Controls and Control Theory Commons^™

A Stroke Therapy Brace Design, Evan Kirkbride

Electrical Engineering

Victims of stroke often have difficulty with rehabilitation. With limited movement on their affected arm, patients often do not want to move much for physical therapy. In this project, we design a robotic brace that helps stroke patients move their arm more effectively in a reaching or pulling motion. By giving patients more movement in their affected arm than they would have otherwise, patients gain more from rehabilitation. The brace also adapts to the patient’s needs, providing more inclination or resistance as needed for their physical therapy. This kind of therapy engages patients rather than relying on their likely dwindled …

Cal Poly Supermileage Electronic Fuel Injection, Alexander Pink

Electrical Engineering

Cal Poly Supermileage is a student-run engineering club that builds prototype gasoline vehicles optimized maximum fuel-efficiency. To power their vehicles, the Supermileage team makes use of single-cylinder, 4-stroke, electronically fuel-injected (EFI) gasoline engines. This report details the development, iterative design & test cycles, and integration of an EFI system for the Supermileage club. This project develops an EFI system that interfaces to the most common types of sensors found in the low-power Supermileage-range of engines, including throttle-position sensors, manifold absolute pressure sensors, gear-tooth hall-effect sensors, variable-reluctance position sensors, engine coolant temperature sensors, intake air temperature sensors, and exhaust oxygen sensors. …

Exertion Control, Travis Taylor

Electrical Engineering

Current wearable fitness devices give the user after-the-fact fitness data, but little real-time feedback. Exertion Control, a new wearable device, continuously measures the user’s heart rate, creates a heart rate target, and helps the user reach it. This project completes the senior design and master’s thesis requirements and contains two milestones. The senior design product continuously measures the wearer’s heart rate and logs it with a user-friendly interface. This data models the heart’s exertion response and recovery response. The master’s thesis device refines the closed control loop with the user to give them a workout optimized to fit their needs.

Automatic Water Pump Controller, Alam D. Salguero, Kyle Russell Marquez Weeks

Electrical Engineering

In countries including Indonesia, Mexico, Guatemala, and El Salvador, a city water authority supplies the clean water and pumps it into large ground-level storage tanks. A resident’s water pump then pumps the water to a water tank on top of his/her house. When the water level in the ground-level storage tank becomes too low, the pump siphons air and shuts down, requiring a resident to manually prime the water pump to get it running again. Residents struggle to monitor the water level of the tanks effectively and keep the pump running properly. To remedy the issue, the Automatic Water Pump …

Out-Of-Loop Compensation Method For Op-Amps Driving Heavy Capacitive Loads, Shubham Gandhi

Master's Theses

It is well known that real op-amps do not share most of the desirable characteristics of an ideal one, particularly those of gain and output impedance. When presented with a capacitive load, such as a MOSFET or ADC, feedback in an op-amp circuit can quickly become unstable. This thesis studies and characterizes an op-amp’s output impedance and how its interaction with this type of load creates a parasitic pole which leads to instability. Applying ideas from feedback control theory, a model for studying the problem is developed from which a generalized method for compensating the undesirable circumstance is formulated.

Even …