Open Access. Powered by Scholars. Published by Universities.®

Electronic Devices and Semiconductor Manufacturing Commons™

Open Access. Powered by Scholars. Published by Universities.®

1994

Articles 1 - 8 of 8

Full-Text Articles in Electronic Devices and Semiconductor Manufacturing

Total Ionizing Dose Effects In Mosfet Devices At 77 K, Kevin J. Daul Dec 1994

Total Ionizing Dose Effects In Mosfet Devices At 77 K, Kevin J. Daul

Theses and Dissertations

Total ionizing dose effects on thermal oxide and reoxidized nitrided oxide (RNO) MOSFET devices at 77 K were studied. The MOSFETs were immersed in liquid nitrogen and irradiated, using a 60Co source, up to 1 Mrad(Si) at a dose rate of 107 rads(Si)-sec. Drain current-gate voltage characteristics were obtained and used to determine threshold voltage and transconductance. At 77 K the subthreshold slopes indicated no observed buildup of interface states in any of the transistors. Furthermore, all transistors experienced very little change in the transconductance. Typical negative shifts in threshold voltage as dose increased were observed in all of …

Go to article

Model Of A Single Impurity In A Wide Bandgap Semiconductor Describing Electric Field Screening, Anthony N. Dills Dec 1994

Model Of A Single Impurity In A Wide Bandgap Semiconductor Describing Electric Field Screening, Anthony N. Dills

Theses and Dissertations

A mathematical model of the influence on electric field screening arising from a single impurity in a wide bandgap semiconductor has been numerically investigated and compared with analytically derived solutions. The parameter set chosen to perform the comparison of analytical solution and numerical solution is based upon a bismuth silicate crystal. Both the analytical calculations and the numerical calculations are an attempt to mathematically model the internal electric field within a semiconductor. Two types of impurities were looked at: a single donor level and a single trap impurity level. In general, after an abrupt application of a voltage across the …

Go to article

Photoluminescence Spectroscopy Of 4h- And 6h-Sic, William A. Davis Dec 1994

Photoluminescence Spectroscopy Of 4h- And 6h-Sic, William A. Davis

Theses and Dissertations

Typical undoped bulk grown SiC shows n- or p-type conductivity due to residual impurities such as nitrogen, boron, or aluminum. In order to produce high resistivity material, vanadium can be used as a compensating dopant. Since vanadium is an amphoteric dopant in SiC, it produces either a donor state, VSi4+(3d1) → VSi5+(3d0), or an acceptor state, VSi4+(3d1) → VSi3+(3d2). Thus, vanadium doping can compensate both n- and p-type conductivity. In this work, vanadium doped and undoped 4H- and 6H-SiC grown …

Go to article

Design, Fabrication, Modeling, And Optical Characterization Of Organic Polymer Nonlinear Directional Couplers, John N. Berry Dec 1994

Design, Fabrication, Modeling, And Optical Characterization Of Organic Polymer Nonlinear Directional Couplers, John N. Berry

Theses and Dissertations

This research was an investigation into the suitability of a recently developed polymer, polyphenylene, as a material for integrated optical circuits (IOCs). Polymers show great promise in the area of IOCs because of material processing advantages, compatibility with most existing integrated circuit technology, and relatively strong nonlinear optical characteristics. This thesis contains an overview of: dielectric waveguides, linear and nonlinear directional coupler theory; various models useful in the design and analysis of optical waveguides; the fabrication of three different waveguide designs; the experimental apparatus and procedure used to optically characterize the waveguides; and the experimental results of the characterization. Waveguiding …

Go to article

The Current Voltage Characteristics Of Electron Beam Controlled Thin Film Diamond Switches, Christopher Anthony Molina Oct 1994

The Current Voltage Characteristics Of Electron Beam Controlled Thin Film Diamond Switches, Christopher Anthony Molina

Electrical & Computer Engineering Theses & Dissertations

The dark current of natural diamond thin films and the induced current due to electron-beam irradiation was measured up to a range of 7000Ncm'. The contact material was aluminum, annealed and unannealed. Switching experiments were performed with electron energies ranging from 70keV to 172keV. The switching results obtained are strongly dependent on the biasing polarity, incident electron energy, and whether the contact is blocking or Ohmic in nature. A simple model which takes traps into consideration allows us to explain the various switching responses. The range of electrons which define, in part, the switch mode was measured for one sample …

Go to article

Transient Simulations And Modelling Of Semi-Insulating Gaas Photoconductive Switches, Prasun Kumar Raha Jul 1994

Transient Simulations And Modelling Of Semi-Insulating Gaas Photoconductive Switches, Prasun Kumar Raha

Electrical & Computer Engineering Theses & Dissertations

The primary objective of this thesis is to develop a one-dimensional transient simulator for Photoconductive Semiconductor Switches (PCSS) taking into consideration the material characteristics, the internal physical effects, and the external circuit. Simulations have been performed to study the device behavior at different voltage levels for copper-doped silicon-compensated GaAs material, though other materials could easily be simulated by changing the parameters. The model includes hole transport, and the results demonstrate the effect of hole injection, with and without recombination centers. In addition to developing a one-dimensional transient simulator, the role of various physical effects, such as the field-dependence of trapping …

Go to article

Optimization Of Electron-Beam Activated Gaas Switches, Raymond Jack Allen Iii Apr 1994

Optimization Of Electron-Beam Activated Gaas Switches, Raymond Jack Allen Iii

Electrical & Computer Engineering Theses & Dissertations

The use of electron induced luminescence (cathodoluminescence) in gallium arsenide offers the possibility to modulate the conductance of the material on a timescale of nanoseconds and with a pulse rate of MHz, through modulation of an electron-beam current. This ionization mechanism allows the utilization of semi-insulating GaAs in fast, high power closing and opening switches. The efficiency of the switches is determined by the hold-off voltage of the GaAs switches, and by the conversion efficiency of electron energy into (useful) photon energy. Studies of the dark-current and the electron-beam induced conductance in semi-insulating GaAs have been performed in order to …

Go to article

The Characteristics Of Motion And Time Study In Taiwan's Electronics Industry And Their Relationship To Business Size, Betty Chang Jan 1994

The Characteristics Of Motion And Time Study In Taiwan's Electronics Industry And Their Relationship To Business Size, Betty Chang

Dissertations and Theses @ UNI

This research was conducted to investigate the characteristics of motion and time study implementation in Taiwan's electronics industry, as perceived by industrial engineers, and the relationships of these perceptions to business sizes of the firms. The questionnaires were mailed to 252 industrial engineers in the general firms group. A total of 206 (81.75%) instruments were returned. The questionnaires were then mailed to another 15 industrial engineers in the highly productive firms group. All the instruments (100%) were returned from the highly productive firm group. Telephone interviews were later conducted with six selected highly productive electronics firms to investigate their successful …

Go to article