Controls and Control Theory Commons^™

Near-Optimal Control Of Switched Systems With Continuous-Time Dynamics Using Approximate Dynamic Programming, Tohid Sardarmehni

Mechanical Engineering Research Theses and Dissertations

Optimal control is a control method which provides inputs that minimize a performance index subject to state or input constraints [58]. The existing solutions for finding the exact optimal control solution such as Pontryagin’s minimum principle and dynamic programming suffer from curse of dimensionality in high order dynamical systems. One remedy for this problem is finding near optimal solution instead of the exact optimal solution to avoid curse of dimensionality [31]. A method for finding the approximate optimal solution is through Approximate Dynamic Programming (ADP) methods which are discussed in the subsequent chapters.

In this dissertation, optimal switching in switched …

Resource Optimization In Wireless Sensor Networks For An Improved Field Coverage And Cooperative Target Tracking, Husam Sweidan

Dissertations, Master's Theses and Master's Reports

There are various challenges that face a wireless sensor network (WSN) that mainly originate from the limited resources a sensor node usually has. A sensor node often relies on a battery as a power supply which, due to its limited capacity, tends to shorten the life-time of the node and the network as a whole. Other challenges arise from the limited capabilities of the sensors/actuators a node is equipped with, leading to complication like a poor coverage of the event, or limited mobility in the environment. This dissertation deals with the coverage problem as well as the limited power and …

Cooperative 3-D Map Generation Using Multiple Uavs, Andrew Erik Lawson

University Scholar Projects

This report aims to demonstrate the feasibility of building a global 3-D map from multiple UAV robots in a GPS-denied, indoor environment. Presented are the design of each robot and the reasoning behind choosing its hardware and software components, the process in which a single robot obtains a individual 3-D map entirely onboard, and lastly how the mapping concept is extended to multiple robotic agents to form a global 3-D map using a centralized server. In the latter section, this report focuses on two algorithms, Online Mapping and Map Fusion, developed to facilitate the cooperative approach. A limited selection …

A Fuzzy Logic Controller For Autonomous Wheeled Vehicles, Mohamed Trabia, Linda Z. Shi, Neil Eugene Hodge

Mechanical Engineering Faculty Research

Autonomous vehicles have potential applications in many fields, such as replacing humans in hazardous environments, conducting military missions, and performing routine tasks for industry. Driving ground vehicles is an area where human performance has proven to be reliable. Drivers typically respond quickly to sudden changes in their environment. While other control techniques may be used to control a vehicle, fuzzy logic has certain advantages in this area; one of them is its ability to incorporate human knowledge and experience, via language, into relationships among the given quantities. Fuzzy logic controllers for autonomous vehicles have been successfully applied to address various …

Socio-Economic Impacts Of Computer Viruses In Tanzania, M Victor

Tanzania Journal of Engineering and Technology (TJET)

This paper reports on a research project conducted with an objective of identifying and assessing various approaches used by different computer users (Management, System Administrators and end users) in Tanzania to combat computer viruses (CVs), and to assess users' awareness level on CVs. Specifically, the study aimed at assessing the awareness level on CVs to the Tanzanian business community; analyze the socio -economic impact caused by CVs in Tanzania and; assess existing methods, capacity and limitations on controlling CVs in Tanzania. Data was collected using both questionnaires and interview from financial institutions such as NBC and BOT, and telecommunications sector …

Mobius: An Omnidirectional Robotic Platform And Software Architecture For Network Teleoperation, Samuel Aaron Miller

Electrical & Computer Engineering Theses & Dissertations

The following thesis presents the results of a project to develop and test an omnidirectional robotic system (hardware and software) at NASA Langley Research Center's Robotics and Intelligent Machines Lab. The impetus for the project was the unique capabilities of omnidirectional systems. Some of the many potential benefits these systems have include improved material-handling capabilities in constrained environments (such as might be found in extraterrestrial manned habitats), efficient camera-based vehicle teleoperation, and simplified route planning for autonomous robot operations.

The project's focus was to design, build, and test a system that used Mecanum wheels to achieve omnidirectional motion. In addition …

Review Of The Product Development Process And Information Flow In The Manufacturing Industry: Problems And A Possible Wav Forward, E Opiyo

Tanzania Journal of Engineering and Technology (TJET)

No abstract provided.

Comparison Of Two Distributed Fuzzy Logic Controllers For Flexible-Link Manipulators, Linda Z. Shi, Mohamed Trabia

Mechanical Engineering Faculty Presentations

The paper suggests that fuzzy logic controllers present a computationally efficient and robust alternative to conventional controllers. The paper presents two possible structures for the distributed fuzzy logic controller of a single-link flexible manipulator. A linear quadratic regulator method is used to prove the effectiveness of fuzzy logic controllers.

Application Of Vibrational Techniques In Determination Of Dynamic Properties Of Agricultural Products-State Of The Arton Of Vibrational Techniques In Determination Of Dynamic Properties Of Agricultural Products-State Of The Art, Silas Kajuna

Tanzania Journal of Engineering and Technology (TJET)

Vibration is one of the techniques employed in the determination of dynamic properties of fruits and vegetables. It entails generation of a mechanical or acoustic vibrational signal which is propagated through the flesh of the agricultural material. A transducer is either attached or held close to the specimen to monitor the propagation of the signal through the specimen. The manner in which the signal is transmitted through the material is analyzed, and the dynamic properties of the specimen which relate to its firmness or its internal being are derived. The technique has been around for the past 30 years or …

Newton Parameter Update Algorithm For Recurrent Neural Networks Applied To Adaptive System Identification And Control, Donald Allen Gates

Electrical & Computer Engineering Theses & Dissertations

This paper shows that the combination of a second-order neural network parameter update algorithm and internal network feedback can be effectively used for adaptive, nonlinear, dynamical system identification and control. Adaptive neural identification and control algorithms are typically utilized for real-time applications where the rate of adaptation is often critical. A fast, adaptive network parameter update algorithm is presented.

Simulation results show that this algorithm is capable of quickly identifying and adapting to changes in system parameters, making it feasible to use for real-time control and fault accommodation applications.

Multiple Stochastic Learning Automata For Vehicle Path Control In An Automated Highway System, Cem Unsal, Pushkin Kachroo, John S. Bay

Electrical & Computer Engineering Faculty Research

This paper suggests an intelligent controller for an automated vehicle planning its own trajectory based on sensor and communication data. The intelligent controller is designed using the learning stochastic automata theory. Using the data received from on-board sensors, two automata (one for lateral actions, one for longitudinal actions) can learn the best possible action to avoid collisions. The system has the advantage of being able to work in unmodeled stochastic environments, unlike adaptive control methods or expert systems. Simulations for simultaneous lateral and longitudinal control of a vehicle provide encouraging results

Simulation Study Of Learning Automata Games In Automated Highway Systems, Cem Unsal, Pushkin Kachroo, John S. Bay

Electrical & Computer Engineering Faculty Research

One of the most important issues in Automated Highway System (AHS) deployment is intelligent vehicle control. While the technology to safely maneuver vehicles exists, the problem of making intelligent decisions to improve a single vehicle’s travel time and safety while optimizing the overall traffic flow is still a stumbling block. We propose an artificial intelligence technique called stochastic learning automata to design an intelligent vehicle path controller. Using the information obtained by on-board sensors and local communication modules, two automata are capable of learning the best possible (lateral and longitudinal) actions to avoid collisions. This learning method is capable of …

Development Of Object-Based Teleoperator Control For Unstructured Applications, Hyunki Cho

Theses and Dissertations

For multi-fingered end effectors in unstructured applications, the main issues are control in the presence of uncertainties and providing grasp stability and object manipulability. The suggested concept in this thesis is object based teleoperator control which provides an intuitive way to control the robot in terms of the grasped object and reduces the operator's conceptual constraints. The general control law is developed using a hierarchical control structure, i.e., human interface I gross motion control level in teleoperation control and fine motion control/object grasp stability in autonomous control. The gross motion control is required to provide the position/orientation of the Super …

Intelligent Control Of Vehicles: Preliminary Results On The Application Of Learning Automata Techniques To Automated Highway System, Cem Unsal, John S. Bay, Pushkin Kachroo

Electrical & Computer Engineering Faculty Research

We suggest an intelligent controller for an automated vehicle to plan its own trajectory based on sensor and communication data received. Our intelligent controller is based on an artificial intelligence technique called learning stochastic automata. The automaton can learn the best possible action to avoid collisions using the data received from on-board sensors. The system has the advantage of being able to work in unmodeled stochastic environments. Simulations for the lateral control of a vehicle using this AI method provides encouraging results.

Text Independent Speaker Verification Using Binary-Pair Partitioned Neural Networks, Claude A. Norton Iii

Electrical & Computer Engineering Theses & Dissertations

A method is presented for the application of binary-pair partitioned neural networks to the task of speaker verification. This technique is based on a previously developed neural network classifier for speaker identification.

The main focus of this research was the development and testing of the algorithms necessary to extend the binary-pair partitioning approach from speaker identification to speaker verification. The method is based on the development of a user profile which is obtained from discriminative data provided by the binary-pair partitioned neural networks.

Experimental results are provided which demonstrate the viability of this approach, using the TIMIT speech corpus for …