Architectural Engineering Commons^™

Measuring Rheological Properties Of Cement Pastes: Most Common Techniques, Procedures And Challenges, Dimitri Feys, Rolands Cepuritis, Stefan Jacobsen, Karel Lesage, Egor Secrieru, Ammar Yahia

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

The Science of Rheology is Increasingly Used to Describe the Properties of Fresh Cement Paste. Compared to Standard Workability Tests, Rheological Properties Allow for More Fundamental Investigation, More Precise Phenomenological Description of Flow Properties and Serve as Input for Numerical Simulations. Standard Commercially Available Rheometers Are Typically Used to Perform Those Measurements. However, the Results of the Measurement Depend on the Geometry, Testing Procedure and a Number of Potential Artefacts. This Technical Letter Describes the Most Common Techniques and Procedures Used to Assess the Rheological Properties of Cement Paste, as Well as Challenges during Measurements and Actions to Counter These …

Impact Of Surface Ozone Interactions On Indoor Air Chemistry: A Modeling Study, M. Kruza, A. C. Lewis, G. C. Morrison, N. Carslaw

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

An INdoor air Detailed Chemical Model was developed to investigate the impact of ozone reactions with indoor surfaces (including occupants), on indoor air chemistry in simulated apartments subject to ambient air pollution. The results are consistent with experimental studies showing that approximately 80% of ozone indoors is lost through deposition to surfaces. The human body removes ozone most effectively from indoor air per square meter of surface, but the most significant surfaces for C6-C10 aldehyde formation are soft furniture and painted walls owing to their large internal surfaces. Mixing ratios of between 8 and 11 ppb of C6-C10 aldehydes are …

Bim+Blockchain: A Solution To The Trust Problem In Collaboration?, Malachy Mathews, Dan Robles, Brian Bowe

Conference papers

This paper provides an overview of historic and current organizational limitations emerging in the Architecture, Engineering, Construction, Building Owner / Operations (AECOO) Industry. It then provides an overview of new technologies that attempt to mitigate these limitations. However, these technologies, taken together, appear to be converging and creating entirely new organizational structures in the AEC industries. This may be characterized by the emergence of what is called the Network Effect and it’s related calculus. This paper culminates with an introduction to Blockchain Technology (BT) and it’s integration with the emergence of groundbreaking technologies such as Internet of Things (IoT), Artificial …

Perception Of Spatial Impression Due To Varying Positions Of The Source On Stage, Sungbeen Cho

Durham School of Architectural Engineering and Construction: Dissertations, Theses, and Student Research

The listener’s surrounding environment affects the perception of sound. The environment includes physical factors such as space size, shape, and finish materials, and psychological factors such as individual difference of impression, and vision. Acoustic spatial impression can be defined as the concept of the type and size of space at which a listener arrives spontaneously when he/she is exposed to an appropriate sound field. This thesis analyzes how physical factors in enclosed spaces affect the acoustic spatial impression, and how sound sources at different positions on stage are perceived in different shapes of spaces.

First, existing spatial impression parameters, IACC …

Hyperelastic Structural Fuses For Improved Earthquake Resilience Of Steel Concentrically-Braced Buildings, Francys López-Mosquera

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Improving structural resilience (i.e., reducing service interruptions and improving rapidity of function restoration) following extreme events is one of the primary contemporary challenges in structural engineering. While massive casualties have successfully been avoided through the adoption of modern building codes, the sole codified performance objective has been limited to the life safety/collapse prevention range of response. Christchurch, NZ, highlighted the insufficiency of this approach, with large sections of the city nonfunctional after a major earthquake, and with subsequent collapses induced by significant aftershocks. Engineering advances to improve building and community resilience are necessary to mitigate hazards from becoming disasters. This …

Bim Innovation Capability Programme Of Ireland, Barry Mcauley, Alan Hore, Roger West

Conference papers

The Irish Government has requested that Enterprise Ireland, an organisation responsible for the development and growth of Irish enterprises in world markets to actively promote the use of BIM in Ireland. This promotion has taken the form of an opportunity for Enterprise Ireland clients to apply for a grant under their BIM Enable and BIM Implementation schemes and also through their funding of the BIM Innovation Capability Programme (BICP) of Ireland. The BICP is a two-year project (2016-2018) which seeks to capture the capability of the Irish Construction Industry and the Higher Education Institutes to respond to the increased requirement …

A Feasibility Investigation Of Modular Portable “Chelson Shelters” Micro-Homes To Alleviate Housing Deficiencies: A Case Study In Mithi, Tharpakar, Pakistan, Muhammad Usman Ghani

Masters Theses & Specialist Projects

Many people in Mithi, Tharparkar do not have proper housing, face an unhygienic water supply, and have no sanitation facilities. These factors contribute to disease, suffering and the inability to rise above their destitute existence. The idea for building portable houses for the people of Mithi is presented to provide them with better living conditions and where they can feel a sense of security, ownership and sanitation. Research on existing building systems and materials showed that the most feasible structure for the desert environment is modular panels attached to a core unit that contains all the basic plumbing and electrical …

The Prevalence Of Six Sigma Trends In The Construction Industry In Pakistan, Muhammad M. Hassan

Masters Theses & Specialist Projects

Economic development in any country or area depends heavily on the performance of the construction industry. This is because the subsequent development of infrastructure increases economic activity, living standards, direct foreign investments, and business opportunities. The construction industry in Pakistan also plays a significant role in its economic activity, and the government’s focus towards increasing infrastructure development provides the construction industry with growth prospects. It is observed that quality management practices in the Pakistan construction industry are highly inadequate to enhance quality. The construction industry there is highly challenged with inadequate delays in projects and project quality. The need for …

Shower Atomization, Chirag Ayappa Ravishankar,

Masters Theses & Specialist Projects

The research will help to design a shower for Dr. Chelson’s shelter, which can control the water flow, pressure and duration of the shower, which optimizes the utilization of water. The showers could be used in drought-hit areas where water is very scarce, as daily sanitation needs are necessary to keep a person safe and healthy without wasting water. The report from, World Health Organization shows that showers consume the most water. A timed shower could help resolve this issue through eliminating the wastage. Eco-friendly environmentalists may also be attracted to the showers, as their main purposes are to save …

Examination Of Leed Certified Building’S Electricity Usage, Nasim Amiri

Masters Theses & Specialist Projects

The number of buildings seeking LEED certification has been growing steadily over the past few years. In this study, three academic buildings which were designed and built to LEED certification standards were targeted in Bowling Green, Kentucky. Their electricity consumption and cost effectiveness were examined and compared with predesigned LEED efficiency models of those three buildings. This research directly examined cost effectiveness of LEED buildings in terms of electricity usage. Three case studies were completed to find the initial and on-going electricity costs of LEED buildings and to verify the LEED standard results. LEED aspects of these buildings were discussed …

Holistic Interdisciplinary Design - Everyone Does Everything (Engineering Students As Sculptors), Craig Baltimore, Allen C. Estes

Architectural Engineering

The ability to offer students an interdisciplinary experience under a team work setting is invaluable in preparation for a career in the built environment. A hands-on approach coupled with a real project presents unique opportunities in student learning. Learning in regards to the dynamics of team personalities, deadlines, approval procedures, and deliverables. One such hands-on based real project was to design, build, and install an 800 lb., 20 ft. long, and 10 ft. tall sculpture. The sculpture was to be built of recycled steel of a mustang in 10 weeks for the University’s library Spring 2016 exhibit. The project gave …

Motivating And Investing In The Freshmen: Paving The Way For The Future, Allen Estes, John Lawson

Architectural Engineering

This paper describes an introductory freshman experience course, “Introduction to Building Systems” that was seven years in the making and meets several critical goals for this engineering department. As one of their very first courses, this two-unit course is taken in the Fall quarter by every incoming freshman, which translates into an annual enrollment of 50 to 120 students, depending on the year. Meeting twice a week, the first meeting is in a large lecture format where all of the students are together and are introduced to the topic for the week which includes structural systems, timber, concrete, steel, earth/foundations, …

Developing A Robust Teaching Portfolio As A Doctoral Student In A Research-Intensive Engineering Program, Anahid A. Behrouzi

Architectural Engineering

Successful faculty applications to teaching/undergraduate institutions can be difficult for doctoral students transitioning directly from a research-intensive engineering program. Oftentimes, these prospective faculty members have limited opportunities to engage in engineering education research, to serve as a primary instructor for a lecture course, or to receive adequate mentoring to prepare them for the environment of a teaching/undergraduate institution.

This paper will highlight the lessons learned by a new faculty member at a top-ranked undergraduate institution (and recent doctoral candidate at a R1 research institution) about how students can build a comprehensive teaching portfolio outside of the traditional coursework and research …

Gas Collection, Haorong Li, Yanshun Yu, Daihong Yu

Durham School of Architectural Engineering and Construction: Faculty Publications

A system includes a vessel configured to couple with a gas source for drawing gas into the vessel. The vessel is also configured to receive liquid. The system includes an over flow port in fluid communication with the environment external to the vessel. The overflow port is configured to separate gas within the vessel from the external environment. The system also includes an overflow conduit having an end within the overflow port so that when gas pressure within the vessel increases, liquid is received by the over flow conduit. Another system includes a tank defining an air space for receiving …

Implementing Subspace Identification On Shake Table Model, Zoe T. Cooperband

Architectural Engineering

Stochastic Subspace Identification is a field of applied mathematics that takes collected experimental time-history data and gives out information about the system that produced the data. SSI is typically used in control analysis but here we apply the methods to the modal analysis of structures. This senior project didn’t involve theory - instead much of the work was in research behind how Subspace Identification works, implementing the algorithm in MATLAB, and applying the program to shake table data to validate the program. In other words, building the framework to make SSI a usable tool and practical learning experience for other …

Structural Analysis Of Overhead Crane In Simpson Strong-Tie Laboratory, Amy Poehlitz

Architectural Engineering

No abstract provided.

Mano De La Amistad: A Thin Shell Concrete Structure Designed For The People Of Havana, Cuba, Peter Aster, Marta Blachowicz-Scott, Aaron Cook, Alex Erler, Elizabeth Townsend, Ger Yang

Architectural Engineering

In designing a thin shell structure to cover the performance space on Tribuna Anti Imperialista Jose Marti, in Havana, Cuba, we developed a heavily symbolic concept and further abstracted it to reach our design. Basing the concept on the quote to the right by Obama about US and Cuba relations, we wanted our design to be representative of a hand that works to adjoin the plaza to the US Embassy which is directly west of the site. The “wrist” portion adds an asymmetric element, while the fingers provide a backdrop to the performers as well as a view through to …

Mt. Carmel Shade Structure, Sonny Moraga, Adam Maclean, Julian Reyes, Christopher Carter

Architectural Engineering

The Mt. Carmel Shade Structure incorporated the efforts of students practicing Architectural Engineering and Construction Management disciplines. The project consisted of designing, engineering and constructing a steel frame structure for the benefit of Mt. Carmel Church and its associated preschool.

Masonry Core Testing, Enrico Aldo Alvaro, Onessa Wyleen Fernandez Anastasio

Architectural Engineering

No abstract provided.

The Ginkgo Shell, Mark Luzi, Karla Santos, Josh Cannon, Erika Davis, Nora Villanueva

Architectural Engineering

The overall concept for this outdoor concrete shell structure, located in Furstliche Park in Inzigkofen, Germany, is derived from an abstracted ginkgo leaf. Drawing on inspiration from a poem about the two parts of the ginkgo leaf becoming one, we took the approach of combining both the natural and built environment into one cohesive piece. To connect the two, it was imperative that we place the shell on the site as to have the smallest impact. With a small portion of the overall site used, the unoccupied space further enhances the natural environment. Creating a literal design connection between the …