Civil Engineering Commons^™

Influence Of Concrete Compressive Strength On Transfer And Development Lengths Of Prestressed Concrete, Alberto Teodoro Ramirez-Garcia

Graduate Theses and Dissertations

This research examines the relationship between concrete compressive strength and strand bond. The goal of this research was to develop an equation that relates strand bond to concrete compressive strength at strand release (approximately 1 day of age) and at 28 days of age, and those equations are presented in this investigation. Strand bond is assessed by measuring the transfer length and development length for prestressed beams cast in the laboratory. In the U.S., strand bond is predicted using transfer length and development length equations provided by the American Concrete Institute (ACI-318) Building Code and American Association of State and …

Soil Moduli Obtained From A Back Pressure Constant Rate Of Strain Bender Element Consolidation Apparatus, Yi Zhao

Graduate Theses and Dissertations

A back-pressure saturated, constant-rate-of-strain consolidation device was modified to incorporate bender elements (BP-CRS-BE) and thus allowed for shear wave measurements during consolidation tests. This newly fabricated system has many advantages over other previous or current devices: 1) it can be utilized not only for laboratory prepared soil samples but also for field sampled soils such as Shelby tube samples, and 2) continuous compression curves, and continuous values of vertical hydraulic conductivity and coefficient of consolidation can be acquired with a significant reduction in testing time. Soil modulus values such as shear modulus and constrained modulus are also able to be …

Shear Investigation Of Polypropylene Fiber-Reinforced Concrete Beams, Ehsan Navadeh

Civil Engineering Theses - Archive

This study investigates the effect of macro-synthetic polypropylene fibers on the shear strength and failure behavior of longitudinally reinforced concrete beams with and/ or without transverse reinforcement. Eight large-scale were constructed, cured and tested at Civil Engineering Laboratory Building (CELB). This includes flexural reinforced concrete beams without transverse reinforcement (RC), reinforced concrete beam with minimum transverse reinforcement (RCS), 0.5% volume macro-synthetic polypropylene fiber-reinforced concrete beams without stirrups (SNFRC 0.5%), and 0.75% macro-synthetic polypropylene-fiber reinforced concrete beams without stirrups (SNFRC 0.75%). During production of large-scale beams, 19 Cylinders and 9 small-scale beams were produced from the same mix-design and cured for …

Effect Of Tio2/Uv-Led Operational Parameters On The Degradation Of Pharmaceuticals In Water, Burhanuddin Khuzema Zaveri

Civil Engineering Theses - Archive

The presence of pharmaceutical residues in water resources has alarmed water and health authorities. Among many treatment technologies for pharmaceuticals, ultraviolet (UV)-based oxidation has gained significant attention because it is capable of decomposing a variety of recalcitrant and toxic chemicals. As an alternative UV source to problematic conventional mercury lamps, light-emitting diode (LED) has shown many advantages for water treatment applications, so-called UV-LED. The overall goal of this study is to evaluate the high potential of the UV-LED technology to treat water contaminated with pharmaceuticals including sulfamethoxazole, ibuprofen, and triclosan. In particular, important operational parameters were investigated, including UV wavelength, …

Integration Of Bim And Utility Sensor Data For Facilities Management, Kamal Suprabhas

Open Access Theses

Building information modelling represents a building as a database of coordinated, consistent and computable information in construction (Sabol, 2008). There has been a recent trend to study the usage of BIM for post-construction facility management. Recently, attempts are also being made to link a BIM model with smart sensing technology or building automation systems (BAC). This thesis aims to investigate the feasibility of using sensor data from mote based light sensors tied to a BIM model, to be used for maintenance based facility management. More specifically, a prototype will be developed that integrates lighting sensor data collected using a mote …

Effect Of Manures On Food Waste Degradation In Biocell, Md Nur Basit Zaman

Civil Engineering Theses - Archive

Proper disposal of food waste is a challenge due to adverse effect on the environment through generation of excessive leachate and greenhouse gas (CH4). After food loss through the food supply chain, the food waste ends up mostly in landfills. A study by EPA showed food waste to be the second largest component found in landfill. However, food waste imposes major cost on landfill management, and demands a potential alternative disposal solution that can negate the adverse effects. Though anaerobic digester and composting are possible solutions for food waste disposal, the former is highly expensive while in later solution, a …

Study Of Parameters Impacting Productivity Of Tunnel Boring Machines, Hamed Hashem Pour

Civil Engineering Theses - Archive

Tunnel construction has been on the rise for transportation of humans, freight and fluids. For a successful tunneling project, it is necessary for that tunneling contractors to have sufficient data about scope of work, project features and characteristics of the ground to estimate advance rate of the a tunnel boring machine (TBM). The main objective of this thesis is to study tunneling case studies and literature to analyze TBM productivity based on ground conditions, diameter and length of each project. Project data was tabulated and results are reported in this thesis. The methodology to conduct this research was literature search …

Laboratory Evaluation Of Tx- Prochem As An Ionic Liquid Stabilizer, Esmat Tavakoli

Civil Engineering Theses - Archive

Chemical treatment of pavement and foundation soil was conducted to improve workability during compaction, to increase the strength and stiffness of a foundation layer, and to reduce potential shrink and swell due to moisture changes and/or frost action. In this study, a commercial liquid ionic stabilizer (Tx ProChem) was evaluated based on its effectiveness to reduce swell potential and improve the strength of Texas expansive clay. This study also evaluated selected, representative liquid chemical stabilizers’ effect on expansive clay soil. The research presented herein assesses how much the chemical treatments changed the relevant engineering properties of the test soil as …

Reflectivity Of Light Emitting Diodes (Led) And Incandescent Lights On Concrete And Asphalt Pavements., Jeremy Elliott Rice

Electronic Theses and Dissertations

The purpose of this study is to investigate the reflectivity of light on concrete and asphalt pavement systems. In 1983, the Illuminating Engineering Society (IES) published the first recommended practice (RP-8) for the design of roadway and parking lot lighting. This design method implemented empirically tested factors which were defined as the “reduced luminance coefficients” or the R-Tables. The R-Tables are essential for proper design of light pole installation dimensions, required power, and the distribution of light. The originally tested pavements are not necessarily representative of modern pavement materials used today. Moreover, recent Light Emitting Diodes (LED) are a relatively …

The Effects Of Notch Geometry On Fracture Testing Of Asphalt Concrete, Rebekah Porter

Civil Engineering Undergraduate Honors Theses

Asphalt concrete is commonly used as the surface layer on pavements because of its convenience, low cost, and smooth ride (Wagoner, 2005). However, there is a significant problem with the cracking and deterioration of asphalt concrete roads. The initiation of cracking in asphalt must be better understood in order to further improve pavement design. Fracture energy is the amount of energy needed to separate two surfaces. The semi circular bend (SCB) test can be used to measure the fracture energy of asphalt concrete. Currently, this method uses a semicircular specimen with a rectangular notch in a three-point bend compression test. …

Dynamic And Static Behavior Of Hollow-Core Frp-Concrete-Steel And Reinforced Concrete Bridge Columns Under Vehicle Collision, Omar I. Abdelkarim, Mohamed Elgawady

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

This paper presents the difference in behavior between hollow-core fiber reinforced polymer-concrete-steel (HC-FCS) columns and conventional reinforced concrete (RC) columns under vehicle collision in terms of dynamic and static forces. The HC-FCS column consisted of an outer FRP tube, an inner steel tube, and a concrete shell sandwiched between the two tubes. The steel tube was hollow inside and embedded into the concrete footing with a length of 1.5 times the tube diameter while the FRP tube stopped at the top of footing. The RC column had a solid cross-section. The study was conducted through extensive finite element impact analyses …

Hydraulic Performance Evaluation Of Evapotranspiration Cover Systems, Brett James De Vries

Civil Engineering Dissertations - Archive

Although alternative covers such as the evapotranspiration (ET) landfill cover system promise to provide equivalent or greater performance than conventional cover systems, uncertainties remain on the performance of these type of cover systems. The uncertainties associated with performance may derive from the relative newness of these covers (when compared to conventional landfill cover systems); and their dependency on relatively site-specific factors such as: climatic, vegetation, and soil conditions. As a results, the Texas Commission on Environmental Quality (TCEQ) requires a landfill facility to design and then verify the design and performance through site specific field scale testing (TCEQ 2012). Utilizing …

Novel Approach For Selective Decomposition Of Target Water Contaminants Onto Porous Titanium Dioxide, Abolfazl Zakersalehi

Civil Engineering Dissertations - Archive

Manipulation of physical and chemical properties of matter with nanoscale precision will enhance our ability for fabrication of material with intended characteristics for environmental applications. In this study we presented two main frameworks for addressing non-selectivity issue in TiO2 photocatalysts, which is believed to be a major drawback in full-scale application of this technology. First, a purely physical approach for enhancing selectivity of nanostructured TiO2 photocatalysts toward water target contaminants have been achieved via tailor-designing meso-porous structure of TiO2. This simple, yet effective method is mainly based on size-exclusion as a mean toward preferential decomposition. It was hypothesized controlled mesoporous …

Harmful Algal Blooms And Biological Toxins Productions; From Integrated Monitoring Approach To On-Site Solar Photocatalytic Decomposition, Hesam Zaman Khan Malayeri

Civil Engineering Dissertations - Archive

Occurrence of Harmful Algal Blooms (HABs) worldwide has caused concern to environmental and health authorities because of their potential to generate and release biological toxins. In particular, microcystins (MCs) produced from cyanobacteria are of great concern. MCs are among the most powerful natural poisons. The presence of MCs in drinking water sources has raised major concern. The overall goal of this research is to predict formation of biological toxins in water bodies and to develop a new sustainable approach to decompose them, if feasible, on-site and in real-time with minimal efforts, less chemicals, and low energy inputs. In order to …

Moisture Distribution Efficiency And Performance Evaluations Of Bioreactor Landfill Operations, Md Zahangir Alam

Civil Engineering Dissertations - Archive

Bioreactor landfills are operated in a modern engineered way to accelerate waste decomposition, gas production, and waste stabilization. The major aspect of a bioreactor landfill operation is associated with the addition of supplemental liquid or leachate recirculation, and the effective operation primarily depends on efficient moisture distribution throughout the waste mass, which enhances performance. The performance of an effective landfill operation can be assessed by several indicators, i.e., leachate generation, gas production, and landfill settlement. Bioreactor landfill operations have several significant economic and environmental advantages, but the impact of efficient moisture distribution and the assessment of performance through combined indicators …

Investigation Of Fiber-Reinforced Concrete Crack Width Measurement By Finite Element Method, Sina Abhaee

Civil Engineering Theses - Archive

This study presents numerical and experimental investigations of flexural cracking, post-cracking strength, and fracture energy of the dry-cast synthetic fiber reinforced concrete (FRC). Notched and un-notched beams for two fiber volume fractions were tested under flexural loading based on the recommendations of RILEM TC 162-TDF and ASTM C1609. The crack profile in terms of crack propagation and crack width, was assessed, using the two-dimensional digital image correlation (2D DIC) technique. Images of the specimen’s surface were captured during the test, and, surface deformation field was obtained by means of 2D DIC analysis. The nonlinear, 3D finite element method (FEM) modeling …

Application Of Wavelet Transform In Structural Health Monitoring, Yashodhya Swarna Sri Dhanapala Liyana Kankanamge

Masters Theses

Structural Health Monitoring (SHM) is a process of implementing a damage detection strategy in structures to evaluate the condition of existing structures to ensure the safety of users in the future. The changes in the material, geometric and/or structural properties affect structural responses, which can be captured and analyzed for condition assessment. Various vibration-based damage detection algorithms have been developed in the past decades. Among them, the Continuous Wavelet Transform (CWT) gained popularity as an efficient method of signal processing to build a framework to identify model properties and detect damage in structures. In this study, the application of wavelet …

Safety Benefit Analysis Of Alternative Delineation Practices In Michigan, Brenda C. Burdick

Masters Theses

Among the many aspects of roadway design, one important system is roadway delineation. The main purposes of roadway delineation include regulating, warning, and guiding drivers in a safe manner. Delineation systems have the potential to reduce crashes. This research sought to perform safety benefit analysis of roadway delineation practices in Michigan. Through literature review, several delineation practices, selection criteria, and previously developed crash modification factors were researched. Even though several pavement marking materials have been implemented in Michigan, a safety benefit analysis of various materials had not been performed. Sites were selected, and pavement marking material inventory data were combined …

Bim Innovation Capability Programme: An Irish Bim Study, Barry Mcauley, Alan Hore, Roger West

Articles

In 2011 the Royal Institute of Architects Ireland (RIAI) conducted a survey which found that BIM adoption within Ireland was quite low at 16%. Over the last five years these figures have risen significantly, with the 2016 Irish Digital Transition Survey reporting that 76% of respondents possess confidence in their organisation’s BIM skills and knowledge. This represents a significant shift of BIM adoption in Ireland over the last five years.

The BIM Innovation Capability Programme (BICP) Irish BIM study, builds on the findings from the BICP Global BIM Study by providing an in depth review of BIM in Ireland with …

Multimedia Techniques For Construction Education And Training, Wayne A. Bunnell

Open Access Theses

The current profession of civil engineering often focuses education and training on code compliance rather than constructability and construction techniques. Also, it is well accepted that it takes a decade or more for engineers to develop a high-level project construction understanding and many state departments of transportation rely on in-field training for entry-level inspectors, with little or no education provisions for contractors. This research investigated the use of time-lapse photography to develop training and education material that will improve the understanding of project construction and crucial quality control specifications of an entry-level engineer, contractor, or inspector. Overall, the project team …