Oil, Gas, and Energy Commons^™

Identification Of ‘Carbon Hot-Spots’ And Quantification 1 Of Ghg Intensities In The Biodiesel Supply Chain Using Hybrid Lca And Structural Path Analysis, Adolf Acquaye, Thomas Wiedmann, Kuishang Feng, Robert Crawford, John Barrett, Johan Kuylenstierna, Aidan Duffy, Lenny Koh, Simon Mcqueen-Mason

Articles

It is expected that biodiesel production in the EU will remain the dominant contributor as part of a 10% minimum binding target for biofuel in transportation fuel by 2020 within the 20% renewable energy target in the overall EU energy mix. Life cycle assessments (LCA) of biodiesel to evaluate its environmental impacts have, however, remained questionable, mainly because of the adoption of a traditional process analysis approach resulting in system boundary truncation and because of issues regarding the impacts of land use change and N2O emissions from fertiliser application. In this study, a hybrid LCA methodology is used to evaluate …

Why Do Some Nations Have More Renewable Energy Policies?, Melissa Dahl

Political Science Theses and Capstones

Some nations have considerably more renewable energy policies than others and this research is attempting to discover why. Renewable energy use is quickly growing in our world and has become a major topic in today’s politics. Existing literature suggests various theories as to why some nations have more renewable energy policies than others. I test these theories with data from two major data sources; REN21, the Renewable Energy Policy Network for the 21st Century, and the International Energy Agency. I anticipate that nations with a larger number of effective political parties, higher GDPs, and larger population would have more renewable …

Measuring Progress With Normalized Energy Intensity, Nathan Lammers, J. Kelly Kissock, Brian Abels, Franc Server

Mechanical and Aerospace Engineering Faculty Publications

Energy standard ISO 50001 will require industries to quantify improvement in energy intensity to qualify for certification. This paper describes a four-step method to analyze utility billing, weather, and production data to quantify a company's normalized energy intensity over time. The method uses 3-pararameter change-point regression modeling of utility billing data against weather and production data to derive energy signature equations. The energy signature equation is driven by typical weather and production data to calculate the 'normal annual consumption', NAC, and divided by typical production to calculate 'normalized energy intensity' NEI. These steps are repeated on sequential sets of 12 …

Improving Compressed Air Energy Efficiency In Automotive Plants: Practical Examples And Implementation, Nasr Alkadi, J. Kelly Kissock

Mechanical and Aerospace Engineering Faculty Publications

The automotive industry is the largest industry in the United States in terms of the dollar value of production [1]. U.S. automakers face tremendous pressure from foreign competitors, which have an increasing manufacturing presence in this country. The Big Three North American Original Equipment Manufacturers (OEMs)-General Motors, Ford, and Chrysler-are reacting to declining sales figures and economic strain by working more efficiently and seeking out opportunities to reduce production costs without negatively affecting the production volume or the quality of the product. Successful, cost-effective investment and implementation of the energy efficiency technologies and practices meet the challenge of maintaining the …

Regional Drilling Activity In The Bakken And Three Forks Formation Of North Dakota, University Of North Dakota. Energy And Environmental Research Center

EERC Maps and Infographics

Map of oil wells in western North Dakota. Includes wells with a spud date prior to April 2011. Map sponsors are illustrated by company logos.

Las Negociaciones Entre Las Comunidades Nativas Machiguengas Y La Industria Extractiva Dentro Del Proyecto Camisea: Asesorando Los Roles De Y Las Interacciones Entre Los Actores, Julia Kim

Independent Study Project (ISP) Collection

En esta investigación, estudié cuales eran los roles de actores diferentes en las negociaciones entre las comunidades nativas amazónicas (CC.NN.) y las empresas extractivas dentro del contexto del Proyecto Gas de Camisea (PGC), uno de los proyectos de extracción más importantes en todo America del Sur. Mis objetivos principales eran conocer el rol de cada actor – las CC.NN., las empresas extractivas, el estado, las ONGs, y la misión católica – en las negociaciones y entender como se interactúan y se relacionan. Completé estos objetivos por la siguiente metodología: entrevistas abiertas en Quillabamba, Koribeni, Monte Carmelo, y Kiteni en la …

Approaches To Alternative Energy Policy: A Comparison Of The United States And Germany, Martina Dzuna

Environment and Sustainability Honors Papers

This paper will examine the types of alternative energies that are available at this point, focus on the formation of markets for alternative energy and discuss how new energy technology enters and then diffuses into the markets. Along with energy technology diffusion, this paper will examine how policy structures make technology diffusion possible and which types of policy are most effective. To answer this question, the report uses Germany and the United States as case studies. From the case studies, we will be able to draw some conclusions about what makes some policies more successful than others, and make recommendations …

Wind For Schools: Fostering The Human Talent Supply Chain For A 20% Wind Energy Future, Ian Baring-Gould

Publications (E)

As the United States dramatically expands wind energy deployment, the industry is challenged with developing a skilled workforce and addressing public resistance. Wind Powering America’s Wind for Schools project addresses these issues by:
• Developing Wind Application Centers (WACs) at universities; WAC students assist in implementing school wind turbines and participate in wind courses
• Installing small wind turbines at community “host” schools
• Implementing teacher training with interactive curricula at each host school.

Factors Of Environmental Sustainability For Africa, Asia, And Latin America, Jacob Converse

Political Science Theses and Capstones

This study incorporates and analyzes several theories in regards to what causes countries to perform in an environmentally sustainable manner. This has been and is becoming an increasingly important and debated topic due to the ever increasing interest and concern about global environmental challenges. This issue has been examined through a variety of different lenses including economic, socio-political, and geographical perspectives and they have an assortment of results. One such existing finding suggests that the best way to improve a country’s environmental sustainability is to first focus on improving the gross domestic product which will eventually allow changes to take …

Correlations Of Capacitance-Voltage Hysteresis With Thin-Film Cdte Solar Cell Performance During Accelerated Lifetime Testing, David S. Albin, Joseph A. Del Cueto

Publications (E)

In this paper we present the correlation of CdTe solar cell performance with capacitance-voltage hysteresis, defined presently as the difference in capacitance measured at zero-volt bias when collecting such data with different pre-measurement bias conditions. These correlations were obtained on CdTe cells stressed under conditions of 1-sun illumination, open-circuit bias, and an acceleration temperature of approximately 100 ºC.

Use Of 2nd And 3rd Level Correlation Analysis For Studying Degradation In Polycrystalline Thin-Film Solar Cells, David S. Albin, Joseph A. Del Cueto, S. H. Demtsu, S. Bansal

Publications (E)

The correlation of stress-induced changes in the performance of laboratory-made CdTe solar cells with various 2^nd and 3^rd level metrics is discussed. The overall behavior of aggregated data showing how cell efficiency changes as a function of open-circuit voltage (V_oc), shortcircuit current density (J_sc), and fill factor (FF) is explained using a two-diode, PSpice model in which degradation is simulated by systematically changing model parameters. FF shows the highest correlation with performance during stress, and is subsequently shown to be most affected by shunt resistance, recombination and in some cases voltage-dependent collection. Large decreases …

Effect Of Hysteresis On Measurements Of Thin-Film Cell Performance, David S. Albin, Joseph A. Del Cueto

Publications (E)

Transient or hysteresis effects in polycrystalline thin film CdS/CdTe cells are a function of pre-measurement voltage bias and whether Cu is introduced as an intentional dopant during back contact fabrication. When Cu is added, the current-density (J) vs. voltage (V) measurements performed in a reverse-to-forward voltage direction will yield higher open-circuit voltage (V_oc), up to 10 mV, and smaller short-circuit current density (J_sc), by up to 2 mA/cm², relative to scanning voltage in a forward-to-reverse direction. The variation at the maximum power point, Pmax, is however small. The resulting variation in FF can be …

High Efficiency, Low Cost Solar Cells Manufactured Using ‘Silicon Ink’ On Thin Crystalline Silicon Wafers October 2009 - November 2010, Homer Antoniadis

Publications (E)

The objectives of Phase I (Feb – Oct 2009) include the development and demonstration of a 17% efficient 25mm x 25mm crystalline Silicon solar cell and a 16% efficient 125mm x 125mm crystalline Silicon solar cell, both produced by Ink-jet printing Silicon Ink on a thin crystalline Sil-icon wafer. To achieve these objectives, processing approaches were developed to print the Silicon Ink in a predetermined pattern to form a high efficiency selective emitter, remove the solvents in the Silicon Ink and fuse the deposited particle Silicon films. Additionally, standard solar cell manufacturing equipment with slightly modified processes were used to …

Hybrid Cooling Systems For Low-Temperature Geothermal Power Production, Andrea Ashwood, Desikan Bharathan

Publications (E)

The overall objective of this investigation is to identify and evaluate methods by which the net power output of an air-cooled geothermal power plant can be enhanced during hot ambient conditions using minimal amounts of water.

Geothermal power plants that use air-cooled heat rejection systems experience a decrease in power production during hot periods of the day. This decrease in power output typically coincides with the time when utilities need power to address high air conditioning loads. Hybrid cooling options, which use both air and water, have been studied for this report to assess how they might mitigate the net …

The Silver Spark For Nevada, Walt Borland, James A. Croce, Richard Seline

Publications (E)

The SILVER Spark for Nevada: Sustainable Innovation Leading a Vital Economic Renaissance

Nevada. A State of stark contrasts, with historic booms and devastating busts experienced throughout its modern history. A State frequently forced to reinvent itself as ever-evolving circumstances have demanded. A State that has been driven to the edge time after time and, yet again and again, has managed to discover another way to prosper. A State that now finds itself in a precarious position as the “Great Recession” hit it harder than any other and has left it struggling to recover.

As you will conclude by reading The …

Measuring Degradation Rates Without Irradiance Data, Steve Pulver, Daniel Cormode, Alex Cronin, Dirk C. Jordan, Ryan Smith, Sarah R. Kurtz

Publications (E)

A method to report PV system degradation rates without using irradiance data is demonstrated. First, a set of relative degradation rates are determined by comparing daily AC final yields from a group of PV systems relative to the average final yield of all the PV systems. Then, the difference between relative and absolute degradation rates is found from a statistical analysis. This approach is verified by comparing to methods that utilize irradiance data. This approach is significant because PV systems are often deployed without irradiance sensors, so the analysis method described here may enable measurements of degradation using data that …

Accelerated Stress Testing Of Hydrocarbon-Based Encapsulants For Medium-Concentration Cpv Applications, M. D. Kempe, T. J. Moricone, M. Kilkenny, J. Z. Zhang

Publications (E)

Concentrating photovoltaic (CPV) systems have great potential to reduce photovoltaic (PV) electricity costs because of the relatively low cost of optical components as compared to PV cells. A transparent polymeric material is used to optically couple the PV cell to optical components and is thus exposed to the concentrated light source at elevated temperatures. In this work polymeric encapsulant materials are positioned close to a Xenon arc lamp to expose them to ultraviolet radiation (UV) that is about 42 times as intense as sunlight. Furthermore, different glass types are used as filters to modify the spectral distribution of light in …

Creep In Photovoltaic Modules: Examining The Stability Of Polymeric Materials And Components, David C. Miller, Michael D. Kempe, Stephen H. Glick, Sarah R. Kurtz

Publications (E)

Interest in renewable energy has motivated the implementation of new polymeric materials in photovoltaic modules. Some of these are non-cross-linked thermoplastics, in which there is a potential for new behaviors to occur, including phase transformation and visco-elastic flow. Differential scanning calorimetry and rheometry data were obtained and then combined with existing site-specific time-temperature information in a theoretical analysis to estimate the displacement expected to occur during module service life. The analysis identified that, depending on the installation location, module configuration and/or mounting configuration, some of the thermoplastics are expected to undergo unacceptable physical displacement. While the examples here focus on …

Impacts Of Mid-Level Biofuel Content In Gasoline On Sidi Engine-Out And Tailpipe Particulate Matter Emissions, Xin He, John C. Ireland, Bradley T. Zigler, Matthew A. Ratcliff, Keith E. Knoll, Teresa L. Alleman, John T. Tester

Publications (E)

In this work, the influences of ethanol and iso-butanol blended with gasoline on engine-out and post three-way catalyst (TWC) particle size distribution and number concentration were studied using a General Motors (GM) 2.0L turbocharged spark ignition direct injection (SIDI) engine. The engine was operated using the production engine control unit (ECU) with a dynamometer controlling the engine speed and the accelerator pedal position controlling the engine load. A TSI Fast Mobility Particle Sizer (FMPS) spectrometer was used to measure the particle size distribution in the range from 5.6 to 560 nm with a sampling rate of 1 Hz. U.S. federal …

Considerations For How To Rate Cpv, Sarah R. Kurtz, Matthew Muller, Bill Marion, Keith Emery, Robert Mcconnell, Sandheep Surendran, Adrianne Kimber

Publications (E)

The concentrator photovoltaic (CPV) industry is introducing multiple products into the marketplace, but, as yet, the community has not embraced a unified method for assessing a nameplate rating. The choices of whether to use 850, 900, or 1000 W/m² for the direct-normal irradiance and whether to link the rating to ambient or cell temperature will affect how CPV modules are rated and compared with other technologies. This paper explores the qualitative and quantitative ramifications of these choices using data from two multi-junction CPV modules and two flat-plate modules.