Nanotechnology Fabrication Commons^™

Design, Modeling, And Experimental Development Of Nanoscale Confinement Structures On Planar Silicon-Based Microelectrode Arrays For Single-Entity Electrochemical Sensing, Parinaz Eskandari

Dissertations, Master's Theses and Master's Reports

Electrochemical sensing is widely used for chemical and biological detection due to its high sensitivity, label-free operation, and compatibility with miniaturized electronic systems. However, conventional microelectrode platforms operate in an ensemble-averaged regime in which the measured current represents the collective response of many molecules interacting with the electrode surface. This ensemble averaging masks localized nanoscale electrochemical events and limits the ability to detect rare interactions, such as single molecules or nanoparticles. Achieving single-entity electrochemical detection therefore requires strategies that confine electrochemical reactions to nanoscale regions while maintaining compatibility with scalable planar microfabrication.

This dissertation investigates nanoscale electrochemical confinement on planar …

Superresolution Enhancement With Active Convolved Illumination, Anindya Ghoshroy

Dissertations, Master's Theses and Master's Reports

The first two decades of the 21st century witnessed the emergence of “metamaterials”. The prospect of unrestricted control over light-matter interactions was a major contributing factor leading to the realization of new technologies and advancement of existing ones. While the field certainly does not lack innovative applications, widespread commercial deployment may still be several decades away. Fabrication of sophisticated 3d micro and nano structures, specially for telecommunications and optical frequencies will require a significant advancement of current technologies. More importantly, the effects of absorption and scattering losses will require a robust solution since this renders any conceivable application of metamaterials …

Design Automation For Carbon Nanotube Circuits Considering Performance And Security Optimization, Lin Liu

Dissertations, Master's Theses and Master's Reports

As prevailing copper interconnect technology advances to its fundamental physical limit, interconnect delay due to ever-increasing wire resistivity has greatly limited the circuit miniaturization. Carbon nanotube (CNT) interconnects have emerged as promising replacement materials for copper interconnects due to their superior conductivity. Buffer insertion for CNT interconnects is capable of improving circuit timing of signal nets with limited buffer deployment. However, due to the imperfection of fabricating long straight CNT, there exist significant unidimensional-spatially correlated variations on the critical CNT geometric parameters such as the diameter and density, which will affect the circuit performance.

This dissertation develops a novel timing …

Nanosphere Lithography And Its Application In Rapid And Economic Fabrication Of Plasmonic Hydrogenated Amorphous Silicon Photovoltaic Devices, Chenlong Zhang

Dissertations, Master's Theses and Master's Reports

Solar photovoltaic (PV) devices harvest energy from solar radiation and convert it to electricity. PV technologies, as an alternative to traditional fossil fuels, use clean and renewable energy while minimizing pollution. For decades researchers have been developing thin film solar cells as an important alternatives to the relatively expensive bulk crystal solar cell technology. Among those, hydrogenated amorphous silicon (a-Si:H) solar cells prevails for good efficiency, non-toxic and materially abundant nature. However, a-Si:H thickness must be minimized to prevent light induced degradation, so optical enhancement is necessary. Light manipulation has to be applied and carefully engineered to trap light within …