Semiconductor and Optical Materials Commons^™

Band Gap Engineering Of Two Dimensional Silicon Photonic Crystals By Oxidation And Oxide Etching, Makhin Thitsa

Electrical & Computer Engineering Theses & Dissertations

In this thesis a thorough analysis is presented on the effects of oxidation and oxide etching on the band structure of two dimensional silicon photonic crystals (2 D Si PC's). By using the plane wave expansion method (PWM), two structures of triangular lattice, namely, air cylinders embedded in a silicon background and silicon cylinders embedded in an air background are modeled. The thesis focuses on triangular lattice arrangement because for certain parameter values such a lattice can give rise to absolute band gap, which prohibits the propagation of either transverse electric (TE) or transverse magnetic (TM) polarizations.

During oxidation three …

Study Of Transport Properties Of Inas Using Monte Carlo Simulation, Satyanadh Gundimada

Electrical & Computer Engineering Theses & Dissertations

The present research is aimed at ascertaining the usefulness of InAs semiconductor material for single photon avalanche photo detectors operating in the Geiger mode at 2 μm wavelengths. InAs is considered as the material suitable for the purpose because of its less bandgap and lower effective mass of the electrons when compared to other semiconductor materials presently in use. Hence, theoretically transient transport properties of bulk InAs are superior and the velocity overshoot phenomena stronger. InAs is a relatively less explored material when compared to other materials like GaAs. The choice of the material is justified with thorough exploration of …

Evaluation Of The Transport Properties Of Gasb For Bipolar Applications Through Monte Carlo Simulations, Damayanthi Palaniappan

Electrical & Computer Engineering Theses & Dissertations

GaAs is currently the semiconductor material of choice for high speed, low power applications. Its electronic transport properties are superior to almost all other semiconductors. It is also used in a variety of bipolar applications such as photodetectors and photo-mixers. However, as is well known, the hole mobility and related transport parameters of GaAs are not very good. This is a serious drawback, and poses a potential problem for all applications involving bipolar conductivity. In order to increase the high :frequency limits and high-speed capability of bipolar devices, the choice of an alternative material, therefore, becomes necessary. An important first …

The Current Voltage Characteristics Of Electron Beam Controlled Thin Film Diamond Switches, Christopher Anthony Molina

Electrical & Computer Engineering Theses & Dissertations

The dark current of natural diamond thin films and the induced current due to electron-beam irradiation was measured up to a range of 7000Ncm'. The contact material was aluminum, annealed and unannealed. Switching experiments were performed with electron energies ranging from 70keV to 172keV. The switching results obtained are strongly dependent on the biasing polarity, incident electron energy, and whether the contact is blocking or Ohmic in nature. A simple model which takes traps into consideration allows us to explain the various switching responses. The range of electrons which define, in part, the switch mode was measured for one sample …

Transient Simulations And Modelling Of Semi-Insulating Gaas Photoconductive Switches, Prasun Kumar Raha

Electrical & Computer Engineering Theses & Dissertations

The primary objective of this thesis is to develop a one-dimensional transient simulator for Photoconductive Semiconductor Switches (PCSS) taking into consideration the material characteristics, the internal physical effects, and the external circuit. Simulations have been performed to study the device behavior at different voltage levels for copper-doped silicon-compensated GaAs material, though other materials could easily be simulated by changing the parameters. The model includes hole transport, and the results demonstrate the effect of hole injection, with and without recombination centers. In addition to developing a one-dimensional transient simulator, the role of various physical effects, such as the field-dependence of trapping …

Light Injection From An Active Cladding To The Core Of A Fiber Optic Fluorosensor, Alvin Leon Bryant

Electrical & Computer Engineering Theses & Dissertations

A fluorosensor works on the basis of light injection from the clad into the core of an optical fiber. The sensitivity of such a sensor depends on the efficiency of light injection. Conditions necessary for a high injection efficiency are experimentally determined. The refractive index difference between the core and the clad,ⁿcore ^-nclad, must be maximized to achieve a high injection efficiency. Since an air clad has the least refractive index, a bare core fiber will have a maximum efficiency. Standard optical fibers used for communication employ a minimum value for ⁿcore ^-nclad, in order …

Study Of Single-Fiber Fiber Optic Lever Microphone, Trung Duc Nguyen

Electrical & Computer Engineering Theses & Dissertations

Fiber optic sensors are widely used in today's technological applications, providing many advantages that conventional sensors lack. In particular, there is a demand in hypersonic applications to develop microphones to measure acoustic pressure that performs in high temperature and noisy surroundings. This thesis analyzes fiber optic lever microphones (FOLM), since they perform at high temperatures. An FOLM system is an intensity modulated sensor, which is simple to implement and is small in size. Two models of the FOLM have been fabricated and calibrated. The first model uses a seven-element fiber array while the second uses a single-fiber to transmit and …

A Novel Technique For Deep Level Characterization Of High-Resistivity Semiconductor Materials, Sridhar Panigrahi

Electrical & Computer Engineering Theses & Dissertations

An improved photo induced current transient spectroscopy (PICTS) technique is developed for studying deep level parameters in high-resistivity semiconductor materials. A new digital data acquisition approach and improvement in the cryogenics of the system have enabled us, for the first time in our laboratory, to detect CuA level in a copper doped silicon compensated gallium arsenide (GaAs:Si:Cu) sample. The digital approach improves both the signal to noise ratio (S/N) and the efficiency of the system. Also, multiple PICTS spectra in a single thermal cycle can be obtained. In the present work, various doped and undoped gallium arsenide ( GaAs) and …

Cathodoluminescence Of Gaas, Tyler Smith

Electrical & Computer Engineering Theses & Dissertations

Cathodoluminescence of band-gap radiation across the bulk of a proposed semiconductor switch has been studied. Such a device relies on the efficient use of cathodoluminescence to modulate the conductivity of the switch. Diagnostics were configured to measure the intensity of band-gap radiation across the bulk of several switch samples. The measured results were compared to calculations based on a four energy level band-gap model which included two deep levels EL2 and HL10.

Q Improvement Of A 5.2 Ghz Te011 Cavity By Incorporating Y1Ba2Cu3O7-X, R. Joseph Leclear

Electrical & Computer Engineering Theses & Dissertations

Research is undertaken to apply high temperature superconducting material to improve the quality factor (Q) of a 5.2 GHz cylindrical resonant cavity. In particular, the approach is to electrophoretically deposit polycrystalline Y₁Ba₂Cu₃O_7-x (YBCO) on the conducting surface of the cavity cylinder. Spalling of the YBCO ceramic coating due to expansion and contraction of the cavity during sintering and testing is overcome by segmenting the cylinder. Results show that the Q of the cavity is increased over that of a copper cavity at temperatures below 60 K. At 20 K, improvement exceeds a factor …

Monte Carlo Simulation Of Millimeter-Wave Gunn Effect Oscillators, Ramani Vaidyanathan

Electrical & Computer Engineering Theses & Dissertations

Monte Carlo simulations have been carried out to investigate the performance of microwave Gunn oscillators. Three separate aspects of the simulation problem have been comprehensively addressed in this work. First, the presence of an external circuit has been self-consistently incorporated into the calculations. The inclusion of the external circuit facilitates a study of the circuit controlled regime, and correctly models effects arising from the time dependent boundary conditions. Secondly, microscopic details of the electronic relaxation mechanisms which ultimately control the frequency response limits, have been taken into account through an iterative Monte Carlo-Poisson scheme. This procedure overcomes a potential shortcoming …

Optical And High Electric Field Effects In Bulk Gallium Arsenide Switches, Randy Roush

Electrical & Computer Engineering Theses & Dissertations

During the past few years, bulk, photoconductive switching has become recognized as a viable topic for future research on moderate and high power switches. The two-pulse, or BOSS, concept relies on an excitation laser pulse, and a separate de-excitation pulse in conjunction with silicon doped, copper compensated, GaAs to create a variable temporal electrical pulse width. The research contained in this document provides information concerning the feasibility of the BOSS concept, as the switch is scaled to larger sizes, and higher voltage and current. The major concern will be the high voltage and current effects. The absorption length for 1064 …