Power and Energy Commons^™

Modeling And Validation Of A Synchronous-Machine/Controlled-Rectifier System, Kyle A. Hord

Theses and Dissertations--Electrical and Computer Engineering

The hardware validation of a novel average-value model (AVM) for the simulation of a synchronous-generator/controlled rectifier system is presented herein. The generator is characterized using genetic algorithm techniques to fit standstill frequency response (SSFR) measurements to q and d-axis equivalent circuits representing the generator in the rotor reference frame. The generator parameters form the basis of a detailed model of the system, from which algebraic functions defining the parametric AVM are derived. The average-value model is compared to the physical system for a variety of loading and operating conditions including step load change, change in delay angle, and external closed-loop …

Investigation Of Protection Issues And Method For The Distribution System With Distributed Generations, Ke Xu

Theses and Dissertations--Electrical and Computer Engineering

Because DGs are introduced into distribution systems, the coordination of fuses and reclosers doesn’t work well. It means the original protection schemes are not available for the distribution systems with DGs. This thesis paper presents the study on the impacts of DGs on the fault current and voltage in the distribution system by the simulation of a model distribution system. After we study the impacts of DG on distribution systems, there is an introduction of current several current protection schemes and fault locations methods. At last, an adaptive protection scheme with a more efficient fault location method for the distribution …

Multifrequency Averaging In Power Electronic Systems, Fei Pan

Theses and Dissertations--Electrical and Computer Engineering

Power electronic systems have been widely used in the electrical power processing for applications with power levels ranging from less than one watt in battery-operated portable devices to more than megawatts in the converters, inverters and rectifiers of the utility power systems. These systems typically involve the passive elements such as inductors, capacitors, and resistors, the switching electronic components such as IGBTs, MOSFETS, and diodes, and other electronic circuits. Multifrequency averaging is one of the widely used modeling and simulation techniques today for the analysis and design of power electronic systems. This technique is capable of providing the average behavior …

A New Design Of Dc-Dc Converter For Capacitive Deionization Process, Zhiao Li

Theses and Dissertations--Electrical and Computer Engineering

The shortage of clean water has become a significant global problem, and capacitive deionization (CDI) is a technology that can be used to help relieve the problem. A Ćuk converter system that can recover energy from CDI cells is described. This converter transfers energy between two CDI cells when a cell is in its desorption period, allowing energy that would otherwise be lost to be recovered and improving overall system efficiency. In order to control the states of the MOSFET switches in the converter, a self boost charge pump is used. In this way, the microcontroller can control system duty …

Coordinated Voltage And Reactive Power Control Of Power Distribution Systems With Distributed Generation, Esa A. Paaso

Theses and Dissertations--Electrical and Computer Engineering

Distribution system voltage and VAR control (VVC) is a technique that combines conservation voltage reduction and reactive power compensation to operate a distribution system at its optimal conditions. Coordinated VVC can provide major economic benefits for distribution utilities. Incorporating distributed generation (DG) to VVC can improve the system efficiency and reliability. The first part of this dissertation introduces a direct optimization formulation for VVC with DG. The control is formulated as a mixed integer non-linear programming (MINLP) problem. The formulation is based on a three-phase power flow with accurate component models. The VVC problem is solved with a state of …

Investigation Of Cds Nanowires And Planar Films For Enhanced Performance As Window Layers In Cds-Cdte Solar Cell Devices, Jianhao Chen

Theses and Dissertations--Electrical and Computer Engineering

Cadmium sulfide (CdS) and cadmium telluride (CdTe) are two leading semiconductor materials used in the fabrication of thin film solar cells of relatively high power conversion efficiency and low manufacturing cost. In this work, CdS/CdTe solar cells with a varying set of processing parameters and device designs were fabricated and characterized for comparative evaluation. Studies were undertaken to elucidate the effects of (i) each step in fabrication and (ii) parameters like thickness, sheet resistance, light absorptivity solution concentration, inert gas pressure etc. Best results were obtained when the thickness of CdS planar film for the window layer was in the …

Copper Indium Diselenide Nanowire Arrays In Alumina Membranes Deposited On Molybdenum And Other Back Contact Substrates, Bhavananda R. Nadimpally

Theses and Dissertations--Electrical and Computer Engineering

Heterojunctions of CuInSe₂ (CIS) nanowires with cadmium sulfide (CdS) were fabricated demonstrating for the first time, vertically aligned nanowires of CIS in the conventional Mo/CIS/CdS stack. These devices were studied for their material and electrical characteristics to provide a better understanding of the transport phenomena governing the operation of heterojunctions involving CIS nanowires. Removal of several key bottlenecks was crucial in achieving this. For example, it was found that to fabricate alumina membranes on molybdenum substrates, a thin interlayer of tungsten had to be inserted. A qualitative model was proposed to explain the difficulty in fabricating anodized aluminum oxide …

Fpga To Power System Theorization For A Fault Location And Specification Algorithm, Christina Yeoman

Theses and Dissertations--Electrical and Computer Engineering

Fault detection and location algorithms have allowed for the power industry to alter the power grid from the traditional model to becoming a smart grid. This thesis implements an already established algorithm for detecting faults, as well as an impedance-based algorithm for detecting where on the line the fault has occurred and develops a smart algorithm for future HDL conversion using Simulink. Using the algorithms, the ways in which this implementation can be used to create a smarter grid are the fundamental basis for this research. Simulink was used to create a two-bus power system, create environment variables, and then …

Active Optimal Control Strategies For Increasing The Efficiency Of Photovoltaic Cells, Sharif Aljoaba

Theses and Dissertations--Electrical and Computer Engineering

Energy consumption has increased drastically during the last century. Currently, the worldwide energy consumption is about 17.4 TW and is predicted to reach 25 TW by 2035. Solar energy has emerged as one of the potential renewable energy sources. Since its first physical recognition in 1887 by Adams and Day till nowadays, research in solar energy is continuously developing. This has lead to many achievements and milestones that introduced it as one of the most reliable and sustainable energy sources. Recently, the International Energy Agency declared that solar energy is predicted to be one of the major electricity production energy …

Power System State Estimation Using Phasor Measurement Units, Jiaxiong Chen

Theses and Dissertations--Electrical and Computer Engineering

State estimation is widely used as a tool to evaluate the real time power system prevailing conditions. State estimation algorithms could suffer divergence under stressed system conditions. This dissertation first investigates impacts of variations of load levels and topology errors on the convergence property of the commonly used weighted least square (WLS) state estimator. The influence of topology errors on the condition number of the gain matrix in the state estimator is also analyzed. The minimum singular value of gain matrix is proposed to measure the distance between the operating point and state estimation divergence.

To study the impact of …

Power Control Of Single-Stage Pv Inverter For Distribution System Volt-Var Optimization, Xiao Liu

Theses and Dissertations--Electrical and Computer Engineering

The output power variability of intermittent renewable sources can cause significant fluctuations in distribution system voltages. A local linear controller that exploits the capability of a photovoltaic inverter to provide both real and reactive power is described. This controller substitutes reactive power for real power when fluctuations in the output of the photovoltaic source are experienced. In this way, the inverter can help mitigate distribution system voltage fluctuations. In order to provide real and reactive to the grid, a three-phase grid-connected single-stage photovoltaic system with maximum power point tracking and power control is described. A method of reducing the current …

Contingency Analysis Of Power Systems In Presence Of Geomagnetically Induced Currents, Sivarama Karthik Vijapurapu

Theses and Dissertations--Electrical and Computer Engineering

Geomagnetically induced currents (GIC) are manifestations of space weather phenomena on the electric power grid. Although not a new phenomenon, they assume great importance in wake of the present, ever expanding power grids. This thesis discusses the cause of GICs, methodology of modeling them into the power system and the ramifications of their presence in the bulk power system. GIC is treated at a micro level considering its effects on the power system assets like Transformers and also at a macro level with respect to issues like Voltage instability. In illustration, several simulations are made on a transformer & the …

Smart Grid Communications, Christopher W. Asbery

Theses and Dissertations--Electrical and Computer Engineering

Smart grid technologies are starting to be the future of electric power systems. These systems are giving the utilities detailed information about their systems in real time. One of the most challenging things of implementing smart grid applications is employing the communications into the systems. Understanding the available communications can help ease the transition to these smart grid applications. Many of the utility personnel are spending too much time trying to figure out which communication is better for their application or applications. So this thesis presents the different communication types available with discussing the different attributes in which these communication …