Open Access. Powered by Scholars. Published by Universities.®

Semiconductor and Optical Materials Commons™

Open Access. Powered by Scholars. Published by Universities.®

Theses and Dissertations

Discipline
Institution
Keyword
Publication Year

Articles 91 - 106 of 106

Full-Text Articles in Semiconductor and Optical Materials

Rapid And Accurate Timing Simulation Of Radiation-Hardened Digital Microelectronics Using Vhdl, Charles P. Brothers Jr. Mar 1994

Rapid And Accurate Timing Simulation Of Radiation-Hardened Digital Microelectronics Using Vhdl, Charles P. Brothers Jr.

Theses and Dissertations

This dissertation presents the development of a fast, accurate, timing simulation capability based on VHSIC Hardware Description Language VHDL without the use of back annotation of timing delay information. This VHDL-based timing simulator is intended for use with radiation-hardened microelectronics in simulating timing of circuit operation in pre-radiation, post-radiation 1 MradSi total dose, and ionizing dose radiation environments. Development of the timing models are presented. The implementation of the timing models are incorporated into a VHDL library composed of basic logic gates and flip-flops. Simulations of complex circuits were run in SPICE and VHDL to assess the timing accuracy and …

Go to article

Influence Of Embedded Optical Fibers On Compressive Strength Of Advanced Composites, Stefan B. Dosedel Dec 1993

Influence Of Embedded Optical Fibers On Compressive Strength Of Advanced Composites, Stefan B. Dosedel

Theses and Dissertations

This study investigated the effects of embedding optical fibers into advanced composite materials. This combination was meant to simulate 'smart structures' that have been shown to sense several different variables in the composite including strain, temperature, and damage. A laminate orientation taken from an existing aircraft structure was used to fabricate sixteen groups of specimens which were subjected to compression testing in an IITRI fixture to determine the ultimate compressive strength and modulus of elasticity. Ten of these groups were fabricated with optical fibers while the other six were control groups and contained no optical fibers. This study showed that …

Go to article

The Effects Of Optical Feedback On Polarization Of Vertical Cavity Surface Emitting Lasers, Gregory J. Vansuch Dec 1993

The Effects Of Optical Feedback On Polarization Of Vertical Cavity Surface Emitting Lasers, Gregory J. Vansuch

Theses and Dissertations

Vertical Cavity Surface Emitting Lasers VCSELs are a type of semiconductor laser with a cavity oriented orthogonally to the planes of material growth. These lasers differ from conventional edge emitting lasers in several important ways. They have symmetric output beams and they are easily built into two dimensional arrays, making them very attractive as photonic components. The characteristic of interest in this thesis is polarization. While the asymmetric cavities of edge emitters exhibit a clear preference for light polarized in a particular direction, the cylindrically symmetric cavity of a VCSEL has no clear preference. Therefore, it should be relatively easy …

Go to article

Design And Performance Evaluation Of A Gas Chromatograph Micromachined In A Single Crystal Silicon Substrate, Rocky R. Reston Mar 1993

Design And Performance Evaluation Of A Gas Chromatograph Micromachined In A Single Crystal Silicon Substrate, Rocky R. Reston

Theses and Dissertations

This investigation designed and developed a miniature gas chromatograph (GC) using silicon micromachining techniques. The GC is composed of a miniature sample injector (10 µl sample loop); a 0.9 m long, rectangular-shaped (300 µm width and 10 micrometers height) capillary column coated with a 0.2 µm thick copper phthalocyanine (CuPc) stationary phase; and a dual-detector scheme incorporating a CuPc-coated chemiresistor and a 125 µm diameter thermal conductivity detector bead. Micromachining was employed to fabricate the sample injector interface, the GC column, and the dual-detector cavity. A novel processing technique was developed to sublime the CuPc stationary phase coating on the …

Go to article

Luminescence Study Of Ion-Implanted And Mbe-Grown Er-Doped Gaas And AlXGa1-XAs, Jose E. Colon Mar 1993

Luminescence Study Of Ion-Implanted And Mbe-Grown Er-Doped Gaas And AlXGa1-XAs, Jose E. Colon

Theses and Dissertations

The excitation and de-excitation mechanisms of the 1.54 microns emissions, from ion implanted and MBE grown GaAs:Er and AlxGa1-xAs:Er, were studied through luminescence experiments. Experimental techniques included photoluminescence, time resolved photoluminescence, and selective excitation photoluminescence. The Er3+ emissions were studied as a function of Er concentration, aluminum mole friction, n- and p-type doping level, and annealing temperature. In addition oxygen co-doping studies were done in order to determine the role played by oxygen in the Er3+ luminescence.

Go to article

Phase Conjugation In Optical Fiber Via Stimulated Brillouin Scattering With Feedback From A Barium Titanate Crystal, Patrick R. Emmert Dec 1992

Phase Conjugation In Optical Fiber Via Stimulated Brillouin Scattering With Feedback From A Barium Titanate Crystal, Patrick R. Emmert

Theses and Dissertations

The goal of this thesis was to obtain phase conjugation in multi-mode optical fiber via stimulated Brillouin scattering (SBS) with the aid of a barium titanate crystal which formed a phase conjugate cavity for the Stokes beam. SBS was demonstrated but the SBS threshold was unaffected by the presence of the barium titanate crystal and no evidence for the presence of phase conjugation in the optical fiber was obtained.

Go to article

Cathodoluminescence Spectroscopy Of Zinc Germanium Phosphide Zngep2, Michael R. Gregg Dec 1992

Cathodoluminescence Spectroscopy Of Zinc Germanium Phosphide Zngep2, Michael R. Gregg

Theses and Dissertations

Zinc Germanium Phosphide (ZnGeP2) is a nonlinear semiconductor suitable for use as a laser tuning element over the two to six micron wavelength range. Although this crystal has been studied in the past, its luminescent properties are not yet well understood. In this present study, ZnGeP2 has been examined using cathodoluminescence spectroscopy (CL). Specifically, the spectral dependence of the CL was obtained as a function of electron beam energy, beam current and temperature. The resulting CL was found to be polarized with a peak structure that was dependent on the polarization. This peak structure observed by CL …

Go to article

The Effect Of Oxide Layers And Boron Doping On The Breakdown Of High Purity Silicon, Brian A. Hibbeln Dec 1992

The Effect Of Oxide Layers And Boron Doping On The Breakdown Of High Purity Silicon, Brian A. Hibbeln

Theses and Dissertations

For many applications such as lasers and radar drive circuits, there exists a need for solid state high voltage, high current switches. Current gaseous discharge switches fail to satisfy the ruggedness, reliability, and lifetime requirements of today's systems. A promising alternative is the Photoconductive Semiconductor Switch (PCSS). The limiting factor in the operation of these switches is the occurrence of breakdown through channels formed slightly below the surface. A theory on the formation of these channels is presented based upon band bending at the metal-semiconductor interface, a nonhomogeneous space charge due to irregular trap distributions, and thermal runaway in localized …

Go to article

Processability Of Polythiophene Thin Films By Ultraviolet Photo Bleaching, Derek D. Fletcher Dec 1992

Processability Of Polythiophene Thin Films By Ultraviolet Photo Bleaching, Derek D. Fletcher

Theses and Dissertations

Materials possessing strong ��(3) optical properties such as Polythiophene are sought for the production of optical switches. Polythiophene thin films produced by plasma enhanced CVD show a surface rms roughness of 10-15 angstroms over single square micron areas which is acceptable for wave guiding in the near IR. This research investigates permanently changing the optical properties of such a thin film by exposure to UV radiation (254 nm, 35 mW/cm2), known as photo bleaching, in hope of creating a refractive index boundary for use in total internal reflection. After 60 minutes exposure the refractive index shows …

Go to article

Excitation And De-Excitation Mechanisms Of Er-Doped Gaas And Algaas, David W. Elsaesser Dec 1992

Excitation And De-Excitation Mechanisms Of Er-Doped Gaas And Algaas, David W. Elsaesser

Theses and Dissertations

Electrical and optical characterization have been performed on GaAs and AlxGa1-xAs samples doped with Er either by ion implantation or during Molecular Beam Epitaxial (MBE) growth. Deep Level Transient Spectroscopy (DLTS) and Temperature-Dependent Hall Effect (TDH) measurements indicated the presence of two hole traps in Er-doped GaAs, at 35 and 360 meV above the valence band maximum. The former (shallower) center was thought to be due to Er substituting for a Ga atom (ErGa) and giving rise to an isoelectronic impurity potential. The second center was attributed to an Er atom occupying an interstitial …

Go to article

A Response Surface Methodology Study Of Ferroelectric Memory Devices, Kevin C. Smith Mar 1992

A Response Surface Methodology Study Of Ferroelectric Memory Devices, Kevin C. Smith

Theses and Dissertations

Fatigue in ferroelectric memory devices was studied. The application of fatigue pulses to a ferroelectric sample was controlled by the RT-66 Ferroelectric Tester, a variation of the Sawyer-Tower circuit. The RT-66 also controlled data collection following the fatiguing process. Seven variables were evaluated for their potential- affect on fatigue. A sequence of fatigue tests, which varied the settings of these variables, was developed using Response Surface Methodology (RSM) experimental designs. Least-squares regression models were developed once a particular RSM set of design experiments was completed. These models were evaluated using RSM tools, and the analysis of these models allowed the …

Go to article

Characterizing The Sensitivity, Selectivity, And Reversibility Of The Metal-Doped Phthalocyanine Thin-Films Used With The Interdigitated Gate Electrode Field-Effect Transistor (Igefet) To Detect Organophosphorous Compounds And Nitrogen Dioxide, Clayton P. Howe Dec 1991

Characterizing The Sensitivity, Selectivity, And Reversibility Of The Metal-Doped Phthalocyanine Thin-Films Used With The Interdigitated Gate Electrode Field-Effect Transistor (Igefet) To Detect Organophosphorous Compounds And Nitrogen Dioxide, Clayton P. Howe

Theses and Dissertations

This study investigated the sensitivity, reversibility, and selectivity of the thin film coatings used on the interdigitated gate electrode field effect transistor (IGEFET) gas microsensor. These responses were quantified based on the dc resistance changes and frequency domain responses of the microsensor. The thin-film materials included: copper phthalocyanine (CuPc), nickel phthalocyanine (NiPc), and cobalt phthalocyanine (CoPc). The challenge gases included: diisopropyl methylphosphonate (DIMP), dimethyl methylphosphonate (DMMP), nitrogen dioxide, ammonia, and boron trifluoride. Tests of the CuPc thin-films and nitrogen dioxide challenges established the primary set of test parameters expected to maximize the selectivity, sensitivity, and reversibility of the thin-film coatings. …

Go to article

Low Temperature Photoluminescence Study Of Holmium And Thulium Implanted Into Iii-V Semiconductors And Silicon, Eric Silkowski Dec 1990

Low Temperature Photoluminescence Study Of Holmium And Thulium Implanted Into Iii-V Semiconductors And Silicon, Eric Silkowski

Theses and Dissertations

Low temperature photoluminescence studies were performed on holmium implanted into InP, GaAs, and Si; and thulium implanted into AlGaAs, GaAs, and Si. Samples were annealed by the conventional furnace and rapid thermal techniques. None of the characteristic 4f emissions of holmium were found in the spectral region of .73 to 1.55 eV. AlGaAs:Tm showed strong thulium emissions in the .93 to 1.03 eV region. These emissions were studied and compared to those in GaAs:Tm. Low and high temperature annealed samples showed evidence of trivalent Tm centers. Temperature dependence studies showed that thulium 4f emissions were present above 200 K but …

Go to article

Angle Of Arrival Detection Through Artificial Neural Network Analysis Of Optical Fiber Intensity Patterns, Scott Thomas Dec 1990

Angle Of Arrival Detection Through Artificial Neural Network Analysis Of Optical Fiber Intensity Patterns, Scott Thomas

Theses and Dissertations

The optical sensors of United States Air Force reconnaissance vehicles, such as satellites, are subject to temporary or permanent blinding from hostile (or threat) laser radiation. By detecting and determining the angle of arrival (AOA) of the hostile radiation, the reconnaissance vehicle may be able to protect its optical sensors by taking evasive maneuvers or by shutting down the optical sensor (such as closing a shutter) until the threat has passed. In addition, the vehicle can relay information to its ground terminal allowing the intelligence community to determine the source of the hostile laser radiation. This thesis demonstrated that an …

Go to article

Fluorescent Lifetime Measurements Of Rare Earth Elements In Gallium Arsenide, Danny J. Topp Dec 1990

Fluorescent Lifetime Measurements Of Rare Earth Elements In Gallium Arsenide, Danny J. Topp

Theses and Dissertations

Lifetime measurements of the excited states of three GaAs semiconductors doped with the rare earth elements Erbium (ER), Praseodymium (Pr) , and Thulium (Tm) has been studied using a pulsed nitrogen laser and germanium detector. The measurements were made with an experimental set up with a system response time of 0.34 micro seconds. A 330 milliwatt nitrogen laser with a wavelength of 3370 angstrums was used to excite transitions of the rare earth elements.

Go to article

Characterization Of Barium Titanate As An Optical Amplifier, George A. Vogel Dec 1990

Characterization Of Barium Titanate As An Optical Amplifier, George A. Vogel

Theses and Dissertations

The introduction of two-beam coupling in photorefractive materials has resulted in an extensive amount of research into their use as optical processing/computing elements. This dissertation develops the theoretical equations for two-beam coupling in barium titanate as an optical amplifier. One of the factors which limits the optical gain in photorefractive crystals is the loss of pump beam power to the amplification of parasitic light (beam fanning). This parasitic light is produced by light scattered from the pump beam by imperfections on both the crystal face and within the crystal. Through the analysis of signal and noise amplification as functions of …

Go to article

First Prev