Electronic Devices and Semiconductor Manufacturing Commons^™

Z-Source Inverter For Automotive Applications, Omar Ellabban, Joeri Van Mierlo

Omar Ellabban

No abstract provided.

Capacitor Voltage Control Techniques Of The Z-Source Inverter: A Comparative Study, Omar Ellabban, Joeri Van Mierlo, Philippe Lataire

Omar Ellabban

The Z-source inverter (ZSI) is a recently proposed single-stage power conversion topology. It adds voltage boost capability for complementing the usual voltage buck operation of a traditional voltage source inverter (VSI) with improved reliability. In this paper, a single-loop and dual-loop capacitor voltage control techniques for the ZSI are digitally designed based on a third order small signal model of the ZSI, implemented using a digital signal processor (DSP) and compared. Simulation and experimental results of a 30 kW ZSI during input voltage changes, load disturbances and steady state operations are presented and compared. The results show that the dual-loop …

Multi-Hole Waveguide Directional Couplers, Mahmoud Moghavvemi, Hossein Ameri Mahabadi, Farhang Alijani

Hossein Ameri Mahabadi

1. Introduction The directional couplers are inherently assumed as four-port devices, which consisted of two transmission lines that are electromagnetically coupled to each other. The first port is named as input, and the second one as output or transmitted, the third one as sampling or coupled and the fourth one as isolated or terminated. By using a special design the input power is divided between output and coupled port in a certain ratio named coupling factor. The required value for coupling factor P1/P3 defines the range of applications for directional couplers. Based on the application, coupling factor could be any …

Recovery Time Of The Schottky-Pin Limiter, Chin-Leong Lim

Chin-Leong Lim

The Schottky-PIN limiter has a ~8dB lower limiting threshold than the self-biased PIN limiter. Following the cessation of overdrive, the limiter requires some time to return to a low-loss state. This transitory state, which is known as the recovery time or blind/dead time, disrupts communication and causes information loss. Unlike the self-biased PIN limiter, there is a dearth of information pertaining to the recovery time of the PIN-Schottky limiter. This work characterizes the most popular form of the PIN-Schottky limiter and also proposes a simple modification to speed up its recovery time. We measured recovery times of >2000uS and 130uS …

Reduce Losses In Rf Schottky-Pin Limiter Circuits, Chin-Leong Lim

Chin-Leong Lim

Limiters can protect wireless receivers from physical damage and information loss. The Schottky-PIN limiter is especially protective because its limiting threshold is ~10dB lower than that of the self-biased PIN limiter. Unfortunately, the limiter diodes have parasitic capacitances that create insertion loss. Moreover, the extra diode in the Schottky-PIN limiter increases its loss over that of the PIN diode-only limiter. Techniques to minimize the parasitic capacitances include using bare chip, air cavity packaging, diode stacking, mesa construction, isolating the Schottky diode from the signal path and connecting the diodes to a low impedance node. But the aforementioned techniques either sacrifice …

Speed Sensorless Torque Control Of An Ipmsm Drive With Online Stator Resistance Estimation Using Reduced Order Ekf, Emad Gameil Shehata E. G. Shehata

Emad Gameil Shehata E. G. Shehata

Speed sensorless control of an interior permanent magnet synchronous motor (IPMSM) based on direct torque control (DTC) is proposed in this paper. The rotor speed and position of the IPMSM are estimated based on an active flux concept, where, the active flux vector position is identical to the rotor position. The proposed algorithm does not require neither high frequency injection signal nor complicated schemes even at vary low speed operation. Torque/ flux sliding mode controller (SMC) combined with space vector modulation is proposed to improve the performance of the classical DTC. Stator resistance value is required for a stator flux …

Digital Control Of Three Phase Three-Stage Hybrid Multilevel Inverter, Saad Mekhilef

Saad Mekhilef

Three-stage 18-level hybrid inverter design with novel control method is presented. The inverter consists of main high-, medium-, and low-voltage stages connected in series from the output side. The high-voltage stage is a three-phase, six-switch conventional subinverter. Themedium- and low-voltage stages are made of three-level subinverters constructed by H-bridge units. The proposed control strategy assumes a reference input voltage vector and aims to approximate it to the nearest inverter vector. The control concept is based on holding the high-voltage state as long as it is feasible to do so. The reference voltage vector has been represented in a 60 -spaced …

Free Standing Gan Nano Membrane By Laser Liftoff Method, Liang Tang, Yuefeng Wang, Gary Cheng, Michael Manfra, Timothy Sands

Yuefeng Wang

In this work, we present a method able to fabricate thin GaN nanomembranes fit for device applications. Starting from commercial GaN on sapphire substrates, MBE was used to deposit a sacrificial layer, which comprises of a superlattice of InN/InGaN, after which thin a GaN film of hundreds of nanometers thickness was grown on top. Pulsed laser irridiation with photon energy of 2.3eV gives rise to the controlled decomposition of the sacrificial intermediate layer, which can be followed by easy separation of the top GaN membrane from the substrate. This process can be used to manufacture GaN membranes with low defect …

Switch Yard Operation In Thermal Power Plant(Katpp Jhalawar Rajasthan), Radhey Shyam Meena Er.

Radhey Shyam Meena

Switchyard Provides the facilities for switching ,protection & Control of electric power. To handle high Voltage power with proper Safety measures. To isolate the noises coming from the grid with true 50Hz power SWITCH YARD IS IMPORTANT PART IN THERMAL PLANT. IN KALISINDH THERMAL 400KV AND 220KV SWITCH YARD LOCATED.

Analysis And Implementation Of Transformerless Lcl Resonant Power Supply For Ozone Generation, Saad Mekhilef

Saad Mekhilef

This paper describes the analysis and design of an LCL resonant power supply for ozone generation. The main advantage of the proposed topology is the absence of high-voltage transformer; the high voltage gain is achievable by means of doubleresonance phenomena. Furthermore, the bandwidth is wider than the ordinary LC and its phase difference is constant over specific frequency range; as a result, an open-loop operation can be implemented. The complete analysis and design procedure of the power supply is presented. The design procedure is verified by implementing the power supply to drive a dielectric barrier discharge prototype ozone chamber. The …

Itex2012 Gold Medal, Prof.Dr. Mahmoud Magha Vvemi, Hossein Ameri Mahabadi, Aliyar Attaran

Hossein Ameri Mahabadi

This is to certify that PROF.DR. MAHMOUD MAGHA VVEMI, HOSSEIN AMERI, ALIYAR ATTARAN has been awarded the ITEX GOLD MEDAL for the invention SIGNAL INTEGRITY ENHANCEMENT IN C-BAND RADIO LINK SYSTEM CONSIDERING JITTER AND PHASE PRECISION at the 23rd International Invention, Innovation & Technology Exhibition ITEX2012 Kuala Lumpur, Malaysia 17th_ 19th May 2012

Interfacial And Electrokinetic Characterization Of Ipa Solutions Related To Semiconductor Wafer Drying And Cleaning, Jin-Goo Park, Sang-Ho Lee, Ju-Suk Ryu, Yi-Koan Hong, Tae-Gon Kim, Ahmed A. Busnaina

Jin-Goo Park

In this study, the interfacial and electrokinetic phenomena of mixtures of isopropyl alcohol (IPA) and deionized (DI) water in relation to semiconductor wafer drying is investigated. The dielectric constant of an IPA solution linearly decreased from 78 to 18 with the addition of IPA to DI water. The viscosity of IPA solutions increased as the volume percentage of IPA in DI water increased. The zeta potentials of silica particles and silicon wafers were also measured in IPA solutions. The zeta potential approached neutral values as the volume ratio of IPA in DI water increased. A surface tension decrease from 72 …

Experimental And Numerical Investigation Of Nanoparticle Removal Using Acoustic Streaming And The Effect Of Time, Kaveh Bakhtari, Rasim O. Guldiken, Prashanth Makaram, Ahmed A. Busnaina, Jin-Goo Park

Jin-Goo Park

Theremoval of nanoparticles is becoming increasingly challenging as the minimumlinewidth continues to decrease in semiconductor manufacturing. In this paper,the removal of nanoparticles from flat substrates using acoustic streamingis investigated. Bare silicon wafers and masks with a 4 nmsilicon cap layer are cleaned. The silicon-cap films are usedin extreme ultraviolet masks to protect Mo–Si reflective multilayers. Theremoval of 63 nm polystyrene latex (PSL) particles from these substratesis conducted using single-wafer megasonic cleaning. The results show higherthan 99% removal of PSL nanoparticles. The results also showthat dilute SC1 provides faster removal of particles, which isalso verified by the analytical analysis. Particle removal …

Effect Of Different Deposition Mediums On The Adhesion And Removal Of Particles, S. Hu, Tae-Hoon Kim, Jin-Goo Park, Ahmed A. Busnaina

Jin-Goo Park

The purpose of this study is to investigate the effect of the different deposition mediums on the adhesion and removal of particles. Polystyrene latex (PSL) particles (50 µm) are deposited on thermal oxide and silicon nitride coated silicon wafers using different suspension mediums: air, isopropyl alcohol (IPA), and deionized water and then removed in a dry environment. The results show that PSL particles deposited on oxide are easier to remove than those on nitride due to a higher van der Waals force in all deposition mediums. In addition, dry particles deposited in air are much easier to remove than those …

Experimental And Analytical Study Of Submicrometer Particle Removal From Deep Trenches, Kaveh Bakhtari, Rasim O. Guldiken, Ahmed A. Busnaina, Jin-Goo Park

Jin-Goo Park

Particle removal from patterned wafers and trenches presents a tremendous challenge in semiconductor manufacturing. In this paper, the removal of 0.3 and 0.8 µm polystyrene latex (PSL) particles from high-aspect-ratio 500 µm deep trenches is investigated. An experimental, analytical, and computational study of the removal of submicrometer particles at different depths inside the trench is presented. Red fluorescent polystyrene latex (PSL) particles were used to verify particle removal. The particles are counted using scanning fluorescent microscopy. A single-wafer megasonic tank is used for the particle removal. The results show that once a particle is removed from the walls or the …

Planning Of Low-Cost 77-Ghz Radar Transceivers For Automotive Applications, Hossein Ameri Mahabadi, A. Attaran, M. Moghavvemi

Hossein Ameri Mahabadi

The key to prevent driving accidents by automotive radar systems at high speed is to have optimum and accurate estimation of position representation and fast visualization of the environment.

Response Characterization Of Electroactive Polymers As Mechanical Sensors, G. Alici, Geoffrey M. Spinks, J. D. Madden, Y. Wu, G G. Wallace

Gursel Alici

The characterization of the dynamic response (including transfer function identification) of trilayer polypyrrole (PPy) type conducting polymer sensors is presented. The sensor was built like a cantilever beam with the free end stimulated through a mechanical lever system, which provided displacement inputs. The voltage generated and current passing between the two outer PPy layers as a result of the input was measured to model the output/input behavior of the sensors based on their experimental current/displacement and voltage/displacement frequency responses. We specifically targeted the low-frequency behavior of the sensor as it is a relatively slowsystem. Experimental transfer function models were generated …

An Improved Particle Swarm Optimization (Pso)–Based Mppt For Pv With Reduced Steady-State Oscillation, Saad Mekhilef

Saad Mekhilef

No abstract provided.

Universal Computer Aided Design For Electrical Machines, Aravind Cv, Grace I, Rozita Teymourzadeh, Rajkumar R, Raj R, Wong Yv

Dr. Rozita Teymourzadeh, CEng.