Electro-Mechanical Systems Commons^™

Microelectromechanical Scanner Using A Vertical Cavity Surface Emitting Laser, Joseph G. Bouchard Jr.

Theses and Dissertations

Optical scanners play a prominent role in the commercial and military industries. The scanner's size, cost and reliability are critical characteristics. In this research a microoptical scanning system was fabricated by incorporating a vertical cavity surface emitting laser (VCSEL) onto a surface machined microelectromechanical die. The micro optics for laser beam steering includes a 135 deg mirror, a Fresnel lens, a lateral scanning rotating mirror, and a vertical scanning fan mirror. The VCSEL was attached to the die by solder and electrical connection was provided by wire bonding. Based on far field measurements the scanner had a lateral scan angle …

Microelectromechanical Optical Beam Steering Systems, David M. Burns

Theses and Dissertations

The development of microelectromechanical systems (MEMS) has matured to the point where the fabrication of micron sized devices is feasible. State of the art MEMS construction processes now support the fabrication of novel optical devices that could not previously be built. This dissertation reports on the development of innovative micro optical devices such as Variable Blaze Gratings (VBGs) using state of the art MEMS construction processes. The principle application of the micro optical devices described in this dissertation is steering optical beams; however other applications such as spectral analysis are identified. Specific optical beam steering systems developed and characterized in …

Micro-Electromechanical Switches For Micro-Satellite Power Transfer, Glen A. Kading

Theses and Dissertations

In the past few years, microelectromechanical systems (MEMS) have emerged as a promising new technology with tremendous application potential. One of the possible implementations of MEMS technology is in the development of micro-satellites. It should be possible to mass-produce micro-satellites at a fraction of the cost of one conventional satellite. In order for satellites to be robust, a method of transferring power to systems must be addressed. As micro-satellites are made with conventional integrated circuit technologies at a very small scale, a means of transferring power on a similar scale will be investigated. This research addresses the issue of the …

A Feasibility Study Of Fuel Cell Cogeneration In Industry, Scott B. Phelps, J. Kelly Kissock

Mechanical and Aerospace Engineering Faculty Publications

Up until now, most of the literature on fuel cell cogeneration describes cogeneration at commercial sites. In this study, a PC25C phosphoric acid fuel cell cogeneration system was designed for an industrial facility and an economic analysis was performed. The US DOE Industrial Assessment Center (IAC) database was examined to determine what industry considers a good investment for energy saving measures. Finally, the results of the cogeneration analysis and database investigation were used to project the conditions in which the PC25C might be accepted by industry.

Analysis of IAC database revealed that energy conservation recommendations with simple paybacks as high …