Wood Science and Pulp, Paper Technology Commons^™

Synergetic Effect Of Cellulose And Chitosan Polymers In Cancer Treatment, Grace Peterson

Graduate Theses, Dissertations, and Problem Reports (ETD)

This research explores the development of a biocompatible, natural drug delivery system designed for targeted cancer therapy. Lung cancer cells are used in these particular tests, but further research indicates treatment could be used for various cancer types. Traditional cancer treatments like chemotherapy are often limited by poor selectivity for tumor cells, causing significant damage to healthy tissues. The study proposes a dual-layered delivery system, utilizing Carboxymethyl Cellulose (CMC) as the core material and a charge-reversible chitosan shell to encapsulate and target cancer drugs. CMC, with its water solubility and ability to form stable gels, serves as a stable drug …

Production, Best Management Practices, And Market Impacts Of Forest Biomass Harvest And Collection In The Mid-Atlantic Region, William E. Smith

Graduate Theses, Dissertations, and Problem Reports (ETD)

Time motion studies were conducted at five mid-Atlantic sites that spanned various operations in West Virginia, Ohio, and Pennsylvania. The harvest systems included integrated harvests where chips were produced in the forest, roundwood systems where only roundwood was produced, and a centralized chipping system. The study collected overall productivity and machine utilization data at the various harvesting operations. The cost per green ton of woody biomass ranged from $18.46 to $39.8 resulting in an average of $30.33 among the five systems. Hauling had the highest average price per green ton at $9.10, while loading had the lowest at $1.73 per …

Evaluation Of Low-Grade Red Oak (Quercus Rubra) And Red Maple (Acer Rubrum) As A Raw-Material For Cross-Laminated Timber Panel Production, Matthew Allen Young

Graduate Theses, Dissertations, and Problem Reports (ETD)

Hardwoods in the Appalachian region are traditionally destined for use in furniture, cabinetry, pallets, and railroad ties. The expanding market for Cross Laminated Timber (CLT) is an opportunity for increased utilization of low-quality hardwoods typically used in pallets or equipment mats. Large quantities of low-grade red oak (Quercus rubra) and red maple (Acer rubrum) to be used in CLTs would provide sufficient lumber sources that could foster the growth of CLT manufacturing facilities in the state of West Virginia or Appalachia all together. The objective of this study was to determine the yield distribution of visual structural grade quality lumber …

Producing Hardwood Cross - Laminated Timber (Hclt) Mats From Low Grade Red Oak Lumber, Jonathan R. Norris

Graduate Theses, Dissertations, and Problem Reports (ETD)

The use of cross-laminated timber (CLT) has significantly grown in North America, but hardwood species have not yet been deemed a viable material to manufacture CLT panels, whereas, softwood species continue to serve as the only approved material for CLT in structural applications according to ANSI/APA PRG-320. In order to introduce hardwoods into the CLT market, we must develop non-structural CLT products that utilize low grade lumber from hardwood species. This allows hardwood manufacturers to enter the CLT market without certification, while also displaying the strength and beauty of the hardwood resources found within this region.

Of the hardwood species …

Evaluation Of Cross-Laminated Timber Panels Produced With Yellow-Poplar (Liriodendron Tulipifera), Rafael Da Rosa Azambuja

Graduate Theses, Dissertations, and Problem Reports (ETD)

Cross-Laminated Timber (CLT) panels are engineered wood products breaking into the building sector. Currently, the range of raw materials used in CLT is still limited to softwoods, while some hardwood species such as yellow-poplar could potentially be used to produce this wood product. Therefore, the main goal of this research was to assess the feasibility of using Appalachian Hardwoods in the production of Cross-Laminated Timber panels. Specifically, the objectives of the research were to 1) Determine the amount of yellow-poplar structural lumber that can be obtained from a representative population of low-grade, yellow-poplar lumber graded for appearance; 2) Evaluate whether …

Valorization Of Xylan In Agroforestry Waste Streams, Harrison Appiah

Graduate Theses, Dissertations, and Problem Reports (ETD)

Valorization of Xylan in Agroforestry Waste Streams.

Harrison Appiah

Microwave-assisted deep eutectic solvent and gamma-valerolactone metallic chloride catalyzed conversion of xylan to furfural were investigated using a 2x3 factorial experimental design at two levels of percent microwave power, reaction time, and catalyst concentration. The levels of each factor studied were (20%, 60% microwave power, 2, 4 minutes, and 10, 20mg) respectively. The effect of three metallic chloride catalysts (LiCl, FeCl3.6H20, CuCl2) on the conversion of xylan to furfural was also investigated. The gamma-valerolactone-ferric chloride sent system exhibited the highest mean yield of furfural (56.50%). The next highest furfural yield of …

Comparison Of The Batch And Individual Log Study Methods For Use In Determining Log Breakeven Pricing, Levi Eric Sisler

Graduate Theses, Dissertations, and Problem Reports (ETD)

Understanding log yields and overrun is critical to a profitable sawmill operation. Lumber yield and overrun data can be gathered through one of two types of sawmill studies: batch studies or individual log studies. Little to no research has previously been conducted to determine if one method provides more reliable results than the other method. For this effort, 16 batch studies were conducted. Individual log studies were also conducted on the same logs, allowing a direct comparison of the results from both study types. A breakeven analysis was conducted for each study type, which determined the amount of variability in …

Lignocellulosic Biomass Derived Activated Carbon For Energy Storage And Adsorption, Changle Jiang

Graduate Theses, Dissertations, and Problem Reports (ETD)

Lignocellulosic biomass has been converted to hierarchical porous carbon materials which possess macro-, meso- and micro-pores. The natural structure of porous lignocellulosic structure was preserved during activation with further developed porosity by the activation. The activated carbon can be well applied to electrochemical double layer capacitor for transportation storage of ions as well as adsorbent materials for metal ion removal from wastewater.

The first chapter of this dissertation presents an introduction of biomass derived carbon and its applications. In the second chapter, both direct and indirect activation methods using carbon dioxide were adopted in this study. The results show that …

An Analysis Of Hardwood Log Grading Systems In The Appalachian Region, Jordan Russell Thompson

Graduate Theses, Dissertations, and Problem Reports (ETD)

This study identifies and describes various hardwood log grading systems historically used by the hardwood industry in the United States through a comprehensive literature review and analysis. Additionally, an industry sector survey (Appendix A) was designed and conducted to identify current log hardwood grading systems. Finally, based on the survey data, an analysis of the practices and techniques currently used for scaling and grading Appalachian hardwood logs is presented and discussed.

In the first component of the study, books, journal articles, and papers pertaining to log grading are sorted and broached chronologically by the publication date and then separated into …

Evaluation Of A Generalized Basal Area Stand Table Projection Model For Appalachian Hardwoods Growth And Yield Systems, Aaron M. Holley

Graduate Theses, Dissertations, and Problem Reports (ETD)

A generalized stand table projection algorithm was used to disaggregate species group level data for the Fernow Experimental Forest in the Allegheny Front physiographic region of the Central Appalachian Hardwoods region. The generalized stand table projection method has proved effective in projecting multi and uni-modal distributions in single species stands. Exploration into the potential for use in mixed species Central Appalachian Hardwoods thinned and unthinned stands proved promising. When compared to basal area projections using SILVAH, generalized stand table projection outperformed SILVAH at the plot level. Generalized stand table projection produced smaller errors on non-overlapping growth projections for both thinned …