Structural Engineering Commons^™

Strain-Based Design Of Steel-Polymer-Steel Composite Pipes, Vul Thang

LSU New Orleans Theses and Dissertations

Many offshore single-wall pipelines and structural failures have occurred in the past. As a result, lives were lost, and billions of dollars were spent. In addition, natural disasters such as earthquake fault zones can cause a large volume of soil movement. This can easily damage single-wall pipelines or piles of fixed offshore platforms in the earthquake fault zone.

Currently, the single-wall pipelines are used for the offshore and onshore oil and gas industry. This research investigated the use of double-wall composite pipe steel-polymer-steel (SPS) in place of single-wall pipe to prevent such failures. The double-wall composite pipe has a larger …

Wave Interactions And Energy Cascade, Bailey Downing

Civil Engineering Undergraduate Honors Theses

Structural engineers design buildings and their components to withstand code-specified wind loads. The ASCE 7-16 manual sets the standards for calculating wind loads in the U.S. Depending on the velocity of wind, deflections may occur as wind passes through the building. The pressure reported from ASCE are based on wind tunnel measurements. The peak pressure from ASCE 7 is much less than what is measured from the field for a low-rise building. As an alternative economic tool, Computer modeling has been developed to help with this dilemma. Methods based on computational fluid dynamics (CFD) are used to calculate velocities and …

Evaluating The Effects Of Curing Methods On Bcsa Cement Concrete, Hannah Allen

Civil Engineering Undergraduate Honors Theses

BCSA cement is a type of cement that makes concrete set up much quicker than typical portland cement concrete. BCSA cement concrete also has a much higher compressive strength than that of portland cement concrete. This study was conducted to determine the effect of different curing conditions on the compressive strength of BCSA cement concrete.

Semi-Annual Progress Report #10, Missouri University Of Science And Technology. Inspire - University Transportation Center

Semi-Annual Progress Reports

No abstract provided.

Mechanical Behavior Of Clay Soil Stabilized With Fly Ash And Bottom Ash, Soewignjo Agus Nugroho, Azra Zulnasari, Ferry Fatnanta, Andius Dasa Putra

Makara Journal of Technology

Soil is one of the most important aspects of an infrastructure given its functions of receiving and holding structural loads. However, not all soils have good physical and mechanical properties. To overcome those conditions, stabilization of the soil is practiced to meet the technical requirements. This study aims to determine the behavior of high plasticity clay stabilized with lime, fly ash, and bottom ash. These additives can be used as a stabilizing agent to increase soil strength. The percentage of additives varied from 5%–25% then mixed with clay and were tested through the (Unconfined Compression Strength (UCS) test. The UCS …

Enhancement Of Biogas Production Through Solid-State Anaerobic Co-Digestion Of Food Waste And Corn Cobs, Lukhi Mulia Shitophyta, Anisa Salsabila, Firanita Angraini Putri, Siti Jamilatun

Makara Journal of Technology

Although biogas has been primarily produced through liquid anaerobic digestion, this method leads to the floating and stratification of fibers and non-homogeneous mixing, which can reduce the biogas yield. Alternatively, biogas can be produced by the solid-state anaerobic digestion (SS-AD) of organic material with a high solid content, such as corn cobs. We investigated the co-digestion of food waste and corn cobs as a biomass feedstock for SS-AD in biogas production. We measured the effects of the total solid (TS) content, percentage of food waste, and reduction in volatile solids (VS), from which we determined its appropriate kinetic model. We …

Control Strategy For Solar Energy-Saving Lamps For Optimized Energy Utilization And Sustainability Of Operation Durability: Indonesia Case, Burhanuddin Halimi, Agus Purwadi, Nana Heryana

Makara Journal of Technology

To solve the electrification ratio issue, the Indonesian government has promoted the use of solar energy-saving lamps. This study proposes a control strategy that adopts current reference time-based profiling for solar energy-saving lamps. For optimal energy consumption, the current reference profile is determined according to users’ daily energy requirements. From the aspect of user comfort, a gradual step reference profile is also introduced to provide a subtle change in lighting intensity level. The proposed control strategy can minimize energy consumption and optimize the operation durability of the system. The concept is verified by simulating four scenarios, the results of which …

Structural Health Monitoring: From Virtual Shakers To Machine Learning, Ahsan Kareem

Abbett Distinguished Seminar Series

Structural health monitoring (SHM) is a critical means of assessing the performance of aging civil infrastructure. Earlier studies used heavy dynamic shakers to assess the dynamics of structures, which are unwieldy and reliance has been shifted to ambient vibration of structures to extract dynamic features. This study introduces a “virtual shaker” concept that effectively replaces the physical shaker and provides all the desired features for SHM. Examples are provided along with an App that facilitates the use of this concept to identify dynamic features. A traditional structural health monitoring (SHM) operation requires a wired system, which is often termed “hub …

Machine Learning-Based Bridge Load Posting Prediction, Sai Naga Sasi Aditya Bandaru

LSU Master's Theses

1600 (12%) of Louisiana's 13,000 bridges that allow the passage of people, goods, and services are load posted, meaning they are deemed incapable of securely carrying all legal loads. A machine learning framework for estimating the number of load-posted bridges within a regional bridge portfolio would be extremely valuable in the future for allocating essential resources during long-term planning. A framework of this type is necessary since a significant proportion of the bridges are load posted. Furthermore, deterioration due to aging and future increases in legal loads can compound this situation. In this setting, there is a lack of data-driven …

Machine Learning-Based Bridge Load Posting Prediction, Sai Naga Sasi Aditya Bandaru

LSU Master's Theses

1600 (12%) of Louisiana's 13,000 bridges that allow the passage of people, goods, and services are load posted, meaning they are deemed incapable of securely carrying all legal loads. A machine learning framework for estimating the number of load-posted bridges within a regional bridge portfolio would be extremely valuable in the future for allocating essential resources during long-term planning. A framework of this type is necessary since a significant proportion of the bridges are load posted. Furthermore, deterioration due to aging and future increases in legal loads can compound this situation. In this setting, there is a lack of data-driven …

A Case Study Of Protecting Bridges Against Overheight Vehicles, Aly Mousaad Aly, Marc Hoffmann

Faculty Publications

Most transportation departments have recognized and developed procedures to address the ever-increasing weights of trucks traveling on bridges in service today. Transportation agencies also recognize the issues with overheight vehicles’ collisions with bridges, but few stakeholders have definitive countermeasures. Bridges are becoming more vulnerable to collisions from overheight vehicles. The exact response under lateral impact force is difficult to predict. In this paper, nonlinear impact analysis shows that the degree of deformation recorded through the modeling of the unprotected vehicle-girder model provides realistic results compared to the observation from the US-61 bridge overheight vehicle impact. The predicted displacements are 0.229 …

Optimizing The Self-Healing Efficiency Of Hydrogel Encapsulated Bacteria In Concrete, Ricardo Hungria

LSU Master's Theses

Calcium carbonate precipitation through microbial means is a promising pathway for concrete self-healing technologies, mainly for its microcrack sealing attributes. The main goal of this project was to study and optimize the crack healing efficiency of hydrogel encapsulated bacteria in concrete. To achieve this purpose, Bacillus pseudiformus was implemented as the bacteria strain at a concentration of 10⁸ cells/ml. This bacterium strain along with yeast extract was combined along with three different mineral precursors corresponding to magnesium acetate, calcium lactate, and sodium lactate. All these three precursors were evaluated at two concentrations (67.76 mM/l and 75 mM/l). For each …

Cost-Efficient Bridge Scour Health Monitoring Using Commercial Sensors, Connor Embleau, Tien Yee, Metin Oguzmert, Mahyar Amirgholy, Alan Akazemi, Dale Goff

Symposium of Student Scholars

Bridge scouring has been a major international issue regarding bridge health and the overall longevity of a bridge. A common bridge health concern such as scouring accounts for close to 60% of bridge failures in the United States and is a leading cause to a bridge being in critical condition. Traditional methods to combat this failure is to measure the scour depth to assess a bridge health. Due to safety concerns of the traditional method, this study proposes to monitor a bridge’s health using a vibration-based technique. At present, vibration-based techniques have yet to be utilized reliably in the field. …

Fast Forest Fire Smoke Detection Using Mvmnet, Yaowen Hu, Jialei Zhan, Guoxiong Zhou, Aibin Chen, Weiwei Cai, Kun Guo, Yahui Hu, Liujun Li

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Forest fires are a huge ecological hazard, and smoke is an early characteristic of forest fires. Smoke is present only in a tiny region in images that are captured in the early stages of smoke occurrence or when the smoke is far from the camera. Furthermore, smoke dispersal is uneven, and the background environment is complicated and changing, thereby leading to inconspicuous pixel-based features that complicate smoke detection. In this paper, we propose a detection method called multioriented detection based on a value conversion-attention mechanism module and Mixed-NMS (MVMNet). First, a multioriented detection method is proposed. In contrast to traditional …

Reducing Early-Age Shrinkage Cracks Of Bridge Decks And Rails, Soumitra Das, George Morcous, Jiong Hu

UNL Student Research Days Posters, Graduate

Early-age shrinkage cracking of concrete bridge decks and rails accelerates the penetration of water and chemicals which leads to reinforcement corrosion, delamination, and eventually spalling. All this results in shorter service life, road closure, and costly repair. Development of Low-cement concrete(LCC) mix to reduce early age shrinkage crack through aggregate grading optimization was done in this research work. This approach also reduces concrete cost ($15-$20/cyd) (15–25%) and its carbon footprint (≈15%).

Evaluating The Effects Of Shored Construction On Steel Girder Composite Bridges, Parker Brooks

Doctoral Dissertations and Master's Theses

Steel composite girder bridges provide economic advantages and higher load-carrying capacity than non-composite alternatives. Over the years, a conventional sequence of un-shored construction for steel girder composite bridges has been developed. There is an alternative construction sequence, known as shored construction, that uses temporary supports (discretely or fully supported) for the superstructure during the installation of metal forms and the pouring of concrete. Shored construction also can be used in an Accelerated Bridge Construction (ABC) practice where construction occurs at a nearby site and fully-formed elements are transported to the final site using self-propelled modular transporters (SPMTs). In order to …

Monitoring Of Structural Quality Under Construction Using 3d Point Cloud Data, Xinxing Yuan

Civil Engineering ETDs

Inspection of infrastructure under construction has become an active research topic in the past few decades. Due to rising costs and safety concerns of current inspection methods, automated inspection methods are proposed. In this context, this dissertation has developed a framework that uses 3D point cloud data from the bridge under construction and evaluates the design specifications and the strength capacity of the structure while is being built. This study presents a slicing algorithm for automatically evaluating rebar placement using 3D point cloud data. The outcomes of this research provide structural engineering with (i) automatic inspection of reinforcement during construction; …

Toward Dexterous Aerial Manipulation Using Embodied Human-Intelligence For Bridge Inspection And Maintenance, Dongbin Kim

INSPIRE Archived Webinars

Current drones perform a wide variety of tasks in surveillance, photography, agriculture, package delivery, etc. However, these tasks are performed passively without the use of human interaction. Aerial manipulation shifts this paradigm and implements drones with robotic arms that allow interaction with the environment rather than simply sensing it. Many research groups have demonstrated aerial manipulation for various applications for over a decade. For example, in construction, aerial manipulation in conjunction with human interaction could allow operators to perform several tasks, such as hosing decks, drill into surfaces, and sealing cracks via a drone. This integration with drones will henceforth …

Bc-Dunet-Based Segmentation Of Fine Cracks In Bridges Under A Complex Background, Tao Liu, Liangji Zhang, Guoxiong Zhou, Weiwei Cai, Chuang Cai, Liujun Li

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Crack is the external expression form of potential safety risks in bridge construction. Currently, automatic detection and segmentation of bridge cracks remains the top priority of civil engineers. With the development of image segmentation techniques based on convolutional neural networks, new opportunities emerge in bridge crack detection. Traditional bridge crack detection methods are vulnerable to complex background and small cracks, which is difficult to achieve effective segmentation. This study presents a bridge crack segmentation method based on a densely connected U-Net network (BC-DUnet) with a background elimination module and cross-attention mechanism. First, a dense connected feature extraction model (DCFEM) integrating …

To Critically Review The Use Of Screencasts For Teaching Land Surveying, Eugen Niculae, Alain Chenaux

Conference papers

Screencasting tools allow for a screen capture of the actions on a computer screen with accompanying audio. This research initially reviews through the literature how screencasting has been used pedagogically and, through this primary research, the application of an existing screencast called Screencast-O-Matic and feedback from students from both Construction Management and Geospatial Surveying Undergraduate Programmes of TU Dublin, where and how it could be deployed for the surveying classes and fieldwork during the pandemic situation. This research occurred when all Irish third-level institutions lectures and tutorials moved online, and access to survey equipment for fieldwork was severely reduced. The …