Food Processing Commons^™

Effects Of Thermal Processing On Peach Puree Of Different Cultivars: Analysis Of Biochemical Alteration, Non-Enzymatic Browning Reaction, And Color Changes, James Hayes

All Theses

The effects of pasteurization temperature and time on the change in seven peach puree variables over a 6-week accelerated shelf-life test (35°C) were evaluated. The variables of interest were three color measures [ L* (lightness), a* (redness), and b* (yellowness)]; two brown pigment measures [spectrophotometric absorption at 420 nm (Browning Index) and 443 nm (Hydroxymethylfurfural)]; °Brix; and pH). Puree was collected from three different cultivars (2 freestone and 1 clingstone) and puree samples from each cultivar were subjected to 20 combinations of pasteurization temperatures (70°C, 80°C, 90 °C, 100°C) and same hold times (0 minutes, 1 minute, 3 minutes, 5 …

Evaluation Of Human Microbiota-Associated (Hma) Porcine Models To Study The Human Gastrointestinal Microbiome, Nirosh D. Aluthge

Department of Food Science and Technology: Dissertations, Theses, and Student Research

Research conducted in the past couple of decades has showcased the importance of the gut microbiota in human health and well-being. While many studies have reported on the differences in community membership between a disease state and a healthy state, few have investigated the mechanisms through which an aberrant microbiota contributes to a disease phenotype. One of the primary reasons for this are the many technical and ethical barriers to conducting the necessary studies directly in human individuals. Human microbiota-associated (HMA) porcine models have the potential to become important research tools which can enable the testing of hypotheses regarding host-microbiota …

To The Window, To The Wall: Improving Environmental Monitoring Protocols, Sarah Jones

Graduate Theses and Dissertations

Detecting microorganisms on environmental surfaces via an environmental monitoring (EM) program is part of a preventive food safety culture. Environmental monitoring should 1) verify that food safety plans are reducing cross-contamination risk from surfaces to food, 2) pinpoint microbial niches, and 3) prevent the transmission of pathogens. Environmental monitoring programs utilize EM tools, such as sponges, to sample food contact and non-food contact surfaces. However, EM tool selection is determined by the individual food firm. This dissertation evaluated and characterized factors influencing EM program effectiveness in the food industry. Specifically, this dissertation focuses on the release of microorganisms from EM …

Arkansas Fresh-Market Blackberries: Identifying Unique Attributes And Harvest Practices That Impact Marketability, Andrea Lea Myers

Graduate Theses and Dissertations

Fresh-market blackberries (Rubus subgenus Rubus) are sold worldwide and have attributes that appeal to consumers. The delicate-nature of the fruit requires hand harvesting, and minimal handling of the fruit postharvest. Objectives of this research on Arkansas fresh-market blackberries was to 1) identify the unique attributes 2) determine the best handling practices to increase postharvest quality, and 3) evaluate the potential of soft robotic gripper for harvesting. For the first objective, blackberry genotypes were harvested from the University of Arkansas System (UA System) Division of Agriculture Fruit Research Station in Clarksville, AR. Nineteen genotypes were harvested in 2020, eight genotypes were …

A Mixed Methods Approach To Context Specific Curriculum Design For Very Small And Small Strawberry Growers In The Southeastern United States, Thomas A. Yeargin

Graduate Theses and Dissertations

Outbreaks of foodborne illness due to fresh produce are a continued threat to both the publichealth and the economy in the United States. Though there are many factors which influence the perpetuation of foodborne pathogens, the inability of the food industry to curtail this issue indicates systemic failure of interventions aimed at improving food safety practices. In this dissertation, we detail the efforts made over the past few decades to provide training to food producers and food handlers as well as recommendations that have been made for improvement based on these studies. By borrowing from more advanced fields of study …

Evaluating The Microbial Quality And Use Of Antimicrobials In Raw Pet Foods, Leslie Pearl Cancio

Department of Food Science and Technology: Dissertations, Theses, and Student Research

Raw meat-based diets (RMBDs) are emerging pet foods that pose food safety risks because of the potential presence of pathogens that could cause illness to humans. In this research, the microbial quality of select RMBD products sold by pet food companies online and the use of chemical antimicrobials to reduce the microbial load in chicken liver, a common RMBD ingredient, were evaluated.

Ground meat blends and livers from four animal species (beef, pork, chicken, turkey) were purchased from four online companies that delivers directly to consumers through parcel businesses. Products were procured at three different times during one year and …

A Cookbook For The Trendy Chef, Katja Roberts

Honors Program: Senior Projects (Public)

A Cookbook for the Trendy Chef contains a compilation of recipes which fall under 8 major food trends for 2021. These trends were determined to be vegan, keto, and gluten-free diets, along with “viral foods”, easy recipes, functional foods, international flavors, and comfort foods. These trends were selected based on predictions made by the Institute of Food Technologists (IFT) and the Washington Post.

Knowledge-Informed Data-Driven Modeling Of Microbial Inactivation In Food, Steve Zhang, Firnaaz Ahamed, Hyun-Seob Song

UNL Student Research Days Posters, Graduate

Prevention of the growth of harmful microorganisms in food products is an important requirement for ensuring food safety and quality. Mathematical models to predict the quantitative changes in microbial populations in food to the variations of environmental conditions are useful tools in this regard. Current approaches that use empirical formulation generate arbitrary forms of model equations, impeding systematic analysis towards identifying key factors governing microbial growth and inactivation in food. To address this challenge, we present a data-driven modeling pipeline that enables automatic discovery of model equations (through parsimonious selection of relevant terms in a pre-built library) without having to …

Physicochemical And Pasting Properties Of Flour And Starch From Two New Cassava Accessions, Raphael Aidoo, Ibok Nsa Oduro, Jacob K. Agbenorhevi, William Otoo Ellis, Nana Baah Pepra-Ameyaw

Food Science Faculty Articles and Research

Some new cassava accessions have been developed and released because of their high yield, resistance to disease, adaptability to wider ecological environment, and less cost of production. However, their flour and starch properties have not been characterized for potential food applications. In the present study, starch and flour were produced from two new cassava accessions (Sika Bankye and Bankye Hemaa) and evaluated for their physicochemical and pasting properties. The flour samples recorded higher values for the various functional parameters compared to their starch counterparts. Both flour samples had a similar water absorption capacity (WAC) of ~263% but the associated …

Fabrication Of Porous Spherical Beads From Corn Starch By Using A 3d Food Printing System, Safoura Ahmadzadeh, Ali Ubeyitogullari

Food Science Faculty Publications and Presentations

This study introduces a 3D food printing approach to fabricate spherical starch beads with small sizes and high porosity for the first time. The results illustrated that 3D food printing could generate starch beads in different sizes depending on the nozzle diameter, printing pressure, and ink viscosity. The 3D-printed beads were characterized for their morphology, crystallinity, and textural properties, while the starch-based ink was analyzed for its rheological properties. A suitable printing was attained when viscosity was in the range of 1000–1200 Pa.s at a low shear rate (˂0.1 s−1). Among the starch concentrations (10–15%, w/w) investigated, 15% starch concentration …

Community Solar Dehydrator Plans, Kate Weigel, Roslynn Mccann

All Current Publications

As interest in home gardening and self sufficiency surged during the pandemic, many are looking for ways to preserve foods from their newfound harvests. This fact sheet provides an overview of how to build a community solar food dehydrator for food preservation, based on our experience doing so for the community of Moab, Utah. A list of needed building materials, tools, and specific plans are included.

Effect Of Very High Frequency Microwave Light On Bread Properties, Dilrabo Tuychieva, Gulnoza Djakhangirova, Yodgorbek Ismoiljonov

CHEMISTRY AND CHEMICAL ENGINEERING

The purpose of the research was to study the effect of microwave on the baking properties of flour obtained from disinfected wheat grain. Trial laboratory baking from grain decontaminated by microwave was carried out. The main physical and chemical indicators of the quality of bakery products are humidity; acidity and porosity. As the object of the study, we used shaped and hearth bread from flour of the 1st grade, made from grain disinfected by microwave. The most acceptable parameters of neutralization were identified, in particular, the duration of exposure to microwave and the amount of power at which the studied …

Investigation Of The Process Of Cotton Cake Extraction Under The Influence Of Pulsed Electric Current, Fazliddin Kayimov, Kakhramon Majidov, Nargiza Sabirova

CHEMISTRY AND CHEMICAL ENGINEERING

The aim of work is study the process of cotton cake extraction by exposure to pulsed electric current. The kinetic equations determined the dependences of technological parameters on external and internal factors. It is established that the technological parameters determine the choice of appropriate dependencies for calculating the parameters of the kinetic equation. Mathematical processing and planning of the experimental data results conducted for extraction of cotton cake.

Activation Of Water Used In The Preparation Of Wheat Grain For Varietal Milling, Suvankul Ravshanov, Ismoil Isabaev

CHEMISTRY AND CHEMICAL ENGINEERING

The purpose of the study is to change the properties of water in order to achieve the optimum impact on wheat grain in preparation for variety milling. The results of influence on the properties of drinking water by acoustic waves in the frequency range of 10-1000 Hz for 1 minute were determined. It is established that the optimal range of exposure is the interval of 80-100 Hz. At the same time water activation is achieved, leading to changes in its properties, such as specific water resistance, electric conductivity, content of dissolved salts, which positively affects the technological indicator - the …

The Poultry Industry And Its Environmental Impacts, Mohamed Taha El-Barbary M.A. Omar

Archived Theses and Dissertations

No abstract provided.

Effects Of Thickness Fraction Process On Physicochemical Properties, Cooking Qualities, And Sensory Characteristics Of Long-Grain Rice Samples, Sara E. Jarma Arroyo, Terry J. Siebenmorgen, Han-Seok Seo

Food Science Faculty Publications and Presentations

A process of removing thinner kernels of rough rice, i.e., thickness fraction process, has been suggested as a method for increasing milling yields in the rice industry. This study aimed at determining whether physicochemical properties, cooking qualities, and sensory characteristics of rice samples could be changed by the addition of a thickness fraction into the rice process stream. Each of four long-grain rice cultivar lots was assigned into two groups: unfractionated and thickness-fractionated. For the thickness-fractionated group, thin rice kernels (

High Resistant Starch Rice: Variation In Starch Related Snps, And Functional, And Sensory Properties, Ming Hsuan Chen, Karen Bett-Garber, Jeanne Lea, Anna Mcclung, Christine Bergman

Hospitality Faculty Research

Human diets containing greater resistant starch (RS) are associated with superior glycemic control. Although high amylose rice has higher RS (29 g/kg to 44 g/kg) than lower amylose content varieties, sensory and processing properties associated with RS have not been evaluated. This study used variants of Waxy and starch synthase II a (SSIIa) genes to divide high amylose (256 g/kg to 284 g/kg) varieties into three haplotypes to examine their effects on RS, RVA parameters, and 14 cooked rice texture properties. RVA characteristics were influenced by both genes with peak and hotpaste viscosity differentiating the three haplotypes. Setback from hotpaste …

A Process To Produce Lactose Phosphate From Dairy Byproducts And Used As An Alternative To Emulsifying Salts In Processed Cheese Food Manufacture, Khalid Ahmed Alsaleem

Electronic Theses and Dissertations

Lactose is the primary carbohydrate in most mammals' milk, commonly known as milk sugar. Milk permeate is a by-product of whey protein manufacturing through membrane technologies. It is cost-effective, available, and an excellent source of lactose. Sugar phosphorylation is a technique used to alter sugar's characteristics. It has numerous applications for developing dairy and food products. Lactose-6-phosphate (LP) is an organic compound that switches the hydrogen on lactose by monophosphate that has the potential to function as emulsifying salts (ES). ES, such as disodium phosphate (DSP) and trisodium citrate, have a critical effect on the emulsification characteristics of casein by …

Autonomous Coffee Brewing System, Lillian Gonzalez, Landon Miller, Tyler Moff, Benjamin Vitu

Williams Honors College, Honors Research Projects

Coffee consumers want an affordable, high-quality cup of coffee that takes minimal time to brew and does not excessively contribute plastic to landfills. A fully autonomous system which utilizes whole coffee beans, water, and filters to brew coffee was designed to meet this need. This system accepts user requests which specify the brew’s portion size, water temperature, and brew strength, as well as the time which the system should begin the brewing process. Occasional maintenance to empty the system’s built-in waste receptacle or resupply the system with water, coffee beans, or filters is the only user intervention required. This report …

The Relationship Between Food Retailers And Distributors, Madison Seigler, Julia Anderson, Aidan Morton, Cassandra Williams, Victoria Bloomgren, Jacob Tutty

Undergraduate Theses, Professional Papers, and Capstone Artifacts

Our understanding of the science of anthropogenic climate change and its immediate and indirect impacts has grown within the last decade.Alongside anincrease in concern for the inequities within the industrialized food system, climate change is impacting agriculture and the communities that depend on it in myriad ways. These challenges have catalyzed investment in sustainable agriculture, “eat local” food movements, and rethinking of all aspects of food systems, including consumers, producers, retailers, and distributors. The body of literature on food systems primarily focuses on the connection between consumers and retailers; however, there is a notable absence of literature on the relationships …