Biomechanical Engineering Commons^™

Numerical Study Of Nutrient Mixing In Trabecular Bone In Microgravity, Disuse And Normogravity, Sagar Gharti

Doctoral Dissertations and Master's Theses

Mechanical loading is known to regulate bone remodeling by driving interstitial fluid flow which stimulates cells and drives nutrient transport within the trabecular network. In microgravity, the absence of mechanical stimulation or loading suppresses convective flow processes, causing diffusion-driven nutrient mixing and renewal, and accelerated bone loss. This thesis investigates how oscillation frequency and trabecular bone density jointly control nutrient mixing and wall shear stress within trabecular cavities.

A computational fluid dynamics (CFD) framework is developed in STAR-CCM+ using a soft-cap oscillation model that mimics cyclic compression. Three idealized trabecular morphologies are simulated across different frequencies to represent microgravity or …

Direct Numerical Simulation Of Pulsating Flow In Curved Pipes: Insights Into Aortic Dissection In Humans, Gokul Anugrah Gopakumar

Theses and Dissertations--Mechanical and Aerospace Engineering

This dissertation investigates the hemodynamics of pulsating blood flow in curved vessels through direct numerical simulations (DNS), with the overarching aim of uncovering fluid dynamic mechanisms linked to the onset and progression of aortic dissection in humans. The work is structured in two parts: (i) fundamental studies in idealized geometries and (ii) preliminary investigations in patient-specific anatomies. In the first part, curved pipe models representing the aortic arch are used to isolate the effects of pulsation frequency, amplitude ratio, and curvature ratio on transitional and turbulent flow dynamics. The simulations reveal that curvature-driven centrifugal forces shift the peak velocity toward …

Multi-Objective Design Optimization Of Two Configurations Of Ventricular Shunts For Hydrocephalus, Will Kirkpatrick

Theses and Dissertations

Hydrocephalus is developed when the flow of cerebrospinal fluid is obstructed in the ventricles and a pressure build-up is generated within the brain. Ventricular shunts are used to remove excess fluid from the brain, but these shunts have a common problem of failure due to the shunt being obstructed by the build-up of astrocytes. To address this, two sets of 27 designs of ventricular shunts were identified and analyzed with parameters that could potentially reduce obstruction risks. The performance of these designs was examined using fluid simulations on these two sets of 27 designs. One set explored close-tipped shunt designs, …

Optimization Of Blalock-Taussig Shunt And Anastomotic Geometry For Vascular Access Fistula Using A Genetic Algorithm, Guangyu Bao

McKelvey School of Engineering Graduate Student Theses & Dissertations

Blalock-Taussig (BT) shunts are used for defects that affect the flow of blood from the right ventricle, through the pulmonary artery, and to the lungs. Arteriovenous (AV) fistula is one type of vascular access which is a surgically created vein used to remove and return blood during hemodialysis. Plastic grafts used in the above two reconstructions may result in areas of non-physiologic flow in the grafts leading to risk of stenosis (blocked area) and thrombosis, which is the single major cause for access morbidity. The focus of this thesis is to study BT shunts and anastomoses models using Computational Fluid …

Computational Fluid Dynamics Applied To The Analysis Of Blood Flow Through Central Aortic To Pulmonary Artery Shunts, Carey Celestin Jr

LSU New Orleans Theses and Dissertations

This research utilizes CFD to analyze blood flow through pathways representative of central shunts, commonly used as part of the Fontan procedure to treat cyanotic heart disease. In the first part of this research, a parametric study of steady, Newtonian blood flow through parabolic pathways was performed to demonstrate the effect that flow pathway curvature has on wall shear stress distribution and flow energy losses. In the second part, blood flow through two shunts obtained via biplane angiograms is simulated. Pressure boundary conditions were obtained via catheterization. Results showed that wall shear stresses were of sufficient magnitude to initiate platelet …

Evaluation Of The Mass Transfer Effect Of The Stalk Contraction–Relaxation Cycle Of Vorticella Convallaria, Jiazhong Zhou

Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research

Vorticella convallaria is a genus of protozoa living in fresh water. It has a bell-shaped zooid equipped with adoral ciliary bands and a contractile stalk tethering the zooid to a substrate. Vorticella is regarded as a biological spring because its contractile stalk can pull the zooid towards the substrate at a remarkably high speed and then relaxes to its extended state much more slowly. However, reasons for Vorticella’s stalk contraction are still unknown. It is presumed that the flow field induced by the contraction-relaxation cycle of Vorticella would augment mass transfer effect near the substrate. We investigated this hypothesis …

Cfd Simulation Of The Thermal Performance Of A Parallel Counter-Parallel Flow Heat Exchanger For The Treatment Of Hypothermia, Alex Heller

UNLV Theses, Dissertations, Professional Papers, and Capstones

Hypothermia is a life-threatening condition. Currently, active warming methods are the most effective treatment for dysthermic patients. The aim of this study is to investigate the use of computational fluid dynamics (CFD) in evaluating the thermal performance of a parallel/counter-parallel flow heat exchanger used as part of a fluid warmer to treat Hypothermia. The 3D model of the heat exchanger is divided into three regions; Infusate (fluid to be heated), Hot Water (heating fluid), and a Solid Region (wall). At the end of the heat exchanger, an elbow section is used to create the counter-parallel flow arrangement specific to this …

Cfd Assessment Of Respiratory Drug Delivery Efficiency In Adults And Improvements Using Controlled Condensational Growth, Ross L. Walenga

Theses and Dissertations

Pharmaceutical aerosols provide a number of advantages for treating respiratory diseases that include targeting high doses directly to the lungs and reducing exposure of other organs to the medication, which improve effectiveness and minimize side effects. However, difficulties associated with aerosolized drug delivery to the lungs include drug losses in delivery devices and in the extrathoracic region of human upper airways. Intersubject variability of extrathoracic and thoracic drug deposition is a key issue as well and should be minimized. Improvements to respiratory drug delivery efficiency have been recently proposed by Dr. P. Worth Longest and Dr. Michael Hindle through the …

Cavitation In Pharmaceutical Manufacturing And Shipping, Donn Sederstrom

Electronic Theses and Dissertations

Therapeutic proteins are used to successfully treat hemophilia, Crohn's Disease, diabetes, and cancer. Recent product recalls have occurred because of sub-visible particle formation resulting from the inherent instability of proteins. It has been suggested that particle formation is associated with late stage processing steps of filling, shipping, and delivery. Previous work at the University of Denver demonstrated that fluid cavitation can generate a large number of sub-visible protein particles in ultra clean formulations, but that mitigation can be achieved with fluid property manipulation. The goal of this research was to (1) assess the risk of cavitation under common pharmaceutical manufacturing …