Fluid Dynamics Commons^™

Complex Ciliary Flows Around Stentor Polymorphus In Solutions Of 2% Buttermilk And Chlamydomonas Reinhardtii, Eliana B. Smithstein

Scripps Senior Theses

Stentor are large, unicellular ciliates of the Heterotricha order. They live in both freshwater and marine habitats and are mostly found in ponds. I studied Stentor polymorphus, which is a species of Stentor only recently discovered to be lab culturable. They range from 0.5-1.5mm in length and are unusual because they live with endosymbiotic algae and are much more likely than other, more widely studied, species of Stentor to form aggregates while they are eating. There are three main components to this thesis: First, I established protocols for keeping a viable S. polymorphus culture, since no protocols had been …

Developing A Uas-Deployable Methane Sensor Using Low-Cost Modular Open-Source Components, Gavin Demali

Williams Honors College, Honors Research Projects

This project aimed to develop a methane sensor for deployment on an unmanned aerial system (UAS), or drone, platform. This design is centered around low cost, commercially available modular hardware components and open source software libraries. Once successfully developed, this system was deployed at the Bath Nature Preserve in Bath Township, Summit County Ohio in order to detect any potential on site fugitive methane emissions in the vicinity of the oil and gas infrastructure present. The deliverables of this project (i.e. the data collected at BNP) will be given to the land managers there to better inform future management and …

Fluid Transport In Porous Media For Engineering Applications, Eric M. Benner

Chemical and Biological Engineering ETDs

This doctoral dissertation presents three topics in modeling fluid transport through porous media used in engineering applications. The results provide insights into the design of fuel cell components, catalyst and drug delivery particles, and aluminum- based materials. Analytical and computational methods are utilized for the modeling of the systems of interest. Theoretical analysis of capillary-driven transport in porous media show that both geometric and evaporation effects significantly change the time dependent behavior of liquid imbibition and give a steady state flux into the medium. The evaporation–capillary number is significant in determining the time-dependent behavior of capillary flows in porous media. …

Physical Applications Of The Geometric Minimum Action Method, George L. Poppe Jr.

Dissertations, Theses, and Capstone Projects

This thesis extends the landscape of rare events problems solved on stochastic systems by means of the \textit{geometric minimum action method} (gMAM). These include partial differential equations (PDEs) such as the real Ginzburg-Landau equation (RGLE), the linear Schroedinger equation, along with various forms of the nonlinear Schroedinger equation (NLSE) including an application towards an ultra-short pulse mode-locked laser system (MLL).

Additionally we develop analytical tools that can be used alongside numerics to validate those solutions. This includes the use of instanton methods in deriving state transitions for the linear Schroedinger equation and the cubic diffusive NLSE.

These analytical solutions are …

A High Quality, Eulerian 3d Fluid Solver In C++, Lejon Anthony Mcgowan

Computer Science and Software Engineering

Fluids are a part of everyday life, yet are one of the hardest elements to properly render in computer graphics. Water is the most obvious entity when thinking of what a fluid simulation can achieve (and it is indeed the focus of this project), but many other aspects of nature, like fog, clouds, and particle effects. Real-time graphics like video games employ many heuristics to approximate these effects, but large-scale renderers aim to simulate these effects as closely as possible.

In this project, I wish to achieve effects of the latter nature. Using the Eulerian technique of discrete grids, I …

A Physics-Based Approach To Modeling Wildland Fire Spread Through Porous Fuel Beds, Tingting Tang

Theses and Dissertations--Mechanical and Aerospace Engineering

Wildfires are becoming increasingly erratic nowadays at least in part because of climate change. CFD (computational fluid dynamics)-based models with the potential of simulating extreme behaviors are gaining increasing attention as a means to predict such behavior in order to aid firefighting efforts. This dissertation describes a wildfire model based on the current understanding of wildfire physics. The model includes physics of turbulence, inhomogeneous porous fuel beds, heat release, ignition, and firebrands. A discrete dynamical system for flow in porous media is derived and incorporated into the subgrid-scale model for synthetic-velocity large-eddy simulation (LES), and a general porosity-permeability model is …

Computational Fluid Dynamics Is Key To Better Flying Aircraft, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.

Parallel Two-Dimensional Unstructured Anisotropic Delaunay Mesh Generation For Aerospace Applications, Juliette Kelly Pardue

Computer Science Theses & Dissertations

A bottom-up approach to parallel anisotropic mesh generation is presented by building a mesh generator from the principles of point-insertion, triangulation, and Delaunay refinement. Applications focusing on high-lift design or dynamic stall, or numerical methods and modeling test cases focus on two-dimensional domains. This push-button parallel mesh generation approach can generate high-fidelity unstructured meshes with anisotropic boundary layers for use in the computational fluid dynamics field.

Advantages Of A Finite Extensible Nonlinear Elastic Potential In Lattice Boltzmann Simulations, Tai-Hsien Wu, Dewei Qi

The Hilltop Review

A new structure, generalized lattice nonlinear spring model (GLNSM), which adopts non-linear FENE-LJ potential instead of harmonic potential, has been coupled with lattice Boltzmann simulation for solving fluid-solid interaction problem. In this article, a significant work is the relationship between the GLNSM (FENE-LJ potential) and Young’s modulus has been described in detail. A validation has also been presented to prove that GLNSM is reliable.

Smarticles: A Method For Identifying And Correcting Instability And Error Caused By Explicit Integration Techniques In Physically Based Simulations, Susan Aileen Marano

Master's Theses

Using an explicit integration method in physically based animations has many advantages including conceptual and computational simplicity, however, it re- quires small time steps to ensure low numerical instability. Simulations with large numbers of individually interacting components such as cloth, hair, and fluid models, are limited by the sections of particles most susceptible to error. This results in the need for smaller time steps than required for the majority of the system. These sections can be diverse and dynamic, quickly changing in size and location based on forces in the system. Identifying and handling these trou- blesome sections could allow …

Type Ii Quantum Computing Algorithm For Computational Fluid Dynamics, James A. Scoville

Theses and Dissertations

An algorithm is presented to simulate fluid dynamics on a three qubit type II quantum computer: a lattice of small quantum computers that communicate classical information. The algorithm presented is called a three qubit factorized quantum lattice gas algorithm. It is modeled after classical lattice gas algorithms which move virtual particles along an imaginary lattice and change the particles’ momentums using collision rules when they meet at a lattice node. Instead of moving particles, the quantum algorithm presented here moves probabilities, which interact via a unitary collision operator. Probabilities are determined using ensemble measurement and are moved with classical communications …