Civil Engineering Commons^™

Experimental And Modeling Comparison Of Modular Photovoltaic-Thermal Solar Panels, Nicole C. Annis

Masters Theses

"Three different prototype photovoltaic-thermal panels using water as the cooling fluid were tested simultaneously. The first two panels (Panel A and B) consisted of a highly conductive thermal sheeting and different sized copper tubing. The third panel (Panel C) consisted of copper tubing with an aluminum fin. Thermal images were used to verify the heat transfer across the panels and compare the amount of heat radiating off the back of the photovoltaic-thermal panels versus the standard photovoltaic paneleaf Three A type panels were thermally connected in series. Three photovoltaic panels were also tested for an electrical comparison. The purpose of …

Innovative Concrete Bridging Systems For Pedestrian Bridges: Implementation And Monitoring, Kurt Edward Bloch

Masters Theses

"Two precast, prestressed pedestrian bridges were designed for rapid construction in Rolla, MO, utilizing high-strength concrete (HSC) and high-strength self-consolidating concrete (HS-SCC) with a target 28 day compressive strength of 68.9 MPa (10,000 psi) and release compressive strength of 24.1 MPa (3,500 psi). In addition, a glass fiber reinforced polymer (GFRP) bar reinforced deck panel system was utilized in one of the two deck panels on each bridge.

Material properties were tested for compression, elastic modulus, modulus of rupture, splitting tensile strength, creep, and shrinkage following ASTM standards. Instrumentation systems within the spandrel beams and precast deck panels were implemented …

Analysis Of Nationwide Intercity Travel Demand On The Us Transportation Network, Tao Li

Masters Theses

"In this thesis, three issues about the intercity travel demand on the US transportation network are addressed. The final one is the estimation of the domestic passengers' delay cost. A scheme is designed by assuming that costs incurred by flight delays relative to the original flight schedules are imposed at passengers' final destination airports. It is applied to estimate the total domestic delay cost of year 2007 and reasonable results arc obtained. The second one is the air travel demand estimation. Two route-based optimization models are proposed to estimate the travel demand based on available data. It is shown that …

Glass Fiber-Reinforced Polyurea Strengthening Of Reinforced Concrete, Courtney Elizabeth Greene

Masters Theses

"Wide varieties of concrete repair-retrofit and strengthening methods have been developed and are being widely implemented. In recent years, the need for such strengthening systems has become apparent with increasing demands on aging infrastructure. These strengthening systems need to be increasingly more adaptable, providing ease of construction as well as withstanding a variety of loading conditions and hazards. Exterior-applied fiber-reinforced polymer systems are increasingly being used to meet these demands. The research contained herein investigates the strengthening benefits and characteristics from a specific glass fiber-reinforced polyurea coating system applied externally to structures by means of spraying. This coating would allow …

Bayesian Approaches On Observational Before-After Highway Safety Analysis, Daxiao Liu

Masters Theses

"Observational before-after evaluation of roadway safety treatments effect is a necessary and challenging study area for traffic safety engineers. In decades, empirical Bayesian approach has been widely adopted among researchers in this area. In this approach, the researcher combined before period observation data with a safety performance function estimated from similar groups to estimate the expected number of crashes that would have occurred in the after period without the treatment. Comparing this estimate with the number of crashes observed in the after period, the researcher evaluated the effectiveness of the treatment. This approach accounts for well-known regression-to-the-mean effects. However, as …

Evaluation Of Variable Speed Limits Using A Genetic Algorithm Approach To Calibrate A Vissim Model, Brian Joseph Schaefer

Masters Theses

"The variable speed limit (VSL) system has been adopted on more and more roadways across the globe as an engineering tool for controlling traffic flow, particularly during congestion situations. An important and fundamental question raised among traffic engineers is: Are the costs of installing and operating variable speed limits really justified? In order to answer this question, this thesis measures the effectiveness of the VSL system applying the VISSIM microscopic simulation model to a non-recurrent congestion situation. For the analysis, a section of interstate was modeled in VISSIM and calibrated so that the simulated results closely reproduce the observed data …

An Assessment Of Delivery Risks In Transportation Projects, Velvet Fitzpatrick, Kumares C. Sinha

JTRP Technical Reports

A large number of uncertainties exist in the delivery of highway projects, and it is important to describe the extent so that budgeting and programming can be carried out in a manner that duly accounts for such uncertainties. The study investigates the sources of delivery variability (risk factors) that occur in the period between project proposed date and the letting date. Data on 366 highway projects were collected from the Indiana Department of Transportation Management Information Portal. Using statistical and econometric techniques, the data was analyzed to identify the potential risk factors and to determine the magnitude and direction of …

The Relationship Between Information Technology And Construction Productivity, Dong Zhai

University of Kentucky Doctoral Dissertations

Over the past decades, information technology has been impacting industries, economics, the way of life and even the culture throughout the world. Productivity has been attracting much attention as an important indicator of economics, and numerous researchers have investigated the relationship between information technology and productivity. Construction is one of the largest industries in the United States, but little research has been conducted to investigate the relationship between information technology and construction productivity.

The major objective of this dissertation is to determine the degree (if any) to which information technology usage, specifically the use of information technology to automate and …

Integration Of The Regression-Based Land Use Model And The Combined Trip Distribution-Assignment Transportation Model, Meiwu An

University of Kentucky Doctoral Dissertations

Regional growth caused the emergence of traffic congestion and pollution in the past few decades, which have started to affect small urban areas. These problems are not only related to transportation system design but also to land use planning. There has been growing recognition that the relationship between land use and transportation needs to be understood and analyzed in a consistent and systematic way. Integrated urban models have recently been introduced and implemented in several metropolitan areas to systematically examine the relationship between land use and transportation. The general consensus in the field of integrated urban models is that each …

Chemical Compatibility Of Soil-Bentonite Cutoff Wall Backfills Containing Modified Bentonites, Matthew D. Mckeehan

Master’s Theses

This study examined the chemical compatibility of several model soil-bentonite(SB) backfills with an inorganic salt solution (CaCl2). First, bentonite-water slurry was created using a natural sodium-bentonite, as well as two modified bentonites –multiswellable bentonite (MSB) and a “salt-resistant” bentonite (SW101). Once slurries that met typical construction specifications had been created using the various bentonites,the model SB backfills were prepared for each type of bentonite. These backfills werealso designed to meet conventional construction and design requirements. The SB backfills were then subjected to permeation with tap water and/or CaCl2 solutions of various concentrations in order to evaluate the compatibility of the …

Impact Of Moisture Content And Density On Stiffness-Based Acceptance Of Geomaterials, Lourdes Guadalupe Pacheco

Open Access Theses & Dissertations

Modulus-based quality management of compacted layers has been considered by a number of highway agencies. Even though simple in concept, the paradigm shift from density to modulus for quality acceptance has generated some technical and institutional challenges. One of these complications is that for a given density, the modulus can vastly vary depending on the moisture content at the time of compaction and at the time of acceptance. The results of a systematic study carried out to qualify and quantify the impact of compaction moisture content, moisture content at the time of field testing and density on the modulus and …

A Risk Analysis Framework For Toll Road Revenue Forecasts, Gabriel Alejandro Valdez Ceniceros

Open Access Theses & Dissertations

In the United States, the shortage for traditional public sector funding sources for a safer and more effective highway infrastructure has made it more increasingly difficult for transportation agencies to keep up with the increasing demand. As a consequence, transportation agencies are considering a number of alternatives to raise funds such as charging tolls or cooperating with the private sector. One of the most important steps when analyzing the feasibility of a toll road is the traffic forecast process. However, the uncertainty of the traffic forecast has become apparent across the U.S. as evident in the common overestimation of traffic …

Decision Support Tools For Bus Rapid Transit Corridor Planning, Luis David Galicia

Open Access Theses & Dissertations

Bus Rapid Transit (BRT) Systems have been gained popularity in the United States and worldwide as a cost-effective solution of mass transit. There are certain elements and characteristics that such a system should accomplish to be considered a BRT. However, a uniform definition, defined phases to be deployed, and a reliable methodology to estimate ridership are not well structured and clear yet. The purpose of this research was to help BRT stakeholders with an effective method to plan and assess BRT projects. The first goal of this research was to provide a comprehensive description of the essential characteristics of BRT …

Applicability Of Mepdg For India Based On Texas Pavement And Environmental Conditions, Vamsi Krishna Pinnamaneni

Open Access Theses & Dissertations

The Indian pavement design guide uses empirical models which were adopted and modified from US design guides. As with any empirical model, the prediction capabilities are limited to the conditions for which it was developed. In USA, Mechanistic Empirical Pavement Design Guide (MEPDG) has been recently developed to account for increase in truck traffic and minimize premature failure of pavements. Since the new design uses mechanistic approach, it is expected that the design guide can better predict performance of pavements. In addition, mechanistic approach allows use of design guide for different pavement and environmental conditions by calibrating model parameters for …

Effects Of Unbalanced Approach Volumes On Roundabout Operations, Marilyn Valdez

Open Access Theses & Dissertations

Modern roundabouts are increasingly popular in the United States due to their advantages in improving safety and reducing delay at intersections. A roundabout is an intersection in which traffic enters the intersection and travels in a circular counterclockwise motion around a center island. In a roundabout, priority is given to vehicles traveling in the circular roadway, and incoming traffic at the roundabout approach must yield to the circulating traffic. If there is an unbalance in approach volume, the approaches with higher input volumes may dominate the circulating flow preventing vehicles the other approaches to enter the roundabout. This may consequently …

Probabilistic Analysis Of Concrete Fracture, Mustafa Abushaala Aldalinsi

Open Access Theses & Dissertations

It is well known to civil engineers that fatigue leads to the bulk of structural failures. In plain and reinforced concrete structures, fatigue might account for excessive deformation, excessive of crack widths, de-bonding of reinforcement and rupture of the reinforcement, all of these can lead to structural collapse. Fatigue crack propagation can be a method to predict a remaining life of a structures. Herein will show some works that have been done in order to analyze the fatigue crack growth for plain concrete specimen. The goals of this study are to estimate the critical crack length and remaining life of …

Fieldmanager® – Construction Management Software, Purdue Ect Team

ECT Fact Sheets Archive

The FieldManager® software is a construction management system jointly owned by the Michigan Department of Transportation (MDOT) and Info Tech, Inc. Designed for any size organization that manages construction projects, FieldManager software wraps up contract documentation and reporting, contract modifications, and pay estimates into one neat package for use on multiple hardware platforms, increasing productivity and accountability by implementing a standard business practice across the organization.

Appia® – Construction Management Web Application, Purdue Ect Team

ECT Fact Sheets Archive

The Appia® software is a hosted web application for construction program administration. The Appia system can manage the business processes in the major functional areas of the project life-cycle – estimation, bid management and construction – due to its flexible configuration and customizable business rules, providing organizations the opportunity to simplify and standardize their processes.

Automated Tank Surface Finishing System, Purdue Ect Team

ECT Fact Sheets Archive

The current finishing techniques are costly and laborious, and they expose workers to significant health and safety risks. The automated tank surface finishing system uses a computer-controlled motion module to refinish the vertical exterior walls of a tank. The module is configurable for both blasting and painting and utilizes conventional surface finishing equipment for these processes. An overspray hood is included to reduce contamination of the surrounding environment during painting. The module attaches to a tank’s wind girts with steel cables, and its position and velocity are controlled by servo-driven hoists.

Visualization And Assessment Of Arterial Progression Quality Using High Resolution Signal Event Data And Measured Travel Time, Christopher M. Day, Ross Haseman, Hiromal Premachandra, Thomas M. Brennan Jr, Jason S. Wasson, James R. Sturdevant, Darcy M. Bullock

Lyles School of Civil Engineering Faculty Publications

No abstract provided.