Computer Engineering Commons^™

An Isolated Multiport Dc–Dc Converter For Simultaneous Power Management Of Multiple Different Renewable Energy Sources, Jianwu Zeng, Wei Qiao, Liyan Qu, Yanping Jiao

Department of Electrical and Computer Engineering: Faculty Publications

This paper proposes a new isolated multiport dc–dc converter for simultaneous power management of multiple renewable energy sources, which can be of different types and capacities. The proposed dc–dc converter only uses one controllable switch in each port to which a source is connected. Therefore, it has the advantages of simple topology and minimum number of power switches. A general topology of the proposed converter is first introduced. Its principle and operation are then analyzed. The proposed converter is applied for simultaneous maximum power point tracking (MPPT) control of a wind/solar hybrid generation system consisting of one wind turbine generator …

Evaluation Of Ann Estimation-Based Mppt Control For A Dfig Wind Turbine, Chun Wei, Liyan Qu, Wei Qiao

Department of Electrical and Computer Engineering: Faculty Publications

This paper proposes an artificial neuronal network (ANN) estimation-based wind speed sensolress MPPT algorithm for wind turbines equipped with doubly-fed induction generators (DFIG). The ANN is designed to produce the optimal control signal for the DFIG power or speed controller. The optimal parameters of the ANN are determined by using a particle swarm optimization (PSO) algorithm. A 3.6 MW DFIG wind turbine is simulated in PSCAD to evaluate and compare the proposed MPPT method with the traditional tip speed ratio (TSR) and turbine power profile-based MPPT methods in both the speed control and power control modes in variable wind speed …

A Flux Vector-Based Discrete-Time Direct Torque Control For Salient-Pole Permanent-Magnet Synchronous Generators, Zhe Zhang, Yue Zhao, Jianwu Zeng, Wei Qiao

Department of Electrical and Computer Engineering: Faculty Publications

This paper proposes a flux vector-based discretetime direct torque control (DTC) scheme for salient-pole permanent-magnet synchronous generators (PMSGs) used in the variable-speed, direct-drive wind energy conversion systems (WECSs). The discrete-time control law is derived from the perspective of flux space vectors and load angle with the torque and stator flux information only. The saliency of the PMSG is eliminated by the active flux concept. Compared with the existing space vector modulation (SVM)-based DTCs, the proposed scheme removes the use of PI regulators and is less dependent on the machine parameters, e.g., stator inductances and permanent-magnet flux linkage, while maintaining the …

Improved Rotor Position And Speed Estimators For Sensorless Control Of Interior Permanent-Magnet Synchronous Machines, Yue Zhao, Wei Qiao, Long Wu

Department of Electrical and Computer Engineering: Faculty Publications

Model-based rotor position/speed estimators are commonly used for sensorless control of interior permanentmagnet synchronous machines (IPMSMs) operating in the medium- and high-speed regions. A rotor position/speed estimation scheme usually contains three major parts: 1) a state observer; 2) a position estimator; and 3) a speed estimator. This paper proposes a sliding-mode observer (SMO) as the state observer to estimate the position-related system states, which are the extended electromotive force components in this paper. Then, two major contributions are made to achieve improved position and speed estimation. First, the rotor speed is estimated independently using a model reference adaptive system (MRAS)-based …

Thyristor-Controlled Switch Capacitor Placement In Large-Scale Power Systems Via Mixed Integer Linear Programming And Taylor Series Expansion, Omid Ziaee, F. Fred Choobineh

Department of Electrical and Computer Engineering: Faculty Publications

Allocation of flexible alternating current transmission system (FACTS) devices to an electric power transmission network may be formulated as a nonlinear mathematical program. Solving such a nonlinear program for a large transmission network is computationally very expensive, and obtaining the optimal solution may be impossible. We present a Taylor series expansion approximation of the nonlinearities of the problem and propose a mixed integer linear program (MILP) for finding the optimum location and proper settings of a Thyristor-Controlled Series Capacitor (TCSC) in an electric power network. The objective of this problem is to minimize total generation cost based on the DC …

Bayesian Network Prior: Network Analysis Of Biological Data Using External Knowledge, Senol Isci, Haluk Dogan, Cengizhan Ozturk, Hasan H. Otu

Department of Electrical and Computer Engineering: Faculty Publications

Motivation: Reverse engineering GI networks from experimental data is a challenging task due to the complex nature of the networks and the noise inherent in the data. One way to overcome these hurdles would be incorporating the vast amounts of external biological knowledge when building interaction networks. We propose a framework where GI networks are learned from experimental data using Bayesian networks (BNs) and the incorporation of external knowledge is also done via a BN that we call Bayesian Network Prior (BNP). BNP depicts the relation between various evidence types that contribute to the event ‘gene interaction’ and is used …

Element Dependence Of Enhancement In Optics Emission From Laser-Induced Plasma Under Spatial Confinement, Changmao Li, Lianbo Guo, Xiangnan He, Zhongqi Hao, Xiangyou Li, Meng Shen, Xiaoyan Zeng, Yongfeng Lu

Department of Electrical and Computer Engineering: Faculty Publications

In this study, the element dependence of spatial confinement effects in LIBS has been studied. Hemispheric cavities were used to confine laser-induced plasmas from aluminum samples with other trace elements. The enhancement factors were found to be dependent on the elements. Equations describing the element dependent enhancement factors were successfully deduced from the local thermodynamic equilibrium conditions, which have also been verified by the experimental results. Research results show that enhancement factors in LIBS with spatial confinement depend on the temperature, electron density, and compression ratio of plasmas, and vary with elements and atomic/ionic emission lines selected. Generally, emission lines …

A Low-Power Compact Nqr Based Explosive Detection System, Xinwang Zhang, Nathan Schemm, Sina Balkır, Michael W. Hoffman

Department of Electrical and Computer Engineering: Faculty Publications

Nuclear quadruple resonance (NQR) has been studied for explosive detection for years. Some prototype NQR-based detection systems have been reported, but were all designed from the laboratory perspective, with bulky sizes and high power consumption. To achieve a portable NQR-based detection system for field applications, a low-power compact system utilizing state-of-the-art semiconductor technologies is presented in this paper. Several novel circuits for the key modules are proposed, including a Class-D type power amplifier, a power multiplexing and matching network, a customized IC with integrated analog signal processing chain, and a microcontroller-based logic control unit. An advanced digital signal processor platform …

Workplace Monitoring Of Employee Health Using The Workstation Pc As A Platform, Priyankar Bhattacharjee

Department of Electrical and Computer Engineering: Faculty Publications

A country’s biggest asset is its workforce, given the fact that a healthy workforce can contribute to rapid growth of the economy. Chronic illnesses reduce productivity, are responsible for rising healthcare costs, and should be managed by the employer to reduce healthcare expenditures. This can be done through employee health and wellness programs, and well-designed health management initiatives. In addition, new information and communication technologies make it possible to monitor employee health with wearable devices and telehealth assisted surveillance techniques. This paper introduces a unique new approach to workplace healthcare monitoring, using the office workstation PC itself to monitor worker …

Clu: Co-Optimizing Locality And Utility In Thread-Aware Capacity Management For Shared Last Level Caches, Dongyuan Zhan, Hong Jiang, Sharad C. Seth

Department of Electrical and Computer Engineering: Faculty Publications

Most chip-multiprocessors nowadays adopt a large shared last-level cache (SLLC). This paper is motivated by our analysis and evaluation of state-of-the-art cache management proposals which reveal a common weakness. That is, the existing alternative replacement policies and cache partitioning schemes, targeted at optimizing either locality or utility of co-scheduled threads, cannot deliver consistently the best performance under a variety of workloads. Therefore, we propose a novel adaptive scheme, called CLU, to interactively co-optimize the locality and utility of co-scheduled threads in thread-aware SLLC capacity management. CLU employs lightweight monitors to dynamically profile the LRU (least recently used) and BIP (bimodal …

Intelligent Maximum Power Extraction Control For Wind Energy Conversion Systems Based On Online Q-Learning With Function Approximation, Chun Wei, Zhe Zhang, Wei Qiao, Liyan Qu

Department of Electrical and Computer Engineering: Faculty Publications

This paper proposes an intelligent maximum power point tracking (MPPT) algorithm for variable-speed wind energy conversion systems (WECSs) based on an online Q-learning algorithm. Instead of using the conventional Qlearning that uses a lookup table to store the action values for the discretized states, artificial neural networks (ANNs) are used as function approximators to output the action values by using the electrical power and rotor speed of the generator as inputs. This eliminates the need for a large storage memory. The proposed method learns the optimal speed control strategy of the WECS by updating the connecting weights of the ANNs, …

Effects Of Droplet Diameter On The Leidenfrost Temperature Of Laser Processed Multiscale Structured Surfaces, Anton Hassebrook, Corey Kruse, Chris Wilson, Troy P. Anderson, Craig Zuhlke, Dennis R. Alexander, George Gogos, Sidy Ndao

Department of Electrical and Computer Engineering: Faculty Publications

In this paper, an experimental investigation of the effects of droplet diameters on the Leidenfrost temperature and its shifts has been carried out. Tests were conducted on a 304 stainless steel polished surface and a stainless steel surface which was processed by a femtosecond laser to form Above Surface Growth (ASG) nano/microstructures. To determine the Leidenfrost temperatures, the droplet lifetime method was employed for both the polished and processed surfaces. A precision dropper was used to vary the size of droplets from 1.5 to 4 millimeters. The Leidenfrost temperature was shown to display shifts as high as 85 ˚C on …

Optimum Renewable Generation Capacities In A Microgrid Using Generation Adequacy Study, Salman Kahrobaee, Sohrab Asgarpoor, Milad Kahrobaee

Department of Electrical and Computer Engineering: Faculty Publications

Microgrids, as small power systems, may be comprised of different types of loads and distributed generation. As the integration of renewable power generation increases, the total available generation capacity of the system will be more derated due to the effect of equipment failures and the intermittent nature of these resources. Therefore, it is critical to determine optimum renewable generation capacities and provide enough reserve margin to meet the target reliability of the microgrid. In this paper, we first model a microgrid, including conventional and renewable distributed generation and the loads. Second, we determine the renewable generation capacity required to meet …

State Of Charge Estimation Based On A Realtime Battery Model And Iterative Smooth Variable Structure Filter, Taesic Kim, Yebin Wang, Zafer Sahinoglu, Toshihiro Wada, Satoshi Hara, Wei Qiao

Department of Electrical and Computer Engineering: Faculty Publications

This paper proposes a novel real-time model-based state of charge (SOC) estimation method for lithium-ion batteries. The proposed method includes: 1) an electrical circuit battery model incorporating the hysteresis effect, 2) a fast upper-triangular and D-diagonal recursive least square (FUDRLS)-based online parameter identification algorithm for the electrical battery model, and 3) an iterated smooth variable structure filter (ISVSF) for SOC estimation. The proposed method enables an accurate and robust condition monitoring for lithium-ion batteries. Due to its low complexity, the proposed method is suitable for the real-time embedded battery management system (BMS) application. Simulation and experiment are performed to validate …

Design And Implementation Of A Low-Cost Embedded Linux Gateway For Smart Home Health Monitoring, Mateusz Mittek, Jay D. Carlson, Lance C. Pérez

Department of Electrical and Computer Engineering: Faculty Publications

Many wireless sensor network applications require a gateway device to interface with services running on the Internet. Because of the software complexity involved in this device, it is often realized using a real-time operating system running on an application processor. Most systems burden the user with developing the protocol handling and device configuration and management inside the application. In this paper, we present the Angelos Gateway – a turnkey, low-cost, Linux-powered WSN gateway that provides a socket-based environment for rapid network-enabled application development. Experimental results demonstrate that the proposed device is capable of high-throughput packet I/O, confirming the efficacy of …

Automated Indoor Rfid Inventorying Using A Self-Guided Micro-Aerial Vehicle, Steven A. Parkison, Eric T. Psota, Lance C. Pérez

Department of Electrical and Computer Engineering: Faculty Publications

A Micro-Aerial Vehicle (MAV) system is presented for automated indoor inventorying using passive radio frequency identification (RFID). This system utilizes a combination of onboard sensing and processing in order to achieve flight stabilization, generate floor maps, and perform path planning. The proposed state estimation method along with a control feedback strategy are demonstrated to be sufficiently accurate for operation in the indoor environment and the proposed path planning technique is shown to be effective for guiding the MAV while it performs automated RFID scanning.

Achieving Robustness And Capacity Gains In Covert Timing Channels, Fahimeh Rezaei, Michael Hempel, Pradhumna Lal Shrestha, Hamid Sharif

Department of Electrical and Computer Engineering: Faculty Publications

In this paper, we introduce a covert timing channel (CTC) algorithm and compare it to one of the most prevailing CTC algorithms, originally proposed by Cabuk et al. CTC is a form of covert channels – methods that exploit network activities to transmit secret data over packet-based networks – by modifying packet timing. This algorithm is a seminal work, one of the most widely cited CTCs, and the foundation for many CTC research activities. In order to overcome some of the disadvantages of this algorithm we introduce a covert timing channel technique that leverages timeout thresholds. The proposed algorithm is …

Monitoring Igbt’S Health Condition Via Junction Temperature Variations, Bo Tian, Wei Qiao, Ze Wang, Tanya Gachovska, Jerry L. Hudgins

Department of Electrical and Computer Engineering: Faculty Publications

Insulated gate bipolar transistor (IGBT) failures are a major issue in modern power electronics applications. Two most dominated failure mechanisms of IGBTs are solder fatigue and bond wire wear-out. This paper proposes a new method to online monitor an IGBT’s health condition by using the instantaneous junction temperature variation between present and the first operating cycles of the IGBT with the same operating current. In this work, the instantaneous junction temperature of an IGBT is estimated from a thermal network model. The proposed method is validated by experimental results obtained from accelerated aging tests for IGBTs.

Advanced Computing Systems For Scientific Research, Jared Buckley, Jason Covert, Talia Martin

Undergraduate Review

An advanced computing system was constructed at Bridgewater State University to provide students access to computing machines tailored to the purpose of computational scientific research. This paper provides an overview of the construction, design, capability, and future potential of the computing system.

Project Reasoning
During the course of projects utilizing a numerical weather prediction (NWP) model, it became evident that the desktop computing machines provided to students in computer labs were not capable of yielding results in a reasonable amount of time for non-standard applications. The standard configuration of computers in the Conant Science and Mathematics Center at Bridgewater State …

An Efficient Similarity Digests Database Lookup -- A Logarithmic Divide And Conquer Approach, Frank Breitinger, Christian Rathgeb, Harald Baier

Electrical & Computer Engineering and Computer Science Faculty Publications

Investigating seized devices within digital forensics represents a challenging task due to the increasing amount of data. Common procedures utilize automated file identification, which reduces the amount of data an investigator has to examine manually. In the past years the research field of approximate matching arises to detect similar data. However, if n denotes the number of similarity digests in a database, then the lookup for a single similarity digest is of complexity of O(n). This paper presents a concept to extend existing approximate matching algorithms, which reduces the lookup complexity from O(n) to O(log(n)). Our proposed approach is based …