Nanotechnology Fabrication Commons^™

Hybrid Plasmonic Nanoantennas: Fabrication, Characterization, And Application, Shengjie Zhai

UNLV Theses, Dissertations, Professional Papers, and Capstones

As optical counterpart of microwave antennas, plasmonic nanoantennas are important nanoscale devices for converting propagating optical radiation into confined/enhanced electromagnetic fields. Presently, nanoantennas, with a typical size of 200-500 nm, have found their applications in bio-sensing, bio-imaging, energy harvesting, and disease cure and prevention. With the device feature size of next generation IC goes down to 22 nm or smaller, and biological/chemical sensing reaches the Gene’s level, the sizes of the corresponding nanoantennas have to be scaled down to sub-100nm level. In the literature, these sub-100nm nanoantennas are referred as deep subwavelength nanoantennas as size of such miniaturized nanoantennas is …

Fabrication Of A Large, Ordered, Three-Dimensional Nanocup Array, Joanne C. Lo, Soongweon Hong, Richard J. Anderson, Luke P. Lee, David A. Horsley, Jack L. Skinner

Mechanical Engineering

Metallic nanocups provide a unique method for redirecting scattered light by creating magnetic plasmon responses at optical frequencies. Despite considerable development of nanocup fabrication processes, simultaneously achieving accurate control over the placement, orientation, and geometry of nanocups has remained a significant challenge. Here we present a technique for fabricating large, periodically ordered arrays of uniformly oriented three-dimensional gold nanocups for manipulating light at subwavelength scales. Nanoimprint lithography, soft lithography, and shadow evaporation were used to fabricate nanocups onto the tips of polydimethylsiloxane nanopillars with precise control over the shapes and optical properties of asymmetric nanocups.

Thermally Actuated Resonant Silicon Crystal Nanobalances, Arash Hajjam

Electronic Theses and Dissertations

As the potential emerging technology for next generation integrated resonant sensors and frequency references as well as electronic filters, micro-electro-mechanical resonators have attracted a lot of attention over the past decade. As a result, a wide variety of high frequency micro/nanoscale electromechanical resonators have recently been presented. MEMS resonators, as low-cost highly integrated and ultra-sensitive mass sensors, can potentially provide new opportunities and unprecedented capabilities in the area of mass sensing. Such devices can provide orders of magnitude higher mass sensitivity and resolution compared to Film Bulk Acoustic resonators (FBAR) or the conventional quartz and Surface Acoustic Wave (SAW) resonators …

Nanoscale Contacts Between Semiconducting Nanowires And Metallic Graphenes, Seongmin Kim, David B. Janes, Sung-Yool Choi, Sanghyun Ju

Birck and NCN Publications

Metal–semiconductor (M–S) junctions are important components in many semiconductor devices, and there is growing interest in realizing high quality M–S contacts that are optically transparent. In this paper, we present our investigations into the characteristics of M–S junction in a semiconducting ZnO nanowire that was directly grown on a multilayer graphene film (MGF). The synthesized nanowires were fabricated into two-terminal devices with MGF as one contact and Al as the other contact. By comparison with devices employing Al contacts at both ends, the nanowire resistivity and specific contact resistivity of the MGF–nanowire contact can be extracted. The extracted specific contact …

Molecular Dynamics Study Of Diffusion Of O2 Penetrates In Uncrosslinked Polydimethysiloxane (Pdms), Crosslinked Pdms, And Pdms-Based Nanocomposites, Varun Ullal

Graduate Theses and Dissertations

Molecular dynamics simulations are used to study diffusion of O₂ molecules in pure polydimethysiloxane (PDMS), crosslinked PDMS, and PDMS-based nanocomposites. The PDMS chains and penetrates are modeled using a hybrid interatomic potential which treats the Si-O atoms along the chain backbone explicitly while coarse-graining the methyl side groups and penetrates. By tracking the diffusion of penetrates in the system and subsequently computing their mean-squared displacement, diffusion coefficients are obtained. In pure PDMS models of varying molecular weight, diffusivity of the O₂2 penetrates is found to have an inverse relationship with chain length. Simulation models with longer chains …

Plasma-Assisted Molecular Beam Epitaxial Growth Of Indium Nitride For Future Device Fabrication, Steven Paul Minor

Graduate Theses and Dissertations

The need for energy conservation has heightened the search for new materials that can reduce energy consumption or produce energy by the means of photovoltaic cells. III-nitride alloys show promise for these applications due to their generally good transport properties and ability to withstand high power applications. Along with these, this family of semiconductor alloys has a direct bandgap energy range (0.7-6.2 eV) which spans the entire visible spectrum and encompasses a large portion of the available solar spectrum. Of the three root III-nitride semiconductors, AlN, GaN, and InN, InN has only recently become attainable epitaxially with qualities good enough …

Use Of Ultra High Vacuum Plasma Enhanced Chemical Vapor Deposition For Graphene Fabrication, Shannen Adcock

Graduate Theses and Dissertations

Graphene, what some are terming the "new silicon", has the possibility of revolutionizing technology through nanoscale design processes. Fabrication of graphene for device processing is limited largely by the temperatures used in conventional deposition. High temperatures are detrimental to device design where many different materials may be present. For this reason, graphene synthesis at low temperatures using plasma-enhanced chemical vapor deposition is the subject of much research. In this thesis, a tool for ultra-high vacuum plasma-enhanced chemical vapor deposition (UHV-PECVD) and accompanying subsystems, such as control systems and alarms, are designed and implemented to be used in future graphene growths. …

High Frequency Characterization Of Carbon Nanotube Networks For Device Applications, Emmanuel Decrossas

Graduate Theses and Dissertations

This work includes the microwave characterization of carbon nanotubes (CNTs) to design new CNTs-based high frequency components. A novel developed method to extract the electrical properties over a broad microwave frequency band from 10 MHz to 50 GHz of carbon nanotubes (CNTs) in a powder form is performed. The measured scattering parameters (S-parameters) with a performance network analyzer are compared to the simulated one obtained from an in-house computed mode matching technique (MMT). An optimized first order gradient method iteratively changes the unknown complex permittivity parameters to map the simulated S-parameters with the measured one until convergence criteria are satisfied. …

Fabrication Of Vertical Silicon Nanowires Through Metal Assisted Deposition, Matthew Garett Young

Graduate Theses and Dissertations

Controlled and ordered growth of Si nanowires through a low temperature fabrication method compatible with CMOS processing lines is a highly desirable replacement to future electronic fabrication technologies as well as a candidate for a low cost route to inexpensive photovoltaics. This stems from the fact that traditional CMOS based electronics are hitting physical barriers that are slowing the Moore's Law trend as well as the demand for an inexpensive solar cell technology that can obtain grid parity. A fractional factorial growth study is presented that compares the growth of Au and Al catalyzed Si nanowires at temperatures ranging from …

Thermal Conductivity Measurement With 3Ω Method Background And Synopsis Of Its Implementation, Fiifi Blankson

College of Engineering: Graduate Celebration Programs

ABSTRACT

Continued advances in nanostructured materials have made it necessary to develop materials with specific thermoelectric properties. The 3ω Method provides an accurate measurement of one such property, thermal conductivity. It will be used in this research to find high electrical conductivity alloys with low thermal conductivity.

Characterization And Manipulation Of Nanorods Via An Applied Magnetic Field, Summer Wu '13

Student Publications & Research

A remote system capable of controlling the motion of magnetic nanorods was created. Two different systems, electromagnets and magnetic stirrers, were used to create continuously changing magnetic fields thus applying a constant torque to make nanorods rotate as “nano stirbars”. The system was tested on three different types of synthesized nanorods: multi-segmented Ni/Au, pure Ni, and pure Au nanorods. Ni and Au were chosen due to the combination of the magnetic properties of Ni and the biocompatible properties of Au. Variables such as length, shape, and geometries of the nanorods were characterized by a scanning electron microscope and an atomic …

Stabilizing Acetylcholinesterase On Carbon Electrodes Using Peptide Nanotubes To Produce Effective Biosensors, Todd J. Stevens

Theses and Dissertations

A biosensor for the detection of organophosphates in water was created by immobilizing acetylcholinesterase (AChE) on a carbon screen printed electrode using peptide nanotubes (PNT) and Nafion®. This sensor was used with acetylthiocholine (ASCh) substrate to detect the inhibitory effects of malathion. The stability of the encapsulated enzyme was measured over 50 days of storage at 4°C in a phosphate buffer solution. The oxidation of thiocholine, a product of the enzymatic reaction of ASCh and AChE, was used to measure the activity of the encapsulated enzyme. Cyclic voltammograms were taken in an ASCh and phosphate buffer solution, and the peak …

Theory Of Charging And Charge Transport In “Intermediate” Thickness Dielectrics And Its Implications For Characterization And Reliability, Sambit Palit, Muhammad A. Alam

Birck and NCN Publications

Thin film dielectrics have broad applications, and the performance degradation due to charge trapping in these thin films is an important and pervasive reliability concern. It has been presumed since the 1960s that current transport in intermediate-thickness (IT) oxides (∼10–100 nm) can be described by Frenkel-Poole (FP) conduction (originally developed for ∼mm-thick films) and algorithms based on the FP theory can be used to extract defect energy levels and charging-limited lifetime. In this paper, we review the published results to show that the presumption of FP-dominated current in IT oxides is incorrect, and therefore, the methods to extract trap-depths to …

Matter Under Unusual Conditions, Bernard Zygelman

NSTec UNLV Symposium

What is curiosity – driven research and why do we support it?

Vannevar Bush Science The Endless Frontier (1945)

“Science is the pacemaker of technological progress … New productsand new processes do not appear full-grown. They are founded on newprinciples and new conceptions, which in turn are painstakingly developedby research in the purest realms of science“

•Magnetic Resonance Imaging
•Positron Emission Tomography
•Laser applications
•GPS
•Nano Technology

A Reconfigurable Cpw Bow-Tie Antenna Using An Integrated Ferroelectric Thin Film Varactor, K. C. Pan, Dustin Brown, Guru Subramanyam, R. Penno, H. Jiang, C. H. Zhang, M. Patterson, David Kuhl, Kevin Leedy, Charles Cerny

Electrical and Computer Engineering Faculty Publications

A novel printed antenna with a frequency reconfigurable feed network is presented. The antenna consists of a bowtie structure patch radiating element in the inner space of an annulus that is on a nongrounded substrate with a ferroelectric (FE) Barium Strontium Titanate (BST) thin film. The bowtie patch is fed by a coplanar waveguide (CPW) transmission line that also includes a CPW-based BST shunt varactor. Reconfiguration of the compact 8 mm × 8 mm system has been demonstrated by shifting the antenna system’s operating frequency 500 MHz in the 7–9 GHz band by applying a DC voltage bias.

New Class Of Garnet Nanocomposites For Use In Magnetic Photonic Crystals Prepared By Rf Magnetron Co-Sputtering, Mohammad Nur-E-Alam, Mikhail Vasiliev, Kamal Alameh

ECU Presentations

No abstract provided.

Tunable Gold Nanostructures With Nanocapsules As Template Reaction Vessels, Balasubramanian Ramjee, Srujana Prayakarao, Sangbum Han, Wei Cao

Chemistry & Biochemistry Faculty Publications

Hollow, polymeric, thiol-ene resorcinarene nanocapsules can act as template reaction vessels for the synthesis of gold nanoshells or spherical aggregates of gold nanoparticles depending on the reaction conditions. The spherical nanoparticle aggregates were evaluated as catalysts in the biphasic reduction of 4-nitrophenol.

Feedback Control For Electron Beam Lithography, Yugu Yang

Theses and Dissertations--Electrical and Computer Engineering

Scanning-electron-beam lithography (SEBL) is the primary technology to generate arbitrary features at the nano-scale. However, pattern placement accuracy still remains poor compared to its resolution due to the open-loop nature of SEBL systems. Vibration, stray electromagnetic fields, deflection distortion and hysteresis, substrate charging, and other factors prevent the electron-beam from reaching its target position and one has no way to determine the actual beam position during patterning with conventional systems. To improve the pattern placement accuracy, spatial-phase-locked electron-beam lithography (SPLEBL) provides feedback control of electron-beam position by monitoring the secondary electron signal from electron-transparent fiducial grids on the substrate. While …

Memristor-Based Reservoir Computing, Manjari S. Kulkarni

Dissertations and Theses

In today's nanoscale era, scaling down to even smaller feature sizes poses a significant challenge in the device fabrication, the circuit, and the system design and integration. On the other hand, nanoscale technology has also led to novel materials and devices with unique properties. The memristor is one such emergent nanoscale device that exhibits non-linear current-voltage characteristics and has an inherent memory property, i.e., its current state depends on the past. Both the non-linear and the memory property of memristors have the potential to enable solving spatial and temporal pattern recognition tasks in radically different ways from traditional binary transistor-based …