Materials Science and Engineering Commons^™

Effect Of Post-Consumer Content And Bioplastic Incorporation On Polymeric Resin In Consumer Applications, Shelby Bicknell

Electronic Theses & Dissertations

Controversy surrounds the use of plastic products, primarily due to their potentially negative impact on the environment at the end of their lifecycle. The most widely used plastics are manufactured from petrochemicals such as petroleum, coal or natural gas. Petrochemical plastics are not able to readily breakdown in the environment, which aggravates the existing pollution problems. Fortunately, there are eco-friendly alternatives to petrochemical-based plastics. Bioplastics may be derived from renewable sources, biodegradable, or both. Bio-based plastics are plastics that may be derived from renewable biomass sources including, but not limited to, vegetable oils, cornstarch, straw, woodchips, and food waste. They …

Ac Conductivity Studies Of Polyethylene-Oxide-Garnet Type Li7la3zr2o12 Hybrid Composite Solid Polymer Electrolyte For Li-Ion Battery, Parisa Bashiri

Wayne State University Dissertations

Solid electrolytes including ceramics and polymers are considered to be the ultimate substitute for organic liquid electrolytes currently used in commercialized lithium ion batteries to address the safety concerns due to Li dendrite growth and internal short circuiting. However, low ionic conductivity due to high grain boundary resistance in ceramics and semi-crystalline nature of polymers has held back the solid electrolytes from being used in Li-ion batteries. Polyethylene oxide (PEO), complexed with a Li-salt, is a well-studied polymer electrolyte showing ionic conductivity properties at room temperature. However, the coexistence of amorphous and crystalline regions at room temperature (< Tm, the melting temperature) has

-8 -6 …

Enhanced Electrochemical Performance Of Li-Ion Battery Cathodes By Atomic Layer Deposition, Yan Gao

Doctoral Dissertations

”Li-ion battery now plays an irreplaceable role in supplying green and convenient energy. In this work, atomic layer deposition (ALD) was used to modify Li-ion battery cathode particles for performance enhancement.

An ultrathin and conductive CeO₂ ALD film was deposited on Li-rich layered cathode particles, of which the specific capacity and cyclic stability were significantly improved. On the same cathode particles, FeO_x ALD and post-annealing resulted in a stable and conductive surface spinel phase to improve the performance.

Synergetic TiN coating and Ti doping were performed on a LiFePO₄ (LFP) cathode and extended its cycle life. The …

Characterization, Modeling, And Thermal Management Of High-Performance Lithium Batteries, Minjun Bae

Wayne State University Theses

Lithium-ion (Li-ion) batteries, as one of the most advanced commercial rechargeable batteries, play a crucial role in modern society as they are extensively used in portable electronic devices. Nevertheless, the limited electrochemical performance and poor thermal management systems of Li-ion batteries have hindered the expansion of their future applications. In search of alternative electrode materials to develop a battery with higher electrochemical performance, lithium (Li) metal has attracted much attention as an ideal alternative anode material due to its high specific capacity and lowest redox potential. However, needle-like Li dendritic growth causes severe safety concerns and thus prohibits practical applications …

Macro - And Microstructure Evaluation And Field Applications Of Concrete With Recycled Glass Pozzolan, Marija Krstic

Dissertations and Theses

Concrete is the most used material in the world, second only to water. Conventional concrete is produced with Portland cement (PC). The production of cement is an energy intensive operation that has raised significant environmental concerns, since one ton of cement generates an equal ton of CO₂. In the USA about 90 million tons of cement are used annually, with 3 million tons used in New York. Most contemporary concrete applications for buildings and infrastructure use high-performance concrete (HPC) mixtures which are produced by replacing a percentage of cement with supplementary cementitious materials (SCMs), consisting mainly of fly-ash …

Interfaces In Lead-Free Tin Perovskite Photovoltaics: An Investigation Of Energetics, Ion Mobility, Surface Modification, And Performance, Alex Boehm

Theses and Dissertations--Chemistry

Halide perovskites have generated tremendous interest as low-cost semiconductors for optoelectronics, such as photovoltaics, lasers, and light emitting diodes due to their extraordinary optical and transport properties. Perovskite photovoltaics in particular have demonstrated a meteoric rise in power conversion efficiencies and drawn considerable interest as a next-generation solar energy technology. The rapid development has centered around lead-based derivatives, and concerns regarding the toxicity of lead has sparked interest in low toxicity and more environmentally friendly perovskite derivatives. In this regime tin (Sn) is regarded as a prominent alternative owing to the ideal bandgap and reduced toxicity exhibited by Sn-halide perovskites. …

Fabrication And Characterization Of Electrical Energy Storage And Harvesting Energy Devices Using Gel Electrolytes, Belqasem Aljafari

USF Tampa Graduate Theses and Dissertations

Redox-active materials in the bulk of gel electrolytes are unquestionably holding the primary roles in developing energy harvesting and storage technology. Both technologies are necessary in order to cope with the current challenges of the environmental crises of global warming and finite non-renewable sources while the demand for energy modern societies have been speedily increased. One of the most challenges of making a hybrid device of energy conversion and storage is the cost of the fabrication process. Therefore, gel electrolyte-based materials with redox-active properties can potentially be a promising solution to improve the performance of electrochemical and photoelectrochemical devices for …

Magnetocaloric Effect Near Room Temperature In Quintenary And Sextenary Heusler Alloys, Benjamin D. White, R. I. Barabash, O. M. Barabash, I. Jeon, M. B. Maple

All Faculty Scholarship for the College of the Sciences

An inverse magnetocaloric effect is studied in Ni₂Mn_1+xX_1-x-type Heusler alloys. Principally known for their shape-memory properties, these alloys also exhibit significant entropy and temperature changes (ΔS and ΔT_Ad, respectively) under adiabatic conditions when a modest magnetic field is applied. We investigated the impact on magnetocaloric properties of introducing substantial chemical disorder on the X-site (X = Si, Ga, In), of replacing Ni with nonmagnetic Ag, and of replacing a small amount of Mn with Gd. While a reduction in ΔS is observed in the first two cases, we observe a significant enhancement …

Evaluation Of Biodegradability Characteristics Of Cellulose-Based Film As Per Is/Iso 14855-1, Narayan C. Saha Dr, Gaurav Madhu Dr, Diksha B. Kadu Ms

Journal of Applied Packaging Research

Biodegradable polymers (especially those derived from plant sources) begin their lifecycle as renewable resources, usually in the form of starch or cellulose. In this paper, the evaluation of biodegradability of cellulose-based polymer film under controlled composting conditions as per the guidelines of IS/ISO 14855 (Part-1) standard has been described. Microcrystalline cellulose (MCC) powder was taken as positive-control polymer. The apparatus used to analyse the degree and rate of biodegradation was developed indigenously. The validation of the biodegradability testing apparatus was also performed as per the prescribed test method given in IS/ISO 14855-1.

Microstructural Effects On Photocatalytic Performance In Ag3po4/Bi2moo6 Z-Scheme Photocatalyst Systems, Kaleab Mengesha Ayalew

UNLV Theses, Dissertations, Professional Papers, and Capstones

As the world population continues to grow and access to modern industry become increasingly common, humanity finds itself amid an environmental and energy crisis. Natural resources, such as clean water are getting scarce. Currently, the development of high efficiency, green energy sources, and eco-friendly methods for water treatment have become a nonelective task. As a result, photocatalysis, as one of the most promising technologies in utilizing solar energy and pollutant removal, has attracted considerable attention.

However, the practical application of photocatalysis is still elusive because of the difficulty of finding an individual material that can satisfy all the requirements for …

Using Numerical Models Of Dewatering At Coal Ash Impoundments To Understand Cost And Schedule, Peter Bell, Joel Thompson, Don Fuller

World of Coal Ash Proceedings

No abstract provided.

Investigating Ccr Units And Evaluating The Physical Properties Of Ponded Ccr, David Skeggs, Zahra Aghazadeh, Rachel Combs

World of Coal Ash Proceedings

No abstract provided.

Demonstration Of “No Migration” Alternative Performance Standard For Ccr Facilities In Arid To Semi- Arid Regions Using Unsaturated Zone Modeling, James Aiken, Katy Lindstom

World of Coal Ash Proceedings

No abstract provided.

Coal Combustion Residuals Management Using Geotextile Containers- Considerations For Various Options, Randall Wilcox, Gregg Lebster, Bryan Hamilton, Thomas Stephens

World of Coal Ash Proceedings

No abstract provided.

State Vs Federal Ccr Rule Regulations: Comparisons And Impacts, Nicole Kron, Eric Nelson

World of Coal Ash Proceedings

No abstract provided.

Continuous, Real-Time Tss Monitoring Verifies Effluent Quality And Coal Ash Management Performance While Reducing Compliance Costs, Dave Fraley, Chris Bauman, Dave Donahue

World of Coal Ash Proceedings

No abstract provided.

Effect Of Coal Fly Ash On Agricultural Crops :Second Phase Showcase Project On Use Of Fly Ash In Agriculture In And Around Thermal Power Station Areas Of National Thermal Power Corporation Ltd., India., K. Arivazhagan, M. Ravichandran, S.K. Dube, V.K. Mathur

World of Coal Ash Proceedings

No abstract provided.

Advantages Of Single Source Contracting In-Plant Ccr Services, Kevin Foody, Marcella Funderburg, Blake Whittington

World of Coal Ash Proceedings

No abstract provided.

Design And Construction Of A Ccr Landfill Adjacent To The Missouri River, Thomas Gredell, Jeffrey Fouse, Jay Ellington

World of Coal Ash Proceedings

No abstract provided.

Geochemical Tools For Groundwater Monitoring At Coal Fired Utilities, Jeff Gillow, Bruce Sass, Hari Parthasarathy

World of Coal Ash Proceedings

No abstract provided.

Bottom Ash Handling Conversions – Lessons Learned, Dustin Doerr

World of Coal Ash Proceedings

No abstract provided.

Encapsulation Of Thermoevaporation Brines Using Coal Combustion Residuals, Dale Prentice, Kirk Ellison, Gaurav Sant

World of Coal Ash Proceedings

No abstract provided.

Recycling Of Coal Ash In Agriculture: Use Of Vermicomposting Biotechnology, G.N. Chattopadhyay, Gourab Roy, Wasim Iftikar

World of Coal Ash Proceedings

No abstract provided.

Surface Water And Groundwater Mixing In Alluvial Floodplains: A Significant Issue For Understanding Contaminant Transport At Coal Ash Facilities Adjacent To Rivers, Joel Thompson, Peter Bell, John Griggs

World of Coal Ash Proceedings

No abstract provided.

Alternate Source Demonstration Considerations Within The Appalachian Basin, Joseph Robb, Larry Mastera

World of Coal Ash Proceedings

No abstract provided.

Locating And Permitting A Ccr Landfill Adjacent To The Missouri River, Paul Reitz, Thomas Gredell, Jay Ellington

World of Coal Ash Proceedings

No abstract provided.

Is Zero Solid Waste Possible For Fly Ash Produced From Any Coal-Fired Power Plant?, Jinder Jow, Yang Dong, Shuqiang Ding, Li Qiao

World of Coal Ash Proceedings

No abstract provided.

Groundwater Corrective Action Assessment Using Fate And Transport Modeling, Brian Hennings, Glenn Luke, Jacob Walczak

World of Coal Ash Proceedings

No abstract provided.

The Application Of Natural Attenuation At Coal Combustion Residual (Ccr) Sites, Ryan Fimmen, Allison Kreinberg

World of Coal Ash Proceedings

No abstract provided.

Coal Ash 2.0: The Calculus Of The Ore Body, Claudio Arato

World of Coal Ash Proceedings

No abstract provided.