Wood Science and Pulp, Paper Technology Commons^™

Evaluation Of Flood Damage On Cross Laminated Timber Wall Configurations, Mustafa Nezih Kaya

Theses and Dissertations

Greenhouse gas emissions are one of the critical factors that affect climate change, increasing flooding risk and threatening human life. The use of traditional construction materials is responsible for a higher percentage of global greenhouse gas emissions when compared to the use of sustainable materials in the construction industry. The substitution of current building materials with sustainable materials is essential to reduce greenhouse gas emissions and positively influence climate change when the current construction demand in the world is considered. Wood is one of the primary environmentally friendly construction materials in regard to high carbon storage and low carbon emissions. …

Enhancing The Performance Of Dowel Type Fasteners And A Case Study Of Timber Truss Failure, Lon A. Yeary

Theses and Dissertations

This document will outline the findings of three separate and independent studies: Study 1: In or around 1972, an experimental building was constructed. One of the intents of the construction project was to demonstrate advancements in wood building construction design. It was value-engineered throughout. That is, its materials and systems were intended to function at or near design capacity. In 2019, part of the roof of the structure collapsed. This case study investigates two potential factors that led to the failure: stress concentration in excess of the 12 allowable stress for 2 × 4 web members and insufficient plywood sheathing …

Field Durability Test Of Clt Wall Envelope Using Physical Barriers Against Termites And Structural Performance Of Nailed Hold-Down Brackets Connected To Fungus-Exposed Clt Walls, Kamal Neupane

Theses and Dissertations

The effectiveness of using commercial polyethylene flashing and stainless-steel mesh in CLT wall systems as the termite barriers were evaluated in a short-term field test. American Wood Protection Association (AWPA) E21's visual ratings ranged from 10 to 9 in the specimens showing little damage when no physical barriers were used. Termites were able to crawl beyond the physical barriers in few specimens showing the necessity of further research on height and installation method of physical barriers. On the second part, the effect of decay caused due to Postia placenta, a brown-rot fungus, on the structural performance of hold-down brackets connected …

Oxidation Of Substituted Catechols At The Air-Water Interface: Production Of Carboxylic Acids, Quinones, And Polyphenols, Elizabeth A. Pillar, Marcelo I. Guzman

Chemistry Faculty Publications

Anthropogenic activities contribute benzene, toluene, and anisole to the environment, which in the atmosphere are converted into the respective phenols, cresols, and methoxyphenols by fast gas-phase reaction with hydroxyl radicals (HO(•)). Further processing of the latter species by HO(•) decreases their vapor pressure as a second hydroxyl group is incorporated to accelerate their oxidative aging at interfaces and in aqueous particles. This work shows how catechol, pyrogallol, 3-methylcatechol, 4-methylcatechol, and 3-methoxycatechol (all proxies for oxygenated aromatics derived from benzene, toluene, and anisole) react at the air-water interface with increasing O3(g) during τc ≈ 1 μs contact time and contrasts their …

Heterogeneous Oxidation Of Catechol, Elizabeth A. Pillar, Ruixin Zhou, Marcelo I. Guzman

Chemistry Faculty Publications

Natural and anthropogenic emissions of aromatic hydrocarbons from biomass burning, agro-industrial settings, and fossil fuel combustion contribute precursors to secondary aerosol formation (SOA). How these compounds are processed under humid tropospheric conditions is the focus of current attention to understand their environmental fate. This work shows how catechol thin films, a model for oxygenated aromatic hydrocarbons present in biomass burning and combustion aerosols, undergo heterogeneous oxidation at the air–solid interface under variable relative humidity (RH = 0–90%). The maximum reactive uptake coefficient of O₃(g) by catechol γ_O3 = (7.49 ± 0.35) × 10^–6 occurs for …

Investigating Wood Welding Parameters Using A Prototype Welding Machine, Timothy R. Melin

Master's Theses

Understanding how different processing variables influence wood welded bonds is vital if the technique will ever be used to create engineered lumber without using adhesives. A variation of vibration welding, wood welding uses pressure and friction to bond materials together. During welding, heat causes a softening in the wood, a naturally occurring composite material. This softening leads to fiber entanglement and a bond forms upon cooling.

The goal of this research was to investigate several processing aspects of the wood welding procedure. A prototype wood welding machine, designed and fabricated from the ground up, was used to investigate the effects …