Power and Energy Commons^™

Investigation Of Cds Nanowires And Planar Films For Enhanced Performance As Window Layers In Cds-Cdte Solar Cell Devices, Jianhao Chen

Theses and Dissertations--Electrical and Computer Engineering

Cadmium sulfide (CdS) and cadmium telluride (CdTe) are two leading semiconductor materials used in the fabrication of thin film solar cells of relatively high power conversion efficiency and low manufacturing cost. In this work, CdS/CdTe solar cells with a varying set of processing parameters and device designs were fabricated and characterized for comparative evaluation. Studies were undertaken to elucidate the effects of (i) each step in fabrication and (ii) parameters like thickness, sheet resistance, light absorptivity solution concentration, inert gas pressure etc. Best results were obtained when the thickness of CdS planar film for the window layer was in the …

Copper Indium Diselenide Nanowire Arrays In Alumina Membranes Deposited On Molybdenum And Other Back Contact Substrates, Bhavananda R. Nadimpally

Theses and Dissertations--Electrical and Computer Engineering

Heterojunctions of CuInSe₂ (CIS) nanowires with cadmium sulfide (CdS) were fabricated demonstrating for the first time, vertically aligned nanowires of CIS in the conventional Mo/CIS/CdS stack. These devices were studied for their material and electrical characteristics to provide a better understanding of the transport phenomena governing the operation of heterojunctions involving CIS nanowires. Removal of several key bottlenecks was crucial in achieving this. For example, it was found that to fabricate alumina membranes on molybdenum substrates, a thin interlayer of tungsten had to be inserted. A qualitative model was proposed to explain the difficulty in fabricating anodized aluminum oxide …

Fpga To Power System Theorization For A Fault Location And Specification Algorithm, Christina Yeoman

Theses and Dissertations--Electrical and Computer Engineering

Fault detection and location algorithms have allowed for the power industry to alter the power grid from the traditional model to becoming a smart grid. This thesis implements an already established algorithm for detecting faults, as well as an impedance-based algorithm for detecting where on the line the fault has occurred and develops a smart algorithm for future HDL conversion using Simulink. Using the algorithms, the ways in which this implementation can be used to create a smarter grid are the fundamental basis for this research. Simulink was used to create a two-bus power system, create environment variables, and then …

Active Optimal Control Strategies For Increasing The Efficiency Of Photovoltaic Cells, Sharif Aljoaba

Theses and Dissertations--Electrical and Computer Engineering

Energy consumption has increased drastically during the last century. Currently, the worldwide energy consumption is about 17.4 TW and is predicted to reach 25 TW by 2035. Solar energy has emerged as one of the potential renewable energy sources. Since its first physical recognition in 1887 by Adams and Day till nowadays, research in solar energy is continuously developing. This has lead to many achievements and milestones that introduced it as one of the most reliable and sustainable energy sources. Recently, the International Energy Agency declared that solar energy is predicted to be one of the major electricity production energy …

Power System State Estimation Using Phasor Measurement Units, Jiaxiong Chen

Theses and Dissertations--Electrical and Computer Engineering

State estimation is widely used as a tool to evaluate the real time power system prevailing conditions. State estimation algorithms could suffer divergence under stressed system conditions. This dissertation first investigates impacts of variations of load levels and topology errors on the convergence property of the commonly used weighted least square (WLS) state estimator. The influence of topology errors on the condition number of the gain matrix in the state estimator is also analyzed. The minimum singular value of gain matrix is proposed to measure the distance between the operating point and state estimation divergence.

To study the impact of …

Power Control Of Single-Stage Pv Inverter For Distribution System Volt-Var Optimization, Xiao Liu

Theses and Dissertations--Electrical and Computer Engineering

The output power variability of intermittent renewable sources can cause significant fluctuations in distribution system voltages. A local linear controller that exploits the capability of a photovoltaic inverter to provide both real and reactive power is described. This controller substitutes reactive power for real power when fluctuations in the output of the photovoltaic source are experienced. In this way, the inverter can help mitigate distribution system voltage fluctuations. In order to provide real and reactive to the grid, a three-phase grid-connected single-stage photovoltaic system with maximum power point tracking and power control is described. A method of reducing the current …

Contingency Analysis Of Power Systems In Presence Of Geomagnetically Induced Currents, Sivarama Karthik Vijapurapu

Theses and Dissertations--Electrical and Computer Engineering

Geomagnetically induced currents (GIC) are manifestations of space weather phenomena on the electric power grid. Although not a new phenomenon, they assume great importance in wake of the present, ever expanding power grids. This thesis discusses the cause of GICs, methodology of modeling them into the power system and the ramifications of their presence in the bulk power system. GIC is treated at a micro level considering its effects on the power system assets like Transformers and also at a macro level with respect to issues like Voltage instability. In illustration, several simulations are made on a transformer & the …

Smart Grid Communications, Christopher W. Asbery

Theses and Dissertations--Electrical and Computer Engineering

Smart grid technologies are starting to be the future of electric power systems. These systems are giving the utilities detailed information about their systems in real time. One of the most challenging things of implementing smart grid applications is employing the communications into the systems. Understanding the available communications can help ease the transition to these smart grid applications. Many of the utility personnel are spending too much time trying to figure out which communication is better for their application or applications. So this thesis presents the different communication types available with discussing the different attributes in which these communication …

New Accurate Fault Location Algorithm For Parallel Transmission Lines, Pramote Chaiwan

University of Kentucky Doctoral Dissertations

Electric power systems have been in existence for over a century. Electric power transmission line systems play an important role in carrying electrical power to customers everywhere. The number of transmission lines in power systems is increasing as global demand for power has increased. Parallel transmission lines are widely used in the modern transmission system for higher reliability. The parallel lines method has economic and environmental advantages over single circuit. A fault that occurs on a power transmission line will cause long outage time if the fault location is not located as quickly as possible. The faster the fault location …