Power and Energy Commons^™

140 New Montgomery Power Distribution Design, Stephen Shaffer

Electrical Engineering

The Power Distribution Design for a high-rise building requires a great deal of coordination and design from the structural, electrical, mechanical, telecommunication, and PG&E engineers. This report will cover how I was able to coordinate and design the power distribution system for 140 New Montgomery, a 28 story building located in San Francisco. Furthermore, this report will cover the steps taken in the future to ensure a smooth transition from the schematic design phase to the construction document phase.

Benefits Of Near-Term Cloud Location Forecasting For Large Solar Pv, Timothy Robert Rudd

Master's Theses

As the ‘green’ energy movement continues to gain momentum, photovoltaic generation is becoming an increasingly popular source for new power generation. The primary focus of this paper is to demonstrate the benefits of close-to real-time cloud sensing for Photovoltaic generation. In order to benefit from this close-to real-time data, a source of cloud cover information is necessary. This paper looks into the potential of point insolation sensors to determine overhead cloud coverage. A look into design considerations and economic challenges of implementing such a monitoring system is included. The benefits of cloud location sensing are examined using computer simulations to …

Android Application Controlled Surge Protector, Lok An

Electrical Engineering

A significant amount of consumer electronics cannot be switched off completely without being unplugged. Standby power, also known as phantom power, refers to the electric power consumed by electronic appliances when they are switched off. There are some devices that need constant power; items like alarm clocks and security systems need constant power to function correctly. Some devices, such as video game consoles and televisions, consume power without offering any features. Electricity lost from standby power has been increasing with the amount of consumer electronics increasing in households.

This project’s goal is to create a low power remote that can …

Off-Grid Photovoltaic System Design Project, Brian Duffy

Electrical Engineering

This project uses the BP SX 150S solar panel to charge a 12 V battery. This battery powers an AIMS 400 W Modified Sine Wave Inverter to provide 120 V RMS AC power to a load of up to 40 W. Inverter efficiency was measured at different load conditions. A control circuit was implemented to prevent overcharging or over-discharging of the battery, by disconnecting it from the panel or the load, respectively. The control circuit turn-on and cutoff voltages were measured versus battery voltage, and the on-resistance of the MOSFET switches was measured for various load currents. A table of …

Hydro-Electric Generation System For The Dc House Project, Dennis Kwan, Mitchell Krug

Electrical Engineering

This paper focuses on the design, integration, and construction of a system that harnesses energy from flowing water. The system will be used in conjunction with the DC House Project. The proposed system employs a DC generator and DC-DC Boost-converter to provide electricity to the DC House at approximately 200-300W. Results of the testing and measurement show that the goal of the system is feasible, but currently limited. The generator could not output the specified power. Details of the design, along with ideas for further improvement, are presented in this report.

Validated Real-Time Energy Models For Small-Scale Grid-Connected Pv-Systems, Lacour Ayompe, Aidan Duffy, Sarah Mccormack, Michael Conlon

Articles

This paper presents validated real-time energy models for small-scale grid-connected PV-systems suitable for domestic application. The models were used to predict real-time AC power output from a PV system in Dublin, Ireland using 30-min intervals of measured performance data between April 2009 and March 2010. Statistical analysis of the predicted results and measured data highlight possible sources of errors and the limitations and/or adequacy of existing models, to describe the temperature and efficiency of PV-cells and consequently, the accuracy of power prediction models. PV-system AC output power predictions using empirical models for PV-cell temperature and efficiency prediction showed lower percentage …

The Applications And Limitations Of Printable Batteries, Matthew Delmanowski

Graphic Communication

This study focuses on the potential applications for printed batteries and how they could affect the printing industry. It also analyzes the main problems associated with manufacturing this technology and what needs to be done to overcome these issues. To find the answers to these questions, two methods of research were used. The first was through the elite and specialized interviewing of Dr. Scott Williams of Rochester Institute of Technology and Professor Nancy Cullins from Cal Poly. The second form of research was a common, yet useful, method called secondary research. This entailed looking at recent written research papers about …

Dc-Dc Converter For Harvesting Energy From An Exercise Bike, Henry Ureh, Chris Henry

Electrical Engineering

Create an efficient buck-boost converter that adapts to input voltage range from ~3.8V to 70V, and outputs 13.7V DC, the voltage required by a charge controller to charge a battery. The energy stored in the battery will be supplied back to the grid.

The cost of energy saved by the converter should eventually cover the initial price of the converter. The converter should help reduce the net power consumption of the exercise machines used in the Cal Poly gym

Nuclear Energy, Steve Kraft

Native American Forum on Nuclear Issues

Abstract:

-Why Nuclear Energy?

-The lesson of the last 20 years in U.S. electricity policy:

– Diversified fuel and technology portfolio is essential

– All fuels and technologies (nuclear, coal, natural gas, renewables, efficiency) have a legitimate role

-The challenge for the future:

– Preserving/restoring diversified portfolio

– Ensuring resource adequacy, particularly in competitive markets

-Expanded use of nuclear energy is part of the answer

– Integrated used fuel management supports nuclear competitiveness