Biomechanical Engineering Commons^™

Computational Fluid Dynamics Investigation Of A Novel Hybrid Comprehensive Stage Ii Operation For Single Ventricle Palliation, Marwan Hameed

Electronic Theses and Dissertations

Hypoplastic left heart syndrome (HLHS) is a type of heart defect where the left ventricle is underdeveloped or not developed, resulting in only a single functioning right ventricle. Approximately 7.5% of patients with congenital heart disease are born with a single ventricle (SV) which is accompanied by a spectrum of other malformations such as atrophied ascending aorta, atrial septal defects, and ventricular septal defects (VSD). The existing three-hybrid staged surgical approach serving as a palliative treatment for this anomaly entails multiple complications and achieves a survival rate of only 50%. To reduce the trauma associated with the second stage of …

Metabolic Cost Calculations Of Gait Using Musculoskeletal Energy Models, A Comparison Study, Anne D. Koelewijn, Dieter Heinrich, Antonie J. Van Den Bogert

Mechanical Engineering Faculty Publications

This paper compares predictions of metabolic energy expenditure in gait using seven metabolic energy expenditure models to assess their correlation with experimental data. Ground reaction forces, marker data, and pulmonary gas exchange data were recorded for six walking trials at combinations of two speeds, 0.8 m/s and 1.3 m/s, and three inclines, -8% (downhill), level, and 8% (uphill). The metabolic cost, calculated with the metabolic energy models was compared to the metabolic cost from the pulmonary gas exchange rates. A repeated measures correlation showed that all models correlated well with experimental data, with correlations of at least 0.9. The model …

Probing The Influence Of Cx43 And Glucose On Endothelial Biomechanics, Md Mydul Islam

Electronic Theses and Dissertations

Endothelial cells (ECs) form the innermost layer of all vasculature and constantly receive both biochemical and biomechanical signals, yielding a plethora of biomechanical responses. In response to various biochemical or biomechanical cues, ECs have been documented to generate biomechanical responses such as tractions and intercellular stresses between the cell and substrate and between adjacent cells in a confluent monolayer, respectively. Thus far, the ability of endothelial tight junctions and adherens junctions to transmit intercellular stresses has been actively investigated, but the role of gap junctions is currently unknown. In addition, there is no report of the independent influence of hyperglycemia …

3d Printed Bioreactor With Optimized Stimulations For Ex-Vivo Bone Tissue Culture, Anirban Chakraborty

Electronic Theses and Dissertations

Motivation: Long term tissue survivability ex-vivo can greatly facilitate research on the influence of external stimulus (loading, radiation, microgravity) on the tissue, including mechanisms of disease transmission and subsequent drug discoveries. Bioreactors (used to culture living tissue ex-vivo) can be a valuable tool to study cell activity during physiological processes by mimicking their in-vivo native 3D environment.
Objective Statement: We have developed a compact, 3D printed bioreactor equipped with both continuous flow-perfusion and dynamic mechanical-loading stimulations, capable of maintaining ex-vivo viability of swine cancellous bone cores over a long period. Qualitative study of the cultured cores (in terms of …

The Influence Of 3d Porous Chitosan-Alginate Biomaterial Scaffold Properties On The Behavior Of Breast Cancer Cells, Minh-Chau N. Le

Honors Undergraduate Theses

The tumor microenvironment plays an important role in regulating cancer cell behavior. The tumor microenvironment describes the cancer cells, and the surrounding endothelial cells, fibroblasts, and mesenchymal stem cells, along with the extracellular matrix (ECM). The tumor microenvironment stiffens as cancer undergoes malignant progression, providing biophysical cues that promote invasive, metastatic cellular behaviors. This project investigated the influence of three dimensional (3D) chitosan-alginate (CA) scaffold stiffness on the morphology, growth, and migration of green fluorescent protein (GFP) – transfected MDA-MB-231 (231-GFP) breast cancer (BCa) cells. The CA scaffolds were produced by the freeze casting method at three concentrations, 2 wt%, …

Quantification Of Myocardial Mechanics In Left Ventricles Under Inotropic Stimulation And In Healthy Right Ventricles Using 3d Dense Cmr, Zhan-Qiu Liu

Theses and Dissertations--Mechanical and Aerospace Engineering

Statistical data from clinical studies indicate that the death rate caused by heart disease has decreased due to an increased use of evidence-based medical therapies. This includes the use of magnetic resonance imaging (MRI), which is one of the most common non-invasive approaches in evidence-based health care research. In the current work, I present 3D Lagrangian strains and torsion in the left ventricle of healthy and isoproterenol-stimulated rats, which were investigated using Displacement ENcoding with Stimulated Echoes (DENSE) cardiac magnetic resonance (CMR) imaging. With the implementation of the 12-segment model, a detailed profile of regional cardiac mechanics was reconstructed for …

Quantification Of Papillary Muscle Motion And Mitral Regurgitation After Myocardial Infarction, Connor R. Ferguson

Theses and Dissertations--Mechanical and Aerospace Engineering

Change in papillary muscle motion as a result of left ventricular (LV) remodeling after posterolateral myocardial infarction is thought to contribute to ischemic mitral regurgitation. A finite element (FE) model of the LV was created from magnetic resonance images acquired immediately before myocardial infarction and 8 weeks later in a cohort of 12 sheep. Severity of mitral regurgitation was rated by two-dimensional echocardiography and regurgitant volume was estimated using MRI. Of the cohort, 6 animals (DC) received hydrogel injection therapy shown to limit ventricular remodeling after myocardial infarction while the control group (MI) received a similar pattern of saline injections. …

A Computational Study Of Patch Implantation And Mitral Valve Mechanics, Dara Singh

Theses and Dissertations--Mechanical and Aerospace Engineering

Myocardial infarction (i.e., a heart attack) is the most common heart disease in the United States. Mitral valve regurgitation, or the backflow of blood into the atrium from the left ventricle, is one of the complications associated with myocardial infarction. In this dissertation, a validated model of a sheep heart that has suffered myocardial infarction has been employed to study mitral valve regurgitation. The model was rebuilt with the knowledge of geometrical changes captured with MRI technique and is assigned with anisotropic, inhomogeneous, nearly incompressible and highly non-linear material properties. Patch augmentation was performed on its anterior leaflet, using a …

The Influence Of Size And Progression Of Intra-Cerebral Hematoma On The Lateral Ventricles, Muhammad J. Ashraf

Dissertations and Theses

Cerebrovascular diseases like intra cerebral hemorrhage are quite deadly and may disturb functioning of the brain, expanding and resulting in formation of an intra cerebral hematoma(ICH). It is imperative to comprehend how hematoma and its expansion inside the brain endangers human life. One of the influences of an ICH inside brain tissue is on the Lateral Ventricles(LV). When the hemorrhage occurs close enough to the lateral ventricles, filled with cerebrospinal fluid(CSF), it disrupts the balance of fluid in LV. A minor pressure change in LV can negatively influence the production of CSF as well as an increase in intracranial pressure. …

Surf Leg, Samantha Campbell, Oyundari Altansukh, Caroline Swanson, Kurtis Barth

Mechanical Engineering

The Surf Leg Prosthetic project team in conjunction with QL+ and Operation Surf designed a transtibial prosthetic to be used for surfing. The senior project team focused on the missions of QL+ and Operation Surf as they went through the design process during the 2018-2019 academic year. The problem solved was that a standard prosthetic for a transtibial amputee does not provide the flexibility in enough degrees of freedom for a user to squat and balance on a surfboard. The goal of this project was to create a device specifically designed to improve the user’s balance and control while surfing. …

Estimation And Prediction Of The Human Gait Dynamics For The Control Of An Ankle-Foot Prosthesis, Guilherme Aramizo Ribeiro

Dissertations, Master's Theses and Master's Reports

With the growing population of amputees, powered prostheses can be a solution to improve the quality of life for many people. Powered ankle-foot prostheses can be made to behave similar to the lost limb via controllers that emulate the mechanical impedance of the human ankle. Therefore, the understanding of human ankle dynamics is of major significance. First, this work reports the modulation of the mechanical impedance via two mechanisms: the co-contraction of the calf muscles and a change of mean ankle torque and angle. Then, the mechanical impedance of the ankle was determined, for the first time, as a multivariable …

A Biomimetic Approach To Controlling Restorative Robotics, Matthew T. Boots

Graduate Theses, Dissertations, and Problem Reports (ETD)

Movement is the only way a person can interact with the world around them. When trauma to the neuromuscular systems disrupts the control of movement, quality of life suffers. To restore limb functionality, active robotic interventions and/or rehabilitation are required. Unfortunately, the primary obstacle in a person’s recovery is the limited robustness of the human-machine interfaces. Current systems rely on control approaches that rely on the person to learn how the system works instead of the system being more intuitive and working with the person naturally. My research goal is to design intuitive control mechanisms based on biological processes termed …

Exoskeleton Leg Brace, Aaron Indermuhle, Magomed Kasumov, Cevat Bagcioglu, Lucas Battaglia

Williams Honors College, Honors Research Projects

This report details the design process of a lower limb exoskeleton leg brace for elderly people with walking disabilities or others with disabilities that limit mobility. While there are other similar products on the market, the general design can be improved and these improvements have been implemented into the design presented within. Among these improvements are progress in efficiency, weight, user comfort, and cost. The results of the study are the design of a novel leg brace that improves on existing designs in each of these areas.

Our design solution incorporates the use of a single leg brace with no …

Design And Mechanical Characterization Of 3d Printed Gradient Porosity Poly(Propylene Fumarate) Scaffolds, Andrea Felicelli

Williams Honors College, Honors Research Projects

Worldwide incidence of bone disorders and conditions, an already prevalent problem, is expected to double by 2020 from the rate in 2013 due to factors such as higher life expectancies and lower levels of physical activity. Every year in the United States, over half a million patients receive bone defect repairs, with costs greater than $2.5 billion. Current repairs are typically done with bone grafts, which are often costly and can result in added complications in the donor surgical site. Tissue engineering, a growing field that seeks to assist and enhance tissue defect repairs through the use of synthetic materials, …

State Estimation For An Agonistic‐Antagonistic Muscle System, Thang Tien Nguyen, Holly Warner, Hung La, Hanieh Mohammadi, Daniel J. Simon, Hanz Richter

Electrical and Computer Engineering Faculty Publications

Research on assistive technology, rehabilitation, and prosthetics requires the understanding of human machine interaction, in which human muscular properties play a pivotal role. This paper studies a nonlinear agonistic‐antagonistic muscle system based on the Hill muscle model. To investigate the characteristics of the muscle model, the problem of estimating the state variables and activation signals of the dual muscle system is considered. In this work, parameter uncertainty and unknown inputs are taken into account for the estimation problem. Three observers are presented: a high gain observer, a sliding mode observer, and an adaptive sliding mode observer. Theoretical analysis shows the …

Side-To-Side Comparison Of Total Shoulder Arthroplasty And Intact Function In Individuals, Sarah Rose Walden

Electronic Theses and Dissertations

Total Shoulder Arthroplasty (TSA) is a surgery which replaces the shoulder joint, or the interface between the humerus and the scapula glenoid. To test TSA success, most prior research compares patients with TSA to healthy controls. However, the shoulder anthropometry, motion, and musculature of individuals varies widely across the population making it important to assess TSA performance in individuals. The overall goal of this study is to determine if patients with one of two TSA implant designs on one side achieve the same range of motion as their intact side, and if so to find if they compensate using increased …

Developing A Testing Instrument To Evaluate The Performance Of 3d-Printed Body-Powered Prosthetic Hands, Araz Al-Dawoodi

All Graduate Theses, Dissertations, and Other Capstone Projects

A 3D printed prosthetic hand is an open source technology that became a good substitution for many products in the market. For many reasons, Low-cost, easy made / easy build. As an open source product, 3D printed prosthetic designs are available to anyone around the world, a good option for young children because they need to have a new prosthetic more frequent until they reach the adulthood age. Most families cannot pay a thousand dollars technology. From the research, it found that that there are not enough studies cover the open source wrist body-powered prosthetic. Other studies covered products used …

Experimental Analysis Of Protective Headgear Used In Defensive Softball Play, John Scott Strickland

UNF Graduate Theses and Dissertations

Every year in the United States, an estimated 1.6 to 3.8 million people sustain sports-related traumatic brain injuries (TBIs), with an appreciable number of these injuries coming from the sport of softball. Several studies have analyzed the impact performance of catcher’s masks within the context of baseball; however, virtually no studies have been performed on fielder’s masks within the context of softball. Thus, the main objective of the present work was to evaluate the protective capabilities of softball fielder’s masks. To better understand the injury mechanisms and frequency associated with softball head/facial injuries, epidemiological data from a national database was …

Estimation Of Multi-Directional Ankle Impedance As A Function Of Lower Extremity Muscle Activation, Lauren Knop

Dissertations, Master's Theses and Master's Reports

The purpose of this research is to investigate the relationship between the mechanical impedance of the human ankle and the corresponding lower extremity muscle activity. Three experimental studies were performed to measure the ankle impedance about multiple degrees of freedom (DOF), while the ankle was subjected to different loading conditions and different levels of muscle activity. The first study determined the non-loaded ankle impedance in the sagittal, frontal, and transverse anatomical planes while the ankle was suspended above the ground. The subjects actively co-contracted their agonist and antagonistic muscles to various levels, measured using electromyography (EMG). An Artificial Neural Network …