Geotechnical Engineering Commons^™

Commercialization Of A Small, Lightweight, Low-Cost Seismic Borehole Receiver, Rachel Adams

Theses and Dissertations--Civil Engineering

Herein, conceptualization of a recently patented seismic borehole receiver and its components is developed for commercialization. The device is significantly cheaper, lighter, and smaller than existing technologies on the market. Additionally, it has the potential to achieve better seismic readings than its competitors via patented sensor-to-borehole coupling mechanism. It is the hope that the commercialization of this device will not only provide a more affordable alternative to engineers and geophysicists in the existing market, but the significant cost difference may open new seismic measurement opportunities in the developing world. Its compact size and light weight will increase mobility, allowing investigators …

Evaluating Methods Of Field-Based 3d Visualization And Their Application To Mapping Metamorphic Terranes: An Example From The Panamint Mountains, California, Jade Ashley Brush

Open Access Theses & Dissertations

Field geology has traditionally relied on 2D, paper-based workflows, but digital mapping techniques are rapidly replacing these outdated methods because they allow for more efficient and accurate mapping. This research applies digital mapping techniques and two terrestrially-based 3D visualization technologies, photogrammetry and Light Detection and Ranging (LiDAR), to the study of metamorphic terranes in the Panamint Mountains, California. This study reports on the spatial accuracy of TINs (triangulated irregular networks) generated from both photogrammetry and ground-based LiDAR using a terrestrial laser scanner (TLS) and discusses how spatial accuracy can be increased. Two levels of comparison were used to test spatial …

Evaluation Of Strength And Hydraulic Properties Of Buried Pipe Systems Used For Stormwater Harvesting, Mario Samson Mena

Electronic Theses and Dissertations

Water scarcity has been identified as a global issue. Both water harvesting and an efficient water piping system are some of the important factors to meet the water demand. In this study, high-density polyethylene (HDPE) pipes used as an underground storage was evaluated and a Microsoft EXCEL based model was developed, called PIPE-R Model. To study the structural integrity of the pipes, laboratory and field testing were conducted. For the water harvesting, UCF Stormwater Management Academy designed an EXCEL based model to simulate the system's performance to store and redistribute water for an average year. The purpose of PIPE-R Model …

Restricted Salt Diffusion In A Geosynthetic Clay Liner, Michael A. Malusis, Jong Beom Kang, Charles D. Shackelford

Faculty Journal Articles

No abstract provided.

Damage Detection Methodologies For Structural Health Monitoring Of Thin-Walled Pressure Vessels, Arturo Modesto

Electronic Theses and Dissertations

There is a need in exploring structural health monitoring technologies for the composite structures particularly aged Composite Overwrapped Pressure Vessels (COPVs) for the current and future implementation of COPVs for space missions. In this study, the research was conducted in collaboration with NASA Kennedy Space Center and also NASA Marshall Space and Flight Center engineers. COPVs have been used to store inert gases like helium (for propulsion) and nitrogen (for life support) under varying degrees of pressure onboard the orbiter since the beginning of the Space Shuttle Program. After the Columbia accident, the COPVs were re-examined and different studies (e.g. …

Mechanical Behavior Of Grouted Sands, Ryan C. Ortiz

Theses and Dissertations--Civil Engineering

Grouting techniques have been in used for many years, but several new grout materials have surfaced in recent decades that have re-defined the boundaries of the limitations of grouting programs. Typically these applications are used for seepage control in earthen impoundments, but strength of these earthen impoundments should be considered where there is potential for movement in the grouted soil mass. This study investigated initial conditions that could affect grout application effectiveness. The initial conditions in question were soil grain size and in situ moisture content. Two grouts were used, ultrafine and acrylate, and variations in pure grout properties were …

Deformation-Based Excavation Support System Design Method, Sekyi K. Intsiful

Theses and Dissertations--Civil Engineering

Development in urban areas around the world has steadily increased in recent years. This rapid development has not been matched by the ever decreasing open space commonly associated with urban centers. Vertical construction, thus, lends itself a very useful solution to this problem. Deep excavation is often required for urban construction. Unfortunately, the ground movements associated with deep excavation can result in damage to adjacent buildings. Thus, it is critically important to accurately predict the damage potential of nearby deep excavations and designing adequate support systems.

A new design method is proposed, as an attempt, to address the problem. The …

Prediction Of Strength And Shear Modulus Of Compacted Clays Within An Unsaturated Critical State Framework, Corrie Walton-Macaulay

Theses and Dissertations--Civil Engineering

The objective of this research study is to determine whether the soil stiffness, from which the small-strain shear modulus is determined, can be used to predict the shearing resistance of compacted clay soil, which are invariably under conditions of partial saturation. The research program developed for this objective included three major soil testing programs of matric suction, shear modulus, and strength.

A method to estimate matric suction of field compacted clay soil was presented and it is based on the quantified effect of change in initial void ratio on the soil water characteristic behaviors. With the use of a non-nuclear …

Simulating Energy Efficient Control Of Multiple-Compressor Compressed Air Systems, Sean Murphy, J. Kelly Kissock

Mechanical and Aerospace Engineering Faculty Publications

In many industrial facilities it is common for more than one air compressor to be operating simultaneously to meet the compressed air demand. The individual compressor set-points and how these compressors interact and respond to the facility demand have a significant impact on the compressed air system total power consumption and efficiency. In the past, compressors were staged by cascading the pressure band of each compressor in the system. Modern automatic sequencers now allow more intelligent and efficient staging of air compressors.

AirSim, a compressed air simulation tool, is now able to simulate multiple-compressor systems with pressure band and automatic …

Mechanical Characteristics Of Organically Modified Fly Ash-Kaolinite Mixtures, Xin Kang

Doctoral Dissertations

"Fly ash is a hazardous waste material to the environment. Beneficial reuse of fly ash, however, brings economic and environmental benefits, i.e., decreases the cost of disposal, reduces greenhouse gas emission, and improves mechanical properties of construction materials. Due to the lack of pozzolanic properties, the reuse rate of Class F fly ash in geotechnical engineering is relatively low (ACAA 2013). In order to promote the effectiveness and sustainability of high volume reuse of class F fly ash in geotechnical engineering, biopolymers (Chitosan, and Xanthan gum) and synthetic polymers (Polyethylene Oxide, PEO) were used instead of the traditional stabilizers to …

Determining Rockfall Volumes In Three Sites Along Habs Mountain Road In Southwestern Saudi Arabia, Using Lidar Technology, Abdullah Ayed Al-Otaibi

Masters Theses

"The rugged elevated topography is a characteristic feature of the western and southwestern regions of Saudi Arabia. Few arterial roads connect the scattered villages of these regions to major cities, such as Habs Road in Jazan region. Rock fall poses a serious hazard to people, property and animals along the rock cuts of this road. Although no traditional Rockfall studies have previously been applied to this road, accessibility and rock formation shape and structure variability influenced the choice of using Terrestrial Light Detection And Ranging (LiDAR) technology to calculate the volume of rockfall at selected sites along this road.

Software …

Performance Life Of Various Hot Mix Asphalt Mixtures In Texas, Danniel David Rodriguez

Open Access Theses & Dissertations

Typically, pavement engineers in subjectively estimate the service lives of various hot-mix asphalt (HMA) mixtures as part of the life-cycle cost analysis considering the staged design and rehabilitation of flexible pavements. This study proposes the performance lives for the various dense-graded (conventional) mixtures, stone-matrix asphalts (SMA), permeable friction courses (PFC), performance design mixtures and other mixtures placed in Texas. A necessary and significant aspect of the approach involved data mining and merging several pavement management databases (Letting Database, DCIS and PMIS) to obtain mixture longevity data along with historical PMIS information. The product of the linking process resulted in the …

Agenda For Second Meeting Of The Forum For Promotion Of Soil Dynamics In India, Shamsher Prakash

Forum for Promotion of Soil Dynamics in India

No abstract provided.

Membership Of Forum For Promotion Of Soil Dynamics In India, Shamsher Prakash

Forum for Promotion of Soil Dynamics in India

No abstract provided.

Center Of Excellence In Geotechnical Earthquake Engineering And Soil Dynamics At Iit Roorkee, Shamsher Prakash

Forum for Promotion of Soil Dynamics in India

No abstract provided.

Honor Stalwarts, Shamsher Prakash

Forum for Promotion of Soil Dynamics in India

No abstract provided.

Soil Dynamics Course In Curriculum, Deepankar Choudhury

Forum for Promotion of Soil Dynamics in India

No abstract provided.

Reliability-Based Design And Acceptance Protocol For Driven Piles, Joseph Jabo

Graduate Theses and Dissertations

The current use of the Arkansas Standard Specifications for Highway Construction Manuals (2003, 2014) for driven pile foundations faces various limitations which result in designs of questionable reliability. These specifications are based on the Allowable Stress Design method (ASD), cover a wide range of uncertainties, do not take into account pile and soil types, and were developed for general use. To overcome these challenges it is deemed necessary to develop a new design and acceptance protocol for driven piles. This new protocol incorporates locally calibrated RLFD resistance factors for accounting for local design and construction experiences and practices, as well …

Calibration Of Resistance Factors For Driven Piles Using Static And Dynamic Tests, Deshinka A. Bostwick

Graduate Theses and Dissertations

The field of geotechnical engineering has evolved from Allowable Stress Design (ASD) to Load Factor and Resistance Design (LRFD) which has led to a need to quantify the measures of uncertainty and the level of reliability associated with a project. The measures of uncertainty are quantified by load and resistance factors, while the level of reliability is driven by the amount of risk an owner is willing to take and is quantified by the reliability index. The load factors are defined through structural design codes, but the resistance factors have uncertainties that can be mitigated through reliability based design. The …

Estimating Field At-Rest Lateral Stress Coefficient And Liquefaction Resistance Of Aged Sands, Md Hossian

All Dissertations

Published results of laboratory tests to evaluate the influence of the at-rest lateral stress coefficient (K0) and the overconsoildation ratio (OCR) on liquefaction resistance of sands are reviewed in this dissertation. It is found that significant increase in liquefaction resistance can occur with high K0 and/or high OCR. A unique relationship between liquefaction resistance of isotropic and anisotropic normally consolidated sands exists based on the published laboratory data. Relationships between liquefaction resistance of overconsolidated sands and normally consolidated sands also have been shown in previous laboratory studies. Based on the previous studies, expressions for K0 and OCR correction factors (KK0 …