Electrical and Electronics Commons^™

Development And Testing Of An Ac Micro Hollow Cathode Simulator, Thomas E. Caldwell

Electrical & Computer Engineering Theses & Dissertations

The use of AC source plasma discharge devices in applications such as material processing and film deposition has increased in recent years due to improvements in discharge efficiency made possible by devices such as the micro hollow cathode. Designing hollow cathodes for specific applications requires an understanding of the processes that govern the discharge. Simulation is an inexpensive tool for understanding hollow cathode operation and optimizing the device for specific applications. This thesis describes the development of an AC micro hollow cathode simulator. It details the theoretical models used in the simulation and presents the results of test cases intended …

Micro Hydro Power, Frederick J. Munster

Maine Collection

Micro Hydro Power

by Frederick J. Munster

Department of Economic and Community Development, August, Me. 1999 (?).

Contents: Introduction / History of Hydropower in Maine / Renewables / Why Micro Hydro / Determining Flow / Determining Head / Estimating Energy Potential / Hydro Turbines / Dams, Impoundments, Penstocks and Power Houses / Utility Interconnected Systems / Battery Charging Systems / Operation and Maintenance / Economics / Regulation of Hydro Development / For More Information / References

Two Dimensional, Time Dependent Modeling And Simulation Of Semi-Insulating Gaas High-Power Photoconductive Switches, Prakasit Kayasit

Electrical & Computer Engineering Theses & Dissertations

The current-voltage (I-V) characteristics and photoconductive behavior of semi-insulating GaAs (SI GaAs) high-power switches have been investigated by using a two-dimensional, time dependent, drift diffusion transport model. The dc current-voltage behavior as predicted by the results of this model was compared with available experimental data to evaluate the accuracy and validity of the model. The results show very good agreement, Next, research was carried out to investigate the behavior of the switches under high-field operation.

Simulations at high voltages emphasize on the two following processes: (a) The mechanism of impact ionization and the effect of this mechanism on device stability …

Electrical Characteristics And Parallel Operation Of Microhollow Cathode Discharges, Wenhui Shi

Electrical & Computer Engineering Theses & Dissertations

This thesis describes the electrical properties of microhollow cathode discharges with argon as filling gas. The appearance and current-voltage characteristics of microhollow cathode discharges have been recorded. Three kinds of discharge modes (predischarge, hollow cathode discharge and abnormal discharge) have been observed. The range of operation of the hollow cathode discharge has been found to be 0.5 < pD & 5 Torr cm in argon. By reducing the hole diameter to 100 pm, we were able to operate the discharge to atmospheric pressure in a dc mode. The possibility of dc parallel operation of microhollow cathode discharges was explored. Parallel operation could be obtained without individual ballast for discharges with a positive I-V slope greater than 10 V/mA over a voltage range of more than 5 % of the sustaining voltage. For parallel operation outside the range the ballasting is required. This model was explored by using a segmented anode model. The result of the simple calculation coincides well with the experiment result, where a semi-insulator silicon was used as distributed ballast.

Fuel Cells, Frederick J. Munster Jr.

Maine Collection

Fuel Cells

by Frederick J. Munster Jr.

Edited by: Mr. Christopher Carroll

Maine Department of Economic Development, Augusta, Maine, 1998.

Contents: Hydrogen / Hydrogen Safety / Electrolysis / Electrolyzers / History of Fuel Cells / How Fuel Cells Operate / Fuel Cell Types / Fuel Cell Electrochemistry / Power Systems / Fuel Cells in Transportation / Hydrogen Powered Internal Combustion Engines / Home, Garden, Education and Industry / For More Information / Glossary / References

An Appraisal Of Electricity Supply In Nigeria And The Privatisation Option, E. I. K. Sule, C. M. Anyanwu

CBN Occasional Papers

Incessant electric power cuts in most parts of the country has become a normal feature of electricity supply throughout Nigeria. The power outages cause much inconvenience and economic losses to all and sundry. This study has shown that the most critical factor behind the incessant power failure is the problem of inadequate funding of the industry at a time it was forced to accommodate rapid expansion. Other factors include lack of autonomy, inefficiency, poor organization as well as lack of skilled manpower. The paper has examined these problems on the basis of which suggestions are made on how the worrisome …

The Effects Of Channel Curvature And Protusion Height On Nucleate Boiling And The Critical Heat Flux Of A Simulated Electronic Chip, John E. Leland

Office for Research Publications and Presentations

The quest for higher power yet smaller electronics has given rise to the need for very effective cooling of these electronics. Because one of the foremost problems in electronics cooling is achieving high heat flux cooling within small packages while expending minimal pumping power, one focus of this study was to investigate the effects of channel curvature on the CHF. Experimental data were obtained for flow rates of 1-7 m/s, subcoolings of 5-35"C, and radii of curvature of 25.4 and 50.8 mm. A correlation was obtained for these data which provided an excellent fit.

One condition that has been ignored …

Plains Electric Members Service Area_04-29-1994, University Of New Mexico Bureau Of Business And Economic Research

BBER Publications

This report presents historical and projected socioeconomic data for 19 New Mexico and two Arizona counties which comprise the service areas of the distribution cooperatives in the Plains Electric Generation and Transmission Cooperative, Inc., system.

Low‐Cost Technique For Preparing N‐Sb2S3/P‐Si Heterojunction Solar Cells, O. Savadogo, K. C. Mandal

Faculty Publications

No abstract provided.

Studies Of High Field Conduction In Diamond For Electron Beam Controlled Switching, R. P. Joshi, M. K. Kennedy, K. H. Schoenbach, W. W. Hofer

Bioelectrics Publications

Experimental studies on a vertical metal‐diamond‐silicon switch structure have been conducted for potential pulsed power applications. Both the dc current‐voltage characteristics and the transient switching response have been measured for a range of voltages. With a 1 μm diamond film, the switch has been seen to withstand electric fields up to 1.8 MV/cm. Our results show a polarity dependence which can be associated with current injection at the asymmetric contacts. Polarity effects were also observed in the presence of e‐beam excitation, and arise due to nonuniform carrier generation near the diamond‐silicon interface. Our switching transients were seen to follow …

Analysis And Development Of A Switched Capacitor Power Supply, John Richard Hackworth

Electrical & Computer Engineering Theses & Dissertations

The combination of a switched capacitor network and switching power supply techniques can result in a transformer less regulated DC power supply that is small, relatively simple, and efficient. In addition, the output of such a system could be operated over a wide range of common mode voltages. Multiple switched capacitor supplies could be stacked to achieve voltage multiplication.

Although the output of a system of this type is a continuous function, the internal operation must be analyzed in finite time elements. This numerical analysis will be shown in both a mathematical approach and a computer model.

The Influence Of Transverse Magnetic Fields On The Current-Voltage Characteristics Of Glow Discharges, Thomas J. Powers

Electrical & Computer Engineering Theses & Dissertations

In low pressure discharges, operated in electronegative gas mixtures to the right of the Paschen curve minimum, the discharge resistance can be increased by application of transverse magnetic fields. In this range of operation, both the mean free path and the larmor radius are small compared to the discharge dimensions. The relationship between the electric field and the magnetic field is therefore controlled by electron- molecule collisional processes. Specifically, the magnetically induced increase in the discharge resistance is caused by a downward shift of the electron energy distribution which leads to an increase in attachment and a reduction in ionization. …

An Investigation Of Overvoltage Effects On A Gas-Blown Spark Gap, Michael Steven Mazzola

Electrical & Computer Engineering Theses & Dissertations

This experimental investigation addresses the anomalous overvoltage breakdown and subsequent recovery characteristics observed in gas-blown spark gaps. Previous investigations have reported a two-stage recovery process in self-break, pulse-charged, gas-blown spark gape in which the spark gap recovers first to an intermediate breakdown strength before recovering to the undisturbed breakdown voltage. The recovery process has been explained in terms of two different characteristic times. The first is that required to obtain initial recovery in which the spark gap regains its intrinsic breakdown strength. The second time is that required to obtain final recovery in which the pulse-charged spark gap regains the …

A 250-Kv Two-Pulse Modulator For The Gas Flow Switch Test Facility, David Michael Barrett

Electrical & Computer Engineering Theses & Dissertations

High-pressure spark gap switches are often used in pulsed power systems because of their high power capabilities. Unfortunately, these switches cannot be operated at high repetition rates because of the time required for the switch to recover. However, the recovery rate of a spark gap may be improved by flowing a gas through the interelectrode region so as to remove the hot gases and debris.

A test facility has been designed and constructed at Old Dominion University to evaluate the performance of gas-flow spark gap switches operating over a wide range of voltages and flow parameters. The facility consists of …

A Plasma Focus Interrupting Switch, Gregory Francis Knapp

Electrical & Computer Engineering Theses & Dissertations

The feasibility of using a dense plasma focus (DPF) as a current interrupting device has been investigated. Specifically, a 34-kJ, Mather-type DPF was modified to accept a third electrode so that a discharge could be created between this electrode and the center electrode of the DPF by a 10-kJ inductive energy storage circuit. It was anticipated that the accelerating mechanisms of the DPF pinch, which are known to cause a rapid reduction in the DPF current, would interrupt the 1-kA to 10-kA secondary discharge current thus forcing the secondary current through an external load and hence result in power amplification. …

Saving Energy In Rural Maine : Or Who's Doing What On The Farm, Mane Department Of Agriculture

Maine Collection

Saving Energy In Rural Maine : Or Who's Doing What on the Farm

Compiled by Bettina M. Blanchard and Edited by Bill Seekins.

Maine Department of Agriculture, Food and Rural Resources, Division of Resources Development, Augusta, Maine, 1983.

Contents: List of Photographs and Diagrams / Introduction / Projects / 1. Wind / 2. Wood Heat Applications On the Farm / 3. Solar Applications / 4. Manure Handling and Waste Utilization / 5. Energy Efficient Cooling Methods / 6. Energy Saving In Field Operations / 7. Production and Use of Alternative Fuels / 8. Multi-Project Sites / Summary and Conclusions / …

Digital Computer Solution Of Electromagnetic Transients In Large Power Systems, Bijan Navidbakhsh

Dissertations and Theses

This thesis is an introduction to the solution of electromagnetic transients by a combination of the Bergeran method of characteristics and the application of trapezoidal rule of integration.

Three test examples solved by digital computer illustrate the step by step solution and computer programming.

To compare this method with the Laplace transformation technique, a test problem solved by both methods and also digital computer is illustrated. In conclusion, the advantages and disadvantages of both methods are compared.

Economics Of Supplying Electric Service To Downtown Areas Under Various Methods Of Distribution, Pericles P. Stathas

Bachelors’ Theses

This thesis aims to present the problems involved in supplying electric service to downtown areas of high load density, with particular stress on the economies of rendering such a service. A considerable portion of the thesis is devoted to the new method of distribution, namely, the low-voltage A-C network.