Public Policy Commons^™

Ddasaccident346, Hd-Aid

Global CWD Repository

13:00 Start of work in the minefield. Team leader issued a task for marking the borders between the cleared and suspect areas with a mine tape. A minute before the explosion did happen he spoke to the injured deminer, tasking him with a particular piece of border to mark. The moment he went up to the top of the riverbank explosion happened.

Ddasaccident434, Hd-Aid

Global CWD Repository

In this case the victims were working with the “special police force” engaged in demining when they initiated a PROM-1. One suffered “heavy body injuries… while mine clearing” and the other was killed.

Ddasaccident275, Hd-Aid

Global CWD Repository

The victim was continuing the breach begun by the earlier victim. He worked a further ten metres and checked the lane with his detector as he walked back towards the safe area. As he passed the site of the earlier accident, he got a slight detector reading and began to investigate with his prod. The mine detonated.

Ddasaccident296, Hd-Aid

Global CWD Repository

Wearing his visor and armour apron, the victim swept the ground with his detector and noticed no signal. He then got up to cut vegetation and, at 0825 hours, detonated an R2M2 mine by stepping on it. “He sustained traumatic high velocity blast amputation of the right foot with sparing of the ipsilateral ankle joint. He also sustained first degree burns to the right arm”. The site supervisor corrected this to “part of” his right foot being amputated.

Improved Anti-Personnel Mine Neutralization Device Test Report, Christopher Wanner

Global CWD Repository

This report describes the results and analysis of the field test of the Improved Anti Personnel Mine Neutralization Device (APMINUD). This is the second test of this equipment and follows a six month design and engineering effort on the equipment to correct and improve upon deficiencies identified in the initial version of the APMINUD.

The APMINUD is a mechanical tool designed to safely detonate antipersonnel landmines as part of a peace time clearance operation. The APMINUD consists of a mobile blast and fragment containment shell, with a mechanical striker inside. It can be used in conjunction with a shielded, all …

Ddasaccident335, Hd-Aid

Global CWD Repository

The accident occurred on land described as “agricultural, soft ground”. The demining group was engaged in Surveys (Levels 1 and 2). He found mines one on each side of the boundary lane and showed these to the supervisor. He was told to move the markers indicating the safe lane. As he turned, he stepped on a missed mine that was between the other two.

Ddasaccident321, Hd-Aid

Global CWD Repository

The accident occurred in a mined area that had been worked on at the provincial government request since January 10th 2000. The method used was conventional manual demining. At 06:51 “while working in a dense vegetation area, the deminer used a machete to cut some branches “… He dragged the cut branches out and heard a “strange click”. He ran about “15 metres into a cleared area and took cover a few seconds before the F1-grenade exploded”.

Ddasaccident264, Hd-Aid

Global CWD Repository

The Team Leader could not see any devices and had turned to call the Site Supervisor at 11:50 when a BLU-97 on the other side of the fence detonated. The boy "suffered a cut nose" and the Team Leader "was deafened in his right ear and received minor metal fragmentation… to his lower right calf".

Assessment Of Rehabilitation Services In Liberia, Usaid-Leahy

Global CWD Repository

From January 15-25, 2000, a three-person, Leahy War Victims Fund (LWVF) team, and the USAID/Liberia health officer conducted an assessment of fund activities in Liberia. The purpose of the assessment was to review the status of activities funded under the LWVF grant to UNICEF/Liberia, and to make recommendations concerning possible follow-on activities with additional funding from the War Victims Fund.

Itf Enhancing Human Security Annual Report 2000, Itf-Enhancy Human Security

Global CWD Repository

ITF Annual Report 2000

The Role Of Civil Affairs In Mine Action, Cisr

Global CWD Repository

This study, “The Role of Civil Affairs in Mine Action,” is not intended to be read from cover to cover by most users. It has been researched and written with three target audiences in mind: 1) the Mine Action official who would like to learn more about the application of Civil Affairs capabilities to humanitarian demining activities, 2) the Civil Affairs officer who would like to learn more about challenges and actions within the realm of humanitarian demining operations, and 3) US military officials who have a responsibility for, or an interest in, the proper unit design and uses of …

Ddasaccident315, Hd-Aid

Global CWD Repository

The accident occurred at 10:45 on December 24th 1999 during the manual demining of power lines between Maputo and Komatiport at the 88th tower about 8km from Moamba Town. The deminer was injured in an area considered to be densely mined during an attempt to enlarge the cleared area from 20 square metres to 40 square metres. While trying to cut some shrubs he made a "false move" and activated a mine outside his lane with his left foot. The mine was outside the "ring" and below a tree.

Developing And Integrating A Lessons Learned Methodology For Humanitarian Mine Action, Cisr Jmu

CISR Studies and Reports

The demand for a centralized lessons learned database has made it clear that there is value in consolidating the experience derived from the numerous de-mining missions by a variety of teams in a variety of countries. Consequently, the James Madison University Mine Action Information Center developed a methodology for collecting, validating, and distributing lessons-learned within the mine action community.

Ddasaccident263, Hd-Aid

Global CWD Repository

As the Team Leader was looking for any signs of the benchmark or any other marking from the site, he used a track well used by the locals. This track had hazard warning tape leading down (red and white chevron tape), either side of it forming a corridor. There were no mine signs or any other signs of restricting access and the track was marked in a way that it should be safe to use. The Victim was tasked to park 15 metres down the track and the Team Leader and the Victim alighted from the vehicle. The Team Leader …

Ddasaccident317, Hd-Aid

Global CWD Repository

The accident took place in a mined area 30k North West of Beira along the Beira-Mwanza road. The victim was told by the Deputy Platoon Commander to take a hoe and a garden spade to the place marked with four red sticks and dig it out to find the metal that was making the detector signal. The victim started to dig at the place. He was not wearing protective equipment. After digging for ten minutes, at 06:20 the hoe he was using detonated a Type-72a mine [both 72a and 72b are mentioned in the varied papers].

Ddasaccident316, Hd-Aid

Global CWD Repository

The accident occurred in a defensive ring of mines laid during 1987. The ring formed part of the protection to Marrumbene Villa. The victim’s partner had marked a signal from his metal detector. The victim went forward and started to probe the ground. The mine was at an angle in the ground. At 11:45 he probed onto and detonated a mine.

Ddasaccident254, Hd-Aid

Global CWD Repository

The victim was working in an area of low brush adjacent to a (then) disused farm vehicle track. He was clearing a working lane along a line of PMA-2 mines and his team had found two that morning (one found by the victim). At 11:30 he initiated a PMA-2 by stepping on the mine with his right foot.

Ddasaccident262, Hd-Aid

Global CWD Repository

After lunch four of the deminers were tasked to build a bridge over a creek to allow better access to the area being cleared. The remaining deminer and the supervisor cleared a one metre wide lane in order to examine a tripwire that had been spotted outside the working area. When they got close to the tripwire the supervisor took over clearance and worked for 20 minutes. Then he "stood up, turned around and requested two more small pickets to mark his lane". While doing this he "lost his footing" and took a step backwards over his base stick with …

Ddasaccident305, Hd-Aid

Global CWD Repository

The accident occurred in a minefield called Palkie that was laid in 1970s. The contamination was such that a metal detector could not be used in some places and a “clearance by excavation” method was used. In one place where a shell had dropped, the victim was excavating using a Russian bayonet when he initiated a mine.

Ddasaccident404, Hd-Aid

Global CWD Repository

A roof of the devastated house is burnt so there were pieces of metal parapets left on sides. Incident was due to a piece of parapet that fell to the ground and activated KB1 cluster bomb. The fallen piece of parapet and the wall of the house took almost all the bomblets [fragments] from KB1. One of them injured an SFOR supervisor in the upper part of his thigh while a deminer was injured under a rib. These were all minor injuries and the bomblets [fragments] were taken out in the hospital. The medic was close to the incident site …

Ddasaccident304, Hd-Aid

Global CWD Repository

The accident occurred when an EOD worker was making a final check over the cleared area. He then discovered a partly buried mortar (PD M-6) fuze. The fuze was already taken apart. The booster was removed and no safety pins (two) were in place. When the EOD worker handled the fuse the striker “sledged and initiated the detonator”.

Ddasaccident255, Hd-Aid

Global CWD Repository

The victim, was clearing a lane past the remains of a dead cow and was already a metre past the cow when the accident occurred. While the victim was sweeping with the mine detector he received a signal on the right 10-cm overlap of the lane he was busy clearing. The ground at the accident site sloped slightly to the right of the lane. The victim started to prod in the area of the signal by using the prodder. When he was prodding on the right of his base stick, he activated an explosive device. This occurred at approximately 13:00.

Ddasaccident357, Hd-Aid

Global CWD Repository

The accident had taken place at 1245hrs; the injured deminer arrived at Emergency hospital in Sulymania at 1400hrs and was admitted. The prodder which he had been using was badly damaged and had taken on the shape of a half moon. This indicated that the point of the prodder had detonated the mine.

Ddasaccident256, Hd-Aid

Global CWD Repository

The victim was engaged in widening a breaching lane at 13:40 when the accident occurred. He was not using approved marking methods [using none] and the accident occurred 3 metres in front of his base stick. His equipment had been removed from the site but witnesses confirmed that the victim's visor and prodder were some metres behind the victim [visor not worn] and that the handle of his trowel was a metre from the accident site

Ddasaccident260, Hd-Aid

Global CWD Repository

The victim was cutting an exploratory lane "to identify the direction of the Plough share mines". This appears to have been done by identifying a picket (post on which the plough share mines were originally placed) and working towards the next. The victim missed the next picket and returned to a place 30 metres from the last picket. "This is the normal drill to be used when row direction is lost". The victim did not use the correct marking and clearance procedures. He was investigating a detector reading at 08:15 when the accident occurred.

Ddasaccident347, Hd-Aid

Global CWD Repository

Deminer worked in a minefield with a metal detector on a metal contaminated ground. While lifting the detector’s head from the surface towards the turf, the detector must have been slanted so it could have easily activated the PROM’s detonator if it was to be at the edge of the turf.

Ddasaccident352, Hd-Aid

Global CWD Repository

This accident occurred because the deminer activated a PROM mine, it is not possible to prove how the fuse was activated. In view of the fact that the deminers on the site were consistently exceeding established productivity rates by an excessively large amount, it is the view of the Board that the excessive operating speed was the major contributing factor.

Ddasaccident582, Hd-Aid

Global CWD Repository

A deminer detonated a mine while about to undertake prodding/excavation of a metal-detector indication. It is thought that the light plastic cross used as a marker for the metal-detector indication got moved by the wind and he knelt directly onto the mine.

Ddasaccident351, Hd-Aid

Global CWD Repository

A failure to find the PROM-1 mine before the break proved fatal for both deminers, as the new No 1, who had been No 2 prior to the break, more than likely stepped on the mine unknowingly, in the presumed ‘cleared’ area, while both deminers were probably about to don their PPE before start of work.

Ddasaccident350, Hd-Aid

Global CWD Repository

The accident occurred due to the activation of a grenade fuze by indentation of the percussion cap. The fuze was disturbed or activated by the deminer. The fuze is comparatively new. The accident site had been interfered with and evidence that may removed or destroyed.