Structural Engineering Commons^™

Testing And Development Of Pre-Stressed Cfrp Retrofit Strategies For Controlling Fatigue Cracking In Steel Waterway Lock Gate Structures, Maggie Langston

Graduate Theses and Dissertations

Steel waterway lock gates across the national inland waterway transportation network are reaching and exceeding their intended service life, often experiencing component failures that lead to service interruptions. Unscheduled maintenance and repair of lock gates can be expensive and cause economic ripples throughout the entire inland waterway network. These lock gate component failures are often caused by fatigue cracking from repeated loading during operation. This thesis develops and tests a prestressed carbon fiber reinforced polymer (CFRP) fatigue retrofit for controlling fatigue demands within lock gate components. The study expands upon a recent analytical work by Lozano (2017) by experimentally investigating …

Development Of Iowa Dot Combination Bridge Separation Barrier With Bicycle Railing, Chaz M. Ginger

Department of Engineering Mechanics: Dissertations, Theses, and Student Research

The Iowa Department of Transportation typically builds separation barriers between vehicle and pedestrian/bicycle facilities when sidewalks or trails are present on vehicular bridges. Currently, Iowa DOT employs a combination bridge rail that utilizes a concrete parapet that previously had been successfully evaluated to National Cooperative Highway Research Program (NCHRP) Report 350 Test Level 4 (TL-4) criteria for these situations. While the parapet had been successfully evaluated, the combination bridge rail system as a whole had not been evaluated to any crash test standards. Iowa DOT desired that researchers at Midwest Roadside Safety Facility (MwRSF) design and test a combination bridge …

Evaluation And Development Of Cpt Based Pile Design In Nebraska Soils, Alex Silvey

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Cone penetration testing (CPT) is a well established geotechnical subsurface investigation technique commonly used for site characterization and soil classification. The CPT gives real time end resistance, side friction, and pore pressure readings. Axially loaded piles also share these two resistance mechanisms, suggesting the cone can be considered similar to a miniature pile. This study focused on evaluating eight CPT methods prediction of pile bearing capacity. The Nebraska Department of Roads (NDOR) conducts dynamic load tests (PDA) of driven pile to verify pile capacity for bridge foundations. 91 comparisons of CPT logs and PDA data were evaluated. CPT prediction methods …

My Catalyst, Gabrielle Gambino Lyon

Celebration of Learning

Over the course of my internship and shadow program with Pepper Lawson Construction and Ziegler Cooper Architects, I was able to explore the various career paths involved in the design, construction, and civil engineering fields. My work on the construction site of a high-rise apartment building located in the heart of Houston, TX allowed me first-hand experience working and learning alongside project engineers, contractors, building developers, and the construction team.

This project was the perfect confluence of my main areas of interest: structural, mechanical, civil, and environmental engineering, as well as architecture. My daily work consisted of on-site walk throughs, …

Seismic Performance And Retrofit Evaluation Of Hollow-Core Composite Bridge Columns, Mohanad M. Abdulazeez, Ahmed Gheni, Nicholas Colbert, Mohamed Elgawady

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

This paper presents the seismic behavior of large-scale hollow-core fiber-reinforced polymerconcrete-steel (HC-FCS) bridge column. The HC-FCS column consists of a concrete wall sandwiched between an outer fiber-reinforced polymer (FRP) tube and an inner thin-walled steel tube. The width-to-diameter ratio for the steel tube was 147. The column had an outer diameter of 24 inches and a height-to-diameter ratio of 4.0. The steel tube was embedded into reinforced concrete footing with an embedded length of 1.25 times the steel tube diameter, while the FRP tube only confined the concrete wall thickness and curtail at the top of the footing level. The …

Non-Linear Deformation Analysis Of An Embankment Dam, Silas T. Sanderson

Civil and Environmental Engineering Master's Project Reports

Non-linear deformation analysis (NDA) of embankment dams is becoming more common as geotechnical engineers seek to better understand how critical infrastructure will perform under high seismic loading. In order to perform this type of analysis, site specific ground motions and engineering properties of the embankment dam are required. The NDA modeling effort consists of a static and seepage analysis to establish an initial stress state followed by a dynamic analysis to simulate the embankment response to ground motions. Using this approach, a two dimensional NDA was performed on an embankment dam using the NDA program FLAC. This report discusses the …

A 3d Model For Earthquake-Induced Liquefaction Triggering And Post-Liquefaction Response, Arash Khosravifar, Ahmed Elgamal, Jinchi Lu, John Li

Civil and Environmental Engineering Faculty Publications and Presentations

A constitutive soil model that was originally developed to model liquefaction and cyclic mobility has been updated to comply with the established guidelines on the dependence of liquefaction triggering to the number of loading cycles, effective overburden stress (Kσ), and static shear stress (Kα). The model has been improved with new flow rules to better capture contraction and dilation in sands and has been implemented as PDMY03 in different computational platforms such as OpenSees finite-element, and FLAC and FLAC3D finite-difference frameworks. This paper presents the new modified framework of analysis and describes a guideline to calibrate the input parameters of …

Identification Of Transportation Infrastructure At Risk Due To Sea Level Rise And Subsidence Of Land In Coastal Louisiana, Sanjay Tewari, Wesley Palmer

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

The coast of Louisiana is under threat because of sea level rise and land subsidence. Sea water is encroaching deeper inland and as a result Louisiana is losing at an alarming rate. The combined effect of sea level rise and land subsidence is variable spatially. This paper focuses on this combined effect in identifying the transportation infrastructure that is at risk of getting affected by the sea-water inundation of the land.

This paper is an attempt of taking account of land elevation data monitored continuously at various locations along the coast of Louisiana and combining it with local sea level …

A Nonlinear Crack Model For Concrete Structure Based On An Extended Scaled Boundary Finite Element Method, Jian-Bo Li, Xin Gao, Xing-An Fu, Chenglin Wu, Gao Lin

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Fracture mechanics is one of the most important approaches to structural safety analysis. Modeling the fracture process zone (FPZ) is critical to understand the nonlinear cracking behavior of heterogeneous quasi-brittle materials such as concrete. In this work, a nonlinear extended scaled boundary finite element method (X-SBFEM) was developed incorporating the cohesive fracture behavior of concrete. This newly developed model consists of an iterative procedure to accurately model the traction distribution within the FPZ accounting for the cohesive interactions between crack surfaces. Numerical validations were conducted on both of the concrete beam and dam structures with various loading conditions. The results …

Inelastic Response Evaluation Of Precast Composite Columns Under Seismic Loads, Mohanad M. Abdulazeez, Mohamed Elgawady

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

This paper presents a non-linear finite element analysis of large-scale hollow-core fiber-reinforced polymer-concrete-thin walled steel (HC-FCS) precast columns under reversed cyclic loading. The HC-FCS columns provide an economical and efficient alternative to conventional concrete bridge columns. The precast HC-FCS column consists of a concrete shell sandwiched between an outer fiber-reinforced polymer (FRP) tube and an inner thin-walled steel tube. The steel tube diameter-to thickness (D_i/t_s) ratio was 254. The proposed FEA model was developed using LS_DYNA multipurpose software and was verified by experimental results performed in this study. The FE model was used to investigate some …

Microstructural Characterization Of Shear Transformation Zones And Modeling Indentation Size Effect In Amorphous Polymers, Leila Malekmotiei

LSU Doctoral Dissertations

The first aim of this work is developing a procedure for experimental and analytical characterization of nano-scale microstructures which mediate large scale deformation in amorphous polymers. Glassy polymers are extensively used as high impact resistant, low density, and clear materials in industries. Nevertheless, their response under severe loading conditions is yet to be appropriately unraveled. Due to the lack of long-range order in the microstructures of glassy solids, their plastic deformation is different from that in crystalline solids. Shear Transformation Zones (STZs) are believed to be the main plasticity carriers in amorphous solids and defined as the localized atomic or …

Climbing Robots For Steel Bridge Inspection And Evaluation, Hung La

INSPIRE Archived Webinars

Steel structures and steel bridges, constituting a major part in civil infrastructure, require adequate maintenance and health monitoring. In the U.S., more than 50,000 steel bridges are either deficient or functionally obsolete, which likely presents a growing threat to people's safety. The collapse of numerous bridges recorded over the past 16 years has shown significant impact on the safety of all travelers.

In this presentation, the design and implementation of two different climbing robots for steel structure inspection are reported. Based on the magnetic wheel design, the robot can climb on different steel surface structures (i.e., flat, cylinder, cube). The …

Investigation Into The Behavior Of An Open Web Steel Joist Bridge, Zahra Andalib, Piero Caputo, Sattar Dorafshan, Marc Maguire, William Collins

Civil Engineering Faculty Publications

Open web steel joists (OWSJ) have been extensively used in the building industry due to numerous advantages when compared with other structural systems. They are lighter than comparable rolled steel shapes, allowing for faster and less costly construction, in addition to their reduced material costs. However, OWSJ are rarely used for bridge structures. This paper examines the behavior of an OWSJ system in a bridge located at the Nucor plant in Brigham City, Utah.

Ccfss Special Edition Technical Bulletin Summer 2018, Wei-Wen Yu Center For Cold-Formed Steel Structures

CCFSS Technical Bulletins (1993 - 2020)

No abstract provided.

An Integrated Decision Support Framework For Life-Cycle Building Asset Management, Maha Reda Alkasisbeh

Dissertations

Building assets are essential to the economic, cultural, and historical growth of any nation. Examples of buildings include shelters, entertainment facilities, living spaces, teaching facilities, civil offices, parking structures, police buildings, libraries, and service areas used to accommodate human activity. Deterioration of building assets, inadequate renewal budgets, climbing deficits, and increasing demand levels are difficulties that face owners when managing building assets. The role of asset management has recently become significant in municipal governments for strategic, operational, and financial reasons. The main functions of an asset management system include assessment of the current condition, prediction of future deterioration, asset prioritization, …

Structural Analysis Of The High Bay Steel Reaction Frames, Jerry Hue Truong Luong, Garrett Michael Brown

Architectural Engineering

No abstract provided.

3-D Reconstructions And Numerical Simulations Of Precarious Rocks In Southern California, Christine E. Wittich, Tara C. Hutchinson, J. Desanto, D. Sandwell

Department of Civil and Environmental Engineering: Faculty Publications

Reliable estimates of seismic hazard are essential for the development of resilient communities; however, estimates of rare, yet high intensity earthquakes are highly uncertain due to a lack of observations and recordings. Lacking this data, seismic hazard analyses may be based on extrapolations from earthquakes with more moderate return periods, which can lead to physically unrealistic earthquake scenarios. However, the existence of certain precariously balanced rocks (PBRs) has been identified as an indicator of an upper bound ground motion, which precludes toppling of the balanced rock, over its lifetime. To this end, a survey of PBRs was conducted in proximity …

Risk Assessment Of Concrete Gravity Dams Under Earthquake Loads, Ufuk Sen

LSU Master's Theses

Dams are important structures to supply water for irrigation or drinking, to control flood, and to generate electricity. In seismic regions, the structural safety of concrete gravity dams is important due to the high potential of life and economic loss if they fail. Therefore, the seismic analysis of existing dams in seismically active regions is very crucial to predict responses of dams to ground motions. In this thesis, earthquake response of concrete gravity dams is investigated using the finite element (FE) method. The selected dam is the Pine Flat Dam which is located in the Central Valley of Fresno County, …

Bridge Inspection: Human Performance, Unmanned Aerial Systems And Automation, Sattar Dorafshan, Marc Maguire

Civil and Environmental Engineering Faculty Publications

Unmanned aerial systems (UASs) have become of considerable private and commercial interest for a variety of jobs and entertainment in the past 10 years. This paper is a literature review of the state of practice for the United States bridge inspection programs and outlines how automated and unmanned bridge inspections can be made suitable for present and future needs. At its best, current technology limits UAS use to an assistive tool for the inspector to perform a bridge inspection faster, safer, and without traffic closure. The major challenges for UASs are satisfying restrictive Federal Aviation Administration regulations, control issues in …

Solar And Rain Catching Canopy. Urban Oasis, Afolabi Ibitoye, Langston Clark, Elena Zimareva, Evan Banks, Alexander Aptekar

Publications and Research

The Urban Oasis is designed to work within existing “pocket parks” in New York City as a combined rainwater collector, personal electronics charging station and resting designation for New Yorkers. Intended to not only lessen the demand on the city power grid by using renewable energy to charge devices, the urban oasis is also intended to mitigate grey water overfill in New York’s combined sewer system and, in general, serve as a model for responsible environmental stewardship in urban areas.

The important technical aspects of the canopy specifically analyzed were:

a) how much rainwater could the canopy be expected to …