Fluid Dynamics Commons^™

Efficient Dynamic Unstructured Methods And Applications For Transonic Flows And Hypersonic Stage Separation, Xiaobing Luo

Mechanical & Aerospace Engineering Theses & Dissertations

Relative-moving boundary problems have a wide variety of applications. They appear in staging during a launch process, store separation from a military aircraft, rotor-stator interaction in turbomachinery, and dynamic aeroelasticity.

The dynamic unstructured technology (DUT) is potentially a strong approach to simulate unsteady flows around relative-moving bodies, by solving time-dependent governing equations. The dual-time stepping scheme is implemented to improve its efficiency while not compromising the accuracy of solutions. The validation of the implicit scheme is performed on a pitching NACA0012 airfoil and a rectangular wing with low reduced frequencies in transonic flows. All the matured accelerating techniques, including the …

Vortex Wake And Exhaust Plume Interaction, Including Ground Effect, Ihab Gaber Adam

Mechanical & Aerospace Engineering Theses & Dissertations

Computational modeling and studies of the near-field wake-vortex turbulent flows, far-field turbulent wake-vortex/exhaust-plume interaction for subsonic and High Speed Civil Transport (HSCT) airplane, and wake-vortex/exhaust-plume interaction with the ground are carried out. The three-dimensional, compressible Reynolds-Averaged Navier-Stokes (RANS) equations are solved using the implicit, upwind, Roe-flux-differencing, finite-volume scheme. The turbulence models of Baldwin and Lomax, one-equation model of Spalart and Allmaras and two-equation shear stress transport model of Menter are implemented with the RANS solver for turbulent-flow modeling.

For the near-field study, computations are carried out on a fine grid for a rectangular wing with a NACA-0012 airfoil section and …

A Study Of The Numerical Implementation Of Multidisciplinary Design Optimization Strategies, Rodney A. Taylor

Mechanical & Aerospace Engineering Theses & Dissertations

Design optimization provides an organized, systematic, and efficient method for obtaining design improvements based upon a specified measure of design performance. In the multidisciplinary design optimization (MDO) environment efficient optimization techniques allow complex designs to be improved by managing conflicting disciplinary design goals so as to improve the global design. This thesis studies the implementation issues surrounding MDO techniques and strategies. To facilitate this investigation two testbed problems have been selected for study. These problems consider two approaches to the conceptual design of an aeroelastic wing. The first approach is based on an idealized, two-dimensional representation of an airfoil under …

Wing-Section Optimization For Supersonic Viscous Flow, Cem Cihan Item

Mechanical & Aerospace Engineering Theses & Dissertations

The recent interest in the High Speed Civil Transport (HSCT) has resulted in renewed research studies of optimized supersonic cruise transport configurations. Incorporation of flow viscosity effects in the design process of such a supersonic wing is currently under investigation. This may lead to more accurate problem formulations and, in tum, greater aerodynamic efficiency than can be obtained by the traditional, inviscid, linear theories. In this context, for a design code to be a candidate for a complex optimization problem, such as three-dimensional viscous supersonic wing design, it should be validated using simpler building-block shapes.

To optimize the shape of …

Simulation Of Active Control Of Asymmetric Flows Around Slender Pointed Forebodies, Hazem Sharaf El-Din

Mechanical & Aerospace Engineering Theses & Dissertations

At high angles of attack, the flowfield over slender forebodies becomes asymmetric with substantial side force, which may exceed the available control capability. The unsteady compressible Navier-Stokes equations are used to investigate the effectiveness of different active control methods to alleviate and possibly eliminate the flow asymmetry and the subsequent side force. Although the research work focuses on active control methods, a passive control method has been investigated. The implicit, Roe flux-difference splitting, finite volume scheme is used for the numerical computations. Both locally-conical and three-dimensional solutions of the Navier-Stokes equations are obtained.

The asymmetric flow over five-degree semi-apex angle …

Investigation Of Computational And Spectral Analysis Methods For Aeroacoustic Wave Propagation, Florence Odile Vanel

Mechanical & Aerospace Engineering Theses & Dissertations

Most computational fluid dynamics (CFD) schemes are not adequately accurate for solving aeroacoustics problems, which have wave amplitudes several orders of magnitude smaller yet with frequencies larger than the flow field variations generating the sound. Hence, a computational aeroacoustics (CAA) algorithm should have minimal dispersion and dissipation features. A dispersion relation preserving (DRP) scheme is, therefore, applied to solve the linearized Euler equations in order to simulate the propagation of three types of waves, namely: acoustic, vorticity, and entropy waves. The scheme is derived using an optimization procedure to ensure that the numerical derivatives preserve the wave number and angular …

Unsteady Flow Simulations About Moving Boundary Configurations Using Dynamic Domain Decomposition Techniques, Guan-Wei Yen

Mechanical & Aerospace Engineering Theses & Dissertations

A computational method is developed to solve the coupled governing equations of an unsteady flowfield and those of rigid-body dynamics in six degrees-of-freedom (6-DOF). This method is capable of simulating the unsteady flowfields around multiple component configurations with at least one of the components in relative motion with respect to the others. Two of the important phenomena that such analyses can help us to understand are the unsteady aerodynamic interference and the boundary-induced component of such a flowfield. By hybridizing two dynamic domain decomposition techniques, the grid generation task is simplified, the computer memory requirement is reduced, and the governing …

Flow Simulations About Steady-Complex And Unsteady Moving Configurations Using Structured-Overlapped And Unstructured Grids, James Charles Newman Iii

Mechanical & Aerospace Engineering Theses & Dissertations

The limiting factor in simulating flows past realistic configurations of interest has been the discretization of the physical domain on which the governing equations of fluid flow may be solved. In an attempt to circumvent this problem, many Computational Fluid Dynamic (CFD) methodologies that are based on different grid generation and domain decomposition techniques have been developed. However, due to the costs involved and expertise required, very few comparative studies between these methods have been performed. In the present work, the two CFD methodologies which show the most promise for treating complex three-dimensional configurations as well as unsteady moving boundary …

Multigrid Acceleration Of Time-Dependent Solutions Of Navier-Stokes Equations, Sarafa Oladele Ibraheem

Mechanical & Aerospace Engineering Theses & Dissertations

Recent progress in Computational Fluid Dynamics is encouraging scientists to look at fine details of flow physics of problems in which natural unsteady phenomena have hitherto been neglected. The acceleration methods that have proven very successful in steady state computations can be explored for time dependent computations. In this work, an efficient multigrid methods is developed to solve the time-dependent Euler and Navier-Stokes equations. The Beam-Warming ADI method is used as the base algorithm for time stepping calculations. Application of the developed algorithm proved very efficient in selected steady and unsteady test problems. For instance, the inherent unsteadiness present in …

Simulation Of Vertical Tail Buffet In Internal Vortex Breakdown Flows, Mark William Flanagan

Mechanical & Aerospace Engineering Theses & Dissertations

Computational simulation of vertical tail buffet in an internal vortex breakdown flow is considered. The fiuid-flow problem is formulated using the full, compressible, unsteady Navier-Stokes equations which are solved using an implicit, flux-difference splitting, finite volume scheme. The fluid-flow problem is solved in a configured circular duct using quasi-axisymmetric assumptions to simplify the flow equations. A plate is placed transverse to the incoming flow. Solution of the flow in the duct is performed with and without a rigid plate, and with and without an elastic plate. The elastic response of the plate is calculated assuming that it is a cantilever …

Application Of Sensitivity Analysis To The Euler Equations, Vamshi Mohan Korivi

Mechanical & Aerospace Engineering Theses & Dissertations

An approximation method is presented for efficiently predicting the changes which occur in a steady-state numerical solution of the Euler equations as a consequence of a small change in the geometric shape of the domain. The method is extended to develop a general procedure for calculating aerodynamic sensitivity derivatives with respect to variations of geometric shape. The techniques are implemented using an upwind cell centered finite volume formulation, and are applied to two test cases, (1) a subsonic nozzle (M_∞ = 0.85), and (2) a supersonic inlet (M_∞ = 2.0). Conventional numerical solutions are first obtained for flow …

Effect Of Passive Flow-Control Devices On The Drug Of A Tractor-Trailer Model, Jagjit K. Ahuja

Mechanical & Aerospace Engineering Theses & Dissertations

The aerodynamic drag of tractor trailers is responsible for approximately half of the fuel consumption at highway speeds (55m.p.h.). Thus, it is important that vehicle drag be reduced in order to reduce operating costs and to conserve fuel. The purpose of the subject research conducted in the Old Dominion University Low-Speed Wind Tunnel was to determine the effect of various add-on flow-control devices, such as a cab-mounted flow deflector and gap seals between the tractor and the trailer. In addition, the effect of trailer rear-edge shaping has been studied. This was accomplished by contouring the trailer's rear end. It has …

Navier-Stokes Analysis Of Cold Gas Scramjet Nozzle-Afterbody Flowfields, Walter C. Engelund

Mechanical & Aerospace Engineering Theses & Dissertations

The recent renewal of interest in hypersonic aerodynamics, brought about largely in part due to the development of the National Aerospace Plane (NASP), is resulting in an increased reliance on computational fluid dynamics for flowfield data in this flight regime. The design of the nozzle-afterbody section for a hypersonic transport such as the NASP is currently underway, and is being conducted using both computational fluid dynamics and cold, non-reacting, simulant gas experimental models. In this study, a computational analysis is conducted for the flow through a scramjet nozzle-afterbody test section.

Computations have been performed for a cold gas simulation of …

Domain Decomposition For Multigrid, Finite Volume Flow Solvers, Victor Robert Lessard

Mechanical & Aerospace Engineering Theses & Dissertations

Computing the flow fields about three-dimensional complex configurations accurately becomes a difficult task, if it is attempted to generate a single, body fitted grid with proper clustering. The domain decomposition methods, which divide the computational domain into less complex subdomains, are extensively used to decrease the grid generation workload. A domain decomposition technique also allows the use of different solution methods for different subdomains. The objective of this work is to develop a domain decomposition method via overlapping/embedding the component grids, which is to be used by upwind, multigrid, finite volume solution algorithms. A computer code, given the name MaGGiE, …

Evaluation Of Equilibrium Turbulence For A Hypersonic Boundary Layer At Nonadiabatic Wall Conditions, Cindy W. Albertson

Mechanical & Aerospace Engineering Theses & Dissertations

This paper presents an experimental study to characterize the compressible turbulent boundary layer produced along a flat plate in the NASA Langley 8-Foot High Temperature Tunnel and determine the test conditions necessary to achieve equilibrium turbulence. In addition, the present study extends the data base for equilibrium compressible turbulent boundary layers over quasi-isothermal walls which are far from the adiabatic wall temperature. The measurements consist of pilot pressure, static pressure, and total temperature distributions in the boundary layer. A flat plate measuring 9.7 feet long and 4.3, feet wide was used for the study to provide a naturally turbulent boundary …

Calculations Of Three-Dimensional Transonic Flows Using The Implicit Formulation Of The Isenthalpic Euler Equations With Flux Vector Splitting, Frank E. Cannizzaro

Mechanical & Aerospace Engineering Theses & Dissertations

A numerical method for solving three-dimensional transonic flows using the isenthalpic formulation of the Euler equations is developed. The method uses van Leer's flux vector splitting to solve the implicit formulation of the governing equations, which are applied to a cell centered finite-volume scheme. A three factor spatial approximate factorization is implemented in solving the implicit part of the governing equations. Time marching to a steady state solution requires short computational times due to the relative efficiency of the basic method. Computational times are further reduced by the implementation of the multigrid acceleration technique, which provided converged solutions in approximately …

An Evaluation Of A Taylor-Galerkin Algorithm For High Speed Inviscid Flows Using Quadrilateral And Triangular Elements, Kim S. Bey

Mechanical & Aerospace Engineering Theses & Dissertations

The Taylor-Galerkin finite element algorithm is used to obtain solutions to the two-dimensional compressible Euler equations. The mathematical formulation of the algorithm is presented for a typical scalar equation. The derivation results in element equations which are assembled over the entire solution domain to obtain the system of equations that are solved explicitly. The algorithm has the unique feature that the finite element matrices can be evaluated in closed form, avoiding expensive numerical integration. Aspects of vector programming strategies and mesh generation important to an effective analysis procedure are also described. Solutions to supersonic flow problems with exact solutions are …

Implementation Of Uniform Perturbation Method For Potential Flow Past Axisymmetric And Two-Dimensional Bodies, Tin Chee Wong

Mechanical & Aerospace Engineering Theses & Dissertations

The aerodynamic characteristics of potential flow past an axisymmetric slender body and a thin airfoil are calculated by using a uniform perturbation analysis method. The method is based on the superposition of potentials of point singularities distributed inside the body. The strength distribution satisfies a linear integral equation by enforcing the flow tangency condition on the surface of the body. The complete uniform asymptotic expansion of its solution is obtained with respect to the slenderness ratio by modifying and adapting an existing technique. Results calculated by the perturbation analysis method are compared with the existing surface-singularity-panel method and some available …