Electrical and Electronics Commons^™

Micro-Electromechanical Switches For Micro-Satellite Power Transfer, Glen A. Kading

Theses and Dissertations

In the past few years, microelectromechanical systems (MEMS) have emerged as a promising new technology with tremendous application potential. One of the possible implementations of MEMS technology is in the development of micro-satellites. It should be possible to mass-produce micro-satellites at a fraction of the cost of one conventional satellite. In order for satellites to be robust, a method of transferring power to systems must be addressed. As micro-satellites are made with conventional integrated circuit technologies at a very small scale, a means of transferring power on a similar scale will be investigated. This research addresses the issue of the …

Microelectromechanical Scanner Using A Vertical Cavity Surface Emitting Laser, Joseph G. Bouchard Jr.

Theses and Dissertations

Optical scanners play a prominent role in the commercial and military industries. The scanner's size, cost and reliability are critical characteristics. In this research a microoptical scanning system was fabricated by incorporating a vertical cavity surface emitting laser (VCSEL) onto a surface machined microelectromechanical die. The micro optics for laser beam steering includes a 135 deg mirror, a Fresnel lens, a lateral scanning rotating mirror, and a vertical scanning fan mirror. The VCSEL was attached to the die by solder and electrical connection was provided by wire bonding. Based on far field measurements the scanner had a lateral scan angle …

Design And Development Of Microswitches For Micro-Electro-Mechanical Relay Matrices, Mark W. Phipps

Theses and Dissertations

Many different micro-electro-mechanical switches were designed in the Multi-User MEMS processes (MUMPs) and deep x-ray lithography and electroforming (LIGA) processes. The switches were composed of actuators that operated based upon either electrostatic forces or thermal forces. A thermally activated beam flexure actuator that operated based upon differential heating was used extensively. This actuator, which was fabricated in the MUMPs process, was able to deflect up to 12 microns with a total input power of less than 25 mW. The thermal resistance, which was needed to model this actuator, was determined from a material constant, 1.9 ± 0.08 m^1.5-°C-W …

Some Facts And Prospects For The Establishment Of Television Broadcasts In Mainland Tanzania, H. R. Mgombelo

Tanzania Journal of Engineering and Technology (TJET)

Abstract