technologies. Both solar photovoltaics (PV) and wind energy have variable and uncertain (sometimes referred to as “intermittent”) output, which are unlike the dispatchable sources used for the majority of electricity generation in the United States. The variability of these sources has led to concerns regarding the reliability of an electric grid that derives a large fraction …

Wind For Schools: A Wind Powering America Project, National Renewable Energy Laboratory

Publications (E)

Energy is largely taken for granted within our society, but that perception is changing as the economic and environmental impacts of our current energy structure are more widely understood. The U.S. Department of Energy’s (DOE’s) Wind Powering America program sponsors the Wind for Schools Project to raise awareness in rural America about the benefits of wind energy while simultaneously developing a wind energy knowledge base in the United States to educate future leaders of our communities, states, and nation about the importance of renewable energy.

The three primary project goals of the Wind for Schools Project are to:

• Engage …

2008 Solar Technologies Market Report, U.S. Department Of Energy

Publications (E)

This report focuses on the U.S. solar electricity market, including photovoltaic (PV) and concentrating solar power (CSP) technologies. The report provides an overview of global and U.S. installation trends. It also presents production and shipment data, material and supply chain issues, and solar industry employment trends. It also presents cost, price, and performance trends; and discusses policy and market drivers such as recently passed federal legislation, state and local policies, and developments in project financing. The final chapter provides data on private investment trends and near-term market forecasts.

Analysis Of Hybrid Hydrogen Systems: Final Report, J. Dean, R. Braun, D. Munoz, M. Penev, C. Kinchin

Publications (E)

This project examined biomass pathways for hydrogen production and how they can be hybridized to support renewable electricity generation. The project considered many potential hybrid systems before narrowing the focus to two. The systems were studied in detail for process feasibility and economic performance. The best-performing system was estimated to produce hydrogen at a cost ($1.67/kg) within range of the Department of Energy target for central biomass-derived hydrogen production, while also providing value-added energy services to the electric grid.

Nrel: A Year In Clean Energy Innovations: A Review Of Nrel's Feature Stories, National Renewable Energy Laboratory

Publications (E)

The National Renewable Energy Laboratory (NREL) is the nation’s primary laboratory for renewable energy and energy efficiency research and development.

NREL’s mission and strategy are focused on advancing the U.S. Department of Energy’s and our nation’s energy goals. The laboratory’s scientists and researchers support critical market objectives to accelerate research from scientific innovations to market-viable alternative energy solutions. At the core of this strategic direction are NREL’s research and technology development competencies. These areas span from understanding renewable resources for energy, to the conversion of these resources to renewable electricity and fuels, and ultimately to the use of renewable electricity …

Wind Powering America: Fy09 Activities Summary, National Renewable Energy Laboratory

Publications (E)

The Wind Powering America FY09 Activities Summary reflects the accomplishments of state Wind Working Groups, WPA programs at the National Renewable Energy Laboratory, and partner organizations.

Green Initiatives, Paul Andricopulos, Ned Thomas

Publications (E)

City practices incorporating energy conservation methods.

Connecticut Transit (Cttransit) Fuel Cell Transit Bus: Third Evaluation Report And Appendices, K. Chandler, L. Eudy

Publications (T)

This report describes operations at Connecticut Transit (CTTRANSIT) in Hartford for one prototype fuel cell bus and three newer diesel buses operating from the same location. The prototype fuel cell bus was manufactured by Van Hool and ISE Corp. and features an electric hybrid drive system with a UTC Power PureMotion 120 Fuel Cell Power System and ZEBRA batteries for energy storage. The fuel cell bus started operation in April 2007, and evaluation results through October 2009 are provided in this report.

United Parcel Service Evaluates Hybrid Electric Delivery Vans, National Renewable Energy Laboratory

Publications (T)

This fact sheet describes how the National Renewable Energy Laboratory's Fleet Test and Evaluation team evaluated the 12-month, in-service performance of six Class 4 hybrid electric delivery vans - fueled by regular diesel - and six comparable conventional diesel vans operated by the United Parcel Service.

Provenance Of The Neoproterozoic Ocoee Supergroup, Eastern Great Smoky Mountains, Suvankar Chakraborty

University of Kentucky Doctoral Dissertations

The Ocoee Supergroup is a sequence of Neoproterozoic, immature, continental rift facies clastic sediments. Potential source rocks were tested by analyzing modes of detrital framework minerals, detrital mineral chemistry, whole rock geochemistry and detrital zircon U/Pb geochronology by LA-ICP-MS for Ocoee siltstone-sandstone dominated formations. Ocoee units are arkosic to subarkosic siltstones/sandstones, and ternary tectonic discrimination diagrams confirm a continental basement uplift source. Alkali feldspar predominates over plagioclase feldspar. Detrital feldspar compositions of Ocoee sediments as a group are similar to feldspar in local basement granitic rocks except for high-Ca plagioclase grains present locally in basement granitic rocks. The high alkali …