Electromagnetics and Photonics Commons^™

Machine Learning Based Automation Of Pcb Pdn Design And Optimization, Haran Manoharan

Doctoral Dissertations

The rapid increase in power density and stringent power-integrity requirements in modern System-on-Chip (SoC) platforms have made Power Delivery Network (PDN) design an increasingly complex, multi-stage challenge. Critical decisions must be made both during pre-layout planning, such as stackup configuration, power-plane geometry, and early decoupling capacitor (decap) budgeting, and during post-layout refinements. Traditional heuristic and evolutionary optimization techniques struggle with scalability, require extensive manual iteration, leading to long runtimes and limited adaptability across varying board configurations. To address these challenges, this work proposes a unified reinforcement-learning-driven framework for automated PDN synthesis and decap optimization that spans both pre-layout and post-layout …

Experimental Validation Of Optical Wireless Communication And Power Transfer For Uav Applications, Fnu Dhruv

UNF Graduate Theses and Dissertations

Unmanned Aerial Vehicles (UAVs) have revolutionized emergency response, disaster assessment, and search-and-rescue operations. However, their operational efficacy is fundamentally constrained by limited battery endurance and the susceptibility of traditional radio-frequency communication to disruption in adverse weather. To address these limitations, this thesis proposes and experimentally validates a novel architecture integrating Free-Space Optical (FSO) communication with Simultaneous Lightweight Information and Power Transfer (SLIPT). This system utilizes a split-beam configuration to concurrently enable high-bandwidth data transmission and optical energy harvesting to replenish the UAV's battery pack. The research was conducted in three progressive phases. Initially, system feasibility was established through rigorous optical …

Development Of Periodic Plasmonic Nano-Structures For Enhanced Labeled Bio-Sensing Systems, Kyle Zackary Smith

Graduate Theses, Dissertations, and Problem Reports (ETD)

The biomedical industry has seen sustained growth over the past half century, with a continually increasing demand for flexible, easy-to-use, and cost-effective tools. One large area of commercial interest has been point-of-use or point-of-care diagnostics, using optical based Lab-On-Chip (LOC) style systems. Label and label-free fluorescence detection systems are common benchtop modalities that have seen recent integration into these portable, cost-effective LOC applications. However, despite their maturity, there are still opportunities to improve device characteristics, specifically in reference to throughput, limit-of-detection (LOD), and hybrid integration (along with associated costs).

Optical research avenues at WVU have focused on improving these systems …

Experimental Characterization Of Photonic Crystal Based Invisibility Cloak Under Tm-Polarized Microwaves, Muhammad Danyal

Dissertations, Master's Theses and Master's Reports

Electromagnetic invisibility cloaks guide waves around an object so that the transmitted wavefront remains undisturbed. Most experimental microwave cloaking studies have focused on transverse electric (TE) polarization due to established measurement techniques. In this thesis, the experimental realization and characterization of a dielectric photonic crystal cloak operating under transverse magnetic (TM) polarization are presented. A measurement system operating in the X-band was developed to map the electric field distribution of the transmitted waves. Cloaking performance was first evaluated qualitatively by comparing numerical and experimental field distributions, where restoration of a flat wavefront indicated effective cloaking. Quantitative evaluation was performed by …

Antenna-Based Sensors For Dielectric Characterization Of Materials, Hilary Scott Nkimbeng Cho

Dissertations, Master's Theses and Master's Reports

This research introduces antenna-based sensors for dielectric characterization aimed at overcoming the limitations of conventional microwave sensors. Although traditional microwave sensors are widely used for their noncontact operation, high sensitivity, and ability to penetrate various materials, they often face challenges such as large size and high-power consumption. To address these issues, antenna-based sensors are explored for their compactness, ease of fabrication, and flexible design adaptability across diverse sensing applications. An in-depth analysis of multiple antenna sensor configurations is conducted, followed by the design and development of high-performance sensing structures. A saw-tooth slot antenna sensor is developed for highly sensitive liquid …

Early-Time/High-Frequency Electromagnetic Induction Sensing For Minimal-Metal And None-Metallic Subsurface Targets, Michele Louise Maxson

Dartmouth College Ph.D Dissertations

Conventional electromagnetic induction (EMI) systems operate within the quasi-static regime, where measurements are dominated by conduction currents and are primarily sensitive to highly conductive targets and bulk soil properties. As a result, these systems exhibit limited sensitivity to low-conductivity and layered media, such as permafrost, composite materials, and minimum-metal landmines, where diagnostically relevant information resides in early-time/high-frequency electromagnetic responses, generally above 100 kHz. This limitation reflects a mismatch between conventional EMI system design and the underlying target physics, restricting the ability of standard EMI approaches to resolve fine-scale non-metallic subsurface structure.

In this thesis, I investigate early-time/high-frequency sensitivity as a …