Polymer and Organic Materials Commons^™

Soil Degradation Of A Plastic Blend Of Opuntia Ficusindica Juice, Animal Protein And Beeswax, Isabel A. Gamez, Daniel R. Kava

Materials Engineering

Since the introduction of single use plastics in the early 1900s, their usage has increased exponentially. Unfortunately, due to this exponential increase there are negative environmental implications of their production, which requires further consideration. Currently, there are various waste disposal practices for SUPs, including landfilling, incineration, and recycling. Recent data revealed that only 14 % of plastic waste was recycled, with 40% of plastic waste being landfilled, while the rest of the plastic waste was incinerated or released to the environment at 14 % and 32 %, respectively. A potential solution to the plastic waste issue is developing a polymer …

Optimization Of Polyhydroxyalkanoates (Phas) Bioplastic Production From Wastewater Activated Sludge, Bo Deng

Dissertations

Polyhydroxyalkanoate (PHA) is a biopolymer which has similar properties as fossil-fuel based plastic but also has capacity to biodegrade completely in the environment condition. This project aims to optimize the process to produce bioplastic PHA using activated sludge from wastewater. Specifically, five major research objectives are explored: (i) develop a quantification method of PHA by using Fourier-transform infrared spectroscopy (FTIR)F; (ii) improve the PHA production from mixed microbial cultures (MMC) by optimizing MMC; (iii) simulate the PHA production by using wastewater; (iv) evaluate the application of enzyme (alpha-amylase) in PHA production process; (v) market the investigation of wastewater produced PHA. …

Chitosan Graphene Composite Fabrication And Characterization For Treatment Of Harmful Algal Blooms And Toxins, Sarah Zetterholm

Master's Theses

Chitosan graphene composites were fabricated and characterized as a management strategy for harmful algal blooms (HABs) caused by various species of cyanobacteria. These chitosan graphene materials were compared to previously studied chitosan graphene-oxide composites in both material properties and HAB treatment. In previous studies, adsorption of the cyanobacteria onto the surface of the composite materials has been observed. Investigations of the pure materials for these composites are also included in this study to determine whether removal is a result of charge interactions with the composite, or as an inherent property of the graphene or graphene oxide. Initial results suggest that …

Effects Of Uv Exposure On The Thermo-Mechanical Properties Of Cactus Based Biopolymers, Madison Glozer, Megan Bolling, Addison Wolfson

Materials Engineering

The viability of renewable biopolymers as sustainable alternatives to synthetic plastics is promising, however ultra-violet (UV) radiation can lead to premature degradation and reduction in the material’s performance. Biopolymers comprised of nopal cactus juice, animal protein, natural wax, and glycerin in differing percentages were studied to obtain thermo-mechanical data in relation to UV exposure. To quantify degradation, dynamic mechanical analysis, thermogravimetric analysis, differential scanning calorimetry, infrared spectroscopy, goniometry and gravimetric measurements were performed. Each formulation experienced mass loss as a result of UV exposure, which could be attributed to water evaporation. The thermogravimetric analysis indicated a reduction in the second …

Development Of A Marine Biodegradable Target Balloon, Blake Samuel Robinson, Arash Sam Akhavi, David Leonardo Albarran-Martinez

Materials Engineering

The US Navy utilizes PVC target balloons, known as Killer Tomatoes, that are inflated onboard a naval vessel then deployed into the ocean to calibrate a variety of weaponry. The Navy has requested the investigation of biodegradable polymers to replace the PVC in attempts to reduce ocean waste that is generated from the leftover PVC material. After communicating with American Pacific Plastic Fabricators (APPF), the current manufacturer of the Killer Tomatoes, we gained an understanding of the manufacturing process and the material requirements that would allow a new material to be integrated into their current process. Two proprietary, trial polymers …

Biopolymer-Stabilized Earth Materials For Resilient And Adaptable Infrastructures, Sherif Abdelaziz, Dilip Gersappe, Dilip Rafailovich

Department of Civil Engineering Faculty Publications

Earth dams and levees are constructed and retrofitted nowadays using the same materials that were used in the past, clays and sands. Despite the current advances in engineering, designing and constructing these critical infrastructure, earthen dams and levees continue to suffer from the same challenges over the years. These challenges include internal and surface erosions, loss of stability due to moisture migration, and inabilities to self-heal potential failure points. This project focuses on the use of biopolymers as additives to strengthen earthen dams and levees targeting an overall increase in their resilience.

Explicitly, the report for Milestone 3 presented the …

Photooxidation Of Biopolymers, Marlon H. Dieguez

Materials Engineering

The lack of degradation of plastic products have imposed problems in the preservation of natural environments and their ecosystems through plastic accumulation. This collection of plastics promotes toxin exposure to wildlife, finding its way into the food chain, affecting both land and marine ecosystems. The project goal is to understand the degradation mechanisms of biodegradable materials and other comparable materials through UV radiation testing. Polylactide (PLA) films and polycarbonate (PC) films will be compared for their relative deterioration from constant UV radiation in a Q-U-V accelerated weather tester for 28 days. Five 3” by 5” samples of 14 mil thick …

Manufacture And Mechanical Testing Of Thin Film Composites Composed Of Poly-Lactic Acid And Nanocrystalline Cellulose, Catherine E. Mohan

Materials Engineering

Society’s overuse of petroleum-based plastic products has created a waste problem that is threatening environments around the world. New efforts have been made to find a suitable replacement derived from a renewable source. Poly-lactic acid has become one of the front-runners in this search. It is derived from starches found in potatoes, corn, and other grains. There are many factors that make Poly-lactic acid-based polymers a suitable replacement for petroleum-based ones, but it still suffers from low mechanical strength due to low crystallinity percentages. Doping the polymer with nanocrystalline cellulose provides more nucleation sites for the crystallization of the polymer …