Biomechanical Engineering Commons^™

An Introduction To The Comparison Of Seismocardiography And Phonocardiography, Anna C. Voyatzoglou

Honors Undergraduate Theses

The intent of this thesis is to lay groundwork for examining the relationship between seismocardiography (SCG) and phonocardiography (PCG). Both are methods of measuring and describing heart mechanical function. SCG is described as chest vibrations while the heart beats, and PCG is described as acoustic chest surface signal believed to represent the heart valves opening or closing. SCG and PCG have both been used separately in clinical and research settings, but there is currently no clear comparison between the two. Therefore, there has been no way at the present to understand how one signal might inform the other. This study …

Controlled Voltage Of Hot Snare Polypectomy Device In Electrosurgical Device, Saidi Olayinka Olalere

College of Graduate Studies: Theses & Dissertations

The study is used to understand the working procedure of the Olympus PSD-30 Electrosurgical Unit which a high-frequency alternating current is to measure the voltage and power output from the unit when used for a surgical operation to determine the extent of tissue damage. The output power and voltage were as examined with the stopwatch, then with an Arduino time based for 1, 2, and 3 seconds to understand the different modes of the cut and coagulation feedback with an RCC circuit used to mimic the human body. This shows a pattern in which the feedback power increases, and voltage …

Antagonistic Co-Contraction Can Minimize Muscular Effort In Systems With Uncertainty, Anne D. Koelewijn, Antonie J. Van Den Bogert

Mechanical Engineering Faculty Publications

Muscular co-contraction of antagonistic muscle pairs is often observed in human movement, but it is considered inefficient and it can currently not be predicted in
simulations where muscular effort or metabolic energy are minimized. Here, we investigated the relationship between minimizing effort and muscular co-contraction
in systems with random uncertainty to see if muscular co-contraction can minimize effort in such system. We also investigated the effect of time delay in the muscle, by varying the time delay in the neural control as well as the activation time constant.We solved optimal control problems for a one-degree-of-freedom pendulum actuated by two identical …

Modeling Human Control Behavior In Command-Following Tasks, Sajad Koushkbaghi

Theses and Dissertations--Mechanical and Aerospace Engineering

Humans interact with a variety of complex dynamic systems on a daily basis. However, they are often the lesser understood component of human-in-the-loop (HITL) systems. In this dissertation, we present the results of two HITL experiments to investigate the control strategies that humans use when performing command-following tasks. The first experiment is designed to investigate the control strategies that humans use to interact with nonlinear dynamic systems. Two groups of human subjects interact with a dynamic system and perform a command-following task. One group interacts with a linear time-invariant (LTI) dynamic system and the other group interacts with a Wiener …

Design Of Human Inspired Feet For Mithra, A High-Performance Humanoid Robot, Spencer Lyle Brewster

Electronic Theses and Dissertations

This thesis explores the foot design for the new humanoid robot Mithra, with the goal to improve impact mitigation, natural gait throughout the gait cycle and balance. Using human gait parameters, a stiff aluminum foot was designed to emulate human center of pressure rollover trajectories. In addition, a 2D dynamic Finite Element Analysis (FEA) of the gait cycle was created in Abaqus to rapidly prototype foot designs. Data from the FE model provided impact forces, parameters for distal foot power evaluation and maximum lean angles. From this model a flexible nylon foot was optimized for the given design objectives. The …

Contact Simulation For Evaluating Patient Specific Surgical Guide Stability, Vincent Nierste

Electronic Theses and Dissertations

This study proposes a novel computational method to quantify guide stability for Patient Specific Instrumentation (PSI) guides. A finite element contact model was used to analyze the final position of PSI guides on a femur across a range of loading parameters representing forces applied by a surgeon during operative use. Separate segmentation methods were used for the guide and bone geometry to represent differences between segmentation and actual patient geometry. The region of loading parameters over which the guide exhibited a consistent final position was measured and reported as Guide Stability Score. The model was verified using cadaver specimens for …

Non-Invasive Detection Of Elevated Intracranial Pressure Using Spontaneous Tympanic Membrane Pulsation, Rajkumar Dhar

Electronic Theses and Dissertations, 2020-2023

Monitoring intracranial pressure (ICP) is a standard diagnostic tool for various neurological conditions such as head injury, ruptured aneurysms, intracerebral and intracranial hemorrhage, and hydrocephalus. Currently, ICP monitoring relies on invasive pressure measurements. These include intraventricular catheter, subdural screw, epidural sensor, and lumbar puncture. Invasive methods pose the risk of infection and hemorrhage, are expensive, and require special clinical skills. A noninvasive method that is reliable, simple to use, low-cost, and provides easily interpretable results can help avoid the complications associated with the invasive methods. This study proposes a novel method for noninvasive ICP monitoring using tympanic membrane pulsation (TMp). …

Skeletal Modeling Parameters And Clinical Factors Related To Injury Risk In Baseball Pitchers, Aaron Trunt

Dissertations and Theses

ABSTRACT Baseball pitching is a well-studied area of biomechanics partially due to high injury rates in the upper extremity. While current known injury risk factors for pitchers include limited shoulder range of motion (ROM), increased ball velocity, and limited shoulder strength, there has been a lack of scientific evidence linking increased joint kinetics to injury risk. The aims of this research were to (1) explore relationships between known risk factors for injury and joint kinetics, (2) establish more specific biomechanical models of pitchers to calculate joint kinetics with greater precision, and (3) deploy these models prospectively to determine how model …

Morphologic Clustering Of Earcanals Using Deep Learning Algorithm To Design Artificial Ears Dedicated To Earplugs Attenuation Measurement, Bastien Poissenot-Arrigoni, Chun Hong Law, Djamal Berbiche, Franck Sgard, Olivier Doutres

Études primaires

Designing earplugs adapted for the widest number of earcanals requires acoustical test fixtures (ATFs) geometrically representative of the population. Most existing ATFs are equipped with unique sized straight cylindrical earcanals, considered representative of average human morphology, and are therefore unable to assess how earplugs can fit different earcanal morphologies. In this study, a methodology to cluster earcanals as a function of their morphologies with the objective of designing artificial ears dedicated to sound attenuation measurement is developed and applied to a sample of Canadian workers’ earcanals. The earcanal morphologic indicators that correlate with the attenuations of six models of commercial …

Modeling Of Patient-Specific Periaortic Mechanics And Pulmonary Artery Hemodynamics Based On Phase-Contrast Magnetic Resonance Imaging Sequences., Johane H. Bracamonte

Theses and Dissertations

Inverse modeling in cardiovascular medicine is a collection of methodologies that can provide non-invasive patient-specific estimations of clinical risk factors using medical imaging as inputs. Its incorporation into clinical practice has the potential to improve diagnosis and treatment planning with low associated risks and costs.

Herein, three different phase contrast magnetic resonance imaging (MRI) modalities were implemented as input data, displacement encoding with stimulated echoes (DENSE MRI) applied, and time-resolved velocity encoding phase-contrast MRI, in 1D and 3D, applied to pulmonary artery (PA) hemodynamics.

A model to account for the effect of periaortic interactions due to static and dynamic structures …

Prolonged Exposure To Microgravity Increases Susceptibility To Traumatic Brain Injury, Ryan Baskerville

UNF Graduate Theses and Dissertations

With the prospect of semi-permanent and permanent habitable fixtures on the moon and Mars, the complications associated with long-term exposure to microgravity should be investigated exhaustively. Spaceflight Associated Neuro-Ocular Syndrome (SANS), a group of neurological and ocular effects resulting from prolonged exposure to microgravity, is characterized by significant fluid shifts into the cranium, namely cerebrospinal fluid and blood, and an upward shift of the brain relative to the skull. This syndrome, along with its immediate effects on visual acuity, cognitive ability, and motor function are recognized by NASA, but its effects on susceptibility to traumatic brain injury have yet to …

Numerical Design Of Steerable Guidewires, Onkar Prakash Salunkhe

Dissertations, Master's Theses and Master's Reports

Biomedical devices are an integral part of the medical industry nowadays. With the increase in cases of heart disease, catheterization procedures are becoming more frequent. Small-scale actuators are needed for the guidance of small-scale catheters and guidewires to remote targets in the human body. Numerical modelling is needed to guide the experiments in developing such steerable devices and to optimize their design. Here, we designed small-scale steerable guidewires by first developing bending actuators and then assembling them with guidewires. The actuators use materials with strain response to electric potential in a very low voltage range that is not harmful to …